Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics

Investigation of Optical Phase Noise in Long, Deployed Fiber Links for Quantum Networks

Matthew E. Grein, Timothy M. Yarnall

Published Jan 1, 2016• 2 citations
Publisher

Abstract

We investigated the phase noise of an ~83-km-long optical fiber link between Lincoln Laboratory and MIT for a quantum communication system and observed a noise process that is not governed entirely by a random-walk process.
DOI
10.1364/cleo_at.2016.jtu5a.15

Related papers

Stabilization of Long, Deployed Optical Fiber Links for Quantum Networks

Matthew E. Grein, Mark L. Stevens, Nicholas D. Hardy +1 more

We implemented an active feedback loop to compensate path-length drift on a deployed ~84-km-long optical fiber link between Lincoln Laboratory and MIT to enable quantum networking measurements and applications.

Conference on Lasers and Electro-Optics•Jan 1, 2017•7 citations

Sub-wavelength stabilization of long, deployed optical fibers for quantum networks

Matthew E. Grein, Mark L. Stevens, Nicholas D. Hardy +1 more

We implemented an active feedback scheme to stabilize an ∼84 km deployed optical fiber between Lincoln Laboratory and MIT Campus. The residual fluctuations of less than 193 attoseconds RMS enable quantum networking and quantum secure communications.

IEEE/LEOS Summer Topical Meetings•Jul 1, 2017•1 citation

Towards Quantum Networks: Characterizing Raman Noise over Metropolitan-scale Fiber Network

Marcello Caleffi, Laura d'Avossa, Italo Ignacio Machuca Flores +3 more

The coexistence of quantum and classical signals in optical fiber infrastructures represents a major challenge for large-scale quantum networks, as noise sources such as Raman scattering can significantly impact entanglement distribution, and the quantum protocols based on it. In this work, we analyze Raman scattering in the C-band, used for entanglement distribution, generated by a classical the O-band signal. The main contribution of this study lays in investigating these effects in a real metropolitan-fiber network, moving beyond controlled laboratory experiments to deployed telecommunication environments. Measurements are performed over a 7 km metropolitan fiber link using commercial sources and narrowband lasers. The experimental results shows good agreement between the measurements taken under laboratory conditions, although, within the metropolitan-scale loop, localized spectral anomalies are observed in the deployed fibers. Therefore, our results show that, whenever a quantum signal propagates in the C-band alongside an O-band classical channel within the same fiber, careful selection of the operating frequency is required, as Raman scattering and other real-world noise sources can significantly affect the quality and stability of the quantum transmission. In particular, we identify spectral regions that are less affected by Raman noise, thereby providing practical guidelines for optimal quantum channel allocation. We demonstrate that Raman-induced noise constitutes a dominant contribution to the quantum signal-to-noise ratio (SNR) in realistic deployments, beyond background and detector noise. Overall, our findings offer practical insights for deploying quantum communication systems over existing fiber networks, supporting the development of robust and scalable quantum infrastructures.

quant-pharXiv:2607.27970•IEEE International Conference on Smart Computing Workshops and Other Affiliated Events (SMARTCOMP Companion)•Jul 31, 2026•1 citation

Phase-noise measurements in long-fiber interferometers for quantum-repeater applications

Jiří Minář, Hugues de Riedmatten, Christoph Simon +2 more

Many protocols for long distance quantum communication require interferometric phase stability over long distances of optical fibers. In this paper we investigate the phase noise in long optical fibers both in laboratory environment and in installed commercial fibers in an urban environment over short time scales (up to hundreds of $\ensuremath{\mu}\text{s}$). We show that the phase fluctuations during the travel time of optical pulses in long-fiber loops are small enough to obtain high visibility first-order interference fringes in a Sagnac interferometer configuration for fiber lengths up to 75 km. We also measure phase fluctuations in a Mach-Zehnder interferometer in installed fibers with arm length 36.5 km. We verify that the phase noise respects Gaussian distribution and measure the mean phase change as a function of time difference. The typical time needed for a mean phase change of 0.1 rad is of order of $100\text{ }\ensuremath{\mu}\text{s}$, which provides information about the time scale available for active phase stabilization. Our results are relevant for future implementations of quantum repeaters in installed optical fiber networks.

arXiv:0712.0740•Physical Review A•May 20, 2008•111 citations

Measurement of Fiber-Induced One-Way Noise Over Deployed Optical Links for Quantum Networks

Helena Zhang, Matthew E. Grein, Scott A. Hamilton +1 more

Noise imparted to an optical signal propagating along a 42-km deployed optical fiber link is measured using two different techniques employing referenced mode-locked lasers. We compare the two techniques and assess their suitability for stabilizing the fiber link for quantum networks.

IEEE/LEOS Summer Topical Meetings•Jul 1, 2018•0 citations

Engineering Quantum Links: Noise and Quantum-State-Degradation Metrics over Metropolitan Fiber Network

Marcello Caleffi, Laura d'Avossa, Angela Sara Cacciapuoti

Deploying quantum networks over existing network infrastructures requires the same engineering foundations that underpin classical communications: quantitative models of the channel's noise and of the impairments it imposes on the transmitted information. In this work, we build such a foundation on experimental measurements, grounding the quantum-network counterparts of the two cornerstone metrics of classical link characterization - namely, the SINR and the BER - on a 7.3 km deployed metropolitan-scale fiber-loop interconnecting two campuses of the University of Naples Federico II within the national QuantumInternet.it testbed. On the noise side, we adopt a photon-counting quantum analog of the SINR - in which dark counts constitute the intrinsic noise and the photons generated by classical traffic (through either spontaneous Raman scattering or inter-fiber crosstalk) constitute the interference - and we quantify each contribution directly on the deployed loop. On the bit-error side, we consider the main degrees-of-freedom available to encode a quantum state within an optical photon - namely, polarization, time, and frequency - and we quantify for each degree the channel-induced degradation and its drift over time. These results show that a quantum fiber link, like its classical counterpart, can be captured by a small set of measurable parameters, turning quantum networking over deployed fiber from a physics demonstration into an engineering design problem. Together, they provide the key ingredients of a quantum link budget for the Quantum Internet.

quant-pharXiv:2609.11359•IEEE Open Journal of the Communications Society•Sep 11, 2026•0 citations
The coexistence of quantum and classical signals in optical fiber infrastructures represents a major challenge for large-scale quantum networks, as noise sources such as Raman scattering can significantly impact entanglement distribution, and the quantum protocols based on it. In this work, we analyze Raman scattering in the C-band, used for entanglement distribution, generated by a classical the O-band signal. The main contribution of this study lays in investigating these effects in a real metropolitan-fiber network, moving beyond controlled laboratory experiments to deployed telecommunication environments. Measurements are performed over a 7 km metropolitan fiber link using commercial sources and narrowband lasers. The experimental results shows good agreement between the measurements taken under laboratory conditions, although, within the metropolitan-scale loop, localized spectral anomalies are observed in the deployed fibers. Therefore, our results show that, whenever a quantum signal propagates in the C-band alongside an O-band classical channel within the same fiber, careful selection of the operating frequency is required, as Raman scattering and other real-world noise sources can significantly affect the quality and stability of the quantum transmission. In particular, we identify spectral regions that are less affected by Raman noise, thereby providing practical guidelines for optimal quantum channel allocation. We demonstrate that Raman-induced noise constitutes a dominant contribution to the quantum signal-to-noise ratio (SNR) in realistic deployments, beyond background and detector noise. Overall, our findings offer practical insights for deploying quantum communication systems over existing fiber networks, supporting the development of robust and scalable quantum infrastructures.
Many protocols for long distance quantum communication require interferometric phase stability over long distances of optical fibers. In this paper we investigate the phase noise in long optical fibers both in laboratory environment and in installed commercial fibers in an urban environment over short time scales (up to hundreds of $\ensuremath{\mu}\text{s}$). We show that the phase fluctuations during the travel time of optical pulses in long-fiber loops are small enough to obtain high visibility first-order interference fringes in a Sagnac interferometer configuration for fiber lengths up to 75 km. We also measure phase fluctuations in a Mach-Zehnder interferometer in installed fibers with arm length 36.5 km. We verify that the phase noise respects Gaussian distribution and measure the mean phase change as a function of time difference. The typical time needed for a mean phase change of 0.1 rad is of order of $100\text{ }\ensuremath{\mu}\text{s}$, which provides information about the time scale available for active phase stabilization. Our results are relevant for future implementations of quantum repeaters in installed optical fiber networks.
Deploying quantum networks over existing network infrastructures requires the same engineering foundations that underpin classical communications: quantitative models of the channel's noise and of the impairments it imposes on the transmitted information. In this work, we build such a foundation on experimental measurements, grounding the quantum-network counterparts of the two cornerstone metrics of classical link characterization - namely, the SINR and the BER - on a 7.3 km deployed metropolitan-scale fiber-loop interconnecting two campuses of the University of Naples Federico II within the national QuantumInternet.it testbed. On the noise side, we adopt a photon-counting quantum analog of the SINR - in which dark counts constitute the intrinsic noise and the photons generated by classical traffic (through either spontaneous Raman scattering or inter-fiber crosstalk) constitute the interference - and we quantify each contribution directly on the deployed loop. On the bit-error side, we consider the main degrees-of-freedom available to encode a quantum state within an optical photon - namely, polarization, time, and frequency - and we quantify for each degree the channel-induced degradation and its drift over time. These results show that a quantum fiber link, like its classical counterpart, can be captured by a small set of measurable parameters, turning quantum networking over deployed fiber from a physics demonstration into an engineering design problem. Together, they provide the key ingredients of a quantum link budget for the Quantum Internet.