Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Stabilizing the trajectory of a superconducting qubit by projective measurement feedback

Philippe Campagne-Ibarcq, Emmanuel Flurin, Nicolas Roch, David Darson, Pascal Morfin, Mazyar Mirrahimi, Michel Devoret, F. Mallet, Benjamin Huard

Published Jan 25, 2013• 2 citations
OpenAlex

Related papers

Stabilizing Rabi oscillations in a superconducting qubit using quantum feedback

Rajamani Vijay, Chris Macklin, D. H. Slichter +5 more

arXiv:1205.5591•Nature•Oct 1, 2012•498 citations

Quantum feedback control in superconducting qubits: Towards creating and stabilizing entanglement in remote qubits

Rajamani Vijayaraghavan

Bulletin of the American Physical Society•Mar 21, 2013•0 citations

Characterizing measurement and feedback processes in superconducting qubit systems

Nissim Ofek, Y. Liu, Michael J. Hatridge +3 more

Bulletin of the American Physical Society•Mar 3, 2014•0 citations

Deterministic entanglement of superconducting qubits by parity measurement and feedback

Diego Ristè, M. Dukalski, C. A. Watson +6 more

arXiv:1306.4002•Nature•Oct 15, 2013•332 citations

Measurement back action and feedback in superconducting circuits

Philippe Campagne-Ibarcq

This thesis presents a series of experiments highlighting measurement back action and decoherence in a basic open quantum system, the superconducting qubit. These observations are enabled by recent advances in amplification close to the quantum limit using Josephson circuits. The information extracted from the system can then be used as input in quantum feedback. A stroboscopic projective readout is performed and a feedback loop is used to correct for detected errors, thus stabilizing an arbitrary predetermined state of the qubit. When monitoring continuously the environment of the qubit by heterodyne detection of its fluorescence, we reconstruct individual quantum trajectories during relaxation. Conditioning this detection to the outcome of a following projective measurement, we access the weak values of the fluorescence signal. Included in a continuous feedback loop, this detection is also used to stabilize an arbitrary state of the qubit. Finally, a last experiment witnesses quantum Zeno dynamics of a resonant microwave mode, entailed by its coupling to the qubit.

•Jun 26, 2015•7 citations

Entanglement stabilization using ancilla-based parity detection and real-time feedback in superconducting circuits

Christian Kraglund Andersen, Ants Remm, Stefania Lazar +6 more

Abstract Fault-tolerant quantum computing relies on the ability to detect and correct errors, which in quantum error correction codes is typically achieved by projectively measuring multi-qubit parity operators and by conditioning operations on the observed error syndromes. Here, we experimentally demonstrate the use of an ancillary qubit to repeatedly measure the ZZ and XX parity operators of two data qubits and to thereby project their joint state into the respective parity subspaces. By applying feedback operations conditioned on the outcomes of individual parity measurements, we demonstrate the real-time stabilization of a Bell state with a fidelity of F ≈ 74% in up to 12 cycles of the feedback loop. We also perform the protocol using Pauli frame updating and, in contrast to the case of real-time stabilization, observe a steady decrease in fidelity from cycle to cycle. The ability to stabilize parity over multiple feedback rounds with no further reduction in fidelity provides strong evidence for the feasibility of executing stabilizer codes on timescales much longer than the intrinsic coherence times of the constituent qubits.

arXiv:1902.06946•npj Quantum Information•Aug 15, 2019•92 citations
This thesis presents a series of experiments highlighting measurement back action and decoherence in a basic open quantum system, the superconducting qubit. These observations are enabled by recent advances in amplification close to the quantum limit using Josephson circuits. The information extracted from the system can then be used as input in quantum feedback. A stroboscopic projective readout is performed and a feedback loop is used to correct for detected errors, thus stabilizing an arbitrary predetermined state of the qubit. When monitoring continuously the environment of the qubit by heterodyne detection of its fluorescence, we reconstruct individual quantum trajectories during relaxation. Conditioning this detection to the outcome of a following projective measurement, we access the weak values of the fluorescence signal. Included in a continuous feedback loop, this detection is also used to stabilize an arbitrary state of the qubit. Finally, a last experiment witnesses quantum Zeno dynamics of a resonant microwave mode, entailed by its coupling to the qubit.
Abstract Fault-tolerant quantum computing relies on the ability to detect and correct errors, which in quantum error correction codes is typically achieved by projectively measuring multi-qubit parity operators and by conditioning operations on the observed error syndromes. Here, we experimentally demonstrate the use of an ancillary qubit to repeatedly measure the ZZ and XX parity operators of two data qubits and to thereby project their joint state into the respective parity subspaces. By applying feedback operations conditioned on the outcomes of individual parity measurements, we demonstrate the real-time stabilization of a Bell state with a fidelity of F ≈ 74% in up to 12 cycles of the feedback loop. We also perform the protocol using Pauli frame updating and, in contrast to the case of real-time stabilization, observe a steady decrease in fidelity from cycle to cycle. The ability to stabilize parity over multiple feedback rounds with no further reduction in fidelity provides strong evidence for the feasibility of executing stabilizer codes on timescales much longer than the intrinsic coherence times of the constituent qubits.