Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Photonics Society Annual Meeting

Ultra low dark-count-rate up-conversion single photon detector

Xiao Hong Tang, Lijun Ma, Oliver Slattery

Published Nov 1, 2010• 3 citations
Publisher

Abstract

We have demonstrated an ultra low noise up-conversion single photon detector using a periodically poled lithium niobate waveguide. The dark count rate of this detector is lower than 100 counts/second at 10% detection efficiency.
DOI
10.1109/photonics.2010.5698783

Related papers

1064-μm-band up-conversion single-photon detector

Fei Ma, Ming-Yang Zheng, Quan Yao +3 more

Based on the technique of periodically poled lithium niobate waveguide, up-conversion single-photon detection at 1.064-μm is demonstrated. We have achieved a system photon detection efficiency of 32.5% with a very low noise count rate of 45 counts per second by pumping with a 1.55-μm-band single frequency laser using the long-wavelength pumping technique and exploiting volume Bragg grating as a narrow band filter. Replacing the volume Bragg grating with a combination of adequate dielectric filters, a detection efficiency of up to 38% with a noise count rate of 700 counts per second is achieved, making the overall system stable and practical. The up-conversion single-photon detector operating at 1.064 μm can be a promising robust counter and find usage in many fields.

arXiv:1703.10838•Optics Express•Jun 16, 2017•14 citations

Single-photon detector based on frequency up-conversion in MgO-doped periodically-poled LiNbO3 waveguide: recordlow dark counts and detectable photons

Da Li, Yujie J. Ding, Ioulia B. Zotova +1 more

We have implemented a single-photon detector in the 1500-nm band based on frequency up-conversion in a MgO-doped periodically-poled LiNbO3 waveguide, with a record-low dark count rate and a record-low detectable signal photon rate.

Conference on Lasers and Electro-Optics•Jan 1, 2012•0 citations

Efficient and low-noise single-photon detection in 1550 nm communication band by frequency upconversion in periodically poled LiNbO_3 waveguides

Hidehiko Kamada, Masaki Asobe, Toshimori Honjo +5 more

We demonstrate 1500 nm band single-photon detection with low dark-count noise and a potentially high efficiency, which may allow long distance and high-bit-rate quantum key distribution. By developing frequency upconversion devices based on periodically poled lithium niobate waveguides, which are specifically designed to use a pump wavelength longer than that of communication-band photons, we completely eliminate the dark-count noise caused by parasitic nonlinear processes in the waveguide. We observed an internal conversion efficiency as high as 40% and demonstrated scaling down to the single photon level while maintaining a background dark-count rate of 10(2)s(-1).

Optics Letters•Mar 18, 2008•52 citations

Long-wavelength-pumped upconversion single-photon detector at 1550 nm: performance and noise analysis

Jason S. Pelc, Long Ma, Christopher R. Phillips +5 more

We demonstrate upconversion-assisted single-photon detection for the 1.55-μm telecommunications band based on a periodically poled lithium niobate (PPLN) waveguide pumped by a monolithic PPLN optical parametric oscillator. We achieve an internal conversion efficiency of 86%, which results in an overall system detection efficiency of 37%, with excess noise as low as 10(3) counts s(-1). We measure the dark count rate versus the upconversion pump-signal frequency separation and find the results to be consistent with noise photon generation by spontaneous anti-Stokes Raman scattering. These results enable detailed design guidelines for the development of low-noise quantum frequency conversion systems, which will be an important component of fiber-optic quantum networks.

Optics Express•Oct 17, 2011•246 citations

Upconversion detection near 2 μm at the single photon level

Guo-Liang Shentu, Xiu-Xiu Xia, Qi-Chao Sun +4 more

We have demonstrated upconversion detection at the single photon level in the 2 μm spectral window using a pump wavelength near 1550 nm, a periodically poled lithium niobate (PPLN) waveguide, and a volume Bragg grating (VBG) to reduce noise. We achieve a system photon detection efficiency of 10%, with a noise count rate of 24,500 counts per second, competitive with other 2 μm single photon detection technologies. This detector has potential applications in environmental gas monitoring, life science, and classical and quantum communication.

arXiv:1310.7422•Optics Letters•Nov 19, 2013•24 citations

Low-noise PPLN-based single-photon detector

Xu Hai, Lijun Ma, Oliver Slattery +1 more

This paper describes the detection of single photons, which have been transmitted through standard fiber at the telecom wavelength of 1310 nm. Following transmission, the 1310-nm photon is up-converted to 710 nm in a periodical-poled LiNbO3 (PPLN) waveguide and then detected by a silicon-based avalanche photodiode (Si-APD). The overall detection efficiency of the detector is 20%. We have also characterized the sensitivity of the PPLN's efficiency to temperature and wavelength changes. We focused on the noise property of the up-conversion detector. Without classical channel co-propagation, the dark count rate is 2.2 kHz, which is lower than current up-conversion detectors by more than one order of magnitude. The up-conversion detector is then applied to a QKD system, which is characterized and is shown to have a very strong performance.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 9, 2007•13 citations
Based on the technique of periodically poled lithium niobate waveguide, up-conversion single-photon detection at 1.064-μm is demonstrated. We have achieved a system photon detection efficiency of 32.5% with a very low noise count rate of 45 counts per second by pumping with a 1.55-μm-band single frequency laser using the long-wavelength pumping technique and exploiting volume Bragg grating as a narrow band filter. Replacing the volume Bragg grating with a combination of adequate dielectric filters, a detection efficiency of up to 38% with a noise count rate of 700 counts per second is achieved, making the overall system stable and practical. The up-conversion single-photon detector operating at 1.064 μm can be a promising robust counter and find usage in many fields.
We demonstrate 1500 nm band single-photon detection with low dark-count noise and a potentially high efficiency, which may allow long distance and high-bit-rate quantum key distribution. By developing frequency upconversion devices based on periodically poled lithium niobate waveguides, which are specifically designed to use a pump wavelength longer than that of communication-band photons, we completely eliminate the dark-count noise caused by parasitic nonlinear processes in the waveguide. We observed an internal conversion efficiency as high as 40% and demonstrated scaling down to the single photon level while maintaining a background dark-count rate of 10(2)s(-1).
We demonstrate upconversion-assisted single-photon detection for the 1.55-μm telecommunications band based on a periodically poled lithium niobate (PPLN) waveguide pumped by a monolithic PPLN optical parametric oscillator. We achieve an internal conversion efficiency of 86%, which results in an overall system detection efficiency of 37%, with excess noise as low as 10(3) counts s(-1). We measure the dark count rate versus the upconversion pump-signal frequency separation and find the results to be consistent with noise photon generation by spontaneous anti-Stokes Raman scattering. These results enable detailed design guidelines for the development of low-noise quantum frequency conversion systems, which will be an important component of fiber-optic quantum networks.
We have demonstrated upconversion detection at the single photon level in the 2 μm spectral window using a pump wavelength near 1550 nm, a periodically poled lithium niobate (PPLN) waveguide, and a volume Bragg grating (VBG) to reduce noise. We achieve a system photon detection efficiency of 10%, with a noise count rate of 24,500 counts per second, competitive with other 2 μm single photon detection technologies. This detector has potential applications in environmental gas monitoring, life science, and classical and quantum communication.
This paper describes the detection of single photons, which have been transmitted through standard fiber at the telecom wavelength of 1310 nm. Following transmission, the 1310-nm photon is up-converted to 710 nm in a periodical-poled LiNbO3 (PPLN) waveguide and then detected by a silicon-based avalanche photodiode (Si-APD). The overall detection efficiency of the detector is 20%. We have also characterized the sensitivity of the PPLN's efficiency to temperature and wavelength changes. We focused on the noise property of the up-conversion detector. Without classical channel co-propagation, the dark count rate is 2.2 kHz, which is lower than current up-conversion detectors by more than one order of magnitude. The up-conversion detector is then applied to a QKD system, which is characterized and is shown to have a very strong performance.