Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical review. E

Renormalized multicanonical sampling in multiple dimensions

Yong Hwan Lee, David O. Yevick

Published Oct 31, 2016• 8 citations
Publisher

Abstract

This paper extends to two and three dimensions the recently proposed renormalized multicanonical sampling procedure [D. Yevick, Int. J. Mod. Phys. C 27, 1650033 (2016)IJMPEO0129-183110.1142/S0129183116500339], which generates the density of states of a system from that of a smaller system. The accuracy and efficiency of the method is additionally enhanced through a transition matrix Monte Carlo method that incorporates multicanonical sampling. The performance of the resulting procedure is investigated through calculations of the specific heat of the standard Ising model for square lattices with up to 128^{2} spins and for cubic lattices with up to 24^{3} spins. A comparison of the scaling properties to those of other algorithms based on the transition matrix Monte Carlo method demonstrates that the relative advantage of the renormalized procedure increases rapidly with system size.

DOI
10.1103/physreve.94.043323

Related papers

Complete high-precision entropic sampling

Ronald Dickman, A. G. Cunha-Netto

Monte Carlo simulations using entropic sampling to estimate the number of configurations of a given energy are a valuable alternative to traditional methods. We introduce tomographic entropic sampling, a scheme which uses multiple studies, starting from different regions of configuration space, to yield precise estimates of the number of configurations over the full range of energies, without dividing the latter into subsets or windows. Applied to the Ising model on the square lattice, the method yields the critical temperature to an accuracy of about 0.01%, and critical exponents to 1% or better. Predictions for system sizes L=10-160, for the temperature of the specific heat maximum, and of the specific heat at the critical temperature, are in very close agreement with exact results. For the Ising model on the simple cubic lattice the critical temperature is given to within 0.003% of the best available estimate; the exponent ratios β/ν and γ/ν are given to within about 0.04% and 1%, respectively, of the literature values. In both two and three dimensions, results for the antiferromagnetic critical point are fully consistent with those of the ferromagnetic transition. Application to the lattice gas with nearest-neighbor exclusion on the square lattice again yields the critical chemical potential and exponent ratios β/ν and γ/ν to good precision.

arXiv:1107.2951•Physical Review E•Aug 4, 2011•18 citations

Replica-exchange cluster algorithm

Wolfhard Janke E, Elmar Bittner

In finite-size scaling analyses of Monte Carlo simulations of second-order phase transitions one often needs an extended temperature/energy range around the critical point.By combining the replica-exchange algorithm with cluster updates and an adaptive routine to find the range of interest, we introduce a new flexible and powerful method for systematic investigations of critical phenomena.As a result, we gain two further orders of magnitude in the performance for 2D and 3D Ising models in comparison with the recently proposed Wang-Landau recursion for cluster algorithms based on the multibondic algorithm, which is already a great improvement over the standard multicanonical variant.

arXiv:1108.0354•International Symposium on Lattice Field Theory (LATTICE)•Jun 23, 2010•0 citations

Monte Carlo Simulations in Complex Systems: Challenges and New Approaches

Jiming Chen

Monte Carlo simulations are crucial for examining the Ising model, especially when it's tough to find analytical solutions. However, traditional Monte Carlo methods, like the Metropolis algorithm, encounter significant hurdles, such as slowing down near phase transitions and issues related to finite sizes. This paper looks into both the advantages and limitations of these traditional Monte Carlo techniques. It also covers recent developments like Tensor Network Monte Carlo and Quantum Monte Carlo methods, which have shown promise in overcoming these challenges. Furthermore, the paper explores how machine learning techniques are being incorporated into Monte Carlo simulations to enhance their efficiency and accuracy. These advancements represent a major leap forward in simulating complex systems and have expanded the use of Monte Carlo methods into new areas, including quantum systems and models with disorder. This paper finds that traditional Monte Carlo methods, like the Metropolis algorithm, face issues such as critical slowing down and finite-size effects. New methods, such as Tensor Network Monte Carlo (TNMC) and Quantum Monte Carlo (QMC), effectively address these challenges, enhancing simulation accuracy and efficiency in complex systems. Additionally, integrating machine learning optimizes parameters and accelerates convergence, expanding Monte Carlo’s applicability to large-scale, high-dimensional systems across various scientific fields.

Theoretical and Natural Science•Jan 15, 2025•5 citations

Microcanonical Monte Carlo study of a two-dimensional Blume-Capel model

C. M. Care

A microcanonical Monte Carlo algorithm has been developed to calculate the density of states of a two-dimensional Blume-Capel model in zero field. The full density of states is calculated for a 16*16 lattice as a function of the two spin summations which appear in the Hamiltonian. This permits the partition function and related thermodynamic functions to be evaluated for any temperature and any single site anisotropy from a single data set. Results are presented for the pseudo-critical transition temperature and the maximum in the specific heat as a function of the single site anisotropy parameter. The technique will allow the region near the tricritical point to be explored in detail and will permit the future determination of the zeros of the partition function. It should be noted that the microcanonical sampling method of Lee (1990) was found to be unusably slow for the S=1 problem in regions were the density of states had a significant slope and the microcanonical sampling described in this work is a significant improvement on his sampling method.

Journal of Physics A Mathematical and General•Apr 7, 1993•22 citations

Monte Carlo renormalization-group calculations of critical behavior in the simple-cubic Ising model

Godfrey Stuart Pawley, Robert H. Swendsen, D. J. Wallace +1 more

The Monte Carlo renormalization group is applied to the three-dimensional Ising model on simple cubic lattices with ${8}^{3}$, ${16}^{3}$, ${32}^{3}$, and ${64}^{3}$ sites. The comparison of block-spin correlation functions from the largest lattices yields the nearest-neighbor critical coupling ${K}_{1}^{c}=0.221654(6)$. After allowing for (i) interpolation to this best estimate for ${K}_{1}^{c}$, (ii) an apparent finite-size effect in the renormalization-group transformation due to the measurement of correlation functions of too few (seven) operators, and (iii) the extrapolation for the effect of a slow transient towards the fixed point, the values $\ensuremath{\nu}=0.629(4)$ and $\ensuremath{\eta}=0.031(5)$ are obtained for the thermal and magnetic exponents. The correction-to-scaling exponent $\ensuremath{\omega}$ is estimated to be around 1; to obtain an accuracy competitive with other methods requires measurements with more than seven operators. We briefly review the problem of redundant operators and indicate the future prospects for this kind of calculation.

Physical review. B, Condensed matter•Apr 1, 1984•314 citations

Monte Carlo Simulation of Real Space Renormalization

WU Da-yan

Mont Carlo simulation of the renormalization of 2-dimensional square lattice Ising model is performed, using simple sampling and important sampling, respectively. For simple sampling, analytical result is got, but only small cell can be simulated; Comparatively, the much larger cell can be simulated using. And the obtained numerical solution becomes closer to the accurate result. The method of this article can highly improve the accuracy of real space renormalization.

Journal of Anhui University of Technology•Jan 1, 2009•0 citations
This paper extends to two and three dimensions the recently proposed renormalized multicanonical sampling procedure [D. Yevick, Int. J. Mod. Phys. C 27, 1650033 (2016)IJMPEO0129-183110.1142/S0129183116500339], which generates the density of states of a system from that of a smaller system. The accuracy and efficiency of the method is additionally enhanced through a transition matrix Monte Carlo method that incorporates multicanonical sampling. The performance of the resulting procedure is investigated through calculations of the specific heat of the standard Ising model for square lattices with up to 128^{2} spins and for cubic lattices with up to 24^{3} spins. A comparison of the scaling properties to those of other algorithms based on the transition matrix Monte Carlo method demonstrates that the relative advantage of the renormalized procedure increases rapidly with system size.
Monte Carlo simulations using entropic sampling to estimate the number of configurations of a given energy are a valuable alternative to traditional methods. We introduce tomographic entropic sampling, a scheme which uses multiple studies, starting from different regions of configuration space, to yield precise estimates of the number of configurations over the full range of energies, without dividing the latter into subsets or windows. Applied to the Ising model on the square lattice, the method yields the critical temperature to an accuracy of about 0.01%, and critical exponents to 1% or better. Predictions for system sizes L=10-160, for the temperature of the specific heat maximum, and of the specific heat at the critical temperature, are in very close agreement with exact results. For the Ising model on the simple cubic lattice the critical temperature is given to within 0.003% of the best available estimate; the exponent ratios β/ν and γ/ν are given to within about 0.04% and 1%, respectively, of the literature values. In both two and three dimensions, results for the antiferromagnetic critical point are fully consistent with those of the ferromagnetic transition. Application to the lattice gas with nearest-neighbor exclusion on the square lattice again yields the critical chemical potential and exponent ratios β/ν and γ/ν to good precision.
In finite-size scaling analyses of Monte Carlo simulations of second-order phase transitions one often needs an extended temperature/energy range around the critical point.By combining the replica-exchange algorithm with cluster updates and an adaptive routine to find the range of interest, we introduce a new flexible and powerful method for systematic investigations of critical phenomena.As a result, we gain two further orders of magnitude in the performance for 2D and 3D Ising models in comparison with the recently proposed Wang-Landau recursion for cluster algorithms based on the multibondic algorithm, which is already a great improvement over the standard multicanonical variant.
Monte Carlo simulations are crucial for examining the Ising model, especially when it's tough to find analytical solutions. However, traditional Monte Carlo methods, like the Metropolis algorithm, encounter significant hurdles, such as slowing down near phase transitions and issues related to finite sizes. This paper looks into both the advantages and limitations of these traditional Monte Carlo techniques. It also covers recent developments like Tensor Network Monte Carlo and Quantum Monte Carlo methods, which have shown promise in overcoming these challenges. Furthermore, the paper explores how machine learning techniques are being incorporated into Monte Carlo simulations to enhance their efficiency and accuracy. These advancements represent a major leap forward in simulating complex systems and have expanded the use of Monte Carlo methods into new areas, including quantum systems and models with disorder. This paper finds that traditional Monte Carlo methods, like the Metropolis algorithm, face issues such as critical slowing down and finite-size effects. New methods, such as Tensor Network Monte Carlo (TNMC) and Quantum Monte Carlo (QMC), effectively address these challenges, enhancing simulation accuracy and efficiency in complex systems. Additionally, integrating machine learning optimizes parameters and accelerates convergence, expanding Monte Carlo’s applicability to large-scale, high-dimensional systems across various scientific fields.
A microcanonical Monte Carlo algorithm has been developed to calculate the density of states of a two-dimensional Blume-Capel model in zero field. The full density of states is calculated for a 16*16 lattice as a function of the two spin summations which appear in the Hamiltonian. This permits the partition function and related thermodynamic functions to be evaluated for any temperature and any single site anisotropy from a single data set. Results are presented for the pseudo-critical transition temperature and the maximum in the specific heat as a function of the single site anisotropy parameter. The technique will allow the region near the tricritical point to be explored in detail and will permit the future determination of the zeros of the partition function. It should be noted that the microcanonical sampling method of Lee (1990) was found to be unusably slow for the S=1 problem in regions were the density of states had a significant slope and the microcanonical sampling described in this work is a significant improvement on his sampling method.
The Monte Carlo renormalization group is applied to the three-dimensional Ising model on simple cubic lattices with 83{8}^{3}83, 163{16}^{3}163, 323{32}^{3}323, and 643{64}^{3}643 sites. The comparison of block-spin correlation functions from the largest lattices yields the nearest-neighbor critical coupling K1c=0.221654(6){K}_{1}^{c}=0.221654(6)K1c​=0.221654(6). After allowing for (i) interpolation to this best estimate for K1c{K}_{1}^{c}K1c​, (ii) an apparent finite-size effect in the renormalization-group transformation due to the measurement of correlation functions of too few (seven) operators, and (iii) the extrapolation for the effect of a slow transient towards the fixed point, the values $\ensuremath{\nu}=0.629(4)$ and $\ensuremath{\eta}=0.031(5)$ are obtained for the thermal and magnetic exponents. The correction-to-scaling exponent $\ensuremath{\omega}$ is estimated to be around 1; to obtain an accuracy competitive with other methods requires measurements with more than seven operators. We briefly review the problem of redundant operators and indicate the future prospects for this kind of calculation.