This chapter treats the ferromagnetic transition as a further example of the renormalization group procedure and shows how critical exponents can be extracted.
This report will study the theory of renormalization group used on a ferromagnet to calculate magnetic phase transitions. As the ferromagnet's temperature changes, so does interatomic interaction, causing either a lingering magnetization at low temperatures, or a random state at high temperatures. At the phase transition, where the magnetization first appears/disappears, depending from which side the critical temperature is approached, the ferromagnet will behave in a certain way that causes some quantities to receive power law behaviours, so called critical exponents. The theory of renormalization group is used to find the critical point and these power units on two different two-dimensional lattices, the square lattice and the triangular lattice. The first step is to study how atoms couple to each other in one-dimension. It is possible to group atoms together into blocks. These blocks will interact with each other through new couplings. It is possible to calculate the critical point and critical exponents by comparing the block couplings with the former atomic couplings and then find the exponents. The theory of renormalization does seem to work in general, as the result will be able to explain experimentally observed relation between exponents.
Abstract In Chapter 8 we gave an introduction to the formalism of the renormalization group. A renormalization transformation changes the scale of a system by a factor b. Systems at criticality flow to fixed points under the transformation and their critical exponents and scaling behaviour are determined by linearizing the recursion equations about the fixed point. The aim of this chapter is two-fold: firstly to illustrate these ideas by giving several examples of renormalization group transformations and secondly to demonstrate the ways in which they can be used to calculate critical properties. Our examples are divided into three classes. In Section 9.1, we shall consider a one-dimensional model where the recursion relations can be written down exactly. The drawback of this as a canonical example is that any critical behaviour is at zero temperature. The decimation transformation presented in one dimension is an example of a real-space transformation and the second task, in Section 9.2, is to show how these may be used approximately to treat models in higher dimensions. Thirdly, in Section 9.5, we shall mention the E-expansion where the renormalization takes place in momentum space. This enables an understanding of the crossover to mean-field behaviour. However, the formalism is somewhat involved and the details are beyond the scope of this book.
Abstract The successful calculation of critical exponents for continuous phase transitions is one of the main achievements of theoretical physics over the last quarter-century. This was achieved through the use of scaling and field-theoretic techniques which have since become standard equipment in many areas of physics, especially quantum field theory. This book provides a thorough introduction to these techniques. Continuous phase transitions are introduced, then the necessary statistical mechanics is summarized, followed by standard models, some exact solutions and techniques for numerical simulations. The real-space renormalization group and mean-field theory are then explained and illustrated. The final chapters cover the Landau-Ginzburg model, from physical motivation, through diagrammatic perturbation theory and renormalization to the renormalization group and the calculation of critical exponents above and below the critical temperature.