Introduction Engineers who design transistors, lasers and other semiconductor components want to understand and control the cause of resistance to current flow so that they may better optimize device performance. A detailed microscopic understanding of electron motion from one part of a semiconductor to another requires the explicit calculation of electron scattering probability. One would like to know how to predict electron scattering from one state to another. In this chapter we will see how to do this using powerful quantummechanical techniques. In addition to understanding electron motion in a semiconductor we also want to understand how to make devices that emit or absorb light. In Chapter 6 it was shown that a superposition of two harmonic oscillator eigenstates could give rise to dipole radiation and emission of a photon. The creation of a photon was only possible if a superposition state existed between a correct pair of eigenstates. This leads directly to the concept of rules determining pairs of eigenstates which can give rise to photon emission. Such selection rules are a useful tool to help us understand the emission and absorption of light by matter. However, the real challenge is to use what we know to make practical devices which operate using emission and absorption of photons. This usually requires imposing some control over atomic-scale physical processes which, of course, can only be understood using quantum mechanics.
Introduction Engineers who design transistors, lasers and other semiconductor components want to understand and control the cause of resistance to current flow so that they may better optimize device performance. A detailed microscopic understanding of electron motion from one part of a semiconductor to another requires the explicit calculation of electron scattering probability. One would like to know how to predict electron scattering from one state to another. In this chapter we will see how to do this using powerful quantummechanical techniques. In addition to understanding electron motion in a semiconductor we also want to understand how to make devices that emit or absorb light. In Chapter 6 it was shown that a superposition of two harmonic oscillator eigenstates could give rise to dipole radiation and emission of a photon. The creation of a photon was only possible if a superposition state existed between a correct pair of eigenstates. This leads directly to the concept of rules determining pairs of eigenstates which can give rise to photon emission. Such selection rules are a useful tool to help us understand the emission and absorption of light by matter. However, the real challenge is to use what we know to make practical devices which operate using emission and absorption of photons. This usually requires imposing some control over atomic-scale physical processes which, of course, can only be understood using quantum mechanics.
Quantum theory has formed a cornerstone for modern physics, engineering, and chemistry since the 1920s. It has found significant modern applications in engineering since the development of the semiconductor diode, transistor, and especially the laser in the 1960s. Not until the 1980s did the fabrication and materials growth technology become sufficiently developed to provide the ability to (1) produce quantum well devices (such as quantum well lasers) and (2) engineer the optical and electrical properties of materials (band-gap engineering). One purpose of this chapter is to summarize a small portion of modern quantum theory. The first few sections of this chapter summarize Lagrange and Hamilton’s approach to classical mechanics. These alternate formulations to Newton’s formulation of classical mechanics allow us to use scalar quantities such as kinetic or potential energy to find the equations of motion. These alternate formulations are so powerful that they can be used to deduce Maxwell’s and other continuous field equations. In fact, the quantum mechanical Hamiltonian comes from the classical one by substituting operators for the classical dynamical variables. The chapter discusses the connection between linear algebra and quantum mechanics and reviews the basic theory. The discussion of the harmonic oscillator introduces the ladder operators and vacuum state, and prepares the way for the harmonic oscillator theory of the electromagnetic field encounter in quantum optics. The chapter includes quantum mechanical representation theory along with the time dependent perturbation theory. The density operator plays a central role in emission and absorption theory.
With the advent of the laser, an interest in the statistical properties of light was born. New theories, which required an understanding of how the lasing medium interacts quantum mechanically with incident light were developed to classify and quantify light. For many laser systems, gaining an understanding of the physical processes occurring in the medium, and translating these into a mathematical formalism has been achieved with relative speed and ease, and the resulting theories form part of the core of the field we know as quantum optics. In the case of semiconductor lasers however, progress has not been so swift, nor the description so complete. The many and complex processes occurring in a semiconductor laser are not well understood and this has led to many-body and solid-state phenomenological descriptions of the semiconductor laser rather than a quantum optical one. Although some attempts have been made at obtaining a fully quantum mechanical description, phenomenological descriptions have been resorted to to describe poorly understood or complex processes such as pumping and scattering. The work in this thesis was inspired by the lack of such a theory, and by the belief that it should be possible to give a description of the semiconductor laser in terms familiar to quantum opticians. With the continued and current interest in non-classical properties of light, such a theory could be very useful in predicting such properties of semiconductor lasers. Since semiconductor lasers have great potential for use in high speed electro-optic, or even optical communications, low-noise operation of these devices is a desired and indeed essential goal. Our first attempt at formulating such a theory was a simple single-mode description, using as a basis for comparison of results the more phenomenological work of Yamamoto and coworkers [Yamamoto 1986, Machida 1987, Yamamoto 1987]. Our work was based on a master equation description of the system however, and thus the methodology differed significantly from that of these authors.
Until now, our discussion of the interaction between radiation and matter has concentrated only on the spectral aspects of radiation. The results could determine the wavelengths for absorption and emission or the selection rules for such transitions, but could not be used to determine the actual extent of emission or absorption. These too are important considerations which are needed to fully quantify radiative energy transfer. Unfortunately, none of the classical theories can predict the extent of emission from an excited medium, or even the extent of absorption. Although the discussion in Section 4.9 (on the propagation of electromagnetic waves through lossy media) touched briefly on the concept of attenuation by absorption, it failed to show the reasons for the spectral properties of the absorption or to accurately predict its extent. We will see later that the classical results are useful only as a benchmark against which the actual absorber is compared. The objective of this chapter is therefore to present an introduction to quantum mechanical processes that control the emission and absorption by microscopic systems consisting of atoms and molecules. The results will then be used to predict the extent of emission by media when excited by an external energy source and to evaluate the absorption of incident radiation.
Chapter 3 provides a brief review of a few concepts from classical Newtonian physics, and how this fails to explain phenomena at the nanoscopic scale. As is detailed within, the classical mechanical model is able to describe all observed physical phenomena; however, when it comes to the nanoscale this model breaks down, because the properties of the materials change dramatically. At this scale, the surface-to-volume ratio increases, gravitational forces become negligible and random molecular motion becomes more important. This changes the properties of the material and affects the devices that are fabricated at this scale. It is hence necessary to develop a new model that can explain such physical phenomena. This has led to a new branch of physics, i.e. quantum physics (QP) or quantum mechanics, which is able to explain the behavior observed at nanoscale. QP enables us to explain phenomena such as the photoelectric effect, Compton effect. etc. In this chapter, we introduce quantum mechanics and how it evolved in the late 19th and early 20th centuries. Further, light’s behaviour as a particle as well as a wave is described by the photoelectric effect and Young’s double-slit experiment, respectively. Further, the dual nature of the particle is explained using the de Broglie principle. Schrodinger’s equation is then explained, which gives the probability of finding a subatomic-scale particle at a certain position in a quantum well. In addition to the formulation of Schrodinger’s equation, its solution, the concept of a potential well, the characteristics of the wave function and its interpretation and significance, and, finally, the application of Schrodinger’s equation in the structure of an atom form subsequent parts of this chapter. The equation serves as a basis with which to understand band theory. Band theory explains the difference between conductors, insulators and semiconductors. Materials are distinguished according to the differences in their band gaps. Adding impurities or varying temperature changes the band gap in semiconductors, which consequently changes the properties of the semiconductor and its electrical conduction. One more important measure to understand and exploit the properties and behaviour of materials is Fermi–Dirac statistics. It is useful to acquire the probability of electrons at a given energy level at a specific temperature. These concepts can be utilised by physicists and chip makers to make more energy-efficient devices. Hence, this chapter details the fundamentals of quantum physics and how they relate to the electrical properties of nanodevices.
Quantum mechanics is the basis for understanding physical phenomena on the atomic and nanometer scale. There are numerous applications of quantum mechanics in biology, chemistry and engineering. Those with significant economic impact include semiconductor transistors, lasers, quantum optics and photonics. As technology advances, an increasing number of new electronic and opto-electronic devices will operate in ways that can only be understood using quantum mechanics. Over the next twenty years fundamentally quantum devices such as single-electron memory cells and photonic signal processing systems will become common-place. The purpose of this course is to cover a few selected applications and to provide a solid foundation in the tools and methods of quantum mechanics. The intent is that this understanding will enable insight and contributions to future, as yet unknown, applications. Prerequisites Mathematics: A basic working knowledge of differential calculus, linear algebra, statistics and geometry. Computer skills: An ability to program numerical algorithms in MATLAB or similar language and display results in graphical form. Physics background: Should include a basic understanding of Newtonian mechanics, waves and Maxwell’s equations.
How to deal with time-dependent potentials, what kinds of physical problems having time-dependent potentials can be solved exactly and which are to be solved with the use of perturbation theory, what are different possible forms of time-dependent perturbating fields, and semi-classical treatment of the interaction of fields with matter are the subject matters of this chapter. First order perturbation theory, computation of transition probability, transition rates and Fermi's Golden Rule for harmonic and constant perturbations, absorption, stimulated emission and dipole approximation when electromagnetic fields interact with matter, spontaneous emission and Einstein coefficients, and dipole selection rules are other topics which are dealt with in detail in the chapter. Discussions with properly justified mathematical treatment on time-dependent potentials and on the exactly solvable time-dependent two-state systems are the special foci of this chapter.