Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Springer eBooks

Cooling Atoms with a Frequency Chirped Laser

William D. Phillips, John V. Prodanf

Published Jan 1, 1984• 6 citations
Publisher
DOI
10.1007/978-1-4757-0605-5_2

Related papers

Laser Cooling of Atoms

Hidekazu Hachisu

Nihon Kikai Gakkaishi/Journal of the Japan Society of Mechanical Engineers•Jan 1, 2009•0 citations

Frequency stabilization of an extended cavity semiconductor diode laser for chirp cooling

J. Morzinski, Parminder S. Bhatia, M. S. Shahriar

We present a technique to stabilize in an atomic transition the chirping frequency of a narrow-band semiconductor diode laser. The technique is demonstrated to chirp-cool Rb85 atoms used for loading a magneto-optical trap. The stabilization process eliminates long-term fluctuations and drifts in the number of atoms caught in the trap. This is a simple, easy-to-implement, and robust method for wide range of laser cooling experiments employing frequency chirping.

Review of Scientific Instruments•Oct 1, 2002•0 citations

Laser Cooling and Trapping of Atoms

Steven Chu, Carl Wieman

Journal of the Optical Society of America B•Nov 1, 1989•93 citations

Laser cooling and trapping of rubidium

Christopher D. Wallace, Timothy T. Grove, T. Dinneen +2 more

We have laser cooled an atomic beam of rubidium with diode lasers and have used these slow atoms to load a magneto-optical trap. The cooling is performed with the frequency-chirp method,1,2 in which the laser's frequency is ramped linearly (by the injection currant) to maintain resonance with the decelerating atoms. Two synchronously chirped lasers are required to prevent optical hyperfine pumping of the ground state. The chirp typically covers 500 MHz in 10 ms. At the end of each ramp, the resulting velocity distribution is measured with a pulsed probe laser. By varying the end point of the chirp, we are able to obtain slow atoms with average velocities ranging from 200 to −50 m/s. The widths of the velocity distributions are measured to be approximately 40 m/s. This relatively large width results from the inherent linewidth (~30 MHz) of the free-running diode lasers used for both cooling and probing.

Quantum Electronics and Laser Science Conference•May 12, 1991•0 citations

Laser Cooling and Trapping of Atoms

Steven Chu, Mara Goff Prentiss, A. Cable +1 more

Springer series in optical sciences/SPringer series in optical sciences•Jan 1, 1987•11 citations

Measurement of axial velocity distribution of a laser-cooled atomic beam

J.L. Hall, M. Zhu, Ch Salomon

We measured the axial velocity distribution produced by frequency-chirp-cooling a sodium atomic beam, including heating effects produced by an optional frequency-fixed postcooling interaction. Frequency sweeps were produced via a voltage-tuned oscillator feeding a broadband, efficient electrooptic modulator to produce a frequency-agile sideband on the output of a dual-frequency dye laser(Δv = 1.712GHz). After the chirp-cooling, the frequency was held stationary for an adjustable time T before the intensity was reduced 30-fold and the frequency jumped to provide a single readout point on the number of atoms vs frequency curve. All frequency sweeps were derived with rf techniques from a single laser so the velocity scale is absolute and uncontaminated by drifts. The + 880-MHz sweep in 1.6 ms gave an effective absorption rate of 10.7 photons/μs (saturation = 1 gives 31 photons/μs, 1 photon gives 3 cm/s). The swept sideband power was 10 mW in Wo ~ 4 mm, decreasing to ~ 350μW for readout. The measured velocity-offset and –drift rate were 24 MHz and 8 photons/μs at T = 15μs, with the velocity offset increasing to 40 MHz and the rate decreasing to 4 photons/μs at T = 100 μs. Over the same time interval, the velocity width monotonically increased from 12.1 to 17 MHz. The presence of heating—rather than cooling—infixed frequency conditions implies the existence of an optimum chirp rate and is not anticipated by some theories of the laser atom cooling dynamics.

International Laser Science Conference•Jan 1, 1986•0 citations
We have laser cooled an atomic beam of rubidium with diode lasers and have used these slow atoms to load a magneto-optical trap. The cooling is performed with the frequency-chirp method,1,2 in which the laser's frequency is ramped linearly (by the injection currant) to maintain resonance with the decelerating atoms. Two synchronously chirped lasers are required to prevent optical hyperfine pumping of the ground state. The chirp typically covers 500 MHz in 10 ms. At the end of each ramp, the resulting velocity distribution is measured with a pulsed probe laser. By varying the end point of the chirp, we are able to obtain slow atoms with average velocities ranging from 200 to −50 m/s. The widths of the velocity distributions are measured to be approximately 40 m/s. This relatively large width results from the inherent linewidth (~30 MHz) of the free-running diode lasers used for both cooling and probing.
We measured the axial velocity distribution produced by frequency-chirp-cooling a sodium atomic beam, including heating effects produced by an optional frequency-fixed postcooling interaction. Frequency sweeps were produced via a voltage-tuned oscillator feeding a broadband, efficient electrooptic modulator to produce a frequency-agile sideband on the output of a dual-frequency dye laser(Δv = 1.712GHz). After the chirp-cooling, the frequency was held stationary for an adjustable time T before the intensity was reduced 30-fold and the frequency jumped to provide a single readout point on the number of atoms vs frequency curve. All frequency sweeps were derived with rf techniques from a single laser so the velocity scale is absolute and uncontaminated by drifts. The + 880-MHz sweep in 1.6 ms gave an effective absorption rate of 10.7 photons/μs (saturation = 1 gives 31 photons/μs, 1 photon gives 3 cm/s). The swept sideband power was 10 mW in Wo ~ 4 mm, decreasing to ~ 350μW for readout. The measured velocity-offset and –drift rate were 24 MHz and 8 photons/μs at T = 15μs, with the velocity offset increasing to 40 MHz and the rate decreasing to 4 photons/μs at T = 100 μs. Over the same time interval, the velocity width monotonically increased from 12.1 to 17 MHz. The presence of heating—rather than cooling—infixed frequency conditions implies the existence of an optimum chirp rate and is not anticipated by some theories of the laser atom cooling dynamics.