Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Huangshi Institute of Technology

Simulation and Experiment on Gate-mode Single Photon Detector of Quantum Key Distribution

Tao Biao

Published Jan 1, 2008• 0 citations
OpenAlex

Abstract

According to the requirements and the characteristics of the InGaAsP/InP avalanche photodiode for single photon detection at infrared wavelengths,the relation between the various gate-mode parameters had been analyzed by the mathematics model and simulation,which provided a reference for the selection of the gate-mode parameters.The result proved that the choice of the bias voltage,the width and the period of the gated pulse was very important to improve the performance of the detector.Based on the simulation,a relatively complete single-photon detector circuit was presented,which can produce the TTL signal for each detected photon.

Related papers

Single photon detection used in quantum communication

Haiqiang Ma

In order to improve the sensitivity of single-photon detection systems,InGaAs/InP avalanche photodiode(InGaAs/InP APD) is used in the design of single photon detector of quantum communication.Single photon detector bias generation circuit in gate pulse mode,single-photon signal amplification circuit,single photon signal detection circuit and temperature control module were realized.By selecting high-precision OP37 preamplifier and precision comparator AD8561,quantum efficiency was increased to 18.3%,dark count was controlled within 4.1 × 10-6/ns.

Journal of Applied Optics•Jan 1, 2010•0 citations

Design and implementation of silicon single-photon avalanche photodiode modeling tool for QKD systems

Adil Fadhil Mushatet, Ahmed Ismael Khaleel, Shelan Khasro Tawfeeq

Single-photon detection concept is the most crucial factor that determines the performance of quantum key distribution (QKD) systems. In this paper, a simulator with time domain visualizers and configurable parameters using continuous time simulation approach is presented for modeling and investigating the performance of single-photon detectors operating in Gieger mode at the wavelength of 830 nm. The widely used C30921S silicon avalanche photodiode was modeled in terms of avalanche pulse, the effect of experiment conditions such as excess voltage, temperature and average photon number on the photon detection efficiency, dark count rate and afterpulse probability. This work shows a general repeatable modeling process for significant performance evaluation. The most remarkable result emerged from the simulated data generated and detected by commercial devices is that the modeling process provides guidance for single-photon detectors design and characterization. The validation and testing results of the single-photon avalanche detectors (SPAD) simulator showed acceptable results with the theoretical and experimental results reported in related references and the device's data sheets.

International Journal of Power Electronics and Drive Systems/International Journal of Electrical and Computer Engineering•Jun 18, 2021•0 citations

The single-photon detection and data acquisition for the quantum key distribution system

Xiuliang Chen, Chunyuan Zhou, Guang Wu +2 more

In our experiment, two InGaAs/InP avalanche photodiodes (APD) were used in the quantum key distribution (QKD) system for single-photon detection at telecom communication wavelength (1310/1550 nm). By using properly designed passive-quenching circuit, the photo-detection efficiency of the APD could reach 10% at 1550 nm. In order to decrease the dark count rate efficiently, we designed a coincident counting circuits for single-photon detection. Before the APD signals were sent to the signal processing circuit, the avalanche signals were amplified and shaped into the TTL pulses. In order to obtain an accurate and efficient data acquisition and to transfer synchronically several signals such as the TTL signals and pulses from Random generators, we designed a signal processing circuit with the parallel port whose speed limitation is about 100Kb/s. In our experiments of single-photon interference and quantum cryptography, the electronic designs presented us satisfactory performance and results. To achieve much higher speed for the data acquisition, we also employed the Universal Serial Bus System (USB2.0) to interface our single-photon avalanche detectors and random generators used in our QKD system, which was believed to improve the performance of QKD such as the key distribution speed.

Frontiers in Optics•Jan 1, 2003•0 citations

Single-photon detector at 1550 nm with gate-mode quenched InGaAs/InP avalanche photodiode

Guang Wu, Chunyuan Zhou, Xiuliang Chen +2 more

In our recent experiment, we have designed a novel single-photon detecting module for quantum key distribution using an InGaAs/InP avalanche photodiode with gate-mode quenched photo-detection. At a repetition rate of 100 kHz and the working temperature of -60°C, we obtained the detection efficiency η higher than 10% and 20% at the dark probability Pd about 1.3×10-5 and 1.6×10-5 per nanosecond, respectively. Also at 100 kHz, we got the best ratio of Pd/η as 1.7×10-3 per pulse (20 ns). And at a lower repetition such as 10 kHz, we obtained Pd/η as 8.9×10-4 per pulse.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 12, 2004•2 citations

Performance evaluation of high-dimensional quantum key distribution with single-photon detector based on avalanche photodiode

Dongdong Li, Yan-Lin Tang, Meisheng Zhao +5 more

The current theoretical analysis model for high-dimensional quantum key distribution (QKD) was developed without carefully considering the dead time and after-pulse of the single-photon detectors. Here, we propose a new model that accounts for these two effects. With this model, we analyze the effects of various properties of the single-photon detector on the performance of the high-dimensional quantum key distribution and show numerically that the high-dimensional quantum key distribution can be achieved up to 180 km with InGaAs/InP-type single-photon detectors. This work can improve our understanding of the factors that determine the performance of high-dimensional quantum key distribution and will help to promote the application of single-photon detectors based on avalanche photodiodes in high-dimensional quantum key distribution.

Modern Physics Letters A•Nov 10, 2022•0 citations

Design and characterization of single photon APD detector for QKD application

Khalid A. Saeed Al-Khateeb, Nazmus Shaker Nafi, Khalid Hasan

Modeling and design of a single photon detector and its various characteristics are presented. It is a type of avalanche photo diode (APD) designed to suit the requirements of a Quantum Key Distribution (QKD) detection system. The device is modeled to operate in a gated mode at liquid nitrogen temperature for minimum noise and maximum gain. Different types of APDs are compared for best performance. The APD is part of an optical communication link, which is a private channel to transmit the key signal. The encrypted message is sent via a public channel. The optical link operates at a wavelength of 1.55μm. The design is based on InGaAs with a quantum efficiency of more than 75% and a multiplication factor of 1000. The calculated dark current is below 10-12A with an overall signal to noise ratio better than 18 dB. The device sensitivity is better than -40 dBm, which is more than an order of magnitude higher than the dark current, corresponding to a detection sensitivity of two photons in pico-second pulses.

International Conference on Computer and Communication Engineering•May 1, 2010•2 citations
According to the requirements and the characteristics of the InGaAsP/InP avalanche photodiode for single photon detection at infrared wavelengths,the relation between the various gate-mode parameters had been analyzed by the mathematics model and simulation,which provided a reference for the selection of the gate-mode parameters.The result proved that the choice of the bias voltage,the width and the period of the gated pulse was very important to improve the performance of the detector.Based on the simulation,a relatively complete single-photon detector circuit was presented,which can produce the TTL signal for each detected photon.
In order to improve the sensitivity of single-photon detection systems,InGaAs/InP avalanche photodiode(InGaAs/InP APD) is used in the design of single photon detector of quantum communication.Single photon detector bias generation circuit in gate pulse mode,single-photon signal amplification circuit,single photon signal detection circuit and temperature control module were realized.By selecting high-precision OP37 preamplifier and precision comparator AD8561,quantum efficiency was increased to 18.3%,dark count was controlled within 4.1 × 10-6/ns.
Single-photon detection concept is the most crucial factor that determines the performance of quantum key distribution (QKD) systems. In this paper, a simulator with time domain visualizers and configurable parameters using continuous time simulation approach is presented for modeling and investigating the performance of single-photon detectors operating in Gieger mode at the wavelength of 830 nm. The widely used C30921S silicon avalanche photodiode was modeled in terms of avalanche pulse, the effect of experiment conditions such as excess voltage, temperature and average photon number on the photon detection efficiency, dark count rate and afterpulse probability. This work shows a general repeatable modeling process for significant performance evaluation. The most remarkable result emerged from the simulated data generated and detected by commercial devices is that the modeling process provides guidance for single-photon detectors design and characterization. The validation and testing results of the single-photon avalanche detectors (SPAD) simulator showed acceptable results with the theoretical and experimental results reported in related references and the device's data sheets.
In our experiment, two InGaAs/InP avalanche photodiodes (APD) were used in the quantum key distribution (QKD) system for single-photon detection at telecom communication wavelength (1310/1550 nm). By using properly designed passive-quenching circuit, the photo-detection efficiency of the APD could reach 10% at 1550 nm. In order to decrease the dark count rate efficiently, we designed a coincident counting circuits for single-photon detection. Before the APD signals were sent to the signal processing circuit, the avalanche signals were amplified and shaped into the TTL pulses. In order to obtain an accurate and efficient data acquisition and to transfer synchronically several signals such as the TTL signals and pulses from Random generators, we designed a signal processing circuit with the parallel port whose speed limitation is about 100Kb/s. In our experiments of single-photon interference and quantum cryptography, the electronic designs presented us satisfactory performance and results. To achieve much higher speed for the data acquisition, we also employed the Universal Serial Bus System (USB2.0) to interface our single-photon avalanche detectors and random generators used in our QKD system, which was believed to improve the performance of QKD such as the key distribution speed.
In our recent experiment, we have designed a novel single-photon detecting module for quantum key distribution using an InGaAs/InP avalanche photodiode with gate-mode quenched photo-detection. At a repetition rate of 100 kHz and the working temperature of -60°C, we obtained the detection efficiency η higher than 10% and 20% at the dark probability Pd about 1.3×10-5 and 1.6×10-5 per nanosecond, respectively. Also at 100 kHz, we got the best ratio of Pd/η as 1.7×10-3 per pulse (20 ns). And at a lower repetition such as 10 kHz, we obtained Pd/η as 8.9×10-4 per pulse.
The current theoretical analysis model for high-dimensional quantum key distribution (QKD) was developed without carefully considering the dead time and after-pulse of the single-photon detectors. Here, we propose a new model that accounts for these two effects. With this model, we analyze the effects of various properties of the single-photon detector on the performance of the high-dimensional quantum key distribution and show numerically that the high-dimensional quantum key distribution can be achieved up to 180 km with InGaAs/InP-type single-photon detectors. This work can improve our understanding of the factors that determine the performance of high-dimensional quantum key distribution and will help to promote the application of single-photon detectors based on avalanche photodiodes in high-dimensional quantum key distribution.
Modeling and design of a single photon detector and its various characteristics are presented. It is a type of avalanche photo diode (APD) designed to suit the requirements of a Quantum Key Distribution (QKD) detection system. The device is modeled to operate in a gated mode at liquid nitrogen temperature for minimum noise and maximum gain. Different types of APDs are compared for best performance. The APD is part of an optical communication link, which is a private channel to transmit the key signal. The encrypted message is sent via a public channel. The optical link operates at a wavelength of 1.55μm. The design is based on InGaAs with a quantum efficiency of more than 75% and a multiplication factor of 1000. The calculated dark current is below 10-12A with an overall signal to noise ratio better than 18 dB. The device sensitivity is better than -40 dBm, which is more than an order of magnitude higher than the dark current, corresponding to a detection sensitivity of two photons in pico-second pulses.