The expressions and distribution curves of the optimal transmissivity for four-level inhomogeneously broadened single-mode laser are given, and then compares them with those of homogeneously broadened single-mode laser.The characteristics of the inhomogeneously broadened single-mode laser are described.
An analysis is made of the operation of a laser with a saturable absorber and dominant inhomogeneous line broadening. A four-level model is used to determine the characteristics of mode intensities and conditions for the appearance of an optical bistability. By analogy with a two-level model, the results obtained demonstrate that in single-mode operation this bistability appears only if the relaxation coefficients of the upper levels of atomic or molecular systems are different in the amplifying and absorbing parts of a laser. Moreover, a change in the inhomogeneous broadening alters greatly the optical bistability interval. The calculation method used in the present study can be readily extended to analyze a multimode laser.
A theoretical modeling analysis is presented to study the optical bistability exhibited in the oscillation of an inhomogeneously broadened quasi-three-level laser. All the major characteristics of optical bistability depend on two normalized parameters, f and xa, which are defined by f = Isat,a/Isat,m and xa = 2αa0pa/δ and are related to measurable properties of the laser medium. In comparison with the case of a homogeneously broadened laser, the essential condition for the occurrence of such bistability, f < xa/(xa + 1), turns out to be the same, whereas the intensities at the up- and down-thresholds are substantially increased and the bistability range is reduced.
We show that the dip in the intensity line shape of a single-mode laser can appear at definite experimental conditions in cases both of nonhomogeneously broadened line as well as homogeneously broadened line of the atomic transition. In both cases the dip is explained by the nonlinear character of the phenomenon. The saturation of the population difference of the involved atomic energy levels has its maximum in the vicinity of the line center. Therefore the saturation of the amplification is at maximum near the atomic line center, and, as a consequence, the lasing power is reduced.