Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Properties of relaxation oscillation SQUIDs (ROSs) based on Nb/AlOx/Nb Josephson tunnel junctions

淳 河合

Published Jan 1, 1995• 2 citations
Publisher
DOI
10.11501/3099984

Related papers

Relaxation Oscillating SQUIDs Using Nb/AlOx/Nb Josephson Tunnel Junctions

Jun Kawai, Gen Uehara, Naoki Mizutani +3 more

Springer proceedings in physics•Jan 1, 1992•2 citations

Nb/Al/AlOx/Nb stacked long Josephson junctions

Paola Barbara, G. Costabile, J. Mygind +1 more

Physica B Condensed Matter•Feb 1, 1994•3 citations

(Double) relaxation oscillation SQUIDs with high flux-to-voltage transfer: Simulations and experiments

Derk Jan Adelerhof, H. Nijstad, J. Flokstra +1 more

Relaxation oscillation superconducting quantum interference devices (SQUIDs) (ROSs) and double relaxation oscillation SQUIDs (DROSs) have been fabricated and characterized. The SQUIDs are based on hysteretic Nb/Al,AlOx/Al/Nb Josephson tunnel junctions. The relaxation oscillations were simulated by computer. By these simulations the minimum and maximum values of the shunt inductance at which the relaxation oscillations persist have been determined for different values of the shunt resistance and of the critical current and capacitance of the junctions. The transfer from flux to dc voltage in ROSs increases linearly with the shunt resistance. The operation range of the shunt inductance, however, becomes smaller with increasing shunt resistance. In ROSs with a SQUID inductance of 20 pH, a maximum voltage modulation width of 400 μV and a flux-to-voltage transfer δV/δφ of 4 mV/φ0 have been obtained. Two ROSs have been operated in a simple flux-locked loop with direct voltage readout. The experimental white flux noise spectral density of about 3μφ0/√Hz is in good agreement with the theoretical model. The sensitivity of these SQUIDs is limited by so-called switching noise, which is noise due to the interaction between the relaxation oscillations and the Josephson frequency. In DROSs typical flux-to-voltage transfer values of 10–30 mV/φ0 and maximum values up to 80 mV/φ0 have been obtained. This transfer is determined by thermal noise on the critical currents of the SQUIDs. The effective flux noise density of DROSs in flux-locked-loop operation with direct voltage readout is in good agreement with the theoretical noise level which is mainly determined by thermal noise on the critical currents. In one of the DROSs with a SQUID inductance of 20 pH, a white flux noise of 1μφ0/√Hz has been obtained at an estimated relaxation frequency of about 80 MHz. This corresponds to an energy sensitivity of about 160 h.

Journal of Applied Physics•Sep 15, 1994•56 citations

Next generation dc-SQUIDs: relaxation oscillation SQUIDs

van Duuren, M.J., Derk Jan Adelerhof, G.C.S. Brons +3 more

•Dec 20, 1994•0 citations

Second generation dc-SQUID sensors: relaxation oscillation SQUIDS (ROS) with frequency readout and double relaxation oscillation SQUIDS (DROS) with voltage readout

Derk Jan Adelerhof, Michiel van Duuren, Jaap Flokstra +1 more

Relaxation Oscillation SQUIDs (ROSs) based on 4x4 micrometers 2 Nb/AlOx Josephson tunnel junctions have been fabricated and characterized. A ROS consists of a hysteretic dc SQUID shunted by an inductor L and a resistor R in series to induce the relaxation oscillations. The values of L range from 20 nH up to about 300 nH, whereas the time constant L/R are between 8 and 45 ns. Frequency-flux characteristics have been recorded with the help of a spectrum analyzer, directly connected to the ROS. The relaxation frequencies range from 5 to 180 MHz. The experimental characteristics can be explained very well with a simple model describing the oscillation cycle. The effect of the self-induced magnetic field due to a magnetic coupling between the dc SQUID and the shunt circuit has been studied in detail. The sensitivity of ROSs and DROSs (Double Relaxation Oscillation SQUIDs) improves with increasing relaxation frequency. In (D)ROSs based on unshunted, hysteretic tunnel junction dc SQUIDs, the maximum relaxation frequency and the sensitivity are limited by LC resonances due to the SQUID capacitance and the shunt inductance. It is shown that the relaxation frequency can be increased up to frequencies of the order of 1 GHz if an extra resistor is integrated to damp these resonances. The optimum value of the damping resistor can be obtained from the ROS parameters. For stable operation of a (D)ROS, the shunt resistance should not be too large. The optimum value of this resistance can be calculated from the effective McCumber parameter and the bias current. Theoretically, the sensitivity of a ROS with a SQUID capacitance of 1 pF, a SQUID inductance of 20 pH and a relaxation frequency of 1 GHz equals about 5h, where h is Planck's constant. In a DROS with voltage readout based on similar SQUIDs, the theoretical sensitivity at a relaxation frequency of 1 GHz is 17h, with an estimated flux-to-voltage transfer coefficient of 5 mV/(phi) 0.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jul 2, 1994•9 citations

Smart SQUID based on double relaxation oscillation SQUIDs

Michiel J. van Duuren, G.C.S. Brons, H.E. Kattouw +2 more

•Dec 19, 1997•0 citations
Relaxation oscillation superconducting quantum interference devices (SQUIDs) (ROSs) and double relaxation oscillation SQUIDs (DROSs) have been fabricated and characterized. The SQUIDs are based on hysteretic Nb/Al,AlOx/Al/Nb Josephson tunnel junctions. The relaxation oscillations were simulated by computer. By these simulations the minimum and maximum values of the shunt inductance at which the relaxation oscillations persist have been determined for different values of the shunt resistance and of the critical current and capacitance of the junctions. The transfer from flux to dc voltage in ROSs increases linearly with the shunt resistance. The operation range of the shunt inductance, however, becomes smaller with increasing shunt resistance. In ROSs with a SQUID inductance of 20 pH, a maximum voltage modulation width of 400 μV and a flux-to-voltage transfer δV/δφ of 4 mV/φ0 have been obtained. Two ROSs have been operated in a simple flux-locked loop with direct voltage readout. The experimental white flux noise spectral density of about 3μφ0/√Hz is in good agreement with the theoretical model. The sensitivity of these SQUIDs is limited by so-called switching noise, which is noise due to the interaction between the relaxation oscillations and the Josephson frequency. In DROSs typical flux-to-voltage transfer values of 10–30 mV/φ0 and maximum values up to 80 mV/φ0 have been obtained. This transfer is determined by thermal noise on the critical currents of the SQUIDs. The effective flux noise density of DROSs in flux-locked-loop operation with direct voltage readout is in good agreement with the theoretical noise level which is mainly determined by thermal noise on the critical currents. In one of the DROSs with a SQUID inductance of 20 pH, a white flux noise of 1μφ0/√Hz has been obtained at an estimated relaxation frequency of about 80 MHz. This corresponds to an energy sensitivity of about 160 h.
Relaxation Oscillation SQUIDs (ROSs) based on 4x4 micrometers 2 Nb/AlOx Josephson tunnel junctions have been fabricated and characterized. A ROS consists of a hysteretic dc SQUID shunted by an inductor L and a resistor R in series to induce the relaxation oscillations. The values of L range from 20 nH up to about 300 nH, whereas the time constant L/R are between 8 and 45 ns. Frequency-flux characteristics have been recorded with the help of a spectrum analyzer, directly connected to the ROS. The relaxation frequencies range from 5 to 180 MHz. The experimental characteristics can be explained very well with a simple model describing the oscillation cycle. The effect of the self-induced magnetic field due to a magnetic coupling between the dc SQUID and the shunt circuit has been studied in detail. The sensitivity of ROSs and DROSs (Double Relaxation Oscillation SQUIDs) improves with increasing relaxation frequency. In (D)ROSs based on unshunted, hysteretic tunnel junction dc SQUIDs, the maximum relaxation frequency and the sensitivity are limited by LC resonances due to the SQUID capacitance and the shunt inductance. It is shown that the relaxation frequency can be increased up to frequencies of the order of 1 GHz if an extra resistor is integrated to damp these resonances. The optimum value of the damping resistor can be obtained from the ROS parameters. For stable operation of a (D)ROS, the shunt resistance should not be too large. The optimum value of this resistance can be calculated from the effective McCumber parameter and the bias current. Theoretically, the sensitivity of a ROS with a SQUID capacitance of 1 pF, a SQUID inductance of 20 pH and a relaxation frequency of 1 GHz equals about 5h, where h is Planck's constant. In a DROS with voltage readout based on similar SQUIDs, the theoretical sensitivity at a relaxation frequency of 1 GHz is 17h, with an estimated flux-to-voltage transfer coefficient of 5 mV/(phi) 0.