In this Ph.D. Thesis we investigate the viability of using quantum dot ensembles as a quantum memory architecture through the use numerical simulations to study population transfer within quantum dots. This is followed by an investigation into the effects of high order wavemixing on the population transfer within two level systems, \nwhich was born from effects noted while simulating quantum dots. \n \nWe study the initialisation of an ensemble of inhomogeneously broadened quantum dots, introducing a novel initialisation method utilising pump field with a slow frequency sweep. We focus on the properties of such an initialisation procedure and conclude that the maximum initialisation fidelities are determined entirely by the Zeeman splittings and decay rates of the quantum dots. \n \nWe study several possibilities for performing π rotations on the population of an ensemble of quantum dots, and show the RCAP protocol is the most applicable. We study this protocol in the context of quantum dots and give the optimal parameters to use to generate high fidelity π pulses. \n \nWe then bring together our work on quantum dots population transfer with the work of others covering the write and read procedures on quantum dots to provide a feasibility analysis of the complete quantum memory protocol. \n \nThe work on wavemixing presented in this thesis uses a novel approach to analyse wavemixing effects which is used to predict the population transferred in two level \nsimulations of wavemixing processes. We provide simulation confirmation of our approach to analyse wavemixing effects and then go on to calculate the disruptive effects of wavemixing caused by high intensity lasers on some simple systems. Finally we show that large orders of wavemixing can, at least in principle, be used for coherent \npopulation transfer. \n
In this Ph.D. Thesis we investigate the viability of using quantum dot ensembles as a quantum memory architecture through the use numerical simulations to study population transfer within quantum dots. This is followed by an investigation into the effects of high order wavemixing on the population transfer within two level systems, \nwhich was born from effects noted while simulating quantum dots. \n \nWe study the initialisation of an ensemble of inhomogeneously broadened quantum dots, introducing a novel initialisation method utilising pump field with a slow frequency sweep. We focus on the properties of such an initialisation procedure and conclude that the maximum initialisation fidelities are determined entirely by the Zeeman splittings and decay rates of the quantum dots. \n \nWe study several possibilities for performing π rotations on the population of an ensemble of quantum dots, and show the RCAP protocol is the most applicable. We study this protocol in the context of quantum dots and give the optimal parameters to use to generate high fidelity π pulses. \n \nWe then bring together our work on quantum dots population transfer with the work of others covering the write and read procedures on quantum dots to provide a feasibility analysis of the complete quantum memory protocol. \n \nThe work on wavemixing presented in this thesis uses a novel approach to analyse wavemixing effects which is used to predict the population transferred in two level \nsimulations of wavemixing processes. We provide simulation confirmation of our approach to analyse wavemixing effects and then go on to calculate the disruptive effects of wavemixing caused by high intensity lasers on some simple systems. Finally we show that large orders of wavemixing can, at least in principle, be used for coherent \npopulation transfer. \n
In this thesis, the coherent interaction of single semiconductor quantum dots and ultrafast optical pulses is studied. Under certain conditions, localized exciton transitions in quantum dots can be seen as semi-isolated two-level systems. While this description is sufficient for the explanation of some observations in coherent experiments, it is sometimes necessary to explicitly consider coupling of the discreet quantum states confined to the dot with the environment. We start out from simple, classical examples of coherent spectroscopy and then turn towards experiments where the interaction with the vicinity of the dot becomes an important factor. First, a novel method for transient differential reflectivity spectroscopy of single quantum systems is introduced. It is a pure far-field optical technique which does not require any sophisticated sample preparation steps which makes it applicable to a broad range of structures. Pump pulses excite the sample structure and probe pulses read out the pump-induced changes in the system after a variable delay time. In the case of a single dipole, the signal is given in the form of the spectral inteferogram between the backscattered wave from the particle and the probe light which is reflected at the sample surface. This form of homodyne detection amplifies the weak scattered wave from the particle and thus makes this kind of spectroscopy for single quantum dots feasible. In the remainder of this thesis our spectroscopic method is applied to either characterize the coherent properties of single quantum dots, to prepare and read-out a desired quantum state or to deliberately manipulate them. Coherence times and oscillator strengths are determined for localized exciton transitions. Arbitrary population states can be written by driving coherent population oscillations using resonant pulses, while entangled superpositions of two exciton states in a single dot are investigated by quantum beats on transient differential spectra. We finally exploit the interaction between the dot and a nearby absorbing layer to switch the dot's absorption spectrum on ultrafast timescales via light-induced transient electric fields.
The nonlinear optical response of an ensemble of semiconductor quantum dots is analyzed by wave-mixing processes, where we focus on four-wave mixing with two incident pulses. Wave-mixing experiments are often described with semiclassical models, where the light is modeled classically and the material quantum mechanically. Here, however, we use a fully quantized model, where the light is given by a quantum state of light. Quantum light involves more degrees of freedom than classical light as e.g., its photon statistics and quantum correlations, which is a promising resource for quantum devices, such as quantum memories. The light-matter interaction is treated with a Jaynes-Cummings type model and the quantum field is given by a single mode since the quantum dots are embedded in a microcavity. We present numerical simulations of the four-wave-mixing response of a homogeneous system for pulse sequences and find a significant dependence of the result on the photon statistics of the incident pulses. The model constitutes a problem with a large state space which arises from the frequency distribution of the transition energies of the inhomogeneously broadened quantum dot ensemble that is coupled with a quantum light mode. Here we approximate the dynamics by summing over individual quantum dot-microcavity systems. Photon echoes arising from the excitation with different quantum states of light are simulated and compared.
This thesis is concerned with coherent effects in high resolution mid-infrared gas phase spectroscopy using quantum cascade lasers (QCLs). An introductory chapter explains the importance of QCLs as radiation sources in the mid-infrared region of the spectrum and goes on to detail their development and structure. A discussion of coherent effects in spectroscopy follows, leading into the second chapter which discusses the theories relevant to the experimental sections of the thesis. In chapter 2 the theory underpinning direct and velocity selective, Doppler-free spectroscopy is discussed and a density matrix formalism is followed to derive the equations of motion that govern coherent excitation effects in two-level systems. In the final part of the chapter this treatment is extended to three-level systems. The equations derived in this chapter form the basis of quantitative interpretations of the phenomena observed in experimental data and presented in the remainder of the thesis. In chapter 3 the characterisation of a high power, narrow linewidth QCL is carried out. This laser is then used to perform direct and sub-Doppler resolution spectroscopy on NO, demonstrating non-linear absorption at high laser intensities and providing a measurement of the laser linewidth in the limit of slow frequency tuning. As the slow tuning rate increases, evidence of coherent transient effects is presented and density matrix theory used to model this behaviour. The data presented include the first observations of asymmetric Lamb dips and the onset of rapid passage oscillations from a Lamb dip. Pump-probe experiments on NO, utilising two cw QCLs are presented in chapter 4. The high level of velocity selection afforded by QCL excitation leads to coherent transient signals at far lower probe scan rates than previously reported. The effect of altering both the scan rate and the gas pressure and the importance of hyperfine structure are presented. A radio frequency noise source applied to one of the lasers is shown to broaden the laser linewidth, leading to rapid dephasing. A two-colour polarisation spectroscopy experiment is also presented which allows the measurement of both the absorption and the Doppler-free dispersion signals and the three-level density matrix formalism presented at the end of chapter 2 used to model the non-linear response of the system. The final chapter details the use of an acousto-optic modulator to create a pulse of mid-IR light using a cw QCL and the application of this to time resolved pump-probe spectroscopy. This capability suggests the prospect of achieving coherent population transfer by stimulated Raman adiabatic passage (STIRAP) using two such pulses. Simulations based on a simple three-level model and including Zeeman coherences are presented, which take the measured properties of the lasers used in this thesis as inputs to predict the potential population transfer achievable in NO as well as providing useful information about the angular momentum polarisation of the excited molecules. An experimental realisation of STIRAP would require the lasers to be stabilised, and so the final part of the chapter details experimental attempts to achieve stabilisation of an external cavity QCL, and suggests future avenues for improved implementation.
Using a master-equation approach for the description of coherent and incoherent dynamics in `artificial atoms and molecules', we present a theoretical analysis of situations where intense laser fields lead to pronounced renormalizations of carrier states. Such enhanced light-matter interactions allow for the solid-state implementation of effects hitherto only observable in atomic systems. Two prototypical examples will be presented: first, we show how two intense laser pulses can be exploited for a robust and high-fidelity population transfer of carrier states in coupled quantum dots; second, we discuss the possibility of observing self-induced transparency in a sample of inhomogenously broadened quantum dots, a phenomenon where intense laser pulses propagate without suffering significant losses.
This work had three objectives to improve an EIT-based, solid-state memory for light. First, we set up a solid-state-laser system for radiation at the wavelength λ = 606nm, i.e., the optical transition in our storage medium, the rare-earth-ion doped crystal PrYSO. Second, we implemented efficient rephasing of optically driven coherences after EIT-based light storage by means of rapid adiabatic passage (RAP) pulses. Last but not least we implemented a novel coherence population mapping (CPM) protocol in order to shelve fragile atomic coherences in robust and long-lived populations in PrYSO. Solid-State-Laser System: We developed a solid-state-laser system based on two nonlinear processes, optical parametric oscillation (OPO) and intra-cavity sum-frequency generation (SFG). The system is designed to generate continuous wave output in the orange part of the visible spectrum. OPO and SFG are implemented on a periodically poled lithium niobate crystal (PPLN). The crystal is divided into sections with appropriate poling periods for quasi phase matching of OPO and SFG. In addition, the poling period changes along the crystal height to allow tuning of the OPO-SFG output wavelength. The system provides output in a range between λ = 605nm and λ = 616nm with an output power P > 1W. For light storage experiments, we operate the OPO-SFG at λ = 606nm with a maximum available output power of P = 1.3W. An external Pound-Drever-Hall (PDH) frequency stabilization reduces the laser linewidth to Δν ≈ 60 kHz on a time scale of 100 ms. The OPO-SFG provides stable output for more than 30 hours with a root-mean-square power jitter below 2%. In comparison to a previously used dye laser, the OPO-SFG requires less maintenance, performs more robust against external temperature fluctuations and vibrational noise and allows easier (re-) alignment. It performs slightly better in terms of frequency stability and the two systems are comparable in terms of output power. Dye lasers on the other hand provide a larger tuning range. Future work should include a revised crystal design, i.e., a reversed section order of OPO and SFG on the PPLN crystal. This has been suggested to yield higher efficiency and output stability. In addition, we use three discrete poling periods in the SFG section, whereas the OPO section consists of a fanned poling structure. A double-fanned structure could provide enhanced tunability and help to partially suppress power fluctuations for different output wavelength. In addition, it should be possible to further reduce the laser-frequency linewidth by revising the locking loop or using a higher finesse cavity for the PDH stabilization. Adiabatic Rephasing of Atomic Coherences: We experimentally implemented rephasing of optically driven coherences in PrYSO by RAP pulses. As a feature of adiabatic pulses, the parameters for RAP are defined in loose boundaries given by the adiabaticity criterion. This makes RAP potentially robust to parameter fluctuations. We experimentally verified this property and showed that rephasing with RAP provides superior performance compared to rephasing with π pulses. In particular, RAP provides enhanced robustness against variations in the Rabi frequency, pulse detuning and spatial inhomogeneity of the driving field. In our specific (3 mm long) PrYSO crystal and for standard experimental parameters, RAP yielded a factor of 1.15 higher rephasing efficiency compared to rephasing with π pulses. This value further increased when we artificially increased experimental imperfections or performed experiments with lower maximum Rabi frequencies. Concluding, RAP provides higher efficiency and more robust performance than π pulses in inhomogeneously broadened media, in the case of low available driving field power and for driving field inhomogeneities. However, RAP pulses typically require longer pulse durations than π pulses. This can cause heating or prevent the use of RAP when fast rephasing is required. An alternative to adiabatic pulses are, e.g., composite pulses or single-shot-shaped pulses. These are investigated in the context of another Ph.D thesis. Coherence Population Mapping: We implemented a novel CPM protocol to store atomic coherences in long-lived populations in PrYSO. CPM works in any three-state system and does not require complex setups beyond a radiation source to generate a short write and read sequence. As an important feature, CPM stores arbitrary coherences equally well in the populations of a three-state system, i.e., CPM does neither require inhomogeneous broadening, nor is the storage efficiency dependent on the phase of the initial coherence. To our best knowledge, this exhibits a unique feature, which no other coherence population mapping protocol provides. Thus, CPM is an alternative to the stimulated photon echo (SPE), which requires inhomogeneous broadening to map an arbitrary initial coherence onto populations. However, the maximum retrieval efficiency with CPM is 1/3 of the initial coherence amplitude (and 1/2 with SPE). We experimentally verified the main characteristics of both protocols with RF driven mapping sequences and RF induced initial coherences. Our results confirm phase-insensitive storage with CPM and storage times reaching the minute regime, i.e., the population relaxation time. We also tested CPM in combination with EIT-based light storage. However, we obtained retrieval efficiencies below 1% and we observed reduced storage durations (for both SPE and CPM) compared to our previous experiments with RF induced coherences. A major contribution to the reduced efficiency is due to the fact that light storage works in a specific ensemble in the inhomogeneously broadened optical line in PrYSO. Our specific CPM (and SPE) pulses on the other hand couple to more ensembles and cause enhanced absorption for the retrieved signal. Future work should thus focus on the implementation of optical CPM to address only the ensemble used for light storage. Regarding a reduced storage duration, we could not yet find an explanation and suggest to implemented CPM in different storage media to further investigate the limitation of storage duration.