We present a first experimental demonstration of classical CW laser light condensation (LC) in the frequency (mode) domain that verifies its prediction (Fischer and Weill, Opt. Express20, 26704 (2012)). LC is based on weighting the modes in a noisy environment in a loss-gain measure compared to an energy (frequency) scale in Bose-Einstein condensation (BEC). It is characterized by a sharp transition from multi- to single-mode oscillation, occurring when the spectral-filtering (loss-trap) has near the lowest-loss mode ("ground-state") a power-law dependence with an exponent smaller than 1. An important meaning of the many-mode LC system stems from its relation to lasing and photon-BEC.
We present a first experimental demonstration of classical CW laser light condensation (LC) in the frequency (mode) domain that verifies its prediction (Fischer and Weill, Opt. Express20, 26704 (2012)). LC is based on weighting the modes in a noisy environment in a loss-gain measure compared to an energy (frequency) scale in Bose-Einstein condensation (BEC). It is characterized by a sharp transition from multi- to single-mode oscillation, occurring when the spectral-filtering (loss-trap) has near the lowest-loss mode ("ground-state") a power-law dependence with an exponent smaller than 1. An important meaning of the many-mode LC system stems from its relation to lasing and photon-BEC.
We present a generic route to classical light condensation (LC) in linear photonic mode systems, such as cw lasers, with different grounds from regular Bose-Einstein condensation (BEC). LC is based on weighting the modes in a noisy environment (spontaneous emission, etc.) in a loss-gain scale, rather than in photon energy. It is characterized by a sharp transition from a multi- to single-mode oscillation. The study uses a linear multivariate Langevin formulation which gives a mode occupation hierarchy that functions like Bose-Einstein statistics. Condensation occurs when the spectral filtering has near the lowest-loss mode a power law dependence with exponent smaller than 1. We then discuss how condensation can occur in photon systems, its relation to lasing and the difficulties to observe regular photon-BEC in laser cavities. We raise the possibility that experiments on photon condensation in optical cavities fall in a classical LC or lasing category rather than being a thermal-quantum BEC phenomenon.
The interesting question if and how can Bose-Einstein condensation (BEC) occur with photons has received a boost by a recent experiment that reported on the observation of photon-BEC condensation in an optical microcavity [1]. Here we present a different laser light condensation (LC) phenomenon [2], while discussing and questioning the meaning and the possibility to observe thermal photon-BEC in laser cavities. LC is a classical condensation effect that is based on very different grounds than the regular BEC. Its “energy” levels are measured in a loss-gain scale inherent in laser cavities, where the “ground-state” is the lowest-loss mode, and noise has the role of temperature. The loss scale gives a power occupation hierarchy and power spectra similar to Bose-Einstein statistics with an effective chemical potential parameter and eventually laser light-condensation (LC) which is formally very similar to BEC in a potential-well [3].
In 1925, Einstein predicted the condensation of bosons into the ground state of the system for low (but finite) temperatures. Several phenomena, including superfluidity and superconductivity have been associated with Bose-Einstein condensation, but these systems interact strongly with their environment and pure Bose-Einstein condensation could not be established. It took 70 years, in which time the laser was discovered, and laser cooling techniques to manipulate atoms in a dilute atomic gas, before Bose-Einstein condensation in dilute atomic gases could be demonstrated in 1995. In the first condensation experiments, BECs were created in a magnetic trap. Since in a magnetic trap not all mF states of the atom can be trapped simultaneously, thereby limiting the number of experiments that can be done, other ways of trapping and generating BECs were sought and found. In 2001, the first all-optical BEC was made, where the dipole force was used to trap atoms in the crossing of two far red detuned laser beams. In an optical dipole trap not only atoms in different internal states can be trapped, but also different atomic species simultaneously. In this thesis, the formation of an all-optical Bose-Einstein condensate with rubidium atoms is presented. Conventional all-optical BECs are usually created in high power CO2 laser dipole traps, or have complicated laser cooling schemes and complex dipole trap setups. In our simple and straightforward setup, we load rubidium atoms from a magneto-optical trap into a crossed optical dipole trap created by a single frequency Yb:YAG laser with a wavelength at 1030 nm. The small wavelength allows for a small diffraction limit, and permits us to use standard optical materials, thus making the experimental setup cost effective. Other attempts to achieve Bose-Einstein condensation in a multi-mode (frequency) fiber laser at 1064 nm failed, because the atom loss was quite high. It is assumed that the multi-mode character of the fiber laser induces Raman transitions in rubidium atoms, thereby heating them. We can trap about ∼ 5E7 atoms in a single beam dipole trap out of ∼ 5E9 atoms trapped in theMOT, and ∼ 350,000 atoms can be trapped in a crossed beam dipole trap due to the smaller trap volume. 70% of the atoms in the dipole trap is optically pumped into one mF state. Quantum degeneracy is reached by evaporatively cooling the atoms in the crossed dipole trap by ramping down the laser power with three linear ramps. We can independently change the power of each beam by an AOM. This allows us to use one beam as an atom waveguide for future experiments. After evaporation, we typically have about 10,000 atoms at a temperature below the critical temperature. We have proved Bose-Einstein condensation by using the anisotropic expansion of a quantum degenerate gas trapped in an anisotropic potential. The aspect ratio of our atom cloud changed during a time of flight from 0.7 to 1.2 in 10 ms, thus proving that we have reached quantum degeneracy. We have about 5,000 condensed atoms in our optical dipole trap at a temperature less than 100 nK. The remaining atoms are thermal. Bose-Einstein condensation is obtained within 8 s, and we can repeat the experiment every 30 s. It should be mentioned that the Bose-Einstein experiment was moved from the ”Leibniz Universität Hannover” to the ”Technische Universität Darmstadt”, and had to be completely rebuilt. All-optical Bose-Einstein condensation was reached within one year after the move. Our Bose-Einstein condensation setup presents an ideal starting point for using our condensates in combination with miniaturized atom optical setups based on our novel microfabricated optical elements. With our microlenses, we can create a number of possible dipole trap configurations, such as the dipole trap array or the cylindrical microlens array. Using microlenses in miniaturized atom optical setups opens a completely new field of coherent atom optics. Also because the tight confinement of the microtraps allows us to load a 3D BEC, a 1D BEC, or a Tonks-Girardeau gas in the micropotentials depending on the density.
Bose-Einstein condensation (BEC) is the transition to a macroscopic occupation of the ground state of a system of bosonic particles. In 1995 the first experimental realization of BEC was achieved by condensing a dilute atomic gas [1,2]. It was long thought only massive particles could undergo BEC. However, in 2010 it was shown that photon BEC was achieved in an optical dye-filled microcavity [3]. In 2015, we became the second group to successfully repeat these experiments.\n\nBEC is a phase transition and thus it occurs at thermal equilibrium. To achieve a thermal photon gas the cavity is filled with a fluorescent dye solution. The dye molecules thermalize the photons by means of repeated absorption-emission cycles. We optically pump the cavity. With the pump we determine the number of photons absorbed by the dye, consequently defining a nonvanishing chemical potential. This ensures a conserved photon number. The photons are trapped by the harmonic potential induced by the concave cavity mirrors. Due to the cutoff energy determined by the cavity length, the trapped photons have a dispersion similar to that of a massive particle in a quantum harmonic oscillator. The cavity length is tuned such that the free spectral range is larger than the bandwidth of the dye. Therefore, only one longitudinal mode fits inside the cavity, making the photon gas effectively two-dimensional. We end up with a thermalized two-dimensional photon gas that has the eigenenergies of a quantum harmonic oscillator. The Bose-Einstein distribution function predicts a critical photon number. Pumping the thermal photon gas beyond this critical number will lead to photon BEC.\n\nWe measure the spectral- and spatial distributions of our two-dimensional photon gas. In both distributions we observe photon BEC. Results show the characteristics of a phase transition: the appearance of a sharp peak on top of the thermal cloud that coincides with a converging chemical potential to zero. Both the spectral- and spatial distribution are in agreement with the theoretical distribution of photons with an effective mass in a quantum harmonic oscillator. Expansion of the condensate has been measured. This could indicate nonlinear optical effects such as thermal lensing or repulsive photon-photon interactions.
Summary form only given. We present, a fully quantum-mechanical model for a quasi-CW phase-sensitive atom laser produced from a Bose-Einstein condensate (BEC) atomic source (reservoir). As a particular realization of our model, we consider the f=1 ground-state multiplet of /sup 23/Na atoms in a harmonic optical trap. The reservoir BEC state, taken to be the spin-0 state, contains a very large number of atoms N, while the other trapped hyperfine states m/sub f/=1 as well as m/sub f/=-1 (the lasing states) are assumed to be initially empty. Pumping from the source BEC state to the lasing BEC states is implemented via two-photon Raman transitions which are driven by an external classical driving field and the quantized field of a single-mode polarization-selective optical cavity.