Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Lasers and Electro-Optics

Fraunhofer/wavelength atomic resonance filter

Jerry A. Gelbwachs

Published Apr 25, 1988• 0 citations
OpenAlex

Abstract

The atomic resonance filter (ARF) is art ultra- high-Q (105–106) optical filter that is isotropic and insensitive to environmental factors and possesses a 180° acceptance angle.1 We are developing a novel ARF for satellite applications. Our filter operates in a Fraunhofer dip in the solar spectrum, thereby offering the key advantage of reduced solar background noise. Other important operational characteristics of the filter are: a projected conversion efficiency of blue-green light into the wavelength-shifted output light of ~90%, a 10-ns response time, and an output in the near UV, a spectral region that is efficiently detected by commercial large-area long-lived photomultiplier tubes.

Related papers

Atomic resonance filters

Jerry A. Gelbwachs

The atomic resonance filter (ARF) is an ultranarrowband (Q approximately 10/sup 5/-10/sup 6/), large-acceptance-angle, isotropic optical filter. These features make the device ideally suited for applications in which weak laser signals are detected against a continuum background. The filter properties arise from the physical processes of absorption, emission, and internal energy conversion in atomic vapors. The characteristics of the ARF are described and the underlying physics that governs the operation is discussed. Representative examples of passive, active, and IR filters are presented. A metastable ARF that offers improved solar background-limited performance by filtering signals at Fraunhofer wavelengths is described.>

IEEE Journal of Quantum Electronics•Jul 1, 1988•88 citations

Proposed Fraunhofer-wavelength atomic filter at 5349 nm

Jerry A. Gelbwachs

A new atomic filter is proposed. It operates at 534.9 nm. The new filter offers two important advantages for openchannel laser communications. First, its wavelength matches the output of the frequency-doubled Nd:BEL laser. Second, the filter overlays a solar Fraunhofer line, thereby offering intrinsic sunlight suppression. Ultranarrowband optical filtering takes place within the singlet manifold of neutral-calcium vapor. Excellent filter properties are deduced from spectroscopic examination of the atomic system. A novel feature of the new filter is the potential for greater-than-unity internal photon conversion.

Optics Letters•Oct 15, 1990•7 citations

4227-nm atomic filter with superior solar background rejection

Jerry A. Gelbwachs

A novel atomic resonance filter with powerful solar background rejection is proposed. The filter wavelength matches the g Fraunhofer line at 422.7 nm. Atomic filtering occurs within the singlet manifold of neutral calcium. Superior sunlight discrimination arises mainly from two factors: overlay with an intense Fraunhofer line and signal levels devoid of fine and hyperfine structures. The new filter should exhibit high throughput and low noise.

Optics Letters•Feb 15, 1990•11 citations

Fast efficient Ca atomic resonance filter at 423 nm

Frederick G. Walther

An optically pumped active Ca atomic resonance filter is demonstrated, applicable to background-limited optical communications through scatter channels. In pump saturation, the filter should detect 50% of the incident 423-nm signal power with an internal photon gain of 6 and a response time of 10 micros, 2 orders of magnitude faster than a passive Ca filter. Response time of 100 micros has been demonstrated, limited by available pump power. The filter maintains the wide field of view and reduced solar background associated with atomic absorption at the Ca Fraunhofer line while permitting higher data rate communications.

Optics Letters•Nov 15, 1992•0 citations

Cesium Atomic Resonance Filter

B. Batdorf, Mike Jacobson, Angus Macleod

Atomic resonance filters (ARF) have the unique property of simultaneously being wide angle and extremely narrowband. ARFs depend on atomic excitation of a contained gas at one wavelength and the fluorescence at a longer wavelength. By sandwiching the gas between two edge filters (the input filter transmitting at and below the excitation wavelength and the output filter transmitting at and above the fluorescence wavelength) the combination has throughput only from the gas resonance.

Annual Meeting Optical Society of America•Jan 1, 1990•0 citations

Experimental evaluation of an atomic line filter for spaceborne application

B. P. Oehry, Walter Schupita, Brigitte Sumetsberger +2 more

Atomic line filters take advantage of the sharp spectral features offered by electronic transitions in free atoms. The basic idea is to convert a narrow atomic absorption profile into an equally narrow optical transmission filter by detecting the fluorescence radiation that is emitted after a photon has been absorbed. We developed the metastable thallium atomic line filter from the basic physical idea to a laboratory prototype in order to evaluate the usefulness of the technology for satellite borne backscatter LIDARs. Atomic thallium provides for an unsurpassed combination of features for this purpose. The input wavelength of the filter is 535 nm, which matches the frequency doubled Nd:BEL laser. The filter is an active device, it upconverts the 535 nm input into 378 nm output that is detected by a PMT. The experimental results were as expected concerning the characteristics directly related to atomic properties, i.e. the filter has only 10 ns response time, its optical bandwidth is 0.004 nm, and its acceptance angle is only limited by the device geometry. An optimized setup, with the size constraints of a space-borne system, displays a total quantum efficiency of 2%, i.e. from input photons to detected output photons. This constitutes a remarkable and unsurpassed value for atomic line filters but is too low for the application in mind. (A ground-based, scaled-up version of our prototype would reach about 10% quantum efficiency). In addition, the 500 degree(s)C operating temperature of the vapor cell requires sophisticated thermal layout and thermal shielding, which means a lot of added mass and volume. In summary, we found that atomic line filters can be built that offer characteristics not found with other technologies, but their applicability for space borne systems is questionable.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Dec 9, 1994•0 citations
The atomic resonance filter (ARF) is art ultra- high-Q (105–106) optical filter that is isotropic and insensitive to environmental factors and possesses a 180° acceptance angle.1 We are developing a novel ARF for satellite applications. Our filter operates in a Fraunhofer dip in the solar spectrum, thereby offering the key advantage of reduced solar background noise. Other important operational characteristics of the filter are: a projected conversion efficiency of blue-green light into the wavelength-shifted output light of ~90%, a 10-ns response time, and an output in the near UV, a spectral region that is efficiently detected by commercial large-area long-lived photomultiplier tubes.
The atomic resonance filter (ARF) is an ultranarrowband (Q approximately 10/sup 5/-10/sup 6/), large-acceptance-angle, isotropic optical filter. These features make the device ideally suited for applications in which weak laser signals are detected against a continuum background. The filter properties arise from the physical processes of absorption, emission, and internal energy conversion in atomic vapors. The characteristics of the ARF are described and the underlying physics that governs the operation is discussed. Representative examples of passive, active, and IR filters are presented. A metastable ARF that offers improved solar background-limited performance by filtering signals at Fraunhofer wavelengths is described.>
A new atomic filter is proposed. It operates at 534.9 nm. The new filter offers two important advantages for openchannel laser communications. First, its wavelength matches the output of the frequency-doubled Nd:BEL laser. Second, the filter overlays a solar Fraunhofer line, thereby offering intrinsic sunlight suppression. Ultranarrowband optical filtering takes place within the singlet manifold of neutral-calcium vapor. Excellent filter properties are deduced from spectroscopic examination of the atomic system. A novel feature of the new filter is the potential for greater-than-unity internal photon conversion.
An optically pumped active Ca atomic resonance filter is demonstrated, applicable to background-limited optical communications through scatter channels. In pump saturation, the filter should detect 50% of the incident 423-nm signal power with an internal photon gain of 6 and a response time of 10 micros, 2 orders of magnitude faster than a passive Ca filter. Response time of 100 micros has been demonstrated, limited by available pump power. The filter maintains the wide field of view and reduced solar background associated with atomic absorption at the Ca Fraunhofer line while permitting higher data rate communications.
Atomic line filters take advantage of the sharp spectral features offered by electronic transitions in free atoms. The basic idea is to convert a narrow atomic absorption profile into an equally narrow optical transmission filter by detecting the fluorescence radiation that is emitted after a photon has been absorbed. We developed the metastable thallium atomic line filter from the basic physical idea to a laboratory prototype in order to evaluate the usefulness of the technology for satellite borne backscatter LIDARs. Atomic thallium provides for an unsurpassed combination of features for this purpose. The input wavelength of the filter is 535 nm, which matches the frequency doubled Nd:BEL laser. The filter is an active device, it upconverts the 535 nm input into 378 nm output that is detected by a PMT. The experimental results were as expected concerning the characteristics directly related to atomic properties, i.e. the filter has only 10 ns response time, its optical bandwidth is 0.004 nm, and its acceptance angle is only limited by the device geometry. An optimized setup, with the size constraints of a space-borne system, displays a total quantum efficiency of 2%, i.e. from input photons to detected output photons. This constitutes a remarkable and unsurpassed value for atomic line filters but is too low for the application in mind. (A ground-based, scaled-up version of our prototype would reach about 10% quantum efficiency). In addition, the 500 degree(s)C operating temperature of the vapor cell requires sophisticated thermal layout and thermal shielding, which means a lot of added mass and volume. In summary, we found that atomic line filters can be built that offer characteristics not found with other technologies, but their applicability for space borne systems is questionable.