Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Современные проблемы науки и образования

Сверхпроводниковый детектор с разрешением числа фотонов для телекоммуникаций и квантовой криптографии

A. Semenov, Рябчун Сергей Александрович, А. А. Шишов, Vladimir A. Anfertev, Yu. P. Korneeva, Matvey I. Finkel, М. В. Ширяев, Anton S. Mukhin

Published Jan 1, 2012• 0 citations
OpenAlex

Abstract

Detector of novel type for quantum key distribution and telecommunications, a photon-number resolving superconducting nanowire detector, is proposed. The Poisson distribution is utilized to describe statistics of incoming photons and photo-counts of the detector and to derive relations for bit-error ratio. Number of photons per pulse required to obtain acceptable bit error ratio while using the detector in classic communication channel is estimated. Qualitative formula is derived, describing dependency of required average number of photons per pulse on bit-error ratio in the limit of high signal-to-noise ratio of the line. The formula can be used for characterizing applicability of photon-number resolving detectors in telecommunication protocols with the required bit-error ratio. The numerical calculations are performed, confirming applicability of the analytical formula. Thereby, the availability of superconducting nanowire detector for long-distance telecommunication with standard single-mode fiber is demonstrated.

Related papers

Towards linear optical detection with single photon sensitivity at telecom wavelengths

Saeedeh Jahanmirinejad, Andrea Fiore

Standard linear optical detectors have a maximum sensitivity in the few hundreds of photons range, limited by amplifier noise. On the other hand, single photon detectors, which are the most sensitive detectors, are strongly nonlinear: One or more photons result in the same output signal. Photon number resolving (PNR) detectors, which have the ability to discriminate the number of photons in a weak optical pulse, are of great importance in the field of quantum information processing and quantum cryptography. Moreover, a PNR detector with large dynamic range can cover the gap between these two detection modes. Such detectors are greatly desirable not only in quantum information science and technology, but also in any application dealing with low light levels. In this work, we propose a novel approach to photon number resolving detectors based on spatial multiplexing of nanowire superconducting single-photon detectors. In the proposed approach, N superconducting nanowires, each connected in parallel to an integrated resistor, are connected in series. Photon absorption in a nanowire switches its bias current to the parallel resistor, forming a voltage pulse across it. The sum of these voltages, proportional to the number of absorbed photons, is measured at the output. The use of a cryogenic preamplifier with high input impedance for the read-out increases the linearity, the signal to noise ratio, and the speed. With this combination, we expect to be able to count up to few tens of photons with high fidelity, excellent timing resolution, and very high sensitivity in the telecommunication wavelength range.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 21, 2012•2 citations

Photon-number resolution with superconducting nanowires

F. B. Baalbergen

Superconducting Nanowire Single Photon Detectors (SNSPDs) are fast and efficient detectors with important applications in optical quantum computers and quantum networks. Current SNSPD implementations lack intrinsic single-wire photon-number resolution. This thesis discusses the electronic and optical characterization of SNSPDs with the goal of obtaining high-speed, high-efficiency photon-number-resolving detectors. Novel laser-induced relaxation oscillations are observed, caused by laser pulses triggering the detector and changing its biasing condition. This leads to discrete steps in the count rate at integer multiples of the pulsed laser repetition rate and limits the maximum achievable count rate for SNSPDs. A Monte Carlo Markov Chain method is applied to detector tomography to characterize single-photon detectors with unprecedented accuracy, and can be applied to detectors regardless of their detection efficiency. Photon number resolution is achieved in (commercial) SNSPDs by projecting measured voltage traces onto the derivative of the average voltage trace. This method enables discrimination of photon numbers by measuring the time difference between traces in a noise-resilient way. The final chapters discuss the design and characterization of impedance-tapered SNSPDs. These devices show both differences in pulse heights and timing depending on the photon number.

•Nov 3, 2026•0 citations

Resolving Photon Numbers Using Ultra-High-Resolution Timing of a Single Low-Jitter Superconducting Nanowire Detector

Sauer, Gregor, Mirco Kolarczik, Rodrigo Gómez +2 more

Photon-number-resolving (PNR) detectors are a key enabling technology in photonic quantum information processing. Here, we demonstrate the PNR capacity of conventional superconducting nanowire single-photon detectors by performing ultra-high-resolution time-tagging of the detector-generated electrical pulses. This method provides a viable approach for PNR with high detection efficiency and a high operational repetition rate. We present the implementation of such a PNR detector in the telecom C-band and its characterization by measuring the photon-number statistics of coherent light with tunable intensity. Additionally, we demonstrate the capabilities of the detection method by measuring photon-number correlations of non-classical states.

arXiv:2310.12472•Oct 19, 2023•18 citations

Coherent detection of weak signals with superconducting nanowire single photon detector at the telecommunication wavelength

Michael Shcherbatenko, Y. Lobanov, Alexander V. Semenov +6 more

Achievement of the ultimate sensitivity along with a high spectral resolution is one of the frequently addressed problems, as the complication of the applied and fundamental scientific tasks being explored is growing up gradually. In our work, we have investigated performance of a superconducting nanowire photon-counting detector operating in the coherent mode for detection of weak signals at the telecommunication wavelength. Quantum-noise limited sensitivity of the detector was ensured by the nature of the photon-counting detection and restricted by the quantum efficiency of the detector only. Spectral resolution given by the heterodyne technique and was defined by the linewidth and stability of the Local Oscillator (LO). Response bandwidth was found to coincide with the detector’s pulse width, which, in turn, could be controlled by the nanowire length. In addition, the system noise bandwidth was shown to be governed by the electronics/lab equipment, and the detector noise bandwidth is predicted to depend on its jitter. As have been demonstrated, a very small amount of the LO power (of the order of a few picowatts down to hundreds of femtowatts) was required for sufficient detection of the test signal, and eventual optimization could lead to further reduction of the LO power required, which would perfectly suit for the foreseen development of receiver matrices and the need for detection of ultra-low signals at a level of less-than-one-photon per second.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 15, 2017•0 citations

Photon-number resolving and distribution verification using a multichannel superconducting nanowire single-photon detection system

Dengkuan Liu, Lixing You, Yuhao He +5 more

Photon-number-resolving (PNR) detection is a prerequisite for many important quantum optics applications. By using a four-channel superconducting nanowire single-photon detection system incorporating the photon multiport network technique, PNR detection of up to four photons was realized. The amplitude of the output pulse is proportional to the detected photon number. Using two channels of the system, the Poisson distribution of photon number in the faint pulsed laser was verified. The theoretical counts of the two-photon response were analyzed as a function of the mean photon number per pulse. The measurement results matched well with the theoretical calculations according to the Poisson distribution.

Journal of the Optical Society of America B•Mar 13, 2014•9 citations

Counting Photons Using a Nanonetwork of Superconducting Wires

Andrea Fiore, Francesco Marsili, David Bitauld +9 more

We show how the parallel connection of photo-sensitive supercon-ducting nanowires can be used to count the number of photons in an optical pulse, down to the single-photon level. Using this principle we demonstrate photon-number resolving detectors with unprecedented sensitivity and speed at telecommunication wavelengths.

•May 9, 2012•0 citations
Detector of novel type for quantum key distribution and telecommunications, a photon-number resolving superconducting nanowire detector, is proposed. The Poisson distribution is utilized to describe statistics of incoming photons and photo-counts of the detector and to derive relations for bit-error ratio. Number of photons per pulse required to obtain acceptable bit error ratio while using the detector in classic communication channel is estimated. Qualitative formula is derived, describing dependency of required average number of photons per pulse on bit-error ratio in the limit of high signal-to-noise ratio of the line. The formula can be used for characterizing applicability of photon-number resolving detectors in telecommunication protocols with the required bit-error ratio. The numerical calculations are performed, confirming applicability of the analytical formula. Thereby, the availability of superconducting nanowire detector for long-distance telecommunication with standard single-mode fiber is demonstrated.
Standard linear optical detectors have a maximum sensitivity in the few hundreds of photons range, limited by amplifier noise. On the other hand, single photon detectors, which are the most sensitive detectors, are strongly nonlinear: One or more photons result in the same output signal. Photon number resolving (PNR) detectors, which have the ability to discriminate the number of photons in a weak optical pulse, are of great importance in the field of quantum information processing and quantum cryptography. Moreover, a PNR detector with large dynamic range can cover the gap between these two detection modes. Such detectors are greatly desirable not only in quantum information science and technology, but also in any application dealing with low light levels. In this work, we propose a novel approach to photon number resolving detectors based on spatial multiplexing of nanowire superconducting single-photon detectors. In the proposed approach, N superconducting nanowires, each connected in parallel to an integrated resistor, are connected in series. Photon absorption in a nanowire switches its bias current to the parallel resistor, forming a voltage pulse across it. The sum of these voltages, proportional to the number of absorbed photons, is measured at the output. The use of a cryogenic preamplifier with high input impedance for the read-out increases the linearity, the signal to noise ratio, and the speed. With this combination, we expect to be able to count up to few tens of photons with high fidelity, excellent timing resolution, and very high sensitivity in the telecommunication wavelength range.
Superconducting Nanowire Single Photon Detectors (SNSPDs) are fast and efficient detectors with important applications in optical quantum computers and quantum networks. Current SNSPD implementations lack intrinsic single-wire photon-number resolution. This thesis discusses the electronic and optical characterization of SNSPDs with the goal of obtaining high-speed, high-efficiency photon-number-resolving detectors. Novel laser-induced relaxation oscillations are observed, caused by laser pulses triggering the detector and changing its biasing condition. This leads to discrete steps in the count rate at integer multiples of the pulsed laser repetition rate and limits the maximum achievable count rate for SNSPDs. A Monte Carlo Markov Chain method is applied to detector tomography to characterize single-photon detectors with unprecedented accuracy, and can be applied to detectors regardless of their detection efficiency. Photon number resolution is achieved in (commercial) SNSPDs by projecting measured voltage traces onto the derivative of the average voltage trace. This method enables discrimination of photon numbers by measuring the time difference between traces in a noise-resilient way. The final chapters discuss the design and characterization of impedance-tapered SNSPDs. These devices show both differences in pulse heights and timing depending on the photon number.
Photon-number-resolving (PNR) detectors are a key enabling technology in photonic quantum information processing. Here, we demonstrate the PNR capacity of conventional superconducting nanowire single-photon detectors by performing ultra-high-resolution time-tagging of the detector-generated electrical pulses. This method provides a viable approach for PNR with high detection efficiency and a high operational repetition rate. We present the implementation of such a PNR detector in the telecom C-band and its characterization by measuring the photon-number statistics of coherent light with tunable intensity. Additionally, we demonstrate the capabilities of the detection method by measuring photon-number correlations of non-classical states.
Achievement of the ultimate sensitivity along with a high spectral resolution is one of the frequently addressed problems, as the complication of the applied and fundamental scientific tasks being explored is growing up gradually. In our work, we have investigated performance of a superconducting nanowire photon-counting detector operating in the coherent mode for detection of weak signals at the telecommunication wavelength. Quantum-noise limited sensitivity of the detector was ensured by the nature of the photon-counting detection and restricted by the quantum efficiency of the detector only. Spectral resolution given by the heterodyne technique and was defined by the linewidth and stability of the Local Oscillator (LO). Response bandwidth was found to coincide with the detector’s pulse width, which, in turn, could be controlled by the nanowire length. In addition, the system noise bandwidth was shown to be governed by the electronics/lab equipment, and the detector noise bandwidth is predicted to depend on its jitter. As have been demonstrated, a very small amount of the LO power (of the order of a few picowatts down to hundreds of femtowatts) was required for sufficient detection of the test signal, and eventual optimization could lead to further reduction of the LO power required, which would perfectly suit for the foreseen development of receiver matrices and the need for detection of ultra-low signals at a level of less-than-one-photon per second.
Photon-number-resolving (PNR) detection is a prerequisite for many important quantum optics applications. By using a four-channel superconducting nanowire single-photon detection system incorporating the photon multiport network technique, PNR detection of up to four photons was realized. The amplitude of the output pulse is proportional to the detected photon number. Using two channels of the system, the Poisson distribution of photon number in the faint pulsed laser was verified. The theoretical counts of the two-photon response were analyzed as a function of the mean photon number per pulse. The measurement results matched well with the theoretical calculations according to the Poisson distribution.