Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Time evolution of matrix product operators in the Heisenberg picture

Jarno N. van der Kolk

Published Jan 1, 2011• 0 citations
OpenAlex

Abstract

Using the Density Matrix Renormalization Group (DMRG) one can simulate spin systems without the computation time growing as 2 , making it feasible to simulate large systems. In this paper, the impact of using the DMRG in the Schrodinger picture and in the Heisenberg picture is investigated for three different models, a spin1 2 XX chain, a spin1 2 XXZ chain and a Bose-Hubbard model. Simulations in the Heisenberg model will turn out to perform better only in the XX chain for certain operators. For all the other tested models, the Schrodinger picture is to be preferred. We will also try to shed some light on why the simulations in the Heisenberg picture fail so quickly.

Related papers

Exact matrix product solutions in the Heisenberg picture of an open quantum spin chain

S R Clark, J Prior, M J Hartmann +2 more

In recent work, Hartmann et al (2009 Phys. Rev. Lett. 102 057202) demonstrated that the classical simulation of the dynamics of open 1D quantum systems with matrix product algorithms can often be dramatically improved by performing time evolution in the Heisenberg picture. For a closed system this was exemplified by an exact matrix product operator (MPO) solution of the time-evolved creation operator of a quadratic fermi chain with a matrix dimension of just two. In this work, we show that this exact solution can be significantly generalized to include the case of an open quadratic fermi chain subjected to master equation evolution with Lindblad operators that are linear in the fermionic operators. Remarkably even in this open system the time evolution of operators continues to be described by MPOs with the same fixed dimension as that required by the solution of a coherent quadratic fermi chain for all times. Through the use of matrix product algorithms the dynamical behaviour of operators in this non-equilibrium open quantum system can be computed with a cost that is linear in the system size. We present some simple numerical examples that highlight how useful this might be for the more detailed study of open system dynamics. Given that Heisenberg picture simulations have been demonstrated to offer significant accuracy improvements for other open systems that are not exactly solvable, our work also provides further insight into how and why this advantage arises.

arXiv:0907.5582•New Journal of Physics•Feb 26, 2010•66 citations

Dynamical Simulation of Integrable and Nonintegrable Models in the Heisenberg Picture

Dominik Muth, Razmik G. Unanyan, Michael Fleischhauer

The numerical simulation of quantum many-body dynamics is typically limited by the linear growth of entanglement with time. Recently numerical studies have shown that for 1D Bethe-integrable models the simulation of local operators in the Heisenberg picture can be efficient. Using the spin-1/2 XX chain as generic example of an integrable model that can be mapped to free fermions, we provide a simple explanation for this. We show furthermore that the same reduction of complexity applies to operators that have a high-temperature autocorrelation function which decays slower than exponential, i.e., with a power law. Thus efficient simulability may already be implied by a single conservation law as we will illustrate numerically for the spin-1 XXZ model.

arXiv:1009.4646•Physical Review Letters•Feb 14, 2011•55 citations

Equivalence of the variational matrix product method and the density matrix renormalization group applied to spin chains

J. Dukelsky, M. A Martín-Delgado, T Nishino +1 more

We study the relationship between the Density Matrix Renormalization Group (DMRG) and the variational matrix product method (MPM). In the latter method one can also define a density matrix whose eigenvalues turn out to be numerically close to those of the DMRG. We illustrate our ideas with the spin-1 Heisenberg chain, where we compute the ground-state energy and the spin correlation length. We also give a rotational invariant formulation of the MPM.

arXiv:cond-mat/9710310•Europhysics Letters (EPL)•Aug 15, 1998•191 citations

Density Matrix Renormalization Group in the Heisenberg Picture

Michael J. Hartmann, Javier Prior, Stephen R. L. Clark +1 more

In some cases the state of a quantum system with a large number of subsystems can be approximated efficiently by the density-matrix renormalization group, which makes use of redundancies in the description of the state. Here we show that the achievable efficiency can be much better when performing density-matrix renormalization group calculations in the Heisenberg picture, as only the observable of interest but not the entire state is considered. In some nontrivial cases, this approach can even be exact for finite bond dimensions.

arXiv:0808.0666•Physical Review Letters•Feb 2, 2009•85 citations

Phase diagram of the anisotropic spin-2 XXZ model: Infinite-system density matrix renormalization group study

Jonas A. Kjäll, Michael P. Zaletel, Roger S. K. Mong +2 more

We study the ground-state phase diagram of the quantum spin-2 XXZ chain in the presence of on-site anisotropy using a matrix-product state based infinite-system density matrix renormalization group (iDMRG) algorithm. One of the interests in this system is in connecting the highly quantum-mechanical spin-1 phase diagram with the classical $S=\ensuremath{\infty}$ phase diagram. Several of the recent advances within DMRG make it possible to perform a detailed analysis of the whole phase diagram. We consider different types of on-site anisotropies, which allows us to establish the validity of the following statements: (1) the spin-2 model can be tuned into a phase, which is equivalent to the ``topologically nontrivial'' spin-1 Haldane phase, and (2) the spin-2 Haldane phase at the isotropic Heisenberg point is adiabatically connected to the ``trivial'' large-$D$ phase, with a continuous change of the Hamiltonian parameters. Furthermore, we study the spin-3 XXZ chain to help explain the development of the classical phase diagram. We present details on how to use the iDMRG method to map out the phase diagram and include an extensive discussion of the numerical methods.

arXiv:1212.6255•Physical Review B•Jun 6, 2013•145 citations

Strongly Correlated Models in One Dimension from a Density Matrix Renormalization Group Perspective

Stefan Rommer

The density matrix renormalization group (DMRG) is a numerical method for studying low dimensional strongly correlated models. The study of these models is one of the most active areas of condensed matter physics today and has been spurred not only by the discovery of high temperature superconductivity but also by experiments on new compounds. In this thesis we study fundamentals of the density matrix renormalization group method as well as applications of the method to Heisenberg spin chains. The introductory text is meant as a brief overview of the DMRG as well as Heisenberg spin systems and provides an introduction to the papers. In papers I and II we investigate the density matrix renormalization group with the aim to better understand the underlying structure of the method. We find that if the renormalization converges to a fixed point in the thermodynamic limit, the resulting basis states can be written as a matrix product form. We also show an explicit relation of the DMRG to variational calculations using the fact that the matrix product states can be rederived through a variational ansatz without any reference to the DMRG calculation. It is then shown how the matrix product states can be used to define a set of Bloch waves for describing elementary excitations of the Heisenberg spin-1 chain. The low lying energy spectrum is calculated. In papers III and IV we investigate the thermodynamics of impurities in a spin-1/2 chain. For this purpose we have shown that a recently developed transfer matrix DMRG method can be used to calculate impurity properties. Both impurity corrections to thermodynamic properties and local properties at finite temperature can be obtained. The method gives quicker and more accurate results than quantum Monte Carlo. The numerical results show good agreement with field theory calculations for a number of impurity configurations and the cross-over function for the magnetic susceptibility from high- to low-temperature behavior shows the expected data collapse. Our results also give quantitative predictions for experiments on doped spin-1/2 chains.

•Jan 1, 1998•0 citations
Using the Density Matrix Renormalization Group (DMRG) one can simulate spin systems without the computation time growing as 2 , making it feasible to simulate large systems. In this paper, the impact of using the DMRG in the Schrodinger picture and in the Heisenberg picture is investigated for three different models, a spin1 2 XX chain, a spin1 2 XXZ chain and a Bose-Hubbard model. Simulations in the Heisenberg model will turn out to perform better only in the XX chain for certain operators. For all the other tested models, the Schrodinger picture is to be preferred. We will also try to shed some light on why the simulations in the Heisenberg picture fail so quickly.
In recent work, Hartmann et al (2009 Phys. Rev. Lett. 102 057202) demonstrated that the classical simulation of the dynamics of open 1D quantum systems with matrix product algorithms can often be dramatically improved by performing time evolution in the Heisenberg picture. For a closed system this was exemplified by an exact matrix product operator (MPO) solution of the time-evolved creation operator of a quadratic fermi chain with a matrix dimension of just two. In this work, we show that this exact solution can be significantly generalized to include the case of an open quadratic fermi chain subjected to master equation evolution with Lindblad operators that are linear in the fermionic operators. Remarkably even in this open system the time evolution of operators continues to be described by MPOs with the same fixed dimension as that required by the solution of a coherent quadratic fermi chain for all times. Through the use of matrix product algorithms the dynamical behaviour of operators in this non-equilibrium open quantum system can be computed with a cost that is linear in the system size. We present some simple numerical examples that highlight how useful this might be for the more detailed study of open system dynamics. Given that Heisenberg picture simulations have been demonstrated to offer significant accuracy improvements for other open systems that are not exactly solvable, our work also provides further insight into how and why this advantage arises.
The numerical simulation of quantum many-body dynamics is typically limited by the linear growth of entanglement with time. Recently numerical studies have shown that for 1D Bethe-integrable models the simulation of local operators in the Heisenberg picture can be efficient. Using the spin-1/2 XX chain as generic example of an integrable model that can be mapped to free fermions, we provide a simple explanation for this. We show furthermore that the same reduction of complexity applies to operators that have a high-temperature autocorrelation function which decays slower than exponential, i.e., with a power law. Thus efficient simulability may already be implied by a single conservation law as we will illustrate numerically for the spin-1 XXZ model.
In some cases the state of a quantum system with a large number of subsystems can be approximated efficiently by the density-matrix renormalization group, which makes use of redundancies in the description of the state. Here we show that the achievable efficiency can be much better when performing density-matrix renormalization group calculations in the Heisenberg picture, as only the observable of interest but not the entire state is considered. In some nontrivial cases, this approach can even be exact for finite bond dimensions.
We study the ground-state phase diagram of the quantum spin-2 XXZ chain in the presence of on-site anisotropy using a matrix-product state based infinite-system density matrix renormalization group (iDMRG) algorithm. One of the interests in this system is in connecting the highly quantum-mechanical spin-1 phase diagram with the classical $S=\ensuremath{\infty}$ phase diagram. Several of the recent advances within DMRG make it possible to perform a detailed analysis of the whole phase diagram. We consider different types of on-site anisotropies, which allows us to establish the validity of the following statements: (1) the spin-2 model can be tuned into a phase, which is equivalent to the ``topologically nontrivial'' spin-1 Haldane phase, and (2) the spin-2 Haldane phase at the isotropic Heisenberg point is adiabatically connected to the ``trivial'' large-DDD phase, with a continuous change of the Hamiltonian parameters. Furthermore, we study the spin-3 XXZ chain to help explain the development of the classical phase diagram. We present details on how to use the iDMRG method to map out the phase diagram and include an extensive discussion of the numerical methods.
The density matrix renormalization group (DMRG) is a numerical method for studying low dimensional strongly correlated models. The study of these models is one of the most active areas of condensed matter physics today and has been spurred not only by the discovery of high temperature superconductivity but also by experiments on new compounds. In this thesis we study fundamentals of the density matrix renormalization group method as well as applications of the method to Heisenberg spin chains. The introductory text is meant as a brief overview of the DMRG as well as Heisenberg spin systems and provides an introduction to the papers. In papers I and II we investigate the density matrix renormalization group with the aim to better understand the underlying structure of the method. We find that if the renormalization converges to a fixed point in the thermodynamic limit, the resulting basis states can be written as a matrix product form. We also show an explicit relation of the DMRG to variational calculations using the fact that the matrix product states can be rederived through a variational ansatz without any reference to the DMRG calculation. It is then shown how the matrix product states can be used to define a set of Bloch waves for describing elementary excitations of the Heisenberg spin-1 chain. The low lying energy spectrum is calculated. In papers III and IV we investigate the thermodynamics of impurities in a spin-1/2 chain. For this purpose we have shown that a recently developed transfer matrix DMRG method can be used to calculate impurity properties. Both impurity corrections to thermodynamic properties and local properties at finite temperature can be obtained. The method gives quicker and more accurate results than quantum Monte Carlo. The numerical results show good agreement with field theory calculations for a number of impurity configurations and the cross-over function for the magnetic susceptibility from high- to low-temperature behavior shows the expected data collapse. Our results also give quantitative predictions for experiments on doped spin-1/2 chains.