Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Silicon Nanoelectronics Workshop (SNW)

Manipulation of silicon quantum dots and isolated structures using GHz photons

T. Ferrus, Alessandro Rossi, Tetsuo Kodera, Tomohiro Kambara, Shunri Oda, D. A. Williams

Published Jun 1, 2014• 0 citations
Publisher

Abstract

We demonstrate that microwave photons can be used to remotely manipulate electron tunneling across a tunnel barrier at 4.2 K. A similar method is used to successfully modify the charges states of an electrically isolated doped silicon double quantum dot with potential coherence time of the order of a few μs.
DOI
10.1109/snw.2014.7348584

Related papers

Microwave manipulation of electrons in silicon quantum dots

T. Ferrus, Alessandro Rossi, Tetsuo Kodera +4 more

Here we present the results of an investigation on microwave-induced effects that we have observed in silicon devices, including phosphorous doped and Metal-Oxide-Semiconductor Single Electron Transistors (SET) as well as IDQD. Continuous pulsed microwave and single shot measurements are used to demonstrate that photons in the range of 10-15 GHz allow manipulation of the electron number in the island of a doped SET, despite the high value for the charging energy and in a regime where photon assisted tunnelling is not observable. The method is applied to a device made of a SET with a capacitively coupled IDQD. Partial control of the qubit is obtained and results in the possibility of manipulating charge states in an isolated structure with GHz photons.

IEEE Silicon Nanoelectronics Workshop•Jun 1, 2012•0 citations

Charge-Qubit Operation of an Isolated Double Quantum Dot

J. Gorman, D. G. Hasko, D. A. Williams

We have investigated coherent time evolution of pseudomolecular states of an isolated (leadless) silicon double quantum dot, where operations are carried out via capacitively coupled elements. Manipulation is performed by short pulses applied to a nearby gate, and measurement is performed by a single-electron transistor. The electrical isolation of this qubit results in a significantly longer coherence time than previous reports for semiconductor charge qubits realized in artificial molecules.

arXiv:cond-mat/0504451•Physical Review Letters•Aug 24, 2005•402 citations

Circuit quantum electrodynamics architecture for gate-defined quantum dots in silicon

X. Mi, J. V. Cady, D. M. Zajac +3 more

We demonstrate a hybrid device architecture where the charge states in a double quantum dot (DQD) formed in a Si/SiGe heterostructure are read out using an on-chip superconducting microwave cavity. A quality factor Q = 5400 is achieved by selectively etching away regions of the quantum well and by reducing photon losses through low-pass filtering of the gate bias lines. Homodyne measurements of the cavity transmission reveal DQD charge stability diagrams and a charge-cavity coupling rate gc/2π= 23 MHz. These measurements indicate that electrons trapped in a Si DQD can be effectively coupled to microwave photons, potentially enabling coherent electron-photon interactions in silicon.

arXiv:1610.05571•Applied Physics Letters•Jan 23, 2017•94 citations

Manipulation of a Single Charge in a Double Quantum Dot

J. R. Petta, Alex C. Johnson, Charles M. Marcus +2 more

We manipulate a single electron in a fully tunable double quantum dot using microwave excitation. Under resonant conditions, microwaves drive transitions between the (1,0) and (0,1) charge states of the double dot. Local quantum point contact charge detectors enable a direct measurement of the photon-induced change in occupancy of the charge states. From charge sensing measurements, we find T1 approximately 16 ns and a lower bound estimate for T*(2) of 400 ps for the charge two-level system.

arXiv:cond-mat/0408139•Physical Review Letters•Oct 27, 2004•437 citations

Tunneling Current in a Double Quantum Dot Driven by Two-Mode Microwave Photons

Weici Liu, Faqiang Wang

In this study, a model of a double-quantum-dot system driven by two-mode microwave photons is presented. The quantum master equation is derived from the system’s Hamiltonians, and the expression for the steady-state current is obtained. Electronic tunneling properties are then analyzed. The results revealed that different two-mode quantum microwave photons have varying effects on the tunneling current within the double-quantum-dot system, with a steplike current trend emerging. The tunneling current showed pronounced negative differential conductance for both coherent and squeezed microwave photons. Furthermore, the tunneling current was significantly influenced by changing the squeezing coefficient and phase. The asymmetric evolution of the tunneling current under varying bias voltages also depends on the asymmetry in system parameters. These findings are crucial for manipulating the transport properties of double-quantum-dot systems in nanostructured devices.

Electronics•Feb 3, 2025•1 citation

SILICON ISOLATED DOUBLE QUANTUM-DOT QUBIT ARCHITECTURES

D. A. WILLIAMS, Michael G. Tanner, T. Ferrus +3 more

We present both experimental and theoretical results on silicon isolated double quantum-dots (IDQDs) fabricated through trench isolation of silicon-on-insulator, with near-by single electron transistors (SETs) for charge state sensing. The IDQD can be described as an artificial molecule and is therefore capable of exhibiting quantum superposition states suitable for quantum information processing.

Foundations of Quantum Mechanics in the Light of New Technology•Jun 1, 2009•1 citation
Here we present the results of an investigation on microwave-induced effects that we have observed in silicon devices, including phosphorous doped and Metal-Oxide-Semiconductor Single Electron Transistors (SET) as well as IDQD. Continuous pulsed microwave and single shot measurements are used to demonstrate that photons in the range of 10-15 GHz allow manipulation of the electron number in the island of a doped SET, despite the high value for the charging energy and in a regime where photon assisted tunnelling is not observable. The method is applied to a device made of a SET with a capacitively coupled IDQD. Partial control of the qubit is obtained and results in the possibility of manipulating charge states in an isolated structure with GHz photons.
We demonstrate a hybrid device architecture where the charge states in a double quantum dot (DQD) formed in a Si/SiGe heterostructure are read out using an on-chip superconducting microwave cavity. A quality factor Q = 5400 is achieved by selectively etching away regions of the quantum well and by reducing photon losses through low-pass filtering of the gate bias lines. Homodyne measurements of the cavity transmission reveal DQD charge stability diagrams and a charge-cavity coupling rate gc/2π= 23 MHz. These measurements indicate that electrons trapped in a Si DQD can be effectively coupled to microwave photons, potentially enabling coherent electron-photon interactions in silicon.
In this study, a model of a double-quantum-dot system driven by two-mode microwave photons is presented. The quantum master equation is derived from the system’s Hamiltonians, and the expression for the steady-state current is obtained. Electronic tunneling properties are then analyzed. The results revealed that different two-mode quantum microwave photons have varying effects on the tunneling current within the double-quantum-dot system, with a steplike current trend emerging. The tunneling current showed pronounced negative differential conductance for both coherent and squeezed microwave photons. Furthermore, the tunneling current was significantly influenced by changing the squeezing coefficient and phase. The asymmetric evolution of the tunneling current under varying bias voltages also depends on the asymmetry in system parameters. These findings are crucial for manipulating the transport properties of double-quantum-dot systems in nanostructured devices.