Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Joint Symposium on Nonlinear Optical Materials

S. Friebel, Rainer A. Deutschmann, G. Wokurka, Wolfgang A. Ertmer, F. J. Bartoli, Dieter H. Jundt

Published Jan 1, 1995• 0 citations
OpenAlex

Abstract

QTuE5 Fig. 3 Map of a potential barrier for metastable argon atoms produced by a doughnut beam of 500 mW. The blue-detuning A is taken to be 15 times the natural linewidth r. The slope angle and exit hole of the he1 prism are assumed to be 60 and 0.2 mm, respectively. The Y axis shows the distance from the inner wall, while the Z axis indicates the distance along the fall line from the center of the exit hole. most 100% conversion rate. A Gaussian beam branches into two paths in the first refraction on the prism, and then a non- divergent doughnut beam appears after the second refraction. Figure 2b shows the intensity profile of the doughnut beam formed through the doublesone prism with a length of 4.25 mm and a diameter of 2.5 mm. The hollow diameter and ring thickness of the doughnut beams are determined by the prism length and the waist of the input Gauss- ian beam, respectively. The funnel can be available for reflec- tion of cold atoms fallen from a MOT. Figure 3 shows the potential barrier for metastable argon atoms expressed in terms of temperature, assuming the fun- nel prism with an exit hole of 0.2 mm and a slope of 60. The doughnut beam con- verted from the Gausian beam with a waist of 1.6 mm and a power of 500 mW produces the potential barrier of more than 1 mK through a distance of 3 mm along the fall line. Unless the funnel in- cludes some cooling mechanisms to com- pensate acceleration resulting from grav- itation, the atoms with the velocity of more than 10 cm/s cannot escape from the exit hole. Recently the addition of a weak pumping beam to cool atoms down to the recoil limit has been reported: The use of the additional beam propagating downward makes up for the lack of cool- ing mechanisms. Progress of the atom- guidance experiment will be also pre-

Related papers

Mode conversion in optical beam in order to create funnel shaped optical near field to collect cold Rb atoms from MOT

S. M. Iftiquar

Doughnut shaped light beam has been generated from Gaussian mode ($TEM_{00}$) cw-Ti sapphire laser. After splitting the pump beam into two equal intensity components and introducing unequal convergence and phase delay while they are recombined it results in doughnut mode. Such a beam is tunable and have long propagation length. The evanescent field generated by 360 mW (at 780 nm wavelength) of such a beam creates optical field of 600 nm decay length with a 5.75 neV repulsive dipole potential. Thus cold Rb atoms (at 10{$μ$}K or less temperature) released from MOT can be reflected by the surface so that the atoms are collected ultimately at the bottom of the prism. By focussing such doughnut beam with 8 cm focal length converging lens, the dark radius reduces to 22{$μ$}. We also observe such beam to contain azimuthal phase as well as radial phase distribution.

arXiv:physics/0306021•Jun 3, 2003•1 citation

Interaction of a beam of metastable argon atoms and a diode laser beam

Boer, AP Alexander de

•Jan 1, 1993•0 citations

Tunable doughnut light beam for a near-field optical funnel of atoms

HARUHIKO ITO

•Jan 1, 2001•0 citations

Optimized coupling of cold atoms into a fiber using a blue-detuned hollow-beam funnel

Jérôme Poulin, P. S. Light, Raman Kashyap +1 more

We theoretically investigate the process of coupling cold atoms into the core of a hollow-core photonic-crystal optical fiber using a blue-detuned Laguerre-Gaussian beam. In contrast to the use of a red-detuned Gaussian beam to couple the atoms, the blue-detuned hollow beam can confine cold atoms to the darkest regions of the beam, thereby minimizing shifts in the internal states and making the guide highly robust to heating effects. This single optical beam is used as both a funnel and a guide to maximize the number of atoms into the fiber. In the proposed experiment, Rb atoms are loaded into a magneto-optical trap (MOT) above a vertically oriented optical fiber. We observe a gravito-optical trapping effect for atoms with high orbital momentum around the trap axis, which prevents atoms from coupling to the fiber: these atoms lack the kinetic energy to escape the potential and are thus trapped in the laser funnel indefinitely. We find that by reducing the dipolar force to the point at which the trapping effect just vanishes, it is possible to optimize the coupling of atoms into the fiber. Our simulations predict that by using a low-power (2.5 mW) and far-detuned (300 GHz) Laguerre-Gaussian beam with a 20-$\ensuremath{\mu}$m-radius core hollow fiber, it is possible to couple 11% of the atoms from a MOT 9 mm away from the fiber. When the MOT is positioned farther away, coupling efficiencies over 50% can be achieved with larger core fibers.

arXiv:1107.4746•Physical Review A•Nov 7, 2011•13 citations

STUDY OF THE PRODUCTION OF A BEAM OF METASTABLE ATOMS WITH THERMAL ENERGY.

T. Sinda, G. Watel

•Jan 1, 1968•0 citations

Atomic funnel with evanescent light

Hajime Ito, K. Sakaki, Wonho Jhe +1 more

We propose an atomic funnel composed of an evanescent-light mirror produced in a conical hollow prism. The funneling of cold Rb atoms released from a magneto-optical trap is simulated in the scheme of the evanescent-light-induced Sisyphus cooling for compensating the heating by gravity. A geometric method of the conversion of a Gaussian light beam into a doughnut-shaped light beam suitable for the atomic funnel is also experimentally demonstrated by means of a double-cone prism. Under the assumption of a proper optical intensity distribution over the inner surface of a specific conical hollow prism, the Monte Carlo simulation including the van der Waals interaction shows that a half of the released Rb atoms can be collected and the mean temperature of the collected atoms is low enough for the application to be guided with a bent hollow optical fiber.

Physical Review A•Jul 1, 1997•76 citations
QTuE5 Fig. 3 Map of a potential barrier for metastable argon atoms produced by a doughnut beam of 500 mW. The blue-detuning A is taken to be 15 times the natural linewidth r. The slope angle and exit hole of the he1 prism are assumed to be 60 and 0.2 mm, respectively. The Y axis shows the distance from the inner wall, while the Z axis indicates the distance along the fall line from the center of the exit hole. most 100% conversion rate. A Gaussian beam branches into two paths in the first refraction on the prism, and then a non- divergent doughnut beam appears after the second refraction. Figure 2b shows the intensity profile of the doughnut beam formed through the doublesone prism with a length of 4.25 mm and a diameter of 2.5 mm. The hollow diameter and ring thickness of the doughnut beams are determined by the prism length and the waist of the input Gauss- ian beam, respectively. The funnel can be available for reflec- tion of cold atoms fallen from a MOT. Figure 3 shows the potential barrier for metastable argon atoms expressed in terms of temperature, assuming the fun- nel prism with an exit hole of 0.2 mm and a slope of 60. The doughnut beam con- verted from the Gausian beam with a waist of 1.6 mm and a power of 500 mW produces the potential barrier of more than 1 mK through a distance of 3 mm along the fall line. Unless the funnel in- cludes some cooling mechanisms to com- pensate acceleration resulting from grav- itation, the atoms with the velocity of more than 10 cm/s cannot escape from the exit hole. Recently the addition of a weak pumping beam to cool atoms down to the recoil limit has been reported: The use of the additional beam propagating downward makes up for the lack of cool- ing mechanisms. Progress of the atom- guidance experiment will be also pre-
Doughnut shaped light beam has been generated from Gaussian mode (TEM00TEM_{00}TEM00​) cw-Ti sapphire laser. After splitting the pump beam into two equal intensity components and introducing unequal convergence and phase delay while they are recombined it results in doughnut mode. Such a beam is tunable and have long propagation length. The evanescent field generated by 360 mW (at 780 nm wavelength) of such a beam creates optical field of 600 nm decay length with a 5.75 neV repulsive dipole potential. Thus cold Rb atoms (at 10{μμμ}K or less temperature) released from MOT can be reflected by the surface so that the atoms are collected ultimately at the bottom of the prism. By focussing such doughnut beam with 8 cm focal length converging lens, the dark radius reduces to 22{μμμ}. We also observe such beam to contain azimuthal phase as well as radial phase distribution.
We theoretically investigate the process of coupling cold atoms into the core of a hollow-core photonic-crystal optical fiber using a blue-detuned Laguerre-Gaussian beam. In contrast to the use of a red-detuned Gaussian beam to couple the atoms, the blue-detuned hollow beam can confine cold atoms to the darkest regions of the beam, thereby minimizing shifts in the internal states and making the guide highly robust to heating effects. This single optical beam is used as both a funnel and a guide to maximize the number of atoms into the fiber. In the proposed experiment, Rb atoms are loaded into a magneto-optical trap (MOT) above a vertically oriented optical fiber. We observe a gravito-optical trapping effect for atoms with high orbital momentum around the trap axis, which prevents atoms from coupling to the fiber: these atoms lack the kinetic energy to escape the potential and are thus trapped in the laser funnel indefinitely. We find that by reducing the dipolar force to the point at which the trapping effect just vanishes, it is possible to optimize the coupling of atoms into the fiber. Our simulations predict that by using a low-power (2.5 mW) and far-detuned (300 GHz) Laguerre-Gaussian beam with a 20-$\ensuremath{\mu}$m-radius core hollow fiber, it is possible to couple 11% of the atoms from a MOT 9 mm away from the fiber. When the MOT is positioned farther away, coupling efficiencies over 50% can be achieved with larger core fibers.
We propose an atomic funnel composed of an evanescent-light mirror produced in a conical hollow prism. The funneling of cold Rb atoms released from a magneto-optical trap is simulated in the scheme of the evanescent-light-induced Sisyphus cooling for compensating the heating by gravity. A geometric method of the conversion of a Gaussian light beam into a doughnut-shaped light beam suitable for the atomic funnel is also experimentally demonstrated by means of a double-cone prism. Under the assumption of a proper optical intensity distribution over the inner surface of a specific conical hollow prism, the Monte Carlo simulation including the van der Waals interaction shows that a half of the released Rb atoms can be collected and the mean temperature of the collected atoms is low enough for the application to be guided with a bent hollow optical fiber.