Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Photonics Technology Letters

Study of spectral dependence of gain saturation and effect of inhomogeneous broadening in erbium-doped aluminosilicate fiber amplifiers

E. Desurvire, James W. Sulhoff, J.L. Zyskind, J.R. Simpson

Published Sep 1, 1990• 67 citations
Publisher

Abstract

The special dependence of gain saturation and the effect of inhomogeneous broadening are investigated in erbium-doped aluminosilicate fiber amplifiers. Experimental data are compared with calculated results using two theoretical models, one assuming completely homogeneous saturation and the other including inhomogeneous gain broadening. Both the homogeneous model and the more accurate inhomogeneous model provide, without the use of fitting parameters, good agreement with experimental data.>

DOI
10.1109/68.59340

Related papers

Spectral Gain Hole-Burning in an Erbium-Doped Fiber Amplifier with GeO2:SiO2 Core

J.L. Zyskind, E. Desurvire, James W. Sulhoff +1 more

The gain saturation characteristics of erbium-doped fiber amplifiers, which are of importance for applications in optical fiber communications, will depend strongly on the relative importance of homogeneous and inhomogeneous saturation. We have recently reported low temperature spectral hole burning measurements in an erbium-doped fiber with an alumino-silicate core1. From these measurements the homogeneous linewidth was determined to be 11.5 nm. This is consistent with the homogeneous gain saturation observed for alumino-silicate fibers.2 For erbium-doped fibers with GeO2:SiO2 cores, on the other hand, inhomogeneous saturation effects have been reported.3

Optical Amplifiers and Their Applications•Jan 1, 1990•5 citations

Inhomogeneous Gain Saturation of Erbium-Doped Fiber Amplifiers

Harry Chou, J. Stimple

An important application of Erbium-doped fiber amplifiers is in future wavelength division multiplexed (WDM) communication systems. In such systems one needs to consider gain cross saturation, i.e., how a signal at one wavelength affects gains at other wavelengths. A contributing factor to gain cross saturation is the inhomogeneous broadening of the gain medium. In this paper we demonstrate a technique for characterizing the inhomogeneous nature of the small-signal gain spectrum in the presence of a saturating signal.

Optical Amplifiers and Their Applications•Jan 1, 1995•8 citations

Inhomogeneous Gain Saturation in EDF: Experiment and Modeling

Romain Peretti, B. Jacquier, David Boivin +2 more

Erbium-Doped Fiber Amplifiers can present holes in spectral gain in Wavelength Division Multiplexing operation. The origin of this inhomogeneous saturation behavior is still a subject of controversy. In this paper we present both an experimental methods and a gain's model. Our experimental method allow us to measure the first homogeneous linewidth of the 1.5$\mu$m erbium emission with gain spectral hole burning consistently with the other measurement in the literature and the model explains the differences observed in literature between GSHB and other measurement methods.

arXiv:1104.5302•Journal of Lightwave Technology•Mar 15, 2011•11 citations

Resonant fluorescence line narrowing measurements in erbium-doped glasses for optical amplifiers

Laurent Bigot, Anne-Marie Jurdyc, B. Jacquier +2 more

Rapid development of optical fiber amplifiers, and more especially of the erbium-doped fiber amplifiers (EDFA) during the last decade, has benefited from extensive work on the configuration of the system itself: determination of pump wavelength, pumping configuration, improvement of noise performance, etc. However, less effort have been dedicated to study the interaction that influences the spectral profile of the gain bandwidth and particularly the relation between the glass composition and the spectroscopy of erbium. Here, we report a systematic determination of key parameters responsible for the global profile of the gain bandwidth: stark splitting, homogeneous broadening, and inhomogeneous broadening. The correlation between these parameters and the glass structure from one part and the behavior of the EDFA in amplification regime from another part is discussed. The quasiregular crystal-field splitting of tellurite and fluoride glasses is found to correlate well with the flatness of the gain profile. Moreover, the low-temperature homogeneous bandwidths extrapolated to room temperature can be correlated to the saturation spectral hole widths measured in the amplification regime.

Physical review. B, Condensed matter•Dec 11, 2002•51 citations

Signal-induced refractive index changes in erbium-doped fiber amplifiers

M. Janos, S.C. Guy

This paper reports the measurement and analysis of signal power-induced changes in the refractive index spectrum of an aluminosilicate erbium-doped fiber amplifier (EDFA). For a constant 980 nm pump power of 11 mW, a 1553 nm signal power of 4.6 mW caused a peak-to-trough change in refractive index of (3.8/spl plusmn/0.4)/spl times/10/sup -8/ across the EDFA gain spectrum. A Kramers-Kronig transform of the signal-induced change in absorption coefficient agreed well with the measured change in refractive index. This result conflicts with the behavior of the system predicted by a homogeneously broadened two-level model and suggests limitations in the representation of the Er/sup 3+/:glass system by a discrete set of homogeneously broadened transitions.

Journal of Lightwave Technology•Apr 1, 1998•26 citations

Fluorescence line narrowing in erbium-doped fiber amplifiers

S.C. Guy, Robert A. Minasian, Simon B. Poole +1 more

Germanosilicate glass shows inhomogeneous saturation behavior,1 whereas aluminogermanosilicate glass shows homogeneous behavior.2 Zemon et al.3 have published a study of nonresonant fluorescence line narrowing (FLN), but their spectra show little evidence of significant spectral narrowing by site selection. Spectral hole-burning spectroscopy has been applied by Desurvire et al.4 on Er3+ in aluminosilicate fiber. They extracted an inhomogeneous linewidth Γin of 12.5 nm and a homogeneous linewidth Γh of 115 nm.

Optical Fiber Communication Conference•Jan 1, 1991•1 citation
The special dependence of gain saturation and the effect of inhomogeneous broadening are investigated in erbium-doped aluminosilicate fiber amplifiers. Experimental data are compared with calculated results using two theoretical models, one assuming completely homogeneous saturation and the other including inhomogeneous gain broadening. Both the homogeneous model and the more accurate inhomogeneous model provide, without the use of fitting parameters, good agreement with experimental data.>
The gain saturation characteristics of erbium-doped fiber amplifiers, which are of importance for applications in optical fiber communications, will depend strongly on the relative importance of homogeneous and inhomogeneous saturation. We have recently reported low temperature spectral hole burning measurements in an erbium-doped fiber with an alumino-silicate core1. From these measurements the homogeneous linewidth was determined to be 11.5 nm. This is consistent with the homogeneous gain saturation observed for alumino-silicate fibers.2 For erbium-doped fibers with GeO2:SiO2 cores, on the other hand, inhomogeneous saturation effects have been reported.3
An important application of Erbium-doped fiber amplifiers is in future wavelength division multiplexed (WDM) communication systems. In such systems one needs to consider gain cross saturation, i.e., how a signal at one wavelength affects gains at other wavelengths. A contributing factor to gain cross saturation is the inhomogeneous broadening of the gain medium. In this paper we demonstrate a technique for characterizing the inhomogeneous nature of the small-signal gain spectrum in the presence of a saturating signal.
Erbium-Doped Fiber Amplifiers can present holes in spectral gain in Wavelength Division Multiplexing operation. The origin of this inhomogeneous saturation behavior is still a subject of controversy. In this paper we present both an experimental methods and a gain's model. Our experimental method allow us to measure the first homogeneous linewidth of the 1.5μ\muμm erbium emission with gain spectral hole burning consistently with the other measurement in the literature and the model explains the differences observed in literature between GSHB and other measurement methods.
Rapid development of optical fiber amplifiers, and more especially of the erbium-doped fiber amplifiers (EDFA) during the last decade, has benefited from extensive work on the configuration of the system itself: determination of pump wavelength, pumping configuration, improvement of noise performance, etc. However, less effort have been dedicated to study the interaction that influences the spectral profile of the gain bandwidth and particularly the relation between the glass composition and the spectroscopy of erbium. Here, we report a systematic determination of key parameters responsible for the global profile of the gain bandwidth: stark splitting, homogeneous broadening, and inhomogeneous broadening. The correlation between these parameters and the glass structure from one part and the behavior of the EDFA in amplification regime from another part is discussed. The quasiregular crystal-field splitting of tellurite and fluoride glasses is found to correlate well with the flatness of the gain profile. Moreover, the low-temperature homogeneous bandwidths extrapolated to room temperature can be correlated to the saturation spectral hole widths measured in the amplification regime.
This paper reports the measurement and analysis of signal power-induced changes in the refractive index spectrum of an aluminosilicate erbium-doped fiber amplifier (EDFA). For a constant 980 nm pump power of 11 mW, a 1553 nm signal power of 4.6 mW caused a peak-to-trough change in refractive index of (3.8/spl plusmn/0.4)/spl times/10/sup -8/ across the EDFA gain spectrum. A Kramers-Kronig transform of the signal-induced change in absorption coefficient agreed well with the measured change in refractive index. This result conflicts with the behavior of the system predicted by a homogeneously broadened two-level model and suggests limitations in the representation of the Er/sup 3+/:glass system by a discrete set of homogeneously broadened transitions.
Germanosilicate glass shows inhomogeneous saturation behavior,1 whereas aluminogermanosilicate glass shows homogeneous behavior.2 Zemon et al.3 have published a study of nonresonant fluorescence line narrowing (FLN), but their spectra show little evidence of significant spectral narrowing by site selection. Spectral hole-burning spectroscopy has been applied by Desurvire et al.4 on Er3+ in aluminosilicate fiber. They extracted an inhomogeneous linewidth Γin of 12.5 nm and a homogeneous linewidth Γh of 115 nm.