Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Instrumentation and Measurement

Light shift measurements in a diode-laser-pumped /sup 87/Rb maser

Jinquan Deng, Jinting Liu, Shaofeng An, Yongfang Tan, Xiwen Zhu

Published Jan 1, 1994• 7 citations
Publisher

Abstract

Light shifts in a diode-laser-pumped /sup 87/Rb maser under the various conditions of laser intensities and frequency detunings were measured, and a linear dependence of the maser frequency on the laser intensities and frequencies was derived. The pulling coefficient of the maser frequency from the laser was found to be about 2.9/spl times/10/sup -3/, and the light shift could be minimized when the laser frequency was adjusted to near the center frequency of the resonance cell.>

DOI
10.1109/19.310167

Related papers

Analysis of the light shift effect in the /sup 87/Rb frequency standard

F. Levi, Carlo Novero, A. Godone

The /sup 87/Rb cell frequency standard, optically pumped by a laser diode, is of great interest in the development of high short-term stability oscillators. We report experiments performed on a rubidium cell prototype aiming at evaluate the transfer of the laser noise to the hyperfine clock transition via the light shift effect, which appears to be the main contribution to the observed short term frequency stability in this kind of standard. Pulsed optical pumping will also be examined in order to strongly reduce the light shift effect and to achieve the theoretical limit never approached up to now despite the strong detected microwave signals.

Conference on Precision Electromagnetic Measurements•Dec 24, 2002•0 citations

Analysis of the light shift in a Rb atomic clock pumped by detuned laser

勲 松田, 静夫 山口, Isao Matsuda +1 more

ln recent years, laser pumped Rb atomic clocks have been numerously studied and developed to reduce "light shift" and increase the accuracy and stability of the frequency. Previously, we reoorted on the measurement of the linewidths and S/N of the optical-microwave double resonance signal and the light shift in a Rb atomic clock pumped by a stabilized diode laser. In this paper, the light shift was numerically calculated by using the theory proposed by Cohen-Tannoudji & Barrat. Furthermore, contributions of the laser power and frequency detuning to the light shift were also estimated to attain the microwave frequency stability as high as 10^<-12>.

•Jan 1, 1992•0 citations

Theoretical Analysis of the Power and Linewidth of the Diode-Laser-Pumped Rb87 Maser

Jinquan Deng, Xiwen Zhu

We calculated the oscillation power and total linewidth of the diode-laser-pumped Rb87 maser with spatial variations of the pumping rate and the radiative microwave field in the resonance cell. It is found that the maximum oscillation power P max corresponding to the optimum pumping rate Γ opt does not increase monotonically with the atomic density n 0 and that the short-term frequency stability of the maser corresponding to P max is about a factor of three better than that currently obtained with a lamp-pumped Rb87 maser. Some results are in fair agreement with our previous experiments. We also examined the variation of the oscillation powers vs light intensity in an average mode for three laser-pumping schemes with different frequencies and polarizations of the diode lasers.

Japanese Journal of Applied Physics•Mar 1, 1994•3 citations

Light shift compensation in a Rb gas cell frequency standard with two-laser pumping

Jinquan Deng

One of the most important physical processes occurring in Rb frequency standards is the light shift, which depends strongly on the intensity and the optical frequency detuning of the pumping light. This paper presents a method to compensate the light shift by means of two-laser pumping. The two-laser pumping schemes will also improve the signal-to-noise ratio, because almost all atoms can be pumped to the desired state.

IEEE Transactions on Ultrasonics Ferroelectrics and Frequency Control•Nov 1, 2001•19 citations

Reducing the light-shift in the diode laser pumped rubidium atomic clock

James C. Camparo

One impediment to achieving the promise of enhanced laser-pumped gas cell clock performance resides with the light-shift effect, a phenomenon whereby diode laser optical frequency fluctuations are mapped onto the atomic clock's output frequency. The alternative to tightly stabilizing the diode laser in order to overcome this problem is to develop means of reducing the actual magnitude of the light-shift. Here, we briefly review two strategies for accomplishing this, and introduce a new one based on optical pumping with laser-induced-fluorescence (LIF). The advantage of LIF optical pumping is that the clock's output frequency is insensitive to laser frequency fluctuations. Though LIF optical pumping creates a dependence of clock frequency on laser intensity variations, it is to be noted that diode lasers have very low intensity noise. Consequently, with regards to the light-shift effect the LIF strategy takes advantage of an inherent diode laser strength.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Dec 24, 2002•6 citations

Study of the /sup 87/Rb maser with both ends pumping

D. Jinquan, Z. Xiwen, Xiang Yuan-hai

Experiments on the /sup 87/Rb maser with both ends pumping showed variations of the maximum output power versus cell temperature. The largest output power was 2.0*10/sup -10/ W, and a preliminary measurement gave an improved short-term frequency stability. The results of the numerical calculations based on the density matrix formalism agreed qualitatively with the experiments.>

IEEE Transactions on Instrumentation and Measurement•Jun 1, 1993•1 citation
Light shifts in a diode-laser-pumped /sup 87/Rb maser under the various conditions of laser intensities and frequency detunings were measured, and a linear dependence of the maser frequency on the laser intensities and frequencies was derived. The pulling coefficient of the maser frequency from the laser was found to be about 2.9/spl times/10/sup -3/, and the light shift could be minimized when the laser frequency was adjusted to near the center frequency of the resonance cell.>
The /sup 87/Rb cell frequency standard, optically pumped by a laser diode, is of great interest in the development of high short-term stability oscillators. We report experiments performed on a rubidium cell prototype aiming at evaluate the transfer of the laser noise to the hyperfine clock transition via the light shift effect, which appears to be the main contribution to the observed short term frequency stability in this kind of standard. Pulsed optical pumping will also be examined in order to strongly reduce the light shift effect and to achieve the theoretical limit never approached up to now despite the strong detected microwave signals.
ln recent years, laser pumped Rb atomic clocks have been numerously studied and developed to reduce "light shift" and increase the accuracy and stability of the frequency. Previously, we reoorted on the measurement of the linewidths and S/N of the optical-microwave double resonance signal and the light shift in a Rb atomic clock pumped by a stabilized diode laser. In this paper, the light shift was numerically calculated by using the theory proposed by Cohen-Tannoudji & Barrat. Furthermore, contributions of the laser power and frequency detuning to the light shift were also estimated to attain the microwave frequency stability as high as 10^<-12>.
We calculated the oscillation power and total linewidth of the diode-laser-pumped Rb87 maser with spatial variations of the pumping rate and the radiative microwave field in the resonance cell. It is found that the maximum oscillation power P max corresponding to the optimum pumping rate Γ opt does not increase monotonically with the atomic density n 0 and that the short-term frequency stability of the maser corresponding to P max is about a factor of three better than that currently obtained with a lamp-pumped Rb87 maser. Some results are in fair agreement with our previous experiments. We also examined the variation of the oscillation powers vs light intensity in an average mode for three laser-pumping schemes with different frequencies and polarizations of the diode lasers.
One impediment to achieving the promise of enhanced laser-pumped gas cell clock performance resides with the light-shift effect, a phenomenon whereby diode laser optical frequency fluctuations are mapped onto the atomic clock's output frequency. The alternative to tightly stabilizing the diode laser in order to overcome this problem is to develop means of reducing the actual magnitude of the light-shift. Here, we briefly review two strategies for accomplishing this, and introduce a new one based on optical pumping with laser-induced-fluorescence (LIF). The advantage of LIF optical pumping is that the clock's output frequency is insensitive to laser frequency fluctuations. Though LIF optical pumping creates a dependence of clock frequency on laser intensity variations, it is to be noted that diode lasers have very low intensity noise. Consequently, with regards to the light-shift effect the LIF strategy takes advantage of an inherent diode laser strength.