We present study on a multi-state vertex model solved by Sogo et al. at one of first order phase transition points. The origin of the level crossings is analyzed in terms of vertex weights and the Bethe ansatz equation. Singularity at this point is discussed in terms of quantum enveloping algebra.
The formulation and resolution of integrable lattice statistical models in a quantum group covariant way is the subject of this review. The Bethe Ansatz turns to be remarkably useful to implement quantum group symmetries and to provide quantum group representations even when q is a root of unity. We start by solving the six-vertex model with fixed boundary conditions (FBC) that guarantee exact SU(2)q invariance on the lattice. The algebra of the Yang-Baxter (YB) and SU(2)q generators turns to close. The infinite spectral parameter limit of the YB generators yields {\bf cleanly} the SU(2)q generators. The Bethe Ansatz states constructed for FBC are shown to be {\bf highest weights} of SU(2)q. The higher level Bethe Ansatz equations (BAE, describing the physical excitations) are explicitly derived for FBC. We then solve the RSOS(p) models on the light--cone lattice with fixed boundary conditions by disentangling the type II representations of SU(2)q, at q=eiπ/p, from the full SOS spectrum obtained through Algebraic Bethe Ansatz. The RSOS states are those with quantum spin $J
This thesis deals with two two-dimensional lattice models in statistical mechanics. The first of these is the zero-field 20-vertex model on a triangular lattice. This model is the analogue to the ice-type, zero-field six-vertex model on a square lattice. We solve this problem exactly for a restricted set of vertex weights. The other model is the q-component Potts model on a square lattice. This model is equivalent to a staggered ice-type model on a square lattice. Using a variational method we estimate the critical exponent ß for several values of q. In part I we outline the fundamental statistical mechanical ideas needed, including the definition of the partition function and its relation to the thermodynamic quantities. Mention is also made of the existence and uniqueness of the thermodynamic limit for these models. The 20-vertex model is discussed in part II. The transfer matrix approach is adopted and a Bethe ansatz is used for the eigenvector. Unlike the square lattice ice-type model, the triangular lattice 20-vertex model is only soluble by this method for a restricted set of vertex weights. In particular, the ten parameters determining the vertex weights must be expressed in terms of four independent parameters. This results in only one type of non-trivial temperature independent solution. This solution exhibits critical behaviour similar to the square lattice KDP model. The general solution has three states: disordered, antiferroelectric and ferroelectric. Which state the model is in is determined by one of the above four parameters. The transition from the disordered to the antiferroelectric state is of infinite-order (i.e the free energy has an essential singularity), and from the disordered to the ferroelectric state is of finite-order. We also compare our results to the free-fermion solution of the same model and note where the two methods overlap. In part III the Potts model is considered. The model is defined and shown to be equivalent to a staggered ice-type model. A variational principle for the eigenvalues of the transfer matrix of the staggered ice model is determined. Using the zero-temperature solution as a ^uide a simple form for a sequence of approximations to the eigenvector, below T , is developed. By using the variational principle we arrive at a set of matrix equations determining the eigenvector at a given level of approximation. By noting some of the symmetries of the transfer matrix we are able to separate some of the dependences of the matrix elements and consequently simplify the original set of equations. We are also able to express the percolation probability ( the analogue of the spontaneous magnetization for general values of q ) of the Potts model as a simple function of these matrix elements. At each level of approximation there is a set of algebraic equations to solve. We have used an electronic computer to solve these equations for the first five levels of approximation, and for several values of q between zero and four. With our results we estimate the critical exponent 3 for the Potts model. These estimates agree reasonably well with previous work and indicate 3=0.145 ±.017 for q=l.