We have measured the characteristics of a novel SQUID magnetometer pumped at 9 GHz. The device comprises a niobium point-contact shunting a low impedance superconducting microwave transmission line which isolates the junction at high frequencies from a toroidal input transformer. The junction is matched to a 50 Ω coaxial transmission line and the SQUID is operated in a reflection mode. For low values of the weak link critical current we observe a modulation of the phase of the reflected microwave signal periodic in the applied flux. The modulation persists at high microwave power levels indicating that the junction response is maintained to at least 200 GHz. For large values of critical current, amplitude modulation is observed. We have obtained a differential sideband power of 230 pW/(\Phi_{0})^{2}which is close to the value predicted by a simple model. In flux-locked loop operation we have obtained an energy sensitivity referred to the input terminals of 7 × 10-31J/Hz, which is superior to that so far reported for any other SQUID.
We have measured the characteristics of a novel SQUID magnetometer pumped at 9 GHz. The device comprises a niobium point-contact shunting a low impedance superconducting microwave transmission line which isolates the junction at high frequencies from a toroidal input transformer. The junction is matched to a 50 Ω coaxial transmission line and the SQUID is operated in a reflection mode. For low values of the weak link critical current we observe a modulation of the phase of the reflected microwave signal periodic in the applied flux. The modulation persists at high microwave power levels indicating that the junction response is maintained to at least 200 GHz. For large values of critical current, amplitude modulation is observed. We have obtained a differential sideband power of 230 pW/(\Phi_{0})^{2}which is close to the value predicted by a simple model. In flux-locked loop operation we have obtained an energy sensitivity referred to the input terminals of 7 × 10-31J/Hz, which is superior to that so far reported for any other SQUID.
A high-sensitivity microwave SQUID (superconducting quantum interference device), suitable for RF attenuation measurements, is constructed taking advantage of the low density of states of current carriers in high-T/sub c/ materials. The dynamics, the noise properties, and the sensitivity of the microwave SQUID are theoretically analyzed. The ultimate energy resolution of the waveguide SQUID is inversely proportional to the characteristic frequency omega /sub c/=R/sub q//L of the loop. omega /sub c/ is high for YBaCuO junctions at 4.2 K because of small leakage. A flux sensitivity of 4*10/sup 4-6/ phi /sub 0// square root Hz has been achieved, which is in good agreement with the theoretical predictions.>
The operation and noise limitations of de and RF SQUID's are outlined, and recent advances in their sensitivity are discussed. A model of the dc SQUID predicts an energy noise level per hertz referred to the SQUID of approximately8 k_{B}TL/R \approx 8 k_{B}T(\piLC)^{1/2}, whereL, R,andCare the SQUID inductance and the shunt resistance and capacitance of each Josephson junction. Some examples of dc SQUID's are described to show that their performance is generally in reasonable agreement with the model. The noise energy has improved from about 2 × 10-30J. Hz-1for a device withL = 1nH and a tunnel junction area of 104µm2to about 2 × 10-33J . Hz-1for a device withL = 0.1nH and a microbridge resistance of 40 Ω. Further improvements axe expected in the near future. The model of the RF SQUID predicts a noise energy per hertz referred to the SQUID of[(\pi\alpha^{2}\phi\min{0}\max{2}/2L) + 2 \pi \alpha k_{B}T\min{a}\max{(eff)}]/\omega_{RF}, where α is the intrinsic width of the distribution of flux transitions,T\min{a}\max{(eff)}is an effective amplifier noise temperature, and ωRFis the pump frequency. With one exception, the performance of the seven types of RF SQUID listed is in reasonable agreement with the model. The noise energy ranges from about 1.5 × 10-29J . Hz-1for a 20-MHz toroidal SQUID to 3.5 × 10-31J . Hz-1for 9-GHz reentrant toroidal SQUID; a somewhat better sensitivity has been reported for a 430-MHz device, apparently in conflict with the theory. In both dc and RF SQUID's, 1/fnoise (fis frequency) is likely to extend to higher frequencies as the white-noise level is decreased.
A superconducting quantum interferometer device (SQUID) electronics with tank frequencies near 150 MHz was constructed to enhance the rf SQUID sensitivity. By these means we characterized our YBa2Cu3O7 thin-film rf SQUIDs with step-edge junctions immersed in liquid N2. We obtained transfer function values of over 40 μV/Φ0, at a 50 Ω input impedance, for both hysteretic and dispersive mode of rf SQUID operation. The rms white and 1/f flux noise levels were significantly lower than at the tank frequency of 20 MHz. The best magnetic field sensitivity at 77 K was 0.9 pT/Hz1/2, and the energy resolution 1.4×10−28 J/Hz, down to 0.3 Hz.
The dynamics and noise of a dc SQUID (the Superconducting Quantum Interference Device), with the McCumber parameter /spl beta//sub c/=2/spl pi/R/sup 2/l/sub c/C//spl Phi//sub 0/ close to the unity (where I/sub c/, R, C is the critical current, the shunt resistance and the capacitance of the Josephson junctions comprising the SQUID, respectively, /spl Phi//sub 0/=2.07 10/sup -15/ Wb is the magnetic flux quantum) integrated with a planar spiral input coil, have been experimentally studied. The length of the spiral input coil was chosen so as to match its /spl lambda//4 microwave resonance frequency to the plasma resonance frequency of the SQUID. The input coil resonance is found to enhance the overall quality factor Q of the Josephson oscillations in the SQUID and, as a result, to increase the dynamic resistance R/sub d/ and the gradient of the flux-to-voltage characteristics, /spl delta/V//spl delta//spl Phi/, without hysteresis. A dc SQUID with a loop inductance L=30.5 pH, /spl beta//sub c/=0.72, and a 6 turn input coil demonstrated a non-distorted quasi-sinusoidal flux-to-voltage transfer function with an exceptionally large modulation depth of 140 /spl mu/V peak-to-peak. The spectral density of the magnetic flux noise was as low as 3.5/spl times/10/sup -7/ /spl Phi//sub 0//Hz/sup 1/2/ in the double stage configuration, measured at a temperature 4.2 K using direct read out electronics. In combination with an intermediary transformer, the current resolution of the SQUID is as low as 1.25 pA/Hz/sup 1/2/ with an input coil inductance of 100 nH.
There is currently fundamental and technological interest in measuring and manipulating nanoscale magnets, particularly in the quantum coherent regime. To observe the dynamics of such systems one requires a magnetometer with not only exceptional sensitivity but also high gain, wide bandwidth, and low backaction. We demonstrate a dispersive magnetometer consisting of a two-junction superconducting quantum interference device (SQUID) in parallel with an integrated, lumped-element capacitor. Input flux signals are encoded as a phase modulation of the microwave drive tone applied to the magnetometer, resulting in a single quadrature voltage signal. For strong drive power, the nonlinearity of the resonator results in quantum limited, phase sensitive parametric amplification of this signal, which improves flux sensitivity at the expense of bandwidth. Depending on the drive parameters, the device performance ranges from an effective flux noise of 0.29 $\ensuremath{\mu}{\ensuremath{\Phi}}_{0}$Hz${}^{\ensuremath{-}1/2}$ and 20 MHz of signal bandwidth to a noise of 0.14 $\ensuremath{\mu}{\ensuremath{\Phi}}_{0}$Hz${}^{\ensuremath{-}1/2}$ and a bandwidth of 0.6 MHz. These results are in excellent agreement with our theoretical model.
We describe measurements of the 10 GHz dynamic impedance of niobium point-contact weak links at 2 K, biased below their critical currents. The measured quantity is Γ(ω), the complex reflection coefficient Of the weak link in parallel with a superconducting cavity resonator terminating a waveguide. Measurements were made at several frequencies close to resonance. In order to interpret the results it is only necessary to assume that the weak link is a two-terminal device consisting of a phase-dependent susceptance in parallel with a phase-dependent conductivity, which is connected to the waveguide through a lossless, phase-independent two-port. The data are consistent with the resistively shunted junction model including a phase-dependent conductance with a negative sign. An important feature of this study was the ability to measure the d.c. IV characteristic simultaneously. The point-contacts investigated had nearly ideal IcR products, and exhibited reproducibile structure in the differential conductance at the superconducting energy gap voltage.