Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of the Optical Society of America B

Two-photon spectroscopy in rubidium with a diode laser

Robert E. Ryan, Lynn A. Westling, H. Metcalf

Published Sep 1, 1993• 36 citations
Publisher

Abstract

We present what is to our knowledge the first measurement of a two-photon transition excited in Rb with a commercial diode laser. In addition to the limitation imposed by diode lasers’ characteristic low powers, their relatively large bandwidths and sensitivity to optical feedback effects impede their application to two-photon spectroscopy. However, we show that optimized signal detection and careful minimization of optical feedback with an acousto-optic modulator combined with a Faraday isolator result in good two-photon signals with an off-the-shelf diode laser.

DOI
10.1364/josab.10.001643

Related papers

Rubidium spectroscopy at 778–780 nm with a distributed feedback laser diode

Sebastian Kraft, Anselm J. Deninger, Christian Trück +3 more

We have performed high resolution spectroscopy of rubidium with a single mode continuous wave distributed feedback (DFB) laser diode. The saturation spectrum of the D 2 -line of 85 Rb and 87 Rb was recorded with a resolution close to the natural line width. The emission frequency was actively stabilized to Doppler-free transitions with a relative accuracy of better than 7 parts in 10 9 using commercially available servo devices only. An output power of 80 mW was sufficient to allow for two-photon spectroscopy of the 5S-5D-transition of 87 Rb. Further, we report on the spectral properties of the DFB diode, its tuning range and its frequency modulation properties. The line width of the diode laser, determined with high resolution Doppler free two photon spectroscopy, was 4 MHz without applying any active stabilization techniques. For time scales below 5 μs the line width drops below 2 MHz.

arXiv:physics/0410256•Laser Physics Letters•Nov 3, 2004•37 citations

Investigation on the Monochromatic Two-Photon Transition Spectroscopy of Rubidium by Using Intensity Modulation Method

Sandan Wang, Jinpeng Yuan, Lirong Wang +2 more

We experimentally study the high-resolution two-photon spectroscopy of rubidium using a single laser. The 5S1/2 − 5P3/2 − 5D5/2 transition is realized via 778.1 nm laser beams acting on the vapor with a counter-propagating configuration. The intensity modulation method is employed to improve the signal-to-noise ratio of the spectrum by two orders of magnitude compared with that for direct measurement. The effects of the vapor temperature, the frequency-scanning speed of the laser, the polarization combination of the laser beams, and the laser power on the spectra are investigated to obtain the optimal experimental parameters. This research is expected to be beneficial for potential applications since it can be used to realize a compact and high-precision frequency standard for optical communication.

Journal of the Physical Society of Japan•Jul 18, 2018•7 citations

Two-photon spectroscopy of rubidium using a grating-feedback diode laser

Abraham J. Olson, Evan J. Carlson, Shannon K. Mayer

We describe an experiment for investigating the 5S1∕2→5D5∕2 two-photon transition in rubidium using a single grating-feedback diode laser operating at 778.1nm (385THz). Continuous tuning of the laser frequency over 4GHz allows for the clear resolution of the Doppler-free spectral features and allows accurate measurement of the hyperfine ground-state splitting. A direct comparison between Doppler-broadened and Doppler-free spectral features is possible because both are distinctly evident in the two-photon spectra. By independently modifying the polarization state of the two laser fields, the impact of electric dipole selection rules on the two-photon transition spectra is investigated. This experiment is a valuable addition to the advanced undergraduate laboratory because it uses much of the same equipment as the single-photon saturated absorption spectroscopy experiment performed on the 5S1∕2→5P3∕2 transition in rubidium (λ=780.24nm) and provides students with an opportunity to investigate characteristics of atomic spectra not evident in the single-photon experiment.

American Journal of Physics•Feb 14, 2006•56 citations

Observation of rubidium 5S_1/2→7S_1/2 two-photon transitions with a diode laser

Ming-Sheng Ko, Yi-Wei Liu

The 5S1/2 --> 7S1/2 two-photon transition of atomic rubidium, which is 100 times weaker than the 5S-5D transition, is observed with an extended-cavity diode laser and a vapor cell. Signals with a signal-to-noise ratio of 280 are obtained with a laser power of 10 mW, and the observed linewidth is 3 MHz. The laser wavelength is 760 nm and is locked on the transitions to a stability of 2 x 10(-11). For the first time to our knowledge, the isotope shift of this transition is measured to be 130(4) MHz in atomic frequency.

Optics Letters•Aug 1, 2004•20 citations

Frequency-modulation spectroscopy of rubidium atoms with an AlGaAs diode laser

Shunsuke Nakanishi, H. Ariki, Hiroshi Itoh +1 more

Frequency-modulation (FM) spectroscopy has been performed on the D(2) transitions of rubidium atoms with an AlGaAs diode laser at 780 nm. Doppler-broadened hyperfine-structure transitions of (85)Rb and (87)Rb were resolved with no residual amplitude-modulation-induced background signal by modulating the injection current of the laser diode at a low frequency (20-50 MHz) compared with the Doppler width. To obtain Doppler-free spectra, we combined FM spectroscopy with saturation spectroscopy. The results show that the FM spectroscopy technique is sensitive and should be useful for high-resolution spectroscopy, although the resolution was instrument limited and unusual double peaks were observed.

Optics Letters•Nov 1, 1987•10 citations

Nonlinear spectroscopy of rubidium: an undergraduate experiment

V. Jacques, B Hingant, A. Allafort +2 more

In this paper, we describe two complementary nonlinear spectroscopy methods which both allow one to achieve Doppler-free spectra of atomic gases. First, saturated absorption spectroscopy is used to investigate the structure of the 5S 1/2 → 5P 3/2 transition in rubidium. Using a slightly modified experimental setup, Doppler-free two-photon absorption spectroscopy is then performed on the 5S 1/2 → 5D 5/2 transition in rubidium, leading to accurate measurements of the hyperfine structure of the 5D 5/2 energy level. In addition, electric dipole selection rules of the two-photon transition are investigated, first by modifying the polarization of the excitation laser, and then by measuring two-photon absorption spectra when a magnetic field is applied close to the rubidium vapour. All experiments are performed with the same grating-feedback laser diode, providing an opportunity to compare different high-resolution spectroscopy methods using a single experimental setup. Such experiments may acquaint students with quantum mechanics selection rules, atomic spectra and Zeeman effect.

arXiv:0902.3115•European Journal of Physics•Jul 8, 2009•23 citations
We present what is to our knowledge the first measurement of a two-photon transition excited in Rb with a commercial diode laser. In addition to the limitation imposed by diode lasers’ characteristic low powers, their relatively large bandwidths and sensitivity to optical feedback effects impede their application to two-photon spectroscopy. However, we show that optimized signal detection and careful minimization of optical feedback with an acousto-optic modulator combined with a Faraday isolator result in good two-photon signals with an off-the-shelf diode laser.
We have performed high resolution spectroscopy of rubidium with a single mode continuous wave distributed feedback (DFB) laser diode. The saturation spectrum of the D 2 -line of 85 Rb and 87 Rb was recorded with a resolution close to the natural line width. The emission frequency was actively stabilized to Doppler-free transitions with a relative accuracy of better than 7 parts in 10 9 using commercially available servo devices only. An output power of 80 mW was sufficient to allow for two-photon spectroscopy of the 5S-5D-transition of 87 Rb. Further, we report on the spectral properties of the DFB diode, its tuning range and its frequency modulation properties. The line width of the diode laser, determined with high resolution Doppler free two photon spectroscopy, was 4 MHz without applying any active stabilization techniques. For time scales below 5 μs the line width drops below 2 MHz.
We experimentally study the high-resolution two-photon spectroscopy of rubidium using a single laser. The 5S1/2 − 5P3/2 − 5D5/2 transition is realized via 778.1 nm laser beams acting on the vapor with a counter-propagating configuration. The intensity modulation method is employed to improve the signal-to-noise ratio of the spectrum by two orders of magnitude compared with that for direct measurement. The effects of the vapor temperature, the frequency-scanning speed of the laser, the polarization combination of the laser beams, and the laser power on the spectra are investigated to obtain the optimal experimental parameters. This research is expected to be beneficial for potential applications since it can be used to realize a compact and high-precision frequency standard for optical communication.
We describe an experiment for investigating the 5S1∕2→5D5∕2 two-photon transition in rubidium using a single grating-feedback diode laser operating at 778.1nm (385THz). Continuous tuning of the laser frequency over 4GHz allows for the clear resolution of the Doppler-free spectral features and allows accurate measurement of the hyperfine ground-state splitting. A direct comparison between Doppler-broadened and Doppler-free spectral features is possible because both are distinctly evident in the two-photon spectra. By independently modifying the polarization state of the two laser fields, the impact of electric dipole selection rules on the two-photon transition spectra is investigated. This experiment is a valuable addition to the advanced undergraduate laboratory because it uses much of the same equipment as the single-photon saturated absorption spectroscopy experiment performed on the 5S1∕2→5P3∕2 transition in rubidium (λ=780.24nm) and provides students with an opportunity to investigate characteristics of atomic spectra not evident in the single-photon experiment.
The 5S1/2 --> 7S1/2 two-photon transition of atomic rubidium, which is 100 times weaker than the 5S-5D transition, is observed with an extended-cavity diode laser and a vapor cell. Signals with a signal-to-noise ratio of 280 are obtained with a laser power of 10 mW, and the observed linewidth is 3 MHz. The laser wavelength is 760 nm and is locked on the transitions to a stability of 2 x 10(-11). For the first time to our knowledge, the isotope shift of this transition is measured to be 130(4) MHz in atomic frequency.
Frequency-modulation (FM) spectroscopy has been performed on the D(2) transitions of rubidium atoms with an AlGaAs diode laser at 780 nm. Doppler-broadened hyperfine-structure transitions of (85)Rb and (87)Rb were resolved with no residual amplitude-modulation-induced background signal by modulating the injection current of the laser diode at a low frequency (20-50 MHz) compared with the Doppler width. To obtain Doppler-free spectra, we combined FM spectroscopy with saturation spectroscopy. The results show that the FM spectroscopy technique is sensitive and should be useful for high-resolution spectroscopy, although the resolution was instrument limited and unusual double peaks were observed.
In this paper, we describe two complementary nonlinear spectroscopy methods which both allow one to achieve Doppler-free spectra of atomic gases. First, saturated absorption spectroscopy is used to investigate the structure of the 5S 1/2 → 5P 3/2 transition in rubidium. Using a slightly modified experimental setup, Doppler-free two-photon absorption spectroscopy is then performed on the 5S 1/2 → 5D 5/2 transition in rubidium, leading to accurate measurements of the hyperfine structure of the 5D 5/2 energy level. In addition, electric dipole selection rules of the two-photon transition are investigated, first by modifying the polarization of the excitation laser, and then by measuring two-photon absorption spectra when a magnetic field is applied close to the rubidium vapour. All experiments are performed with the same grating-feedback laser diode, providing an opportunity to compare different high-resolution spectroscopy methods using a single experimental setup. Such experiments may acquaint students with quantum mechanics selection rules, atomic spectra and Zeeman effect.