Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physics Research International

Microcanonical Entropy of the Infinite-State Potts Model

Jonas Johansson, Mats‐Erik Pistol

Published Nov 24, 2011• 2 citations
Publisher

Abstract

In this investigation we show that the entropy of the two-dimensional infinite-state Potts model is linear in configurational energy in the thermodynamic limit. This is a direct consequence of the local convexity of the microcanonical entropy, associated with a finite system undergoing a first-order transition. For a sufficiently large number of states , this convexity spans the entire energy range of the model. In the thermodynamic limit, the convexity becomes insignificant, and the microcanonical entropy (the logarithm of the density of states) tends to a straight line. In order to demonstrate the behaviour of the convexity, we use the Wang-Landau Monte-Carlo technique to numerically calculate the density of states for a few finite but high values of . Finally, we calculate the free energy and discuss the generality of our results.

DOI
10.1155/2011/437093

Related papers

Inflection points of microcanonical entropy: Monte Carlo simulation of q state Potts model on a finite square lattice

E. Praveen, S. V. M. Satyanarayana

Traditional definition of phase transition involves an infinitely large system in thermodynamic limit. Finite systems such as biological proteins exhibit cooperative behavior similar to phase transitions. We employ recently discovered analysis of inflection points of microcanonical entropy to estimate the transition temperature of the phase transition in q state Potts model on a finite two dimensional square lattice for q=3 (second order) and q=8 (first order). The difference of energy density of states (DOS) Δ ln g(E) = ln g(E+ ΔE) −ln g(E) exhibits a point of inflexion at a value corresponding to inverse transition temperature. This feature is common to systems exhibiting both first as well as second order transitions. While the difference of DOS registers a monotonic variation around the point of inflexion for systems exhibiting second order transition, it has an S-shape with a minimum and maximum around the point of inflexion for the case of first order transition.

AIP conference proceedings•Jan 1, 2014•1 citation

Phase transitions in finite systems = topological peculiarities of the microcanonical entropy surface

D. H. E. Gross, Evgeny V. Votyakov

It is discussed how phase transitions of first order (with phase separation and surface tension), continuous transitions and (multi)-critical points can be defined and classified for finite systems from the topology of the energy surface $e^{S(E,N)}$ of the mechanical N-body phase space or more precisely of the curvature determinant $D(E,N)=\partial^2S/\partial E^2*\partial^2S/\partial N^2-(\partial^2S/\partial E\partial N)^2$ without taking the thermodynamic limit. The first calculation of the entire entropy surface $S(E,N)$ for a q=3-states Potts lattice gas on a 50*50 square lattice is shown. There are two lines, where $S(E,N)$ has a maximum curvature $\sim 0$. One is the border between the regions in \{$E,N$\} with $D(E,N)>0$ and with $D(E,N)<0$, the other line is critical starting as a valley in $D(E,N)$ running from the continuous transition in the ordinary q=3-Potts model, converting at $P_m$ into a flat ridge/plateau (maximum) deep inside the convex intruder of $S(E,N)$ which characterizes the first order liquid-gas transition. The multi-critical point $P_m$ is their crossing.

arXiv:cond-mat/9904073•Apr 6, 1999•5 citations

Continuous phase transitions with a convex dip in the microcanonical entropy

Hans Behringer, Michel Pleimling

The appearance of a convex dip in the microcanonical entropy of finite systems usually signals a first order transition. However, a convex dip also shows up in some systems with a continuous transition as, for example, in the Baxter-Wu model and in the four-state Potts model in two dimensions. We demonstrate that the appearance of a convex dip in those cases can be traced back to a finite-size effect. The properties of the dip are markedly different from those associated with a first order transition and can be understood within a microcanonical finite-size scaling theory for continuous phase transitions. Results obtained from numerical simulations corroborate the predictions of the scaling theory.

arXiv:cond-mat/0606283•Physical Review E•Jul 17, 2006•47 citations

Microcanonical Ensemble in Quantum Statistical Mechanics

Robert B. Griffiths

The infinite-volume limit of thermodynamic functions calculated in the quantum microcanonical ensemble is shown to exist for a fairly wide class of spin systems and quantum gases. The entropy is set equal to the logarithm of the number of eigenstates in an energy interval which increases linearly with the size of the system, but is otherwise arbitrary. The limiting entropy per unit volume agrees with that calculated in the canonical formalism, and possesses certain convexity properties required for thermodynamic stability. A precise criterion, in terms of the energy spectra of large systems, is given for determining the limit of the thermodynamic entropy as the temperature approaches zero. This is not determined by the degeneracy of the ground state, contrary to the discussion of the ``third law of thermodynamics'' found in some textbooks.

Journal of Mathematical Physics•Oct 1, 1965•98 citations

Normalized entropy density of the 3D 3-state Potts model

Alexei Bazavov, Bernd A. Berg

Using a multicanonical Metropolis algorithm we have performed Monte Carlo simulations of the 3D 3-state Potts model on ${L}^{3}$ lattices with $L=20$, 30, 40, 50. Covering a range of inverse temperatures from ${\ensuremath{\beta}}_{\mathrm{min}}=0$ to ${\ensuremath{\beta}}_{\mathrm{max}}=0.33$ we calculated the infinite volume limit of the entropy density $s(\ensuremath{\beta})$ with its normalization obtained from $s(0)=\mathrm{ln}3$. At the transition temperature the entropy and energy endpoints in the ordered and disordered phase are estimated employing a novel reweighting procedure. We also evaluate the transition temperature and the order-disorder interface tension. The latter estimate increases when capillary waves are taken into account.

arXiv:hep-lat/0702018•Physical review. D. Particles, fields, gravitation, and cosmology/Physical review. D. Particles and fields•May 31, 2007•15 citations

Monte Carlo study of finite-size effects at a weakly first-order phase transition

Pawel Peczak, D. P. Landau

A new kind of finite-size phenomenon in the five-state Potts model in two dimensions, a ``false'' ground state, was recently reported by Katznelson and Lauwers based on Monte Carlo studies of large lattices. We reexamine the behavior of this weakly first-order system by performing extensive Monte Carlo simulations, and demonstrate that the ``novel'' states previously observed in internal-energy-distribution histograms tend to disappear when runs of sufficient length are used. We present evidence that very strong critical slowing down and a pseudodivergent correlation length are responsible for the observed effects. Our additional analysis of finite-size effects in the ten-state Potts model on small lattices (L\ensuremath{\le}10) shows a crossover of scaling from ${L}^{\mathrm{\ensuremath{-}}d}$ behavior (observed earlier on larger lattices) to a nonanalytic form. This result is used to discuss the observed nonanalytic scaling of thermodynamic quantities in the five-state Potts model.

Physical review. B, Condensed matter•Jun 1, 1989•95 citations
In this investigation we show that the entropy of the two-dimensional infinite-state Potts model is linear in configurational energy in the thermodynamic limit. This is a direct consequence of the local convexity of the microcanonical entropy, associated with a finite system undergoing a first-order transition. For a sufficiently large number of states , this convexity spans the entire energy range of the model. In the thermodynamic limit, the convexity becomes insignificant, and the microcanonical entropy (the logarithm of the density of states) tends to a straight line. In order to demonstrate the behaviour of the convexity, we use the Wang-Landau Monte-Carlo technique to numerically calculate the density of states for a few finite but high values of . Finally, we calculate the free energy and discuss the generality of our results.
Traditional definition of phase transition involves an infinitely large system in thermodynamic limit. Finite systems such as biological proteins exhibit cooperative behavior similar to phase transitions. We employ recently discovered analysis of inflection points of microcanonical entropy to estimate the transition temperature of the phase transition in q state Potts model on a finite two dimensional square lattice for q=3 (second order) and q=8 (first order). The difference of energy density of states (DOS) Δ ln g(E) = ln g(E+ ΔE) −ln g(E) exhibits a point of inflexion at a value corresponding to inverse transition temperature. This feature is common to systems exhibiting both first as well as second order transitions. While the difference of DOS registers a monotonic variation around the point of inflexion for systems exhibiting second order transition, it has an S-shape with a minimum and maximum around the point of inflexion for the case of first order transition.
It is discussed how phase transitions of first order (with phase separation and surface tension), continuous transitions and (multi)-critical points can be defined and classified for finite systems from the topology of the energy surface eS(E,N)e^{S(E,N)}eS(E,N) of the mechanical N-body phase space or more precisely of the curvature determinant D(E,N)=∂2S/∂E2∗∂2S/∂N2−(∂2S/∂E∂N)2D(E,N)=\partial^2S/\partial E^2*\partial^2S/\partial N^2-(\partial^2S/\partial E\partial N)^2D(E,N)=∂2S/∂E2∗∂2S/∂N2−(∂2S/∂E∂N)2 without taking the thermodynamic limit. The first calculation of the entire entropy surface S(E,N)S(E,N)S(E,N) for a q=3-states Potts lattice gas on a 50*50 square lattice is shown. There are two lines, where S(E,N)S(E,N)S(E,N) has a maximum curvature ∼0\sim 0∼0. One is the border between the regions in \{E,NE,NE,N\} with D(E,N)>0D(E,N)>0D(E,N)>0 and with D(E,N)<0D(E,N)<0D(E,N)<0, the other line is critical starting as a valley in D(E,N)D(E,N)D(E,N) running from the continuous transition in the ordinary q=3-Potts model, converting at PmP_mPm​ into a flat ridge/plateau (maximum) deep inside the convex intruder of S(E,N)S(E,N)S(E,N) which characterizes the first order liquid-gas transition. The multi-critical point PmP_mPm​ is their crossing.
The appearance of a convex dip in the microcanonical entropy of finite systems usually signals a first order transition. However, a convex dip also shows up in some systems with a continuous transition as, for example, in the Baxter-Wu model and in the four-state Potts model in two dimensions. We demonstrate that the appearance of a convex dip in those cases can be traced back to a finite-size effect. The properties of the dip are markedly different from those associated with a first order transition and can be understood within a microcanonical finite-size scaling theory for continuous phase transitions. Results obtained from numerical simulations corroborate the predictions of the scaling theory.
The infinite-volume limit of thermodynamic functions calculated in the quantum microcanonical ensemble is shown to exist for a fairly wide class of spin systems and quantum gases. The entropy is set equal to the logarithm of the number of eigenstates in an energy interval which increases linearly with the size of the system, but is otherwise arbitrary. The limiting entropy per unit volume agrees with that calculated in the canonical formalism, and possesses certain convexity properties required for thermodynamic stability. A precise criterion, in terms of the energy spectra of large systems, is given for determining the limit of the thermodynamic entropy as the temperature approaches zero. This is not determined by the degeneracy of the ground state, contrary to the discussion of the ``third law of thermodynamics'' found in some textbooks.
Using a multicanonical Metropolis algorithm we have performed Monte Carlo simulations of the 3D 3-state Potts model on L3{L}^{3}L3 lattices with L=20L=20L=20, 30, 40, 50. Covering a range of inverse temperatures from ${\ensuremath{\beta}}_{\mathrm{min}}=0$ to ${\ensuremath{\beta}}_{\mathrm{max}}=0.33$ we calculated the infinite volume limit of the entropy density $s(\ensuremath{\beta})$ with its normalization obtained from s(0)=ln3s(0)=\mathrm{ln}3s(0)=ln3. At the transition temperature the entropy and energy endpoints in the ordered and disordered phase are estimated employing a novel reweighting procedure. We also evaluate the transition temperature and the order-disorder interface tension. The latter estimate increases when capillary waves are taken into account.
A new kind of finite-size phenomenon in the five-state Potts model in two dimensions, a ``false'' ground state, was recently reported by Katznelson and Lauwers based on Monte Carlo studies of large lattices. We reexamine the behavior of this weakly first-order system by performing extensive Monte Carlo simulations, and demonstrate that the ``novel'' states previously observed in internal-energy-distribution histograms tend to disappear when runs of sufficient length are used. We present evidence that very strong critical slowing down and a pseudodivergent correlation length are responsible for the observed effects. Our additional analysis of finite-size effects in the ten-state Potts model on small lattices (L\ensuremath{\le}10) shows a crossover of scaling from ${L}^{\mathrm{\ensuremath{-}}d}$ behavior (observed earlier on larger lattices) to a nonanalytic form. This result is used to discuss the observed nonanalytic scaling of thermodynamic quantities in the five-state Potts model.