Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Quantum Electronics

Dynamic properties of transverse-magnetic wave injected semiconductor lasers

Yoshihiro Mori

Published Jan 1, 1991• 10 citations
Publisher

Abstract

Dynamic responses of optical polarization bistability and self-sustained pulsation in transverse-magnetic (TM) wave injected semiconductor lasers are analyzed. Due to the TM wave injection, laser amplification of TM wave and laser oscillation in the transverse-electric (TE) mode simultaneously occurs in the laser. The calculated dynamic responses of optical polarization bistability are compared with measured responses. The upper limit of the switching time and the repetition frequency are clarified from calculations. The self-sustained pulsation triggered by a change of TM input power is found in the course of the calculation. The conditions needed for the pulsation are discussed.>

DOI
10.1109/3.100880

Related papers

Optical polarization bistability in TM wave injected semiconductor lasers

Yoshihiro Mori, J. Shibati, Takao Kajiwara

Experimental results of optical polarization bistability in InGaAsP lasers are reported and the causes of polarization switching and nonlinear response in this bistability are discussed. The input light signal consisted of the transverse magnetic (TM) wave, while the semiconductor lasers operated in a fundamental transverse electric (TE) mode when the light input was not injected. The light output versus light input characteristics were dependent on the input wavelength. Switching times of up to a few hundred picoseconds were achieved for both switch-up and switch-down. It was found that the TE and TM outputs originate from the TE oscillation and the TM amplification, respectively. Calculations using the rate equations showed that the TM input induces the nonlinearity of the carrier density. These results indicate that this bistability is a type of dispersive bistability.>

IEEE Journal of Quantum Electronics•Mar 1, 1989•22 citations

Polarization optical bistability induced by TM mode injection to a DFB laser with complex coupled coefficient

C.-X. Shi

A novel method is proposed to produce an optical bistability by using a dynamically stable complex coupled DFB (CC-DFB) laser with TM mode injection. In this paper polarization optical bistabilities are analyzed in detail using coupled mode equations and rate equations for the CC-DFB lasers considering the longitudinal hole burning and carrier dependent complex coupling coefficients. Several parameters reflecting the physical features of a complex coupled DFB laser are discussed. It is shown that for a CC-DFB laser the polarization bistability induced by the TM mode injection is much stronger for the antiphase of complex coupling than that for the in-phase. In addition, the influences of initial coupling condition for gain grating structure on the optical bistability are also investigated considering both cases of the antiphase and in-phase.

Journal of Lightwave Technology•Apr 1, 1996•0 citations

Instabilities in passive and active optical systems with a Gaussian transverse intensity profile

L. A. Lugiato, R. J. Horowicz, G. Strini +1 more

In this paper we analyze the steady-state and stability properties of bistable optical systems, lasers with an injected signal, and ordinary free-running lasers. The starting point of our study is a unified model of a ring cavity containing a finite-size cylindrical sample of homogeneously broadened two-level atoms, and capable of supporting a single field mode with a Gaussian transverse profile. After solving the equations of motion in the steady state, we carry out a linear stability analysis of the stationary solutions, identify the domains of unstable operation of each of the three systems, and compare in detail the results of this work with those of earlier plane-wave uniform-field calculations. In the case of the laser with an injected signal, we find a significant enhancement of the instability domain relative to the plane-wave limit. A similar conclusion holds for mixed absorptive and dispersive optical bistability, although the enhancement of the domain of instability is less pronounced. Unstable behavior is predicted to occur for experimentally accessible values of the bistability parameter, and to be favored by the absence of bistability and by the selection of atomic and cavity detunings having opposite signs. This configuration ensures that the instability will be responsible for the emergence of undamped output pulsations of the type that will make the bistable system behave as an optical clock.

Physical Review A•Sep 1, 1984•47 citations

Static and dynamical properties of dispersive optical bistability in semiconductor lasers

Rongqing Hui

Static and dynamic properties of dispersive optical bistability (OB) in semiconductor lasers biased from below to above threshold has been investigated both theoretically and experimentally. The OB result is found to be varied continuously from below to above threshold. Although conventionally the OB switch-off time in dispersive semiconductor laser amplifiers is limited by the effective carrier lifetime, a much faster OB switch-off can be obtained when a laser diode operates well above threshold in the injection-locked condition.>

Journal of Lightwave Technology•Jan 1, 1995•21 citations

Dynamics of optically switched bistable laser diodes in the injection-locked state

Rongqing Hui, A. Paradisi, Sergio Benedetto +1 more

The dynamical properties of dispersive optical bistability in a semiconductor laser biased from below to above threshold are investigated both experimentally and theoretically. The optical bistability switch-off time is found to decrease continuously from below to above threshold. A fast switch-off in less than 100 ps has been observed when the laser operates in the injection-locked condition.

Optics Letters•Oct 15, 1993•17 citations

Effects of TE–TM splitting on bistability and nonlinear spin dynamics in resonantly driven spinor exciton-polaritons

Szu-Cheng Cheng, Ting-Wei Chen

We investigate the influence of transverse-electric–transverse-magnetic (TE–TM) splitting on the nonlinear response and bistability of resonantly driven spinor exciton-polaritons in a spatially homogeneous microcavity system. Using a coupled exciton–photon mean-field model, we find that TE–TM splitting significantly modifies the bistability threshold, hysteresis width, and spin composition of the steady states. In particular, TE–TM splitting counteracts the spin imbalance imposed by elliptically polarized pumping, leading to nearly equal populations of the two spin components and strongly suppressed degree of circular polarization in the steady state. The pump momentum plays a crucial role through its connection to the curvature of the lower polariton dispersion, resulting in distinct nonlinear regimes with different switching thresholds and dynamical responses. The intermediate branch within the hysteresis loop is unstable but may exhibit slow instability growth rates, giving rise to long-lived transient states. These results clarify how TE–TM splitting reshapes bistability and nonlinear spin dynamics in polariton systems and provide insight into the controlling polariton switching behavior through cavity anisotropy and pump parameters.

Journal of the Optical Society of America B•May 1, 2026•0 citations
Dynamic responses of optical polarization bistability and self-sustained pulsation in transverse-magnetic (TM) wave injected semiconductor lasers are analyzed. Due to the TM wave injection, laser amplification of TM wave and laser oscillation in the transverse-electric (TE) mode simultaneously occurs in the laser. The calculated dynamic responses of optical polarization bistability are compared with measured responses. The upper limit of the switching time and the repetition frequency are clarified from calculations. The self-sustained pulsation triggered by a change of TM input power is found in the course of the calculation. The conditions needed for the pulsation are discussed.>
Experimental results of optical polarization bistability in InGaAsP lasers are reported and the causes of polarization switching and nonlinear response in this bistability are discussed. The input light signal consisted of the transverse magnetic (TM) wave, while the semiconductor lasers operated in a fundamental transverse electric (TE) mode when the light input was not injected. The light output versus light input characteristics were dependent on the input wavelength. Switching times of up to a few hundred picoseconds were achieved for both switch-up and switch-down. It was found that the TE and TM outputs originate from the TE oscillation and the TM amplification, respectively. Calculations using the rate equations showed that the TM input induces the nonlinearity of the carrier density. These results indicate that this bistability is a type of dispersive bistability.>
A novel method is proposed to produce an optical bistability by using a dynamically stable complex coupled DFB (CC-DFB) laser with TM mode injection. In this paper polarization optical bistabilities are analyzed in detail using coupled mode equations and rate equations for the CC-DFB lasers considering the longitudinal hole burning and carrier dependent complex coupling coefficients. Several parameters reflecting the physical features of a complex coupled DFB laser are discussed. It is shown that for a CC-DFB laser the polarization bistability induced by the TM mode injection is much stronger for the antiphase of complex coupling than that for the in-phase. In addition, the influences of initial coupling condition for gain grating structure on the optical bistability are also investigated considering both cases of the antiphase and in-phase.
In this paper we analyze the steady-state and stability properties of bistable optical systems, lasers with an injected signal, and ordinary free-running lasers. The starting point of our study is a unified model of a ring cavity containing a finite-size cylindrical sample of homogeneously broadened two-level atoms, and capable of supporting a single field mode with a Gaussian transverse profile. After solving the equations of motion in the steady state, we carry out a linear stability analysis of the stationary solutions, identify the domains of unstable operation of each of the three systems, and compare in detail the results of this work with those of earlier plane-wave uniform-field calculations. In the case of the laser with an injected signal, we find a significant enhancement of the instability domain relative to the plane-wave limit. A similar conclusion holds for mixed absorptive and dispersive optical bistability, although the enhancement of the domain of instability is less pronounced. Unstable behavior is predicted to occur for experimentally accessible values of the bistability parameter, and to be favored by the absence of bistability and by the selection of atomic and cavity detunings having opposite signs. This configuration ensures that the instability will be responsible for the emergence of undamped output pulsations of the type that will make the bistable system behave as an optical clock.
Static and dynamic properties of dispersive optical bistability (OB) in semiconductor lasers biased from below to above threshold has been investigated both theoretically and experimentally. The OB result is found to be varied continuously from below to above threshold. Although conventionally the OB switch-off time in dispersive semiconductor laser amplifiers is limited by the effective carrier lifetime, a much faster OB switch-off can be obtained when a laser diode operates well above threshold in the injection-locked condition.>
We investigate the influence of transverse-electric–transverse-magnetic (TE–TM) splitting on the nonlinear response and bistability of resonantly driven spinor exciton-polaritons in a spatially homogeneous microcavity system. Using a coupled exciton–photon mean-field model, we find that TE–TM splitting significantly modifies the bistability threshold, hysteresis width, and spin composition of the steady states. In particular, TE–TM splitting counteracts the spin imbalance imposed by elliptically polarized pumping, leading to nearly equal populations of the two spin components and strongly suppressed degree of circular polarization in the steady state. The pump momentum plays a crucial role through its connection to the curvature of the lower polariton dispersion, resulting in distinct nonlinear regimes with different switching thresholds and dynamical responses. The intermediate branch within the hysteresis loop is unstable but may exhibit slow instability growth rates, giving rise to long-lived transient states. These results clarify how TE–TM splitting reshapes bistability and nonlinear spin dynamics in polariton systems and provide insight into the controlling polariton switching behavior through cavity anisotropy and pump parameters.