Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Quantum Electronics

Trivalent-iron-doped andalusite as crystal for microwave waves

I. I. Eru, S. A. Peskovatskiǐ, A. Chernets

Published Nov 1, 1968• 12 citations
Publisher

Abstract

Paramagnetic ions Fe3+, substituted as an impurity in andalusite (Al2SiO5) host crystals, have been experimentally investigated. The spin-lattice relaxation and cross-relaxation times and inversion ratio in this spin system were observed. Dielectric properties of the host crystals were determined. General maser properties of trivalent-iron-doped andalusite crystal are discussed. Two types of the andalusite cavity masers are described. TheX-band three-level maser operates at a temperature of 2.1°K and a magnetic field of 1400 gauss. Electronic gains of 25 dB and instantaneous bandwidth of 3.5 \pm 0.5 MHz, at the frequency of 9.45 GHz, were obtained. TheF-band push-pull maser operates at a temperature of 2.1°K and a magnetic field of 2800 gauss. Electronic gains of 30 dB and instantaneous bandwidth of 5.5 ± 0.5 MHZ, at the frequency of 100.4 GHz, were obtained.

DOI
10.1109/jqe.1968.1074969

Related papers

An 81-Gc/s zero-field maser

W.E. Hughes, C.R. Kremenek

A zero magnetic field millimeter maser is described which uses the iron ion Fe3+in a host crystalline structure of rutile, TiO2, as the active material. The maser operates as a classical three-level maser [1] between three doubly degenerate zero-field spin levels of the iron ion at a frequency of 81.3 Gc/s and is pumped at a frequency of 124.5 Gc/s. Net gain in excess of 20 dB with instantaneous bandwidths of 3-6 Mc/s have been obtained in a dielectric cavity type configuration.

Proceedings of the IEEE•Jan 1, 1966•0 citations

Use of Active Material in Three-Level Solid State Masers*

E. O. Schulz-DuBois, H. E. D. Scovil, R. W. DeGrasse

The three-level excitation method for solid state masers, including some background material on paramagnetic resonance, is reviewed. With respect to the experimental application of the maser material, two cases can be distinguished, In the first, maser action is based mainly on a favorable relaxation time ratio in signal and idler transitions. It is shown that the relaxation time ratio can be changed artificially by a doping technique. Experimental evidence is presented for two such doping techniques, one self-doping, the other impurity doping. In the second case, maser action is based primarily on a favorable frequency ratio of signal and idler transitions. Maser experiments using this approach are described. In addition, excitation of unidirectional gain and attenuation by circular polarization is discussed. Properties of practical isolator materials are surveyed; they include high-concentration paramagnetic and polycryslolline ferrimagnetic materials.

Bell System Technical Journal•Mar 1, 1959•25 citations

Fe3+ paramagnetic ion in α-Al2 O3 energy levels revisited. Application to a 31 GHz Maser proposal

M. Mrad, P.Y. Bourgeois, Y. Kersalé +1 more

The molecular structure of a 3d 5 configuration ion in a trigonal ligand field is theoretically established on the basis of the 252\times252 complete energy matrice. The optical absorption and the electron paramagnetic resonance spectra of the Fe3+ ion in the sapphire crystal (α-Al2 O3) have been studied by diagonalizing the complete energy matrice. The calculated results are in very good agreement with previous experimental observations. The strength of the transition probabilities between pairs of the energy levels have been calculated to determine the possibility to achieve a population inversion in the ground state by applying optical pumping to the crystal. Preliminary results based on the computed transition parameters and on the maser rate equations model show that a 31 GHz maser signal can be effectively generated depending on the cryogenic resonator design.

arXiv:1201.1760•Jan 9, 2012•1 citation

Performance analysis of diamond-based masers

Alexander Sherman, Lotem Buchbinder, Siyuan Ding +1 more

Masers, the microwave analog of lasers, are an important class of devices that can be used to generate highly coherent and stable microwave signals as well as quantum-limited amplification of microwave photons. Recently, the interest in such devices has increased, probably owing to experiments demonstrating the successful operation at room temperature of solid-state maser employing defects in diamond. These defects, called nitrogen vacancy (NV) centers, are comprised of a negatively charged substitutional nitrogen that replaces one of the diamond crystal lattice’s carbons and a vacancy adjacent to the excluded carbon atom. The performance of diamond-based masers, in terms of gain, noise, bandwidth, frequency of operation, and saturation, greatly depends upon the specific diamond crystal composition and its geometry in the respective microwave device. The currently available data on these issues are scarce and sometimes conflicting. It is, therefore, important to provide additional experimental data, complemented by theoretical analysis, to further optimize the required diamond material and thus enhance the capabilities of diamond-based maser technology. The latter is currently limited to operate only as an oscillator at very small bandwidths, with low saturation power. Here, we provide experimental results on a set of important parameters affecting diamond maser operation, such as the population and linewidth of the electron spin energy levels of the NVs under light illumination, as well as their relaxation times for several different diamond material compositions. These results are then used to point out which diamond material compositions and crystal geometry may be best suitable for maser-type applications.

Journal of Applied Physics•Apr 14, 2021•9 citations

Generation of bimodal solitons in a sapphire whispering-gallery-mode maser at millikelvin temperatures

Catriona A. Thomson, Michael Edmund Tobar, Maxim Goryachev

We present experimental observations of bimodal solitons in a solid state three-level maser cooled to millikelvin temperatures. The maser is built on a highly dilute ${\text{Fe}}^{3+}$ spin ensemble hosted by a high-purity ${\text{Al}}_{2}{\text{O}}_{3}$ crystal constituting a high-quality factor whispering-gallery-mode resonator. The maser is pumped through one of these modes, near 31 GHz, generating two signals near 12.04 GHz from two distinct modes, 8 MHz apart. The system demonstrates three regimes, namely, a continuous-wave regime, a dense soliton regime, and a sparse soliton regime. These results open other avenues for studying nonlinear wave phenomena using microwave systems as well as different applications of solitons in this part of the electromagnetic spectrum.

arXiv:2105.11180•Physical Review A•Mar 17, 2022•2 citations

Spin-lattice relaxation and the calculation of gain, pump power, and noise temperature in ruby

J. R. Lyons

The use of a quantitative analysis of the dominant source of relaxation in ruby spin systems to make predictions of key maser amplifier parameters is described. The spin-lattice Hamiltonian which describes the interaction of the electron spins with the thermal vibrations of the surrounding lattice is obtained from the literature. Taking into account the vibrational anisotropy of ruby, Fermi's rule is used to calculate the spin transition rates between the maser energy levels. The spin population rate equations are solved for the spin transition relaxation times, and a comparison with previous calculations is made. Predictions of ruby gain, inversion ratio, and noise temperature as a function of physical temperature are made for 8.4-GHz and 32-GHz maser pumping schemes. The theory predicts that ruby oriented at 90 deg will have approximately 50 percent higher gain in dB and slightly lower noise temperature than a 54.7-deg ruby at 32 GHz (assuming pump saturation). A specific calculation relating pump power to inversion ratio is given for a single channel of the 32-GHz reflected wave maser.

•Aug 15, 1989•4 citations
Paramagnetic ions Fe3+, substituted as an impurity in andalusite (Al2SiO5) host crystals, have been experimentally investigated. The spin-lattice relaxation and cross-relaxation times and inversion ratio in this spin system were observed. Dielectric properties of the host crystals were determined. General maser properties of trivalent-iron-doped andalusite crystal are discussed. Two types of the andalusite cavity masers are described. TheX-band three-level maser operates at a temperature of 2.1°K and a magnetic field of 1400 gauss. Electronic gains of 25 dB and instantaneous bandwidth of 3.5 \pm 0.5 MHz, at the frequency of 9.45 GHz, were obtained. TheF-band push-pull maser operates at a temperature of 2.1°K and a magnetic field of 2800 gauss. Electronic gains of 30 dB and instantaneous bandwidth of 5.5 ± 0.5 MHZ, at the frequency of 100.4 GHz, were obtained.
The three-level excitation method for solid state masers, including some background material on paramagnetic resonance, is reviewed. With respect to the experimental application of the maser material, two cases can be distinguished, In the first, maser action is based mainly on a favorable relaxation time ratio in signal and idler transitions. It is shown that the relaxation time ratio can be changed artificially by a doping technique. Experimental evidence is presented for two such doping techniques, one self-doping, the other impurity doping. In the second case, maser action is based primarily on a favorable frequency ratio of signal and idler transitions. Maser experiments using this approach are described. In addition, excitation of unidirectional gain and attenuation by circular polarization is discussed. Properties of practical isolator materials are surveyed; they include high-concentration paramagnetic and polycryslolline ferrimagnetic materials.
The molecular structure of a 3d 5 configuration ion in a trigonal ligand field is theoretically established on the basis of the 252\times252 complete energy matrice. The optical absorption and the electron paramagnetic resonance spectra of the Fe3+ ion in the sapphire crystal (α-Al2 O3) have been studied by diagonalizing the complete energy matrice. The calculated results are in very good agreement with previous experimental observations. The strength of the transition probabilities between pairs of the energy levels have been calculated to determine the possibility to achieve a population inversion in the ground state by applying optical pumping to the crystal. Preliminary results based on the computed transition parameters and on the maser rate equations model show that a 31 GHz maser signal can be effectively generated depending on the cryogenic resonator design.
Masers, the microwave analog of lasers, are an important class of devices that can be used to generate highly coherent and stable microwave signals as well as quantum-limited amplification of microwave photons. Recently, the interest in such devices has increased, probably owing to experiments demonstrating the successful operation at room temperature of solid-state maser employing defects in diamond. These defects, called nitrogen vacancy (NV) centers, are comprised of a negatively charged substitutional nitrogen that replaces one of the diamond crystal lattice’s carbons and a vacancy adjacent to the excluded carbon atom. The performance of diamond-based masers, in terms of gain, noise, bandwidth, frequency of operation, and saturation, greatly depends upon the specific diamond crystal composition and its geometry in the respective microwave device. The currently available data on these issues are scarce and sometimes conflicting. It is, therefore, important to provide additional experimental data, complemented by theoretical analysis, to further optimize the required diamond material and thus enhance the capabilities of diamond-based maser technology. The latter is currently limited to operate only as an oscillator at very small bandwidths, with low saturation power. Here, we provide experimental results on a set of important parameters affecting diamond maser operation, such as the population and linewidth of the electron spin energy levels of the NVs under light illumination, as well as their relaxation times for several different diamond material compositions. These results are then used to point out which diamond material compositions and crystal geometry may be best suitable for maser-type applications.
We present experimental observations of bimodal solitons in a solid state three-level maser cooled to millikelvin temperatures. The maser is built on a highly dilute Fe3+{\text{Fe}}^{3+}Fe3+ spin ensemble hosted by a high-purity Al2O3{\text{Al}}_{2}{\text{O}}_{3}Al2​O3​ crystal constituting a high-quality factor whispering-gallery-mode resonator. The maser is pumped through one of these modes, near 31 GHz, generating two signals near 12.04 GHz from two distinct modes, 8 MHz apart. The system demonstrates three regimes, namely, a continuous-wave regime, a dense soliton regime, and a sparse soliton regime. These results open other avenues for studying nonlinear wave phenomena using microwave systems as well as different applications of solitons in this part of the electromagnetic spectrum.
The use of a quantitative analysis of the dominant source of relaxation in ruby spin systems to make predictions of key maser amplifier parameters is described. The spin-lattice Hamiltonian which describes the interaction of the electron spins with the thermal vibrations of the surrounding lattice is obtained from the literature. Taking into account the vibrational anisotropy of ruby, Fermi's rule is used to calculate the spin transition rates between the maser energy levels. The spin population rate equations are solved for the spin transition relaxation times, and a comparison with previous calculations is made. Predictions of ruby gain, inversion ratio, and noise temperature as a function of physical temperature are made for 8.4-GHz and 32-GHz maser pumping schemes. The theory predicts that ruby oriented at 90 deg will have approximately 50 percent higher gain in dB and slightly lower noise temperature than a 54.7-deg ruby at 32 GHz (assuming pump saturation). A specific calculation relating pump power to inversion ratio is given for a single channel of the 32-GHz reflected wave maser.