Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Metrologia

Josephson tunnel junctions as highly sensitive photodetectors for radiometry

E. Monticone, V. Lacquaniti, M. Rajteri, Maria Luisa Rastello

Published Aug 1, 1998• 1 citation
Publisher

Abstract

Josephson tunnel junctions have recently proved to be fairly sensitive photodetectors over a broad range of wavelengths. This paper shows the results obtained with Nb/Al-AlO x /Nb Josephson junctions at 4.2 K irradiated via an optical fibre and laser light at λ = 633 nm and 690 nm. The responsivity of the devices is about 50 V/W and is linear over several decades. Moreover, stacks of two Josephson junctions are shown to have twice the responsivity of a single junction. A thermal model of the device is considered and the responsivity is calculated as a function of the temperature derivative of the energy gap, the thermal parameters of the junction, and the modulation frequency of the incident beam.

DOI
10.1088/0026-1394/35/4/29

Related papers

Analysis of NB Josephson Junction Properties under Optical Irradiation

E. Monticone, M. Rajteri, Sabino Maggi +6 more

The gap voltage shift of Nb Josephson junctions fabricated on different substrates is measured under optical illumination at several conditions of light intensity and chopping frequency. The signal dependence on the chopping frequency for junctions realized on glass substrates is bolometer-like with a strong thermal coupling between film and substrate. The responsivity of a junction of 50 μ m × 20 μ m is 50 V/W in vacuum and at liquid helium temperature, and its time constant is lower than 10 μ s . The linearity of the response on the optical power extends over five order of magnitude. The response of junctions fabricated on silicon substrates is flat versus the chopping frequency and about 100 times lower than a junction on glass with the same incident optical power. The shift of the gap at temperatures between 1.2 K and 4.2 K has been measured to separate the nonequilibrium effects from the heating effects.

International Journal of Modern Physics B•Apr 20, 1999•1 citation

NbN–Nb–Al superconducting tunnel junctions as photon counting detectors

N. Rando, P. Verhoeve, A. Poelaert +2 more

Asymmetric NbN–Nb–Al–AlOx-Al–Nb superconducting tunnel junctions have been investigated as photon counting detectors at x-ray and ultraviolet (UV)-visible wavelengths. The inclusion of a thin NbN passivation layer on the top electrode of the devices in place of the natural niobium oxides has reduced the quasiparticle loss rates, thereby enhancing the probability of multiple tunnel processes. As a consequence, the detector responsivity has increased from 900e−/eV, up to values in excess of 2000e−/eV in the temperature range 0.3–0.8 K. Such a responsivity level has allowed single photon counting performance at wavelengths as long as 700 nm and at operating temperatures as high as 830 mK. The devices show a linear response in the UV-visible range, while at 6 keV the expected nonlinearities in the energy response and moderate energy resolution similar to that found in Nb–Al junctions are observed.

Journal of Applied Physics•May 15, 1998•10 citations

Stacked niobium Josephson junction arrays under x-band irradiation

Alexander M. Klushin, S. Schornstein, H. Kohlstedt +3 more

Stacked Josephson junction arrays located at the rf current antinodes of a superconducting microstripline resonator were investigated. The circuits were designed to obtain highly accurate voltages at cm-waveband microwave driving and low rf-power level. Nb-Al/AlO/sub x/-Nb Josephson junctions with tunneling area of 60 /spl mu/m/spl times/300 /spl mu/m and critical current density up to 7 A/cm/sup 2/ were used. We compared the average voltages of the rf induced maximal current steps in arrays with up to three junctions per stack. Quantized current steps up to 300 mV were observed under microwave irradiation at frequency of 19.20 GHz in circuits with 384 three-junction stacks. The dynamics of stacked tunnel junctions in the presence of rf-currents will be discussed with respect to application as voltage standards.

IEEE Transactions on Applied Superconductivity•Jun 1, 1997•6 citations

Response of Nb-aSi-Nb junctions to 604 GHz radiation

W. C. Danchi, John U. Free, F. Habbal +2 more

We have measured the response of Nb-aSi-Nb junctions to 604 GHz radiation from an optically pumped far-infrared (FIR) laser source. These rugged and thermally cyclable junctions situated at the midpoint of 180 μm long dipole antennas, were fabricated on oxidized silicon wafers using the Selective Niobium Anodization Process (SNAP). Josephson current densities were\sim 9,000A/cm2, the McCumber parameters βcwere ∼3.5, and the Josephson plasma frequencies\omega_{J}\sim2.5\times10^{12}. On a junction with a normal state resistance of\sim7\Omega, we observed three Josephson steps and one photon-assisted tunneling step. The widths of the Josephson steps were studied as a function of the laser power. An RSJ model computer simulation with a nonlinear quasiparticle conductance and an rf current bias (assumed because of the low junction resistance) is able to account reasonably well for the laser-power dependence of the critical current (zeroth step) and the second step. However, the temperature dependence is more complex, and a discrepancy still exists between the RSJ model calculation and the data for the hysteretic first step.

IEEE Transactions on Magnetics•Mar 1, 1985•3 citations

High quality Nb-AlO/sub x/-Nb junctions for microwave receivers and SFQ logic device

V. P. Koshelets, Sergey Kovtonyuk, I. L. Serpuchenko +2 more

The specific capacitance of high-quality (V/sub m/>50 mV) Nb-AlO/sub x/-Nb tunnel junctions is determined by the following methods: the measurement of zero field step resonances in specially prepared long Josephson junctions, and the definition of the resonant voltages in two-junction interferometers based on Nb-AlO/sub x/-Nb junctions. The results obtained by these methods were compared with each other and with the figures calculated from the measurements of tunnel barrier parameters. The application of the procedure for the fabrication of single flux quantum (SFQ) logic devices is discussed.

IEEE Transactions on Magnetics•Mar 1, 1991•36 citations

Niobium Josephson junction bolometers for optical detection in the visible-infrared region

E. Monticone, V. Lacquaniti, R. Steni +4 more

The response of Nb Josephson junctions fabricated on different substrates, silicon and amorphous glass, is measured under optical illumination at several conditions of light intensity and light chopping frequency. The linearity of the response on the optical power extends over five orders of magnitude. The signal of the junction on silicon is 2 orders of magnitude lower than that of the junction on amorphous glass, but at least one order of magnitude faster, as the time constant of a directly irradiated junction on silicon is lower than 10 /spl mu/s. The signal dependence on chopping frequency of the junction on amorphous glass is typical of a strong thermal coupling between film and substrate, while for the junction on silicon it depends mainly on the thermal boundary resistance between film and substrate.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•4 citations
Josephson tunnel junctions have recently proved to be fairly sensitive photodetectors over a broad range of wavelengths. This paper shows the results obtained with Nb/Al-AlO x /Nb Josephson junctions at 4.2 K irradiated via an optical fibre and laser light at λ = 633 nm and 690 nm. The responsivity of the devices is about 50 V/W and is linear over several decades. Moreover, stacks of two Josephson junctions are shown to have twice the responsivity of a single junction. A thermal model of the device is considered and the responsivity is calculated as a function of the temperature derivative of the energy gap, the thermal parameters of the junction, and the modulation frequency of the incident beam.
The gap voltage shift of Nb Josephson junctions fabricated on different substrates is measured under optical illumination at several conditions of light intensity and chopping frequency. The signal dependence on the chopping frequency for junctions realized on glass substrates is bolometer-like with a strong thermal coupling between film and substrate. The responsivity of a junction of 50 μ m × 20 μ m is 50 V/W in vacuum and at liquid helium temperature, and its time constant is lower than 10 μ s . The linearity of the response on the optical power extends over five order of magnitude. The response of junctions fabricated on silicon substrates is flat versus the chopping frequency and about 100 times lower than a junction on glass with the same incident optical power. The shift of the gap at temperatures between 1.2 K and 4.2 K has been measured to separate the nonequilibrium effects from the heating effects.
Asymmetric NbN–Nb–Al–AlOx-Al–Nb superconducting tunnel junctions have been investigated as photon counting detectors at x-ray and ultraviolet (UV)-visible wavelengths. The inclusion of a thin NbN passivation layer on the top electrode of the devices in place of the natural niobium oxides has reduced the quasiparticle loss rates, thereby enhancing the probability of multiple tunnel processes. As a consequence, the detector responsivity has increased from 900e−/eV, up to values in excess of 2000e−/eV in the temperature range 0.3–0.8 K. Such a responsivity level has allowed single photon counting performance at wavelengths as long as 700 nm and at operating temperatures as high as 830 mK. The devices show a linear response in the UV-visible range, while at 6 keV the expected nonlinearities in the energy response and moderate energy resolution similar to that found in Nb–Al junctions are observed.
Stacked Josephson junction arrays located at the rf current antinodes of a superconducting microstripline resonator were investigated. The circuits were designed to obtain highly accurate voltages at cm-waveband microwave driving and low rf-power level. Nb-Al/AlO/sub x/-Nb Josephson junctions with tunneling area of 60 /spl mu/m/spl times/300 /spl mu/m and critical current density up to 7 A/cm/sup 2/ were used. We compared the average voltages of the rf induced maximal current steps in arrays with up to three junctions per stack. Quantized current steps up to 300 mV were observed under microwave irradiation at frequency of 19.20 GHz in circuits with 384 three-junction stacks. The dynamics of stacked tunnel junctions in the presence of rf-currents will be discussed with respect to application as voltage standards.
We have measured the response of Nb-aSi-Nb junctions to 604 GHz radiation from an optically pumped far-infrared (FIR) laser source. These rugged and thermally cyclable junctions situated at the midpoint of 180 μm long dipole antennas, were fabricated on oxidized silicon wafers using the Selective Niobium Anodization Process (SNAP). Josephson current densities were\sim 9,000A/cm2, the McCumber parameters βcwere ∼3.5, and the Josephson plasma frequencies\omega_{J}\sim2.5\times10^{12}. On a junction with a normal state resistance of\sim7\Omega, we observed three Josephson steps and one photon-assisted tunneling step. The widths of the Josephson steps were studied as a function of the laser power. An RSJ model computer simulation with a nonlinear quasiparticle conductance and an rf current bias (assumed because of the low junction resistance) is able to account reasonably well for the laser-power dependence of the critical current (zeroth step) and the second step. However, the temperature dependence is more complex, and a discrepancy still exists between the RSJ model calculation and the data for the hysteretic first step.
The specific capacitance of high-quality (V/sub m/>50 mV) Nb-AlO/sub x/-Nb tunnel junctions is determined by the following methods: the measurement of zero field step resonances in specially prepared long Josephson junctions, and the definition of the resonant voltages in two-junction interferometers based on Nb-AlO/sub x/-Nb junctions. The results obtained by these methods were compared with each other and with the figures calculated from the measurements of tunnel barrier parameters. The application of the procedure for the fabrication of single flux quantum (SFQ) logic devices is discussed.
The response of Nb Josephson junctions fabricated on different substrates, silicon and amorphous glass, is measured under optical illumination at several conditions of light intensity and light chopping frequency. The linearity of the response on the optical power extends over five orders of magnitude. The signal of the junction on silicon is 2 orders of magnitude lower than that of the junction on amorphous glass, but at least one order of magnitude faster, as the time constant of a directly irradiated junction on silicon is lower than 10 /spl mu/s. The signal dependence on chopping frequency of the junction on amorphous glass is typical of a strong thermal coupling between film and substrate, while for the junction on silicon it depends mainly on the thermal boundary resistance between film and substrate.