Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Letters

Optical gain exceeding 35 dB at 156 μm due to stimulated Raman scattering by molecular D_2 in a solid silica optical fiber

ANDREW R. CHRAPLYVY, J. Stone, CHARLES A. BURRUS

Published Jul 1, 1983• 32 citations
Publisher

Abstract

A stimulated-Raman-gain medium at 1.56-microm wavelength, consisting of molecular deuterium dissolved in low-loss silica optical fiber and pumped by 1.06-microm Nd:YAG laser light, is described. In a 100-m-long fiber with pump power of 130 W, InGaAsP injection-laser probe light at 1.56 microm was amplified by a factor of 4000 to an output power of 150 mW. The measured stimulated-Raman-gain coefficient at 1.56 microm is 7 x 10(-12) cm/W, about equal to the Raman gain of SiO(2) at the same wavelength.

DOI
10.1364/ol.8.000415

Related papers

Efficient optical amplifier using a low-concentration erbium-doped fiber

Nobuyuki Kagi, Akira Oyobe, K. Nakamura

A gain coefficient of 3.8 dB/mW was achieved for an erbium-doped fiber amplifier pumped by a 1.48 mu m laser diode. The main reasons for the improvement are high NA (0.23) and low concentration (43 p.p.m.). Pump-to-signal energy conversion efficiency was 18% at 3 dB gain compression. A decrease in saturation power with increasing erbium concentration was also demonstrated. In high-concentration fiber, fluorescence at 0.98 mu m due to cooperative upconversion was detected. These results indicate that several kilometers of distributed fiber amplifier with high gain and high output saturation power could be possible, because the absorption coefficient at 1.48 mu m is still two orders higher than the background loss in the 43 p.p.m. fiber.>

IEEE Photonics Technology Letters•Aug 1, 1990•32 citations

Optical switch based on stimulated Raman scattering

Ariel Flores-Rosas, Evgeny A. Kuzin, B. Ibarra-Escamilla +2 more

We investigate optical switching based on stimulated Raman scattering. The circuit consists of two fiber stages connected in series through a bandpass filter. When the pump and signal are launched to the input, the pump is saturated because of the signal amplification in the first stage; the amplified signal is rejected by the filter, so that only low-power pump enters the second stage; and no signal pulses appear at the output. The second stage is fed by 1 mW power at signal wavelength. When the pump only enters at the input, it passes through the first stage without saturation, enters the second stage, and amplifies the signal entering this stage; strong signal pulses appear at the output. We use 2-ns pump pulses at 1528 nm and cw signal at 1620 nm. In the first stage, we use both fibers with normal and anomalous dispersion. In fibers with anomalous dispersion, pump saturation is affected by modulation instability. We find that the contrast may be improved using fibers with normal and anomalous dispersion connected in series in the first stage, provided there is appropriate selection of their lengths. The best contrast we achieve is 15 dB at 6 W pump peak power.

Optical Engineering•Mar 29, 2011•1 citation

Raman gain measurement in solid parahydrogen

M. Katsuragawa, K. Hakuta

We report a steady-state Raman gain measurement of the Q(1)(0) transition (v = 1 ? 0, J = 0 ? 0) in solid parahydrogen. We carry out measurements by pumping with a continuous-wave frequency-doubled YAG laser at 532 nm and observing the direct amplification of a probe-laser beam for the first Stokes transition at 683 nm. A large single-pass amplification coefficient of 2.3 +/- 0.2 is obtained at a pump intensity of 46 kW/cm(2), with an interaction length of 1 cm, giving a steady-state Raman gain coefficient of 18 +/- 3 cm/MW.

Optics Letters•Feb 1, 2000•14 citations

1.08μm superradiation in Nd-doped silica fiber

Y Chen

Pumped by 514.5 nm Ar ion laser, superfluorescence was observed in a 3 m Nd-doped silica fiber. The maximum output power is 6 mW with the emission linewidth-of 3 nm. A good agreement is found between experimental; data and theoretical fits.

Acta Optica Sinica•Jan 1, 1991•0 citations

Theory of stimulated Raman scattering with broad-band lasers

Michael G. Raymer, Jan Mostowski, John L. Carlsten

The authors have extended the theory of stimulated Raman scattering to include the effects of laser bandwidths, in both the transient and steady-state regimes. The case of two interacting laser beams, a pump laser and a probe (Stokes) laser, is treated. Using the phase-diffusion model for laser bandwidth, the authors demonstrate that in the absence of dispersion, the forward Raman gain is essentially independent of the laser bandwidths in the high-gain limit, while in the low-gain limit the gain coefficient is inversely proportional to the sum of the bandwidths. It is further shown that when the pump-laser bandwidth is much larger than the linewidth of the Raman medium, the stimulated Stokes output assumes the same spectrum as the pump laser in the high-gain limit. A possible interpretation of these results is discussed assuming a "phase-locking" of the Stokes phase to the fluctuations in the pump-laser phase, due to the nonlinear interaction of the two beams through the Raman medium.

Physical Review A•Jun 1, 1979•136 citations

Stimulated Raman Scattering for All Optical Switches

Ariel Flores-Rosas, Evgeny A. Kuzin, Orlando Díaz-Hernández +4 more

We theoretically and experimentally investigate an all optical switch based on stimulated Raman scattering in optical fibers. The experimental setup consists of a Raman circuit of two stages connected in series through a bandpass filter. In the first stage, we have a saturated amplifier, in this stage the pump pulses are saturated when pump and signal are launched to the input or the pump pulses remain without saturation when pump only is launched at the input. The second stage works as the Raman amplifier; for this stage amplification is directly dependent on the pump power entering from the first stage. For the case when pump pulse only is launched at the input pass to the second stage without saturation and amplifies the signal entering in the second stage, very intense signal pulses appear at the output of this stage. For the case when both pump and signal pulses are launched to the input, the pump pulse is saturated in the first stage and the filter rejected the amplified signal, so that only low power pump enters the second stage and consequently no signal pulses appear at the output. We show that the contrast can be improved when using fibers with normal and anomalous dispersion connected in series in the first stage. The best contrast (the ratio of energies) obtained was 15 dB at 6 W pump peak power.

InTech eBooks•Feb 15, 2017•0 citations
A stimulated-Raman-gain medium at 1.56-microm wavelength, consisting of molecular deuterium dissolved in low-loss silica optical fiber and pumped by 1.06-microm Nd:YAG laser light, is described. In a 100-m-long fiber with pump power of 130 W, InGaAsP injection-laser probe light at 1.56 microm was amplified by a factor of 4000 to an output power of 150 mW. The measured stimulated-Raman-gain coefficient at 1.56 microm is 7 x 10(-12) cm/W, about equal to the Raman gain of SiO(2) at the same wavelength.
A gain coefficient of 3.8 dB/mW was achieved for an erbium-doped fiber amplifier pumped by a 1.48 mu m laser diode. The main reasons for the improvement are high NA (0.23) and low concentration (43 p.p.m.). Pump-to-signal energy conversion efficiency was 18% at 3 dB gain compression. A decrease in saturation power with increasing erbium concentration was also demonstrated. In high-concentration fiber, fluorescence at 0.98 mu m due to cooperative upconversion was detected. These results indicate that several kilometers of distributed fiber amplifier with high gain and high output saturation power could be possible, because the absorption coefficient at 1.48 mu m is still two orders higher than the background loss in the 43 p.p.m. fiber.>
We investigate optical switching based on stimulated Raman scattering. The circuit consists of two fiber stages connected in series through a bandpass filter. When the pump and signal are launched to the input, the pump is saturated because of the signal amplification in the first stage; the amplified signal is rejected by the filter, so that only low-power pump enters the second stage; and no signal pulses appear at the output. The second stage is fed by 1 mW power at signal wavelength. When the pump only enters at the input, it passes through the first stage without saturation, enters the second stage, and amplifies the signal entering this stage; strong signal pulses appear at the output. We use 2-ns pump pulses at 1528 nm and cw signal at 1620 nm. In the first stage, we use both fibers with normal and anomalous dispersion. In fibers with anomalous dispersion, pump saturation is affected by modulation instability. We find that the contrast may be improved using fibers with normal and anomalous dispersion connected in series in the first stage, provided there is appropriate selection of their lengths. The best contrast we achieve is 15 dB at 6 W pump peak power.
We report a steady-state Raman gain measurement of the Q(1)(0) transition (v = 1 ? 0, J = 0 ? 0) in solid parahydrogen. We carry out measurements by pumping with a continuous-wave frequency-doubled YAG laser at 532 nm and observing the direct amplification of a probe-laser beam for the first Stokes transition at 683 nm. A large single-pass amplification coefficient of 2.3 +/- 0.2 is obtained at a pump intensity of 46 kW/cm(2), with an interaction length of 1 cm, giving a steady-state Raman gain coefficient of 18 +/- 3 cm/MW.
The authors have extended the theory of stimulated Raman scattering to include the effects of laser bandwidths, in both the transient and steady-state regimes. The case of two interacting laser beams, a pump laser and a probe (Stokes) laser, is treated. Using the phase-diffusion model for laser bandwidth, the authors demonstrate that in the absence of dispersion, the forward Raman gain is essentially independent of the laser bandwidths in the high-gain limit, while in the low-gain limit the gain coefficient is inversely proportional to the sum of the bandwidths. It is further shown that when the pump-laser bandwidth is much larger than the linewidth of the Raman medium, the stimulated Stokes output assumes the same spectrum as the pump laser in the high-gain limit. A possible interpretation of these results is discussed assuming a "phase-locking" of the Stokes phase to the fluctuations in the pump-laser phase, due to the nonlinear interaction of the two beams through the Raman medium.
We theoretically and experimentally investigate an all optical switch based on stimulated Raman scattering in optical fibers. The experimental setup consists of a Raman circuit of two stages connected in series through a bandpass filter. In the first stage, we have a saturated amplifier, in this stage the pump pulses are saturated when pump and signal are launched to the input or the pump pulses remain without saturation when pump only is launched at the input. The second stage works as the Raman amplifier; for this stage amplification is directly dependent on the pump power entering from the first stage. For the case when pump pulse only is launched at the input pass to the second stage without saturation and amplifies the signal entering in the second stage, very intense signal pulses appear at the output of this stage. For the case when both pump and signal pulses are launched to the input, the pump pulse is saturated in the first stage and the filter rejected the amplified signal, so that only low power pump enters the second stage and consequently no signal pulses appear at the output. We show that the contrast can be improved when using fibers with normal and anomalous dispersion connected in series in the first stage. The best contrast (the ratio of energies) obtained was 15 dB at 6 W pump peak power.