Light switches: The photon capture area of single fluorescent molecules has been directly measured by switching them “on and off” with light. Stimulated emission of single molecules (see picture) enables the precise control of the excited state population probability of an individual molecule at room temperature.
Experiments with single quantum systems are at the frontier of modern physics. Probing single molecules allows for very precise control of light-matter interaction and for quantum optical studies. Moreover, a single guest molecule in a solid host matrix is a very sensitive probe of local dynamics in its nano-environment. Fluorescence excitation spectroscopy on single molecules is a powerful tool for spectroscopic characterizations at highest resolution, as information can be revealed that is not accessible in experiments on ensembles of molecules. The detection of the fluorescence signal of a single absorber is achieved by exploiting the high spectral selectivity given by the ratio (10 10) of homogeneous to inhomogeneous linewidths of optical transitions at cryogenic temperatures (zero-phonon transitions). Two-photon fluorescence excitation, a fundamental nonlinear optical process, was observed on a single quantum system [1]. Single diphenyl-octatetraene molecules trapped in an n-tetradecane matrix were excited from the 1Ag ground to the lowest excited singlet state by simultaneous absorption of two photons using a single-mode cw laser. Excited molecules were observed through weak one-photon emission resulting from a symmetry breaking induced by the crystal field. The fundamental principles and the experimental technique of single molecule spectroscopy will be introduced briefly and some particular single molecule experiments presented. This work was done in collaboration with T. Plakhotnik, A. Renn and U.P. Wild
A significant limitation in the detection and spectroscopy of individual dye molecules in liquid room temperature samples is the loss of fluorescence signal through chromophore photobleaching. Although often considered a fundamental restriction on sensitivity, it has been shown that the probability per excitation cycle of photobleaching may be reduced by enhancing the spontaneous emission rate of the chromophore located inside a microdroplet, which acts as a optical cavity. Studies of glycerol microdroplets containing R6G dye molecules, and levitated in a three-dimensional electrodynamic trap, have demonstrated a significant enhancement of both the fluorescence decay rate [1] and the total fluorescence yield [2] of the chromophore. Modification of the emission rate is greatest for molecules located near the surface of small (< 10 μm) microdroplets, where the influence of the droplet cavity modes of the droplet is most significant. To exploit this surface sensitivity, surfactant forms of rhodamine dyes were recently studied [3]. Fluorescence emission of the dye molecules, constrained to the droplet surface and with fixed transition moments perpendicular to the surface normal, were shown to be significantly enhanced at small droplet sizes. Additionally, at larger droplet sizes corresponding to higher droplet Q’s, preferential emission into the cavity modes was observed, however the detection of fluorescence photons was delayed by the storage time of the cavity, which may be on the same order as the fluorescence lifetime. These measurements, performed on relatively concentrated dye solutions, suggest that microcavity effects may be exploited to greatly enhance single molecule detection sensitivity in glycerol microdroplets. Furthermore, the large cavity storage time of the high-Q droplets opens the possibility for re-excitation of the molecule following emission into the droplet resonance, and subsequent stimulated emission, that is, single-molecule lasing.
With the growing popularity of cryogenic correlative light and electron microscopy, it is becoming increasingly important to bridge the resolution gap between these two modalities. At cryogenic temperatures, the photon yield of fluorophores is a few orders of magnitude higher than at room temperature, enabling localization precisions on the \AA{}ngstr\"om scale. The current challenge is to induce sparsity at cryogenic temperatures such that individual fluorescent molecules can be localized. In this paper, we demonstrate the progress of using polarized stimulated-emission depletion (STED) to induce sparsity at cryogenic temperatures and in vacuum. We generate linear polarization of arbitrary in-plane orientations to achieve polarized STED with a sparsity of 3.3:1. Furthermore, we have probed the dark-state lifetime of ATTO 647N at cryogenic temperatures and in vacuum at room temperature. This dark state in vacuum is long-lived ($\ensuremath{\tau}=38$ ms) and could be the cause for reduced photostability of fluorophores under STED illumination in vacuum. The experiments were done on an in-house designed and built liquid nitrogen cryostat, enabling 30 hours of stable cryogenic fluorescence microscopy.
The generation of non-classical states of light [1] is an important scientific challenge with many potential applications. For example, squeezed states of light [2] have generated much interest in the past decade, because measurements can be performed with noise levels that are lower than those available with classical light. A particularly novel non-classical source of light is a triggered single-photon source: a source that has the property to emit with a high degree of certainty one (and only one) photon at a user-specified time. Such a deterministic source of single photons can be important for quantum information processing [3], quantum cryptography [4] and certain quantum computation problems [5]. A single quantum emitter such as a molecule or an atom is a good potential source because it can emit only one photon at a time. The emitted light is antibunched [6, 7] and consists of single photons separated by random time intervals, which depend on the excited state lifetime and on the pumping rate. Thus triggered emission of single photons can be obtained with controlled excitation of a single emitter. The first demonstration of a single photons source [8] using a single molecule in a solid is based on a rapid adiabatic passage method [9] to excite the molecule. In the effective spin picture, the Bloch vector follows the driving magnetic field adiabatically if the laser-molecule frequency detuning is swept slowly through the resonance. Since the passage inverts the field, the system goes from the ground to the excited state. From this fluorescent state the molecule can emit only a single photon. The molecular resonance is swept by Stark effect at fixed laser frequency. This is done easily by applying a radio frequency electric field to the molecule. The results showed photon states with statistics that differ radically from those of coherent states. But this method requires cryogenic temperatures (2K) since narrow zero phonon lines are needed for the adiabatic following. At room temperature a source of triggered single photons based on the concept of pulsed optical excitation of a single highly fluorescent molecule has been demonstrated [10]. A short pulse of green laser light pumps the molecule from the ground state to a vibronically excited level of the first electronic excited state. After fast (ps) relaxation to the lowest electronic excited state, the molecule subsequently emits a single photon. A frequency-doubled mode-locked Nd-YAG laser is used to pump highly stable single terrylene molecules contained in a p-terphenyl molecular crystal where they are protected from exposure to diffusing quenchers (such as oxygen). The result shows that the photons are emitted after the laser pulses at times separated by the laser repetition time within the lifetime of terrylene in p-terphenyl. Since the pump pulse width is very short compared to the fluorescence lifetime, the probability of two (or more) photon emission per pulse is always zero. At the maximum laser power, 90% of the laser pulses lead to a single photon emission. The parameters of this source (repetition rate and single photon generation probability) were limited only by the laser system used; nevertheless, this performance already surpasses that of previous work. The high performance combined with the vanishing two photon emission probability and the simplicity of this source suggests that it can be considered for a variety of quantum optical experiments and for secure quantum cryptography [11]. Semiconductor quantum dots (QD) are other potential systems for single photon generation [12]. QDs are often referred to as “artificial atoms” because many of their optical properties, such as ultranarrow transitions, arise from discrete, atomic-like energy levels [13, 14]. To reinforce this analogy a study of the photon antibunching in this system was needed. QDs differ from atoms and molecules since the creation of multiple excitons is possible in QDs. Consequently, if two electron-hole pairs can radiatively recombine, the simultaneous emission of two photons from a QD is then possible. Thus different regimes of photon statistics were expected because the probability of multiple exciton creation depends on excitation intensity. The fluorescence intensity correlation function of a single CdSe quantum dot has been investigated [15] using a coincidence setup (start-stop experiment). A strong photon antibunching has been observed over a large range of intensities (0.1-100 kW/cm2). The lack of coincidence at zero time delay indicates a highly efficient Auger ionization process [16], which suppresses multi-photon emission in these colloidal quantum dots. This result shows that room temperature single photon sources can be achieved with colloidal nanoparticles.