Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Laser Physics

Measurement of the absolute total electron impact cross section on Cs atoms using a magnetooptical trap

José Roberto Garbin, D. M. B. P. Milori, Daniel Varela Magalhães, M. Anwar, Mushtaq Ahmed, Aida Bebeachibuli, S. Müller, Vanderlei Salvador Bagnato

Published Feb 1, 2008• 0 citations
Publisher

Abstract

Laser cooling and trapping of neutral atoms has been employed for the measurement of the total electron impact cross sections of the ground state 62 S 1/2 of 133Cs atoms in the energy range from 80 to 500 eV. The total electron impact cross sections of the cold Cs atoms in the MOT were measured by observing the decay of the MOT after the interaction with the electron beam, and were found to depend only on the electron flux and not on the total number of atoms in the MOT. We confirm and extend the existing data on these measurements.

DOI
10.1134/s1054660x08020084

Related papers

Electron Collisions with Laser Cooled and Trapped Metastable Helium Atoms: Total Scattering Cross Sections

L. J. Uhlmann, R. G. Dall, Andrew G. Truscott +3 more

Absolute measurements of total scattering cross sections for low energy (5-70 eV) electrons by metastable helium (2(3)S) atoms are presented. The measurements are performed using a magneto-optical trap which is loaded from a laser-cooled, bright beam of slow He(2(3)S) atoms. The data are compared with predictions from convergent close coupling and R matrix with pseudostate calculations, and we find good agreement between experiment and theory.

Physical Review Letters•May 3, 2005•36 citations

Electron collision studies of cesium using a magneto-optical trap.

J. A. MacAskill

Experiments involving a magneto-optical trap (MOT) as the target in electron impact cross section studies were carried out. The use of a MOT allows the kinematic properties of the target atoms, and their electronic states, to be controlled via operating parameters of the MOT's lasers. A MOT is capable of saturating the excited state of a gaseous target of atoms and provides a unique opportunity to measure exotic collision processes. Measurements use a trap-loss technique to relate the loss rate of atoms from the trap due to electron interactions to a collision cross section. Total scattering cross section measurements are given for the 62S 1/2 ground state and the 62P3/2 excited state of cesium. The excited state measurement is the first measurement of its kind. Total ionization cross sections are also presented for the both the 6 2S1/2 ground state and 62P3/2 excited state. The ionization cross sections are measured by adjusting the radiation force of the MOT lasers to damp the elastic scattering component of the total cross section. The ionization cross section for the excited state is the first experimental determination of its kind. Full details of the experimental apparatus and the analysis procedure are presented. The results of this experiment are combined with other experimental data and compared to the most recent calculations.Dept. of Physics. Paper copy at Leddy Library: Theses & Major Papers - Basement, West Bldg. / Call Number: Thesis2003 .M322. Source: Dissertation Abstracts International, Volume: 64-10, Section: B, page: 4996. Adviser: J. W. McConkey. Thesis (Ph.D.)--University of Windsor (Canada), 2003.

•Oct 1, 2003•1 citation

Electron-impact ionization cross sections out of the ground and 6P2 excited states of cesium

Michał Łukomski, Sean Sutton, W. Kedzierski +6 more

An atom trapping technique for determining absolute, total ionization cross sections (TICS) out of an excited atom is presented. The unique feature of our method is in utilizing Doppler cooling of neutral atoms to determine ionization cross sections. This fluorescence-monitoring experiment, which is a variant of the ``trap loss'' technique, has enabled us to obtain the experimental electron impact ionization cross sections out of the Cs $6\phantom{\rule{0.2em}{0ex}}^{2}{P}_{3∕2}$ state between $7\phantom{\rule{0.3em}{0ex}}\mathrm{eV}$ and $400\phantom{\rule{0.3em}{0ex}}\mathrm{eV}$. CCC, RMPS, and Born theoretical results are also presented for both the ground and excited states of cesium and rubidium. In the low energy region $(<11\phantom{\rule{0.3em}{0ex}}\mathrm{eV})$ where best agreement between these excited state measurements and theory might be expected, a discrepancy of approximately a factor of five is observed. Above this energy there are significant contributions to the TICS from both autoionization and multiple ionization.

Physical Review A•Sep 21, 2006•27 citations

Absolute Electron-Impact Ionization Cross Section Measurements Using a Magneto-Optical Trap

R. Scott Schappe, Thad G Walker, L. W. Anderson +1 more

We present a new method for measuring absolute total electron-impact ionization cross sections. The technique measures fractional loss rates from a magneto-optical trap due to electron-impact ionization. The method requires only relative measurements of the number of target atoms and therefore eliminates a major source of difficulty in previous experiments. We report total ionization cross sections of Rb for electron energies from 50 to 500 eV.

Physical Review Letters•Jun 3, 1996•55 citations

Electron Collision Cross-Sections Measured with the Use of a Magneto-Optical Trap

R. Scott Schappe, P Feng, L. W. Anderson +2 more

We present the first application of optically trapped atoms as targets for a scattering experiment. We report absolute total electron scattering cross-sections for ground-state Rb atoms in the range of 7-500 eV.

Europhysics Letters (EPL)•Feb 20, 1995•33 citations

Electron-atom collisions: From Franck-Hertz experiment to atom traps

Chang-Chun Lin

The key features of the cross sections for electron-impact excitation out of the ground levels of the rare-gas atoms are summarized and application of these cross section data is shown. This is followed by discussions of recent experiments on determination of electron-impact cross sections for excitation out of the metastable levels of He and Ar. The metastiable atom targets are produced by two different methods, i.e., hollow-cathode discharges and charge-exchange collisions of rare-gas ions with Cs atoms. The former method is simple but is limited to low electron energies because of the very small metastable concentration, whereas the latter method yields a fast target beam with predominantly metastable atoms allowing measurements up to the keV range. The measured cross sections show features very different from those of excitation out of the ground levels. Another new development in electron-atom collision is the use of atom traps for measuring ionization cross sections. The experiment is conducted by passing an electron beam pulse through magneto-optically trapped Rb atoms while the trap is momentarily turned off. Turning the trap back on immediately after the electron beam pulse recaptures the unionized atoms allowing only the ions to escape. The ionization cross section is determined bymore » measuring the electron beam current density at the trapped atom region and the fractional loss of trapped atoms due to the electron beam. This method avoids measurements of the absolute number of the target atoms and the overlap between the atomic and electron beams and therefore eliminates the major sources of uncertainty associated with the crossed-beam method for measuring ionization cross section.« less

Bulletin of the American Physical Society•May 1, 1996•0 citations
Laser cooling and trapping of neutral atoms has been employed for the measurement of the total electron impact cross sections of the ground state 62 S 1/2 of 133Cs atoms in the energy range from 80 to 500 eV. The total electron impact cross sections of the cold Cs atoms in the MOT were measured by observing the decay of the MOT after the interaction with the electron beam, and were found to depend only on the electron flux and not on the total number of atoms in the MOT. We confirm and extend the existing data on these measurements.
Experiments involving a magneto-optical trap (MOT) as the target in electron impact cross section studies were carried out. The use of a MOT allows the kinematic properties of the target atoms, and their electronic states, to be controlled via operating parameters of the MOT's lasers. A MOT is capable of saturating the excited state of a gaseous target of atoms and provides a unique opportunity to measure exotic collision processes. Measurements use a trap-loss technique to relate the loss rate of atoms from the trap due to electron interactions to a collision cross section. Total scattering cross section measurements are given for the 62S 1/2 ground state and the 62P3/2 excited state of cesium. The excited state measurement is the first measurement of its kind. Total ionization cross sections are also presented for the both the 6 2S1/2 ground state and 62P3/2 excited state. The ionization cross sections are measured by adjusting the radiation force of the MOT lasers to damp the elastic scattering component of the total cross section. The ionization cross section for the excited state is the first experimental determination of its kind. Full details of the experimental apparatus and the analysis procedure are presented. The results of this experiment are combined with other experimental data and compared to the most recent calculations.Dept. of Physics. Paper copy at Leddy Library: Theses & Major Papers - Basement, West Bldg. / Call Number: Thesis2003 .M322. Source: Dissertation Abstracts International, Volume: 64-10, Section: B, page: 4996. Adviser: J. W. McConkey. Thesis (Ph.D.)--University of Windsor (Canada), 2003.
An atom trapping technique for determining absolute, total ionization cross sections (TICS) out of an excited atom is presented. The unique feature of our method is in utilizing Doppler cooling of neutral atoms to determine ionization cross sections. This fluorescence-monitoring experiment, which is a variant of the ``trap loss'' technique, has enabled us to obtain the experimental electron impact ionization cross sections out of the Cs 62P3∕26\phantom{\rule{0.2em}{0ex}}^{2}{P}_{3∕2}62P3∕2​ state between 7eV7\phantom{\rule{0.3em}{0ex}}\mathrm{eV}7eV and 400eV400\phantom{\rule{0.3em}{0ex}}\mathrm{eV}400eV. CCC, RMPS, and Born theoretical results are also presented for both the ground and excited states of cesium and rubidium. In the low energy region (<11eV)(<11\phantom{\rule{0.3em}{0ex}}\mathrm{eV})(<11eV) where best agreement between these excited state measurements and theory might be expected, a discrepancy of approximately a factor of five is observed. Above this energy there are significant contributions to the TICS from both autoionization and multiple ionization.
The key features of the cross sections for electron-impact excitation out of the ground levels of the rare-gas atoms are summarized and application of these cross section data is shown. This is followed by discussions of recent experiments on determination of electron-impact cross sections for excitation out of the metastable levels of He and Ar. The metastiable atom targets are produced by two different methods, i.e., hollow-cathode discharges and charge-exchange collisions of rare-gas ions with Cs atoms. The former method is simple but is limited to low electron energies because of the very small metastable concentration, whereas the latter method yields a fast target beam with predominantly metastable atoms allowing measurements up to the keV range. The measured cross sections show features very different from those of excitation out of the ground levels. Another new development in electron-atom collision is the use of atom traps for measuring ionization cross sections. The experiment is conducted by passing an electron beam pulse through magneto-optically trapped Rb atoms while the trap is momentarily turned off. Turning the trap back on immediately after the electron beam pulse recaptures the unionized atoms allowing only the ions to escape. The ionization cross section is determined bymore » measuring the electron beam current density at the trapped atom region and the fractional loss of trapped atoms due to the electron beam. This method avoids measurements of the absolute number of the target atoms and the overlap between the atomic and electron beams and therefore eliminates the major sources of uncertainty associated with the crossed-beam method for measuring ionization cross section.« less