Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optical Engineering

Effect of multiorder harmonics in a double-Raman pumped gain medium for a superluminal laser

Ye Wang, Zifan Zhou, Joshua Yablon, M. S. Shahriar

Published May 27, 2015• 15 citations
Publisher

Abstract

Use of a double-Raman pump applied to a three-level system is a convenient method for generating negative dispersion. When the gain at the center is high enough, such a system can be used to realize a superluminal laser, which in turn can be used to enhance the sensitivity of rotation sensors. For this condition, it is often necessary to apply strong pumps that are closely spaced in frequency. Accurate modeling of this system thus requires taking into account interference between the two pumps. We present such an analysis where we allow for an arbitrary number of harmonics that result from this interference, and investigate the behavior of the gain profile under a wide range of conditions. We also describe an experimental study of double-Raman gain in a Rb vapor cell, and find close agreement between the experimental result and the theoretical model. The technique reported here can be used in developing a quantitative model of a superluminal laser under wide-ranging conditions.

DOI
10.1117/1.oe.54.5.057106

Related papers

Enhanced sensing in a double-Raman superluminal ring laser

Tony Abi-Salloum, M. S. Shahriar

We investigate the feasibility of realizing a superluminal ring laser with enhanced sensitivity by using the gain produced via double-Raman pumping in an inverted three-level system. If the laser cavity is tuned to the center between the two gain peaks produced in such a system, it is expected to experience an effective negative dispersion, which can be tuned to the condition necessary for enhancing the sensitivity of the laser frequency to a change in the cavity length. Using a model of two idealized, independent Lorentzian gains, we solve the laser equations to show the enhancement of sensitivity. We then extend our analysis to calculate the gain profile in a real lambda system. Unlike the idealized system mentioned above, where the dual gain peaks are modeled as two adjacent Lorentzians in a manner that ignores the relative coherence between the Raman pumps, we present a more accurate model where this coherence is not neglected. As such, the Hamiltonian remains time dependent after making the rotating wave transformation. Using an approximation --- valid for practical systems --- where higher order terms in the density matrix are neglected, we determine the gain experienced by a weak probe beam. Numerical techniques are needed to incorporate the resulting gain and dispersion profiles into the laser equation to determine accurately the behavior of the superluminal laser. This work will be carried out in the near future. Experimental realization of a superluminal laser based on this approach may prove to be easier than other approaches proposed previously.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Mar 6, 2013•0 citations

Observation of a highly superluminal laser employing optically pumped Raman gain and depletion

Zifan Zhou, Nicholas Condon, Devin Hileman +1 more

In this paper, we report a Raman laser which is extremely sensitive to a variation of the cavity length, using a scheme employing two stable isotopes of Rb. One isotope is used for producing a broad gain spectrum via the optically pumped Raman gain process, while the other is used for producing a narrow dip via the optically pumped Raman depletion process. By tuning the frequencies of the two Raman pumps, the center frequencies of the gain and dip can be aligned to the same frequency. This approach allows tuning of the gain and dip parameters independently over a broad range of operating conditions. With such a configuration, we can produce a negative dispersion around the two-photon resonance frequency in the vapor cell, which leads to a group index that is close to zero. By theoretically matching the experimental observations, we can infer that the sensitivity of such laser is enhanced by a factor of more than 2800, which is nearly a factor of three larger than the highest value reported previously using a different approach.

Optics Express•Feb 3, 2022•6 citations

Double-Raman Gain for Realizing a Superluminal Ring Laser

Yu-Hong Wang, Tony Abi-Salloum, J. Yablon +3 more

We show how a dual-peak gain produced via optical pumping and non-degenerate Raman pumps in a single vapor cell can be used to realize a superluminal ring laser with enhanced sensitivity for gyroscopy and accelerometry.

Conference on Lasers and Electro-Optics•Jan 1, 2013•0 citations

Demonstration of a superluminal laser using electromagnetically induced transparency in Raman gain

Zifan Zhou, Ruoxi Zhu, Yael Sternfeld +3 more

We report the realization of a superluminal laser in which the dip in the gain profile necessary for anomalous dispersion is produced via electromagnetically induced transparency caused by the optical pumping laser. This laser also creates the ground state population inversion necessary for generating Raman gain. Compared to a conventional Raman laser with similar operating parameters but without the dip in the gain profile, the spectral sensitivity of this approach is explicitly demonstrated to be enhanced by a factor of ∼12.7. Compared to an empty cavity, the peak value of the sensitivity enhancement factor under optimal operation parameters is inferred to be ∼360.

Optics Express•Mar 21, 2023•7 citations

Electromagnetically induced transparency in Raman gain for realizing a superluminal ring laser

Yael Sternfeld, Zifan Zhou, Jacob Scheuer +1 more

We describe an approach for realizing a superluminal ring laser using a single isotope of Rb vapor by producing electromagnetically induced transparency (EIT) in Raman gain. We show that by modifying the detuning and the intensity of the optical pump field used for generating the two-photon population inversion needed for generating Raman gain, it is possible to generate a dip in the center of the gain profile that can be tuned to produce a vanishingly small group index, as needed for making the Raman laser superluminal. We show that two such lasers, employing two different vapor cells, can be realized simultaneously, operating in counter-propagating directions in the same cavity, as needed for realizing a superluminal ring laser gyroscope. This technique, employing only one isotope, is much simpler than the earlier, alternative approach for realizing a superluminal Raman laser based on Raman gain and Raman dip in two isotopes [Zhou et. al, Opt. Express27, 29738 (2019)10.1364/OE.27.029738]. We present both an approximate theoretical model based on four levels as well as the results of a model that takes into account all relevant hyperfine states corresponding to the D1 and D2 transitions in 85Rb atom. We also present experimental results, in good agreement with the theoretical model, to validate the approach.

Optics Express•Nov 26, 2020•16 citations

Strong frequency correlation and anticorrelation between a Raman laser and its pump laser for positive and negative dispersions

Zifan Zhou, Ruoxi Zhu, M. S. Shahriar

We show that the frequency of a Raman laser is highly correlated or anticorrelated with the frequency of the Raman pump laser, depending on whether the dispersion experienced by the Raman laser is positive or negative. For a subluminal laser, corresponding to a positive dispersion with a group index that is much larger than unity, the shift in its frequency is approximately the same as that in the Raman pump laser. In contrast, for a superluminal laser, corresponding to a negative dispersion with a group index that is close to zero, its frequency shifts in the direction opposite to that of the Raman pump lasers and has an amplitude that is larger by a factor approximately equaling the inverse of the group index. These findings would play a critical role in determining the maximum achievable sensitivity of sensors employing such lasers, especially under conditions where the pump laser linewidth is broadened significantly beyond the Schawlow-Townes linewidth due to classical fluctuations.

arXiv:2312.15841•Physical Review A•Jun 14, 2024•0 citations
Use of a double-Raman pump applied to a three-level system is a convenient method for generating negative dispersion. When the gain at the center is high enough, such a system can be used to realize a superluminal laser, which in turn can be used to enhance the sensitivity of rotation sensors. For this condition, it is often necessary to apply strong pumps that are closely spaced in frequency. Accurate modeling of this system thus requires taking into account interference between the two pumps. We present such an analysis where we allow for an arbitrary number of harmonics that result from this interference, and investigate the behavior of the gain profile under a wide range of conditions. We also describe an experimental study of double-Raman gain in a Rb vapor cell, and find close agreement between the experimental result and the theoretical model. The technique reported here can be used in developing a quantitative model of a superluminal laser under wide-ranging conditions.
We investigate the feasibility of realizing a superluminal ring laser with enhanced sensitivity by using the gain produced via double-Raman pumping in an inverted three-level system. If the laser cavity is tuned to the center between the two gain peaks produced in such a system, it is expected to experience an effective negative dispersion, which can be tuned to the condition necessary for enhancing the sensitivity of the laser frequency to a change in the cavity length. Using a model of two idealized, independent Lorentzian gains, we solve the laser equations to show the enhancement of sensitivity. We then extend our analysis to calculate the gain profile in a real lambda system. Unlike the idealized system mentioned above, where the dual gain peaks are modeled as two adjacent Lorentzians in a manner that ignores the relative coherence between the Raman pumps, we present a more accurate model where this coherence is not neglected. As such, the Hamiltonian remains time dependent after making the rotating wave transformation. Using an approximation --- valid for practical systems --- where higher order terms in the density matrix are neglected, we determine the gain experienced by a weak probe beam. Numerical techniques are needed to incorporate the resulting gain and dispersion profiles into the laser equation to determine accurately the behavior of the superluminal laser. This work will be carried out in the near future. Experimental realization of a superluminal laser based on this approach may prove to be easier than other approaches proposed previously.
In this paper, we report a Raman laser which is extremely sensitive to a variation of the cavity length, using a scheme employing two stable isotopes of Rb. One isotope is used for producing a broad gain spectrum via the optically pumped Raman gain process, while the other is used for producing a narrow dip via the optically pumped Raman depletion process. By tuning the frequencies of the two Raman pumps, the center frequencies of the gain and dip can be aligned to the same frequency. This approach allows tuning of the gain and dip parameters independently over a broad range of operating conditions. With such a configuration, we can produce a negative dispersion around the two-photon resonance frequency in the vapor cell, which leads to a group index that is close to zero. By theoretically matching the experimental observations, we can infer that the sensitivity of such laser is enhanced by a factor of more than 2800, which is nearly a factor of three larger than the highest value reported previously using a different approach.
We report the realization of a superluminal laser in which the dip in the gain profile necessary for anomalous dispersion is produced via electromagnetically induced transparency caused by the optical pumping laser. This laser also creates the ground state population inversion necessary for generating Raman gain. Compared to a conventional Raman laser with similar operating parameters but without the dip in the gain profile, the spectral sensitivity of this approach is explicitly demonstrated to be enhanced by a factor of ∼12.7. Compared to an empty cavity, the peak value of the sensitivity enhancement factor under optimal operation parameters is inferred to be ∼360.
We describe an approach for realizing a superluminal ring laser using a single isotope of Rb vapor by producing electromagnetically induced transparency (EIT) in Raman gain. We show that by modifying the detuning and the intensity of the optical pump field used for generating the two-photon population inversion needed for generating Raman gain, it is possible to generate a dip in the center of the gain profile that can be tuned to produce a vanishingly small group index, as needed for making the Raman laser superluminal. We show that two such lasers, employing two different vapor cells, can be realized simultaneously, operating in counter-propagating directions in the same cavity, as needed for realizing a superluminal ring laser gyroscope. This technique, employing only one isotope, is much simpler than the earlier, alternative approach for realizing a superluminal Raman laser based on Raman gain and Raman dip in two isotopes [Zhou et. al, Opt. Express27, 29738 (2019)10.1364/OE.27.029738]. We present both an approximate theoretical model based on four levels as well as the results of a model that takes into account all relevant hyperfine states corresponding to the D1 and D2 transitions in 85Rb atom. We also present experimental results, in good agreement with the theoretical model, to validate the approach.
We show that the frequency of a Raman laser is highly correlated or anticorrelated with the frequency of the Raman pump laser, depending on whether the dispersion experienced by the Raman laser is positive or negative. For a subluminal laser, corresponding to a positive dispersion with a group index that is much larger than unity, the shift in its frequency is approximately the same as that in the Raman pump laser. In contrast, for a superluminal laser, corresponding to a negative dispersion with a group index that is close to zero, its frequency shifts in the direction opposite to that of the Raman pump lasers and has an amplitude that is larger by a factor approximately equaling the inverse of the group index. These findings would play a critical role in determining the maximum achievable sensitivity of sensors employing such lasers, especially under conditions where the pump laser linewidth is broadened significantly beyond the Schawlow-Townes linewidth due to classical fluctuations.