Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE International Conference on Photonics

Experimental investigation of slow light generation based on SBS in optical fibers

Soroush Abbasi Zargaleh, Dinesh Kumar, Z. Yusoff, Hairul Azhar Abdul-Rashid

Published Jul 1, 2010• 0 citations
Publisher

Abstract

In this paper we report experimental investigation of slow light generation via SBS in Standard Single Mode Fiber (SSMF) and Photonic Crystal Fiber (PCF). The slow light region has been characterized in terms of gain, phase change and delay of optical probe signal as it swept across the narrowband slow light region.
DOI
10.1109/icp.2010.5604418

Related papers

Observation of the fast and slow light in an optical fiber based on SBS gain region

Shoujun Zhang, Xiaoyan Li, Xianpu Su +3 more

Fast and slow light in optical fibers was a powerful tool for future all-optical networks. We observed fast and slow light based on the stimulated Brillouin scattering using the gain region in optical fibers just adjusting the pump power experimentally. In this paper, the time delay as a function of the pump signal power, Stokes signal power and the fiber length were studied.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 6, 2010•0 citations

Slow light generation using SBS in a liquid-core photonic crystal fiber

Wenbin An, Haiming Jiang, Yinjia Fang +3 more

Based on stimulated Brillouin scattering (SBS), the slow light effect in photonic crystal fibre (PCF), which is filled with highly nonlinear liquid-carbon disuphide in the core region, is investigated. Maximum allowable pump power for undistorted output pulse, minimum value of pump power required to initiate the SBS effect, Brillouin gain and time-tonic delay experienced by the pulse in the designed liquid-core photonic crystal fibre, are all calculated numerically. We have found that the maximum time-delay up to ∼134.4 ns at 1.064 μm can be obtained using 1 m long liquid-core PCF pumped with only 65.8 mW, which is lower than the value reported in the literature for achieving such a high delay time. The results indicate that liquid-core PCF is capable of generating tunable time-delay that is adjusted by the pump power and structural parameters of the proposed liquid-core PCF.

Journal of Modern Optics•Nov 11, 2016•4 citations

Slow light with a swept-frequency source

Rui Zhang, Yunhui Zhu, Jing Wang +1 more

ct: We introduce a new concept for stimulated-Brillouin-scattering-based slow light in optical fibers that is applicable for broadly-tunable frequency-swept sources. It allows slow light to be achieved, in principle, over the entire transparency window of the optical fiber. We demonstrate a slow light delay of 10 ns at 1.55 μm using a 10-m-long photonic crystal fiber with a source sweep rate of 400 MHz/μs and a pump power of 200 mW. We also show that there exists a maximal delay obtainable by this method, which is set by the SBS threshold, independent of sweep rate. For our fiber with optimum length, this maximum delay is ~38 ns, obtained for a pump power of 760 mW.

arXiv:1010.3179•Optics Express•Dec 10, 2010•8 citations

The advancements of research on controllable slow light using stimulated Brillouin scattering in optical fibers

Zhao Jun-fa

The recent advancements on controllable slow light based on Stimulating Brillouin Scattering (SBS) in optical fibers is presented.The experimental methods and results on broadening SBS Brillouin gain bandwidth are reviewed firstly.Then the researches on SBS controllable slow light in highly nonlinear fiber and photonic crystal fiber are introduced.

Optical Communication Technology•Jan 1, 2010•0 citations

SBS Slow Light in High Nonlinearity Photonic Crystal Fiber

Yin Wang, Wei Zhang, Yidong Huang +1 more

Up to 14-ns delay is achieved by the SBS slow light in a 25-m long high nonlinearity photonic crystal fiber. The high delay efficiency improves the control rate of SBS slow light systems.

Optical Fiber Communication Conference•Mar 1, 2007•5 citations

Broadening-free SBS-based slow and fast light in optical fibers

Thomas Schneider, Andrzej Wiatrek

To change the group velocity of optical signals has a lot of possible applications in telecommunications, sensing, nonlinear optics and so on. Especially the exploitation of the effect of stimulated Brillouin scattering (SBS) in optical fibers is of special interest since it just requires standard telecom equipment and low to moderate optical power. However, each delay in one single, low-gain SBS based slow-light system is accompanied by pulse broadening. This is a result of the inherent Kramers-Kronig relations between the gain, the phase-change and the accompanied group velocity. For an ideal flat gain the phase-change is non-ideal, and for an ideal phase-change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is broadened in order to adapt it to the signal, the delay will be reduced. Thus, for one single low-gain slow-light system the broadening can be reduced by several methods but it cannot be zero. Here we will show how a zero-broadening SBS based slow-light system can be achieved by two different methods. The basic idea is a reshaping of the original pulse by an adapted gain in a second stage. This adaptation is achieved by the superposition of two Gaussian gain profiles or by a single saturated gain. As will be shown, these systems show an almost ideal over-all gain and phase function over the bandwidth of the pulses. Thus, SBS based slow-light with a delaybandwidth product of more than 1 bit and zero distortion is possible.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Feb 21, 2014•0 citations
Based on stimulated Brillouin scattering (SBS), the slow light effect in photonic crystal fibre (PCF), which is filled with highly nonlinear liquid-carbon disuphide in the core region, is investigated. Maximum allowable pump power for undistorted output pulse, minimum value of pump power required to initiate the SBS effect, Brillouin gain and time-tonic delay experienced by the pulse in the designed liquid-core photonic crystal fibre, are all calculated numerically. We have found that the maximum time-delay up to ∼134.4 ns at 1.064 μm can be obtained using 1 m long liquid-core PCF pumped with only 65.8 mW, which is lower than the value reported in the literature for achieving such a high delay time. The results indicate that liquid-core PCF is capable of generating tunable time-delay that is adjusted by the pump power and structural parameters of the proposed liquid-core PCF.
ct: We introduce a new concept for stimulated-Brillouin-scattering-based slow light in optical fibers that is applicable for broadly-tunable frequency-swept sources. It allows slow light to be achieved, in principle, over the entire transparency window of the optical fiber. We demonstrate a slow light delay of 10 ns at 1.55 μm using a 10-m-long photonic crystal fiber with a source sweep rate of 400 MHz/μs and a pump power of 200 mW. We also show that there exists a maximal delay obtainable by this method, which is set by the SBS threshold, independent of sweep rate. For our fiber with optimum length, this maximum delay is ~38 ns, obtained for a pump power of 760 mW.
To change the group velocity of optical signals has a lot of possible applications in telecommunications, sensing, nonlinear optics and so on. Especially the exploitation of the effect of stimulated Brillouin scattering (SBS) in optical fibers is of special interest since it just requires standard telecom equipment and low to moderate optical power. However, each delay in one single, low-gain SBS based slow-light system is accompanied by pulse broadening. This is a result of the inherent Kramers-Kronig relations between the gain, the phase-change and the accompanied group velocity. For an ideal flat gain the phase-change is non-ideal, and for an ideal phase-change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is broadened in order to adapt it to the signal, the delay will be reduced. Thus, for one single low-gain slow-light system the broadening can be reduced by several methods but it cannot be zero. Here we will show how a zero-broadening SBS based slow-light system can be achieved by two different methods. The basic idea is a reshaping of the original pulse by an adapted gain in a second stage. This adaptation is achieved by the superposition of two Gaussian gain profiles or by a single saturated gain. As will be shown, these systems show an almost ideal over-all gain and phase function over the bandwidth of the pulses. Thus, SBS based slow-light with a delaybandwidth product of more than 1 bit and zero distortion is possible.