Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Characterization of HTS SFQ circuits using interface-engineered Josephson junctions

K. Saitoh, Yoshihisa Soutome, Tokuumi Fukazawa, Y. Tarutani, Katsuaki Takagi

Published Mar 1, 2001• 17 citations
Publisher

Abstract

We fabricated and tested high-temperature superconducting (HTS) rapid-single-flux-quantum (RSFQ) circuits using interface-engineered Josephson junction (IEJ). The characteristics of high-speed operation were examined by voltage-divider operation based on the toggle-flip-flop circuit. An operation at 155 GHz was obtained at 15 K and the proper functioning of the voltage divider was observed up to 27 K. Temperature dependence of the maximum operation speed was analyzed by circuit simulation with thermal-noise sources. To achieve higher speed operation using a Josephson junction with a higher I/sub c/R/sub n/ product, we also fabricated an RSFQ balanced comparator using IEJ; proper switching characteristics of the circuit was confirmed up to 190 GHz at 30 K. The bias condition dependencies were studied based on the circuit simulations in the relationship of the I/sub c/R/sub n/ product. The results of circuit simulation indicate that a Josephson junction with an I/sub c/R/sub n/ product of more than 0.7 mV is required for high-speed operation (100 GHz) in high-temperature range (30-40 K). We believe that the IEJ is a promising junction candidate for realizing high-speed operation in a high-temperature range.

DOI
10.1109/77.919464

Related papers

Voltage divider operation using high-Tc superconducting interface-engineered Josephson junctions

Kazuo Saitoh, Yoshihisa Soutome, Tokuumi Fukazawa +2 more

A rapid-single-flux-quantum toggle-flip-flop logic gate was fabricated using high-temperature superconducting interface-engineered Josephson junctions. It was shown that the gate can operate as a voltage divider up to 155 GHz at 15 K and 19 GHz at 27 K. At the same time, the temperature dependence of the IcRn product and the maximum divided voltage was compared. As a result, it was found that the ratio of these values is 0.4–0.1 for 15 K>T>27 K. Circuit simulation with noise sources reveals this peculiar temperature dependence of the maximum divided voltage.

Applied Physics Letters•May 1, 2000•19 citations

Operation of Toggle Flip-Flop Circuits Up to 500 GHz Based on Vertically-Stacked High-Temperature Superconductor Josephson Junctions

Taishi Kimura, Kemmei Kajino, Makoto Watanabe +3 more

We report a developed single-flux-quantum (SFQ) circuit fabrication process for vertically-stacked interface-treated Josephson junctions by using high-temperature superconductor (HTS) and also report the 500 GHz operation of a toggle flip-flop (TFF). As the first trial of the circuit operation, we fabricated TFF circuits, because TFF is used as a benchmark circuit to indicate potential of the circuit operating speed. To develop the circuit fabrication process, we utilized the counter YBCO layer as a wiring layer. We obtained resistively-shunted-junction behavior of single junction fabricated by new process. In addition, we observed current-voltage characteristics at the input port and the output port of the TFF, and confirmed that the input voltage coincided with twice the output voltage up to 1.1 mV at 4.2 K, which corresponds to the correct operation up to 500 GHz. This frequency is the highest value in HTS circuits ever observed, which suggests the high potential of the vertically-stacked JJs for the circuit operation.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•7 citations

Fabrication and voltage divider operation of a T flip-flop using high-Tc interface-engineered Josephson junctions

Jun-Ho Kim, Sang‐Hyeob Kim, Gun Yong Sung

We designed and fabricated a rapid-single-flux-quantum T flip-flop (TFF) with high- T c interface-engineered Josephson junctions. Y 1 Ba 2 Cu 3 O 7− d and Sr 2 AlTaO 6 were deposited for the superconducting layer and the insulating layer, respectively. The Josephson junction was formed through an interface treatment process using Ar ion milling and vacuum annealing. We simulated a TFF circuit and designed a physical layout using WRspice and Xic. The fabricated TFF has a minimum junction width of 3 μm. Through the measurement of the voltage divider operation, the maximum operation frequency was estimated to be 53 GHz at 22 K and 106 GHz at 12 K.

Superconductor Science and Technology•Aug 2, 2002•3 citations

Dc-characteristics of a high-Tcsuperconducting sigma–delta modulator using interface-engineered Josephson junctions

K. Saitoh, Yoshihisa Soutome, Tokuumi Fukazawa +1 more

We fabricated and tested a high-temperature superconducting (HTS) sigma–delta modulator using interface-engineered Josephson junctions. Proper dc-characteristics were obtained with a sampling frequency of 100 GHz at 20 K. To achieve high-speed sampling, Josephson junctions with a higher critical-current normal-resistance product were used. Circuit simulations with thermal noise were performed for the analysis of switching characteristics and SFQ dynamics.

Superconductor Science and Technology•Jan 18, 2002•9 citations

High-frequency performance of RSFQ circuits realized in SINIS technology

M. Khabipov, D Balashov, F.-I. Buchholz +1 more

The paper presents the determination of the high-frequency performance of Rapid Single Flux Quantum (RSFQ) circuits fabricated in superconductor-insulator-normal metal-insulator-superconductor (SINIS) technology. Circuits of different designs have been realized and were experimentally investigated, including specially designed T flip-flop (TFF) structures and circuits consisting of a switch terminated in Josephson transmission lines. For TFF circuits, the operational functionality was investigated in the frequency range from dc up to nearly 200 GHz. Two frequency domains were found. In the first domain, ranging up to frequencies of 80 GHz (f/sub C//spl cong/Y/sub C///spl Phi//sub 0/), correct digital operation of the device was ascertained. Beyond this range a second domain was found, ranging to nearly 200 GHz, for which quasi-analog frequency dividing is assumed. The bias current margins are /spl plusmn/30% at 40 GHz and /spl plusmn/15% between 130 GHz and 200 GHz. For circuits consisting of a switch, the operational functionality was proved in the frequency range from dc up to 50 GHz, with bias current margins of more than /spl plusmn/20%. The critical current density of the circuits is j/sub C//spl cong/750 A/cm/sup 2/. The smallest junction area is about A=12 /spl mu/m/sup 2/, and the characteristic voltage is V/sub C/=170 /spl mu/V.

IEEE Transactions on Applied Superconductivity•Mar 1, 2001•7 citations

Monte Carlo and thermal noise analysis of ultra-high-speed high temperature superconductor digital circuits

Mark Jeffery, P.Y. Xie, Stephen R. Whiteley +1 more

We model the high temperature superconductor (HTS) rapid single flux quantum (RSFQ) toggle (T) flip-flop including process variations and thermal noise. A Monte Carlo method is used to calculate the theoretical yield of the circuit at speeds ranging from 1-83 GHz and for various process parameter spreads. Thermal noise is also included in the simulations and we calculate bit error rates at 1-150 GHz as a function of temperature. Our results demonstrate quantitatively the difference between HTS layouts with and without parasitic inductance. Furthermore, our simulations suggest that using the existing HTS process with a 250 /spl mu/V I/sub c/R/sub n/ product the T flip-flop operating temperature should be below 40 K in order to obtain bit error rates less than 10/sup -6/ at gigahertz speeds.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•50 citations
We fabricated and tested high-temperature superconducting (HTS) rapid-single-flux-quantum (RSFQ) circuits using interface-engineered Josephson junction (IEJ). The characteristics of high-speed operation were examined by voltage-divider operation based on the toggle-flip-flop circuit. An operation at 155 GHz was obtained at 15 K and the proper functioning of the voltage divider was observed up to 27 K. Temperature dependence of the maximum operation speed was analyzed by circuit simulation with thermal-noise sources. To achieve higher speed operation using a Josephson junction with a higher I/sub c/R/sub n/ product, we also fabricated an RSFQ balanced comparator using IEJ; proper switching characteristics of the circuit was confirmed up to 190 GHz at 30 K. The bias condition dependencies were studied based on the circuit simulations in the relationship of the I/sub c/R/sub n/ product. The results of circuit simulation indicate that a Josephson junction with an I/sub c/R/sub n/ product of more than 0.7 mV is required for high-speed operation (100 GHz) in high-temperature range (30-40 K). We believe that the IEJ is a promising junction candidate for realizing high-speed operation in a high-temperature range.
A rapid-single-flux-quantum toggle-flip-flop logic gate was fabricated using high-temperature superconducting interface-engineered Josephson junctions. It was shown that the gate can operate as a voltage divider up to 155 GHz at 15 K and 19 GHz at 27 K. At the same time, the temperature dependence of the IcRn product and the maximum divided voltage was compared. As a result, it was found that the ratio of these values is 0.4–0.1 for 15 K>T>27 K. Circuit simulation with noise sources reveals this peculiar temperature dependence of the maximum divided voltage.
We report a developed single-flux-quantum (SFQ) circuit fabrication process for vertically-stacked interface-treated Josephson junctions by using high-temperature superconductor (HTS) and also report the 500 GHz operation of a toggle flip-flop (TFF). As the first trial of the circuit operation, we fabricated TFF circuits, because TFF is used as a benchmark circuit to indicate potential of the circuit operating speed. To develop the circuit fabrication process, we utilized the counter YBCO layer as a wiring layer. We obtained resistively-shunted-junction behavior of single junction fabricated by new process. In addition, we observed current-voltage characteristics at the input port and the output port of the TFF, and confirmed that the input voltage coincided with twice the output voltage up to 1.1 mV at 4.2 K, which corresponds to the correct operation up to 500 GHz. This frequency is the highest value in HTS circuits ever observed, which suggests the high potential of the vertically-stacked JJs for the circuit operation.
We designed and fabricated a rapid-single-flux-quantum T flip-flop (TFF) with high- T c interface-engineered Josephson junctions. Y 1 Ba 2 Cu 3 O 7− d and Sr 2 AlTaO 6 were deposited for the superconducting layer and the insulating layer, respectively. The Josephson junction was formed through an interface treatment process using Ar ion milling and vacuum annealing. We simulated a TFF circuit and designed a physical layout using WRspice and Xic. The fabricated TFF has a minimum junction width of 3 μm. Through the measurement of the voltage divider operation, the maximum operation frequency was estimated to be 53 GHz at 22 K and 106 GHz at 12 K.
The paper presents the determination of the high-frequency performance of Rapid Single Flux Quantum (RSFQ) circuits fabricated in superconductor-insulator-normal metal-insulator-superconductor (SINIS) technology. Circuits of different designs have been realized and were experimentally investigated, including specially designed T flip-flop (TFF) structures and circuits consisting of a switch terminated in Josephson transmission lines. For TFF circuits, the operational functionality was investigated in the frequency range from dc up to nearly 200 GHz. Two frequency domains were found. In the first domain, ranging up to frequencies of 80 GHz (f/sub C//spl cong/Y/sub C///spl Phi//sub 0/), correct digital operation of the device was ascertained. Beyond this range a second domain was found, ranging to nearly 200 GHz, for which quasi-analog frequency dividing is assumed. The bias current margins are /spl plusmn/30% at 40 GHz and /spl plusmn/15% between 130 GHz and 200 GHz. For circuits consisting of a switch, the operational functionality was proved in the frequency range from dc up to 50 GHz, with bias current margins of more than /spl plusmn/20%. The critical current density of the circuits is j/sub C//spl cong/750 A/cm/sup 2/. The smallest junction area is about A=12 /spl mu/m/sup 2/, and the characteristic voltage is V/sub C/=170 /spl mu/V.
We model the high temperature superconductor (HTS) rapid single flux quantum (RSFQ) toggle (T) flip-flop including process variations and thermal noise. A Monte Carlo method is used to calculate the theoretical yield of the circuit at speeds ranging from 1-83 GHz and for various process parameter spreads. Thermal noise is also included in the simulations and we calculate bit error rates at 1-150 GHz as a function of temperature. Our results demonstrate quantitatively the difference between HTS layouts with and without parasitic inductance. Furthermore, our simulations suggest that using the existing HTS process with a 250 /spl mu/V I/sub c/R/sub n/ product the T flip-flop operating temperature should be below 40 K in order to obtain bit error rates less than 10/sup -6/ at gigahertz speeds.