Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Even harmonic Josephson magnetometry

Q. Geng, Eiichi Goto

Published Mar 1, 1993• 0 citations
Publisher

Abstract

A novel Josephson junction magnetometry scheme is proposed in which magnetic flux is applied to Josephson junctions with a modulation flux +or-z( Phi /sub 0//2 pi ) cos omega t. Two Josephson junctions are used in a push-pull mode to perform amplification through two mechanisms: negative inductance amplification of DC (low frequency) components and parametric amplification of the second harmonic. The second harmonic component of the Josephson currents, which is directly proportional to the strength of the input flux, is then selected and amplified by a phase-sensitive detector. Computer simulations show that the device behaves very well as a magnetic flux sensor with a DC offset free feature. The device's parameters and noise problems are also discussed. A preliminary analysis indicates that it is likely to have a better sensitivity than superconducting quantum interference devices.>

DOI
10.1109/77.233330

Related papers

Dispersive magnetometry with a quantum limited SQUID parametric amplifier

Michael J. Hatridge, Rajamani Vijay, D. H. Slichter +2 more

There is currently fundamental and technological interest in measuring and manipulating nanoscale magnets, particularly in the quantum coherent regime. To observe the dynamics of such systems one requires a magnetometer with not only exceptional sensitivity but also high gain, wide bandwidth, and low backaction. We demonstrate a dispersive magnetometer consisting of a two-junction superconducting quantum interference device (SQUID) in parallel with an integrated, lumped-element capacitor. Input flux signals are encoded as a phase modulation of the microwave drive tone applied to the magnetometer, resulting in a single quadrature voltage signal. For strong drive power, the nonlinearity of the resonator results in quantum limited, phase sensitive parametric amplification of this signal, which improves flux sensitivity at the expense of bandwidth. Depending on the drive parameters, the device performance ranges from an effective flux noise of 0.29 $\ensuremath{\mu}{\ensuremath{\Phi}}_{0}$Hz${}^{\ensuremath{-}1/2}$ and 20 MHz of signal bandwidth to a noise of 0.14 $\ensuremath{\mu}{\ensuremath{\Phi}}_{0}$Hz${}^{\ensuremath{-}1/2}$ and a bandwidth of 0.6 MHz. These results are in excellent agreement with our theoretical model.

arXiv:1003.2466•Physical Review B•Apr 4, 2011•270 citations

Limit characteristics of two-junction magnetic flux detector

Victor I. Danilov, K. K. Likharev, O. Sniguiriev +1 more

The sensitivity of a two-Josephson-junction interferometer as a magnetic flux detector (dc SQUID) is estimated. The minimum value of the basic SQUID characteristic-noise equivalent temperature δT = (δΦ)2/kBL appears to be as low as for the best rf SQUID mode:(\deltaT)_{\min}/(\Deltaf)\cong 3 T/f_{o}. HereTis an operating temperature, fois a characteristic frequency of the Josephson junctions and\Deltafis a post-detector bandwidth. For a typical value of SQUID inductance L this limit corresponds to flux sensitivity of the order of 10-7Φo/Hz1/2.

IEEE Transactions on Magnetics•Jan 1, 1977•8 citations

Self-synchronous parametric amplification using Josephson junctions

M. Yu

A new way to use Josephson junctions for parametric amplification with phase control is proposed. The dc current bias of the junction is adjusted such that the Josephson oscillation automatically synchronizes with the input signal and oscillates at twice the signal frequency with the proper relative phase. The impedance of the junction then has a negative resistive component which can be used for amplification. Extension to other phase sensitive circuits is also discussed.

IEEE Transactions on Magnetics•Mar 1, 1975•2 citations

Magnetometry by a proximity Josephson junction interferometer

Robab Najafi Jabdaraghi

In quantum technology, several aspects of superconductivity such as proximity effect have studied to develop a wide range of attractive applications at sub-kelvin temperatures. A new type of interferometer based on the proximity effect, taking place around transparent interfaces between normal- and superconducting metals, the Superconducting Quantum Interference Proximity Transistor (SQUIPT), relies on the phase dependence of the density of states in the proximized weak link. The SQUIPT devices offer the possibility to realize sensitive low-dissipation magnetometers compared to conventional DC SQUIDs. In this thesis, we investigate the development of the sensitive SQUIPT magnetometers. \n \nThe first part of the thesis covers the characterization of non-hysteretic SQUIPTs with enhanced responsivity. In these structures, we demonstrate magnetic flux modulation of the device characteristics displaying no hysteresis at low temperatures by simply increasing the Josephson inductance of the weak link compared to self-inductance of the superconducting loop in the device. As a consequence, improvement in magnetic field responsivity is achievable. \n \nWe then turn to the implementation of SQUIPT devices based on different fabrication methods and superconductor materials for improving the device performance. In this aspect, we fabricate and characterize niobium-based SNS devices utilizing two separate lithography and deposition steps with strong Ar ion cleaning in between. We further investigate a prototype hybrid SQUIPT device based on an Nb-Cu-Nb SNS junction with a conventional Al probe in tunnel junction. \n \nIn the third part of the thesis, we present the flux noise characterization of a SQUIPT device using simultaneous measurement of DC transport properties and shot noise. To probe the noise, we use a cryogenic amplifier operating at frequencies in the range of a few MHz. We adapt this technique for flux noise measurements in SQUIPTs, adaptable also to low-temperature shot noise measurements of other nonlinear devices with high impedance. In order to investigate flux noise of SQUIPTs, we develop a model allowing one to optimize the figures of merit of the magnetometers such as the noise-equivalent flux.

•Jan 1, 2018•2 citations

Self-synchronous parametric amplification using Josephson junctions

Yu, M. L.

A new way to use Josephson Junctions for parametric amplification with phase control is proposed.The dc current bias of the junction ts adjusted such that the Josephaon oscillation automatically synchronizes with the input signal and oscillates at twice the signal frequency with the proper relative phase.The impedance of the junction Chen haa a negative resistive component which cen be used for amplification.Extension to other phase sensitive circuits Is also discussed.

•Sep 30, 1974•0 citations

Low noise Josephson dc parametric amplifier

Mark Jeffery, Eiichi Goto

We describe a new Josephson Inductive Kinetic Amplifier (IKA) designed to measure weak dc magnetic fields with low noise. The IKA operates by frequency shifting dc input to a high frequency range and then parametrically amplifying. The IKA does not require dc offset and by frequency shifting dc input 1/f noise may be reduced. We define the circuit Lagrangian and derive the system equations. An analytical expression for the IKA transfer function is derived and the frequency response, optimal parameters, and stability are all obtained from the analytic theory. We also calculate the temperature at which the internal Nyquist noise should equal the quantum sensitivity limit. Our analysis suggests that the IKA could be more sensitive than the conventional dc Superconducting Quantum Interference Device.

Journal of Applied Physics•Jun 1, 1994•4 citations
A novel Josephson junction magnetometry scheme is proposed in which magnetic flux is applied to Josephson junctions with a modulation flux +or-z( Phi /sub 0//2 pi ) cos omega t. Two Josephson junctions are used in a push-pull mode to perform amplification through two mechanisms: negative inductance amplification of DC (low frequency) components and parametric amplification of the second harmonic. The second harmonic component of the Josephson currents, which is directly proportional to the strength of the input flux, is then selected and amplified by a phase-sensitive detector. Computer simulations show that the device behaves very well as a magnetic flux sensor with a DC offset free feature. The device's parameters and noise problems are also discussed. A preliminary analysis indicates that it is likely to have a better sensitivity than superconducting quantum interference devices.>
There is currently fundamental and technological interest in measuring and manipulating nanoscale magnets, particularly in the quantum coherent regime. To observe the dynamics of such systems one requires a magnetometer with not only exceptional sensitivity but also high gain, wide bandwidth, and low backaction. We demonstrate a dispersive magnetometer consisting of a two-junction superconducting quantum interference device (SQUID) in parallel with an integrated, lumped-element capacitor. Input flux signals are encoded as a phase modulation of the microwave drive tone applied to the magnetometer, resulting in a single quadrature voltage signal. For strong drive power, the nonlinearity of the resonator results in quantum limited, phase sensitive parametric amplification of this signal, which improves flux sensitivity at the expense of bandwidth. Depending on the drive parameters, the device performance ranges from an effective flux noise of 0.29 $\ensuremath{\mu}{\ensuremath{\Phi}}_{0}$Hz${}^{\ensuremath{-}1/2}$ and 20 MHz of signal bandwidth to a noise of 0.14 $\ensuremath{\mu}{\ensuremath{\Phi}}_{0}$Hz${}^{\ensuremath{-}1/2}$ and a bandwidth of 0.6 MHz. These results are in excellent agreement with our theoretical model.
The sensitivity of a two-Josephson-junction interferometer as a magnetic flux detector (dc SQUID) is estimated. The minimum value of the basic SQUID characteristic-noise equivalent temperature δT = (δΦ)2/kBL appears to be as low as for the best rf SQUID mode:(\deltaT)_{\min}/(\Deltaf)\cong 3 T/f_{o}. HereTis an operating temperature, fois a characteristic frequency of the Josephson junctions and\Deltafis a post-detector bandwidth. For a typical value of SQUID inductance L this limit corresponds to flux sensitivity of the order of 10-7Φo/Hz1/2.
In quantum technology, several aspects of superconductivity such as proximity effect have studied to develop a wide range of attractive applications at sub-kelvin temperatures. A new type of interferometer based on the proximity effect, taking place around transparent interfaces between normal- and superconducting metals, the Superconducting Quantum Interference Proximity Transistor (SQUIPT), relies on the phase dependence of the density of states in the proximized weak link. The SQUIPT devices offer the possibility to realize sensitive low-dissipation magnetometers compared to conventional DC SQUIDs. In this thesis, we investigate the development of the sensitive SQUIPT magnetometers. \n \nThe first part of the thesis covers the characterization of non-hysteretic SQUIPTs with enhanced responsivity. In these structures, we demonstrate magnetic flux modulation of the device characteristics displaying no hysteresis at low temperatures by simply increasing the Josephson inductance of the weak link compared to self-inductance of the superconducting loop in the device. As a consequence, improvement in magnetic field responsivity is achievable. \n \nWe then turn to the implementation of SQUIPT devices based on different fabrication methods and superconductor materials for improving the device performance. In this aspect, we fabricate and characterize niobium-based SNS devices utilizing two separate lithography and deposition steps with strong Ar ion cleaning in between. We further investigate a prototype hybrid SQUIPT device based on an Nb-Cu-Nb SNS junction with a conventional Al probe in tunnel junction. \n \nIn the third part of the thesis, we present the flux noise characterization of a SQUIPT device using simultaneous measurement of DC transport properties and shot noise. To probe the noise, we use a cryogenic amplifier operating at frequencies in the range of a few MHz. We adapt this technique for flux noise measurements in SQUIPTs, adaptable also to low-temperature shot noise measurements of other nonlinear devices with high impedance. In order to investigate flux noise of SQUIPTs, we develop a model allowing one to optimize the figures of merit of the magnetometers such as the noise-equivalent flux.
We describe a new Josephson Inductive Kinetic Amplifier (IKA) designed to measure weak dc magnetic fields with low noise. The IKA operates by frequency shifting dc input to a high frequency range and then parametrically amplifying. The IKA does not require dc offset and by frequency shifting dc input 1/f noise may be reduced. We define the circuit Lagrangian and derive the system equations. An analytical expression for the IKA transfer function is derived and the frequency response, optimal parameters, and stability are all obtained from the analytic theory. We also calculate the temperature at which the internal Nyquist noise should equal the quantum sensitivity limit. Our analysis suggests that the IKA could be more sensitive than the conventional dc Superconducting Quantum Interference Device.