Dark Counts in Nanostructured NbN Superconducting Single-Photon Detectors and Bridges
J. Kitaygorsky, I. Komissarov, Artūras Jukna, D. Pan, Olga V. Minaeva, N. Kaurova, Alexander V. Divochiy, Alexander A. Korneev, Michael A. Tarkhov, B. Voronov, I. Milostnaya, Gregory N Gol'tsman, Roman Sobolewski
We present our studies on dark counts, observed as transient voltage pulses, in current-biased NbN superconducting single-photon detectors (SSPDs), as well as in ultrathin (~4 nm), submicrometer-width (100 to 500 nm) NbN nanobridges. The duration of these spontaneous voltage pulses varied from 250 ps to 5 ns, depending on the device geometry, with the longest pulses observed in the large kinetic-inductance SSPD structures. Dark counts were measured while the devices were completely isolated (shielded by a metallic enclosure) from the outside world, in a temperature range between 1.5 and 6 K. Evidence shows that in our two-dimensional structures the dark counts are due to the depairing of vortex-antivortex pairs caused by the applied bias current. Our results shed some light on the vortex dynamics in 2D superconductors and, from the applied point of view, on intrinsic performance of nanostructured SSPDs.
We present our studies on dark counts, observed as transient voltage pulses, in current-biased NbN superconducting single-photon detectors (SSPDs), as well as in ultrathin (~4 nm), submicrometer-width (100 to 500 nm) NbN nanobridges. The duration of these spontaneous voltage pulses varied from 250 ps to 5 ns, depending on the device geometry, with the longest pulses observed in the large kinetic-inductance SSPD structures. Dark counts were measured while the devices were completely isolated (shielded by a metallic enclosure) from the outside world, in a temperature range between 1.5 and 6 K. Evidence shows that in our two-dimensional structures the dark counts are due to the depairing of vortex-antivortex pairs caused by the applied bias current. Our results shed some light on the vortex dynamics in 2D superconductors and, from the applied point of view, on intrinsic performance of nanostructured SSPDs.
Nanostructured NbN superconducting single-photon detectors (SSPDs) are fast and reliable photon counters that have become a highly desired technology in recent years. SSPDs feature counting rates up to 250 MHz in the wavelength range from UV to mid-IR, along with very low dark count rates, low timing jitter, and high detection efficiencies. Nanosecond and sub-nanosecond spontaneous transient voltage pulses, or dark counts, are studied in SSPDs along with NbN nanostripes of various dimensions. Dark counts, along with quantum efficiency (QE), determine the ultimate SSPD sensitivity. In experiments, the detector was completely isolated from the outside world by a metallic shield, and kept at temperatures below the superconducting critical temperature. Dark counts are associated with the formation of phase-slip centers, and dissociation of vortex-antivortex pairs, due to thermal fluctuations. Both temperature and current dependences are studied extensively. Additionally, resistive transitions of different samples are investigated, as well as their transport properties. Investigation of the photodetection mechanism, which requires understanding of hotspot dynamics, is presented. This was accomplished by measuring the QE dependence on temperature; it was found that QE increases monotonically with decreasing temperature. Additionally, two different read-out schemes are presented: the first is the standard scheme, where SSPDs act as photon counters, and dark counts are indistinguishable from photon counts. The second scheme is based on integrating the SSPD with a low-noise cryogenic HEMT amplifier with high-input impedance, which allows us to achieve amplitude resolution of the recorded output transients. The new read-out technique should enable photon-number resolving capability of standard devices, and possibly even energy-resolving capability, while also allowing us to study further the physics of dark counts and the photoresponse mechanism.
We report on our progress in research and development of ultrafast superconducting single-photon detectors (SSPDs) based on ultrathin NbN nanostructures. Our SSPDs were made of the 4-nm-thick NbN films with Tc ~11 K, patterned as meander-shaped, 100-nm-wide strips, and covering an area of 10×10 μm2. The detectors exploit a combined detection mechanism, where upon a single-photon absorption, a hotspot of excited electrons and redistribution of the biasing supercurrent, jointly produce a picosecond voltage transient signal across the superconducting nanostripe. The SSPDs are typically operated at 4.2 K, but their sensitivity in the infrared radiation range can be significantly improved by lowering the operating temperature from 4.2 K to 2 K. When operated at 2 K, the SSPD quantum efficiency (QE) for visible light photons reaches 30-40%, which is the saturation value limited by the optical absorption of our 4-nm-thick NbN film. With the wavelength increase of the incident photons,the QE of SSPDs decreases significantly, but even at the wavelength of 6 μm, the detector is able to count single photons and exhibits QE of about 10-2 %. The dark (false) count rate at 2 K is as low as 2x10-4 s,-1 which makes our detector essentially a background-limited sensor. The very low dark-count rate results in a noise equivalent power (NEP) below 10-18 WHz-1/2 for the mid-infrared range (6 μm). Further improvement of the SSPD performance in the mid-infrared range can be obtained by substituting NbN for another, lower-Tc materials with a narrow superconducting gap and low quasiparticles diffusivity. The use of such superconductors should shift the cutoff wavelength below 10 μm.
Dark counts in superconducting single-photon detectors (SSPDs) manifest themselves as spontaneous, transient voltage pulses, typically indistinguishable from photon counts. We present here a new readout technique based on integrating the SSPD with a low-noise, cryogenic high-electron-mobility transistor (HEMT) with high-input impedance. This arrangement allowed us to achieve amplitude resolution of the recorded output transients. In two-dimensional superconducting nanostripes, the physics of photon counting is based on the hotspot formation mechanism, while the dark counts correspond to voltage transients triggered by the vortex-antivortex motion and/or phase-slip centers. Thus, their respective transients can be distinguished by comparing the output pulse amplitude distributions. Our scheme also allowed us to perform photon-energy-resolution studies by comparing the SSPD output pulse amplitude distributions (the mean pulse amplitude and the distribution width) collected for incident single photons with different energies.
We present our studies on quantum efficiency (QE), dark counts, and noise equivalent power (NEP) of the latest generation of nanostructured NbN superconducting single-photon detectors (SSPDs) operated at 2.0 K. Our SSPDs are based on 4 nm-thick NbN films, patterned by electron beam lithography as highly-uniform 100÷120-nm-wide meander-shaped stripes, covering the total area of 10x10 μm2 with the meander filling factor of 0.7. Advances in the fabrication process and low-temperature operation lead to QE as high as ~30-40% for visible-light photons (0.56 μm wavelength)-the saturation value, limited by optical absorption of the NbN film. For 1.55 μm photons, QE was ~20% and decreased exponentially with the wavelength reaching ~0.02% at the 5-μm wavelength. Being operated at 2.0-K temperature the SSPDs revealed an exponential decrease of the dark count rate, what along with the high QE, resulted in the NEP as low as 5x10-21 W/Hz-1/2, the lowest value ever reported for near-infrared optical detectors. The SSPD counting rate was measured to be above 1 GHz with the pulse-to-pulse jitter below 20 ps. Our nanostructured NbN SSPDs operated at 2.0 K significantly outperform their semiconducting counterparts and find practical applications ranging from noninvasive testing of CMOS VLSI integrated circuits to ultrafast quantum communications and quantum cryptography.
We present our study of dark counts in ultrathin (3.5 to 10 nm thick), narrow (120 to 170 nm wide) NbN superconducting stripes of different lengths. In experiments, where the stripe was completely isolated from the outside world and kept at temperature below the critical temperature T/sub c/, we detected subnanosecond electrical pulses associated with the spontaneous appearance of the temporal resistive state. The resistive state manifested itself as generation of phase-slip centers (PSCs) in our two-dimensional superconducting stripes. Our analysis shows that not far from T/sub c/, PSCs have a thermally activated nature. At lowest temperatures, far below T/sub c/, they are created by quantum fluctuations.
We present our studies on ultrafast superconducting single-photon detectors (SSPDs) based on ultrathin NbN nanostructures. Our SSPDs are patterned by electron beam lithography from 4-nm thick NbN film into meander-shaped strips covering square area of 10/spl times/10 /spl mu/m/sup 2/. The advances in the fabrication technology allowed us to produce highly uniform 100-120-nm-wide strips with meander filling factor close to 0.6. The detectors exploit a combined detection mechanism, where upon a single-photon absorption, an avalanche of excited hot electrons and the biasing supercurrent, jointly produce a picosecond voltage transient response across the superconducting nanostrip. The SSPDs are typically operated at 4.2 K, but they have shown that their sensitivity in the infrared radiation range can be significantly improved by lowering the operating temperature from 4.2 K to 2 K. When operated at 2 K, the SSPD quantum efficiency (QE) for visible light photons reaches 30-40%, which is the saturation value limited by optical absorption of our 4-nm-thick NbN film. For 1.55 /spl mu/m photons, QE was /spl sim/20% and decreases exponentially with the increase of the optical wavelength, but even at the wavelength of 6 /spl mu/m the detector remains sensitive to single photons and exhibits QE of about 10/sup -2/%. The dark (false) count rate at 2 K is as low as 2 /spl times/ 10/sup -4/ s/sup -1/, what makes our detector essentially a background-limited sensor. The very low dark-count rate results in the noise equivalent power (NEP) as low as 10/sup -18/ WHz/sup -1/2/ for the mid-infrared range (6 /spl mu/m). Further improvement of the SSPD performance in the mid-infrared range can be obtained by substituting NbN for the other, lower-T/sub c/ superconductors with the narrow superconducting gap and low quasiparticle diffusivity. The use of such materials will shift the cutoff wavelength towards the values even longer than 6 /spl mu/m.