Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Instrumentation and Measurement

Observation of Quantized Voltage Steps Using a Josephson Junction Array Driven by Optoelectronically Generated Pulses

Chiharu Urano, Nobu‐Hisa Kaneko, Masaaki Maezawa, Taro Itatani, Sucheta M. Gorwadkar, H. Saitou, J. Maeda, Shogo Kiryu

Published Mar 16, 2007• 8 citations
Publisher

Abstract

In this paper, quantized voltage steps were observed by driving an overdamped Josephson junction array (JJA) with current pulse trains. The current pulse trains were generated by triggering a metal-semiconductor-metal photodetector installed close to JJA at 4.2 K with a mode-locked fiber laser. The intervals of the constant voltage steps were 10 muV, which agrees with the repetition frequency of the light source (49.7 MHz) and the number of Josephson junctions (100) in the JJA. This is the first step toward establishing an ac voltage standard at the National Institute of Advanced Industrial Science and Technology

DOI
10.1109/tim.2007.891065

Related papers

Operation of Josephson Junctions With Current Pulses Generated by Triggering a Cold Photo Detector With an Optical Comb

Chiharu Urano, Nobu‐Hisa Kaneko, Masaaki Maezawa +5 more

We report the experimental results on a Josephson junction array (JJA) driven by current pulse trains generated by triggering a photo detector located in a cryostat with an optical comb. The key components in the experimental system are a mode locked fiber laser, a metal-semiconductor-metal (MSM) photoconductive switch, and an overdamped JJA. Optical pulse trains generated at room temperature are transmitted via an optical fiber to the MSM-photo detector installed at 4.2 K, and then converted into electric current pulse trains to drive the overdamped JJA. Quantized voltage steps have been verified at multiples of 10 muV, which agrees with the repetition rate of the pulse laser and the number of Josephson junctions in the JJA.

IEEE Transactions on Applied Superconductivity•Jun 1, 2007•7 citations

Pulse driven Josephson voltage standard using modulated optical comb

Chiharu Urano, Nobu‐Hisa Kaneko, Masaaki Maezawa +2 more

We have performed an experiment to drive an overdamped superconductor-insulator-normal-insulator-superconductor (SINIS) Josephson junction array (JJA) with modulated current pulse trains, which are generated by modulated ultra short optical pulses. Averaged voltage outputs of the JJA have been systematically measured for various modulation patterns as a function of the bias voltage of an optical modulator. Quantized voltage steps has been clearly observed in accordance with modulation patterns under certain condition of the bias voltage of the optical modulator.

Journal of Physics Conference Series•Feb 1, 2008•6 citations

Generation of Constant Voltage Steps by a Josephson Array Driven by Optoelectronically Generated Pulses at BNM-LNE

O. Monnoye, Sophie Djordjevic, P. Cancela +1 more

Here we report the first results obtained at BNM-LNE on a Josephson array biased by optoelectronically generated pulse trains over repetition frequencies, f, from 0.5 to 1.75 MHz. For all the frequencies, we have observed quantized voltage steps as a function of the current pulse amplitude Ip. We demonstrate the independence of the step widths with f in close agreement with the numerical simulations and we confirm the flatness of a single voltage step

Conference on Precision Electromagnetic Measurements•Jun 1, 2004•7 citations

Quantum Locking Range in Pulse-Driven Josephson Junction Arrays for Alternating Voltage

D. Georgakopoulos

Pulse-driven Josephson junction arrays (PD JJAs) enable "intrinsically-accurate" generation of alternating (ac) voltage waveforms. For quantized operation, all junctions must maintain a quantum locking range (QLR) with respect to radio frequency (RF) bias. In this paper we investigate the QLR of PD JJAs for the generation of ac voltage. For this purpose, we use a lock-in amplifier-based technique that can resolve voltage changes of a few nanovolts caused by the change in RF bias. Our results show that near the QLR, the current-voltage characteristics can show apparent voltage quantization with statistical behavior nearly indistinguishable from that observed within the QLR.

Conference on Precision Electromagnetic Measurements•Sep 1, 2026•0 citations

Driving a Josephson Junction Array with a Mode-Locked Laser and a Photodiode

J. Nissilä, Thomas Fordell, Oliver Kieler +1 more

This paper describes development of a new technique to drive Josephson junction arrays (JJA). We have designed and built an optical pulse generator (up to 12 GHz pulse rate) based on a mode-locked laser to feed an ultra-fast photodiode which again can drive current pulses to a JJA. Our preliminary experiments show that precise direct current (dc) voltages can be realized with a JJA with 5000 junctions. The work ultimately aims at development of an arbitrary pulse pattern generator allowing generation of precise arbitrary voltage waveforms.

Conference on Precision Electromagnetic Measurements•Jul 1, 2018•3 citations

Josephson Arbitrary Waveform System with Optoelectronic Drive

Jane Ireland, Oliver Kieler, J. Kohlmann +10 more

Quantum-accurate arbitrary voltage waveforms have been generated using electrical pulse driven Josephson junction arrays (JJAs) by several groups [1, 2]. An alternative method is to use optoelectronic components to convert the electrical pulse drive into an optical signal which is subsequently converted by a photodiode into an electrical drive signal connected directly to the JJA. This optoelectronic pulse drive system has several advantages. Due to the electrical isolation between electrical pulse drive and JJA, it is possible to connect several arrays in series without the requirement for complex electrical compensation circuits. This allows larger output voltages to be realized. An optoelectronic drive also offers the ability to easily tune pulse height, via continuous optical attenuation, allowing the drive signal to be tuned to the middle of the JJA constant voltage step giving optimum operation margins. We here present an optoelectronic pulse drive which forms part of a system incorporating a JJA and delta sigma feedback loop [3] for quantum-accurate digitization of arbitrary voltage waveforms. Results showing the generation of quantum-accurate voltages synchronized to the feedback loop master clock are presented.

IEEE International Superconductive Electronics Conference (ISEC)•Jun 1, 2017•3 citations
In this paper, quantized voltage steps were observed by driving an overdamped Josephson junction array (JJA) with current pulse trains. The current pulse trains were generated by triggering a metal-semiconductor-metal photodetector installed close to JJA at 4.2 K with a mode-locked fiber laser. The intervals of the constant voltage steps were 10 muV, which agrees with the repetition frequency of the light source (49.7 MHz) and the number of Josephson junctions (100) in the JJA. This is the first step toward establishing an ac voltage standard at the National Institute of Advanced Industrial Science and Technology
We report the experimental results on a Josephson junction array (JJA) driven by current pulse trains generated by triggering a photo detector located in a cryostat with an optical comb. The key components in the experimental system are a mode locked fiber laser, a metal-semiconductor-metal (MSM) photoconductive switch, and an overdamped JJA. Optical pulse trains generated at room temperature are transmitted via an optical fiber to the MSM-photo detector installed at 4.2 K, and then converted into electric current pulse trains to drive the overdamped JJA. Quantized voltage steps have been verified at multiples of 10 muV, which agrees with the repetition rate of the pulse laser and the number of Josephson junctions in the JJA.
We have performed an experiment to drive an overdamped superconductor-insulator-normal-insulator-superconductor (SINIS) Josephson junction array (JJA) with modulated current pulse trains, which are generated by modulated ultra short optical pulses. Averaged voltage outputs of the JJA have been systematically measured for various modulation patterns as a function of the bias voltage of an optical modulator. Quantized voltage steps has been clearly observed in accordance with modulation patterns under certain condition of the bias voltage of the optical modulator.
Pulse-driven Josephson junction arrays (PD JJAs) enable "intrinsically-accurate" generation of alternating (ac) voltage waveforms. For quantized operation, all junctions must maintain a quantum locking range (QLR) with respect to radio frequency (RF) bias. In this paper we investigate the QLR of PD JJAs for the generation of ac voltage. For this purpose, we use a lock-in amplifier-based technique that can resolve voltage changes of a few nanovolts caused by the change in RF bias. Our results show that near the QLR, the current-voltage characteristics can show apparent voltage quantization with statistical behavior nearly indistinguishable from that observed within the QLR.
This paper describes development of a new technique to drive Josephson junction arrays (JJA). We have designed and built an optical pulse generator (up to 12 GHz pulse rate) based on a mode-locked laser to feed an ultra-fast photodiode which again can drive current pulses to a JJA. Our preliminary experiments show that precise direct current (dc) voltages can be realized with a JJA with 5000 junctions. The work ultimately aims at development of an arbitrary pulse pattern generator allowing generation of precise arbitrary voltage waveforms.
Quantum-accurate arbitrary voltage waveforms have been generated using electrical pulse driven Josephson junction arrays (JJAs) by several groups [1, 2]. An alternative method is to use optoelectronic components to convert the electrical pulse drive into an optical signal which is subsequently converted by a photodiode into an electrical drive signal connected directly to the JJA. This optoelectronic pulse drive system has several advantages. Due to the electrical isolation between electrical pulse drive and JJA, it is possible to connect several arrays in series without the requirement for complex electrical compensation circuits. This allows larger output voltages to be realized. An optoelectronic drive also offers the ability to easily tune pulse height, via continuous optical attenuation, allowing the drive signal to be tuned to the middle of the JJA constant voltage step giving optimum operation margins. We here present an optoelectronic pulse drive which forms part of a system incorporating a JJA and delta sigma feedback loop [3] for quantum-accurate digitization of arbitrary voltage waveforms. Results showing the generation of quantum-accurate voltages synchronized to the feedback loop master clock are presented.