Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

On-chip integration of HTS Josephson oscillator and mixer

S. Beuven, Marian Darula, Oliver Harnack, K. Karlovský, H. Kohlstedt

Published Jun 1, 1999• 2 citations
Publisher

Abstract

We report on the experimental realization of a sub-mm wavelength oscillator based on HTS Josephson junctions integrated on-chip with detector Josephson junction-mixer. Detector and oscillator are coupled via a microstripline. The oscillator is a 2-dimensional (2D) network (array) of 20 HTS step-edge junctions. The array is biased in parallel, i.e. all junctions of the network are oscillating with the same frequency. Effective pumping of the Josephson mixer was possible up to several hundred GHz. The best results, i.e. significant depression of the critical current and steep Shapiro steps up to the 4th order, were obtained between 150 GHz and 200 GHz. Power transfer was detectable up to frequencies around 1.15 THz.

DOI
10.1109/77.783848

Related papers

Superconducting millimeter wave oscillators and SIS mixers integrated on a chip

V. P. Koshelets, А. В. Щукин, S. V. Shitov +1 more

All-refractory material superconducting millimeter-wave oscillators have been designed and investigated experimentally with different superconductor-insulator-superconductor (SIS) mixers integrated on the same chip. Tested structures include a flux-flow oscillator (FFO) based on a long Josephson junction, a coupling section, and an SIS detector with tuned out junction capacitance. Coupling sections were designed as multistep microstrip quarter-wave impedance transformers. All junctions have been fabricated on the basis of a high-quality trilayer Nb-AlO/sub x/-Nb process. Microwave oscillations in the frequency range 75-500 GHz have been detected experimentally. The level of delivered power was estimated from the pumped I-V curve of the strongly coupled single junction detector. Coupled power levels higher than 0.1 mu W at 256 GHz were achieved. A spectral linewidth of the FFO of less than 1 MHz has been estimated experimentally. The first attempt to create an integrated receiver based on an FFO and an SIS array mixer integrated on the same chip was made in the 2-mm wavelength band.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•65 citations

HTS Josephson junction devices for microwave and terahertz applications

Jia Du

The CSIRO Applied Superconductivity Group has a long-term effort in research and development of superconducting electronic devices and systems for various practical applications. In this paper, I will mainly describe our recent research progress in developing novel HTS Josephson devices for high frequency applications. Specifically, we have recently developed a novel HTS Josephson heterodyne gigahertz (GHz) microwave oscillator and on-chip down-converter (mixer). For even higher frequency application, we developed a HTS Josephson junction terahertz (THz) detector and applied it successfully to THz imaging. I will highlight some of the recent results and describe the on-going effort of developing an array of such detectors and associated electronics as well as system integration.

International Conference on Applied Superconductivity and Electromagnetic Devices•Dec 1, 2011•1 citation

HTS step-edge Josephson junction terahertz harmonic mixer

Jia Du, Andrew R. Weily, Xiang Gao +3 more

A high-temperature superconducting (HTS) terahertz (THz) frequency down-converter or mixer based on a thin-film ring-slot antenna coupled YBa 2 Cu 3 O 7– x (YBCO)/MgO step-edge Josephson junction is reported. The frequency down-conversion was achieved using higher order harmonics of an applied lower frequency (19–40 GHz) local oscillator signal in the Josephson junction mixing with a THz signal of over 600 GHz, producing a 1–3 GHz intermediate frequency signal. Up to 31st order of harmonic mixing was obtained and the mixer operated stably at temperatures up to 77 K. The design details of the antenna, HTS Josephson junction mixer, the matching and isolation circuits, and the DC and RF performance evaluation are described in this paper.

Superconductor Science and Technology•Nov 30, 2016•45 citations

Characterizations of High-Temperature Superconducting Step-Edge Josephson Junction Mixer

Dan Dan Bai, Jia Du, Yu Sheng He

We report the experimental evaluation of a high-temperature superconducting (HTS) Josephson mixer. The mixer is fabricated from a HTS step-edge junction on MgO substrate. The mixer device operates as a lower side-band down-converter from a radio frequency between 6 and 10 GHz to a 1-2 GHz intermediate frequency under the action of a local oscillator. The experimental results of the current-voltage characteristics, optimal bias conditions, dynamic range, linearity, conversion gain, and the temperature dependence of the mixer are presented.

IEEE Transactions on Applied Superconductivity•Aug 15, 2014•6 citations

Harmonic Mixing Using a HTS Step-Edge Josephson Junction at 0.6 THz Frequency

Jia Du, Colin M. Pegrum, Xiang Gao +4 more

A high-temperature superconducting (HTS) terahertz (THz) heterodyne mixer based on a thin-film antenna-coupled YBa2Cu3O7-xstep-edge Josephson junction is presented. The frequency down-conversion from 0.6 THz to an intermediate frequency (IF) of 2 GHz was achieved using high-order harmonic mixing of a local oscillator (LO), thus removing the need to use a second THz source as the LO pumping source. The DC and RF characteristics of the harmonic mixer as well as the relationship of the IF output power versus the harmonic number were experimentally studied and compared with simulated results. Most of our measurements were made at 40 K, but we also observed stable harmonic mixing at 77 K which we believe has not been reported previously in HTS junction mixers.

IEEE Transactions on Applied Superconductivity•Dec 6, 2016•29 citations

A self-pumped high-temperature superconducting Josephson mixer: Modelling and measurement

Jia Du, J.C. Macfarlane, Colin M. Pegrum +3 more

We have recently developed a high-temperature superconducting (HTS) Josephson self-pumped mixer with an on-chip heterodyne local oscillator. The device is based on HTS step-edge junction technology and a “resistive-superconducting quantum interference device” (RSQUID) configuration. The heterodyne local oscillator and mixer output are frequency-tunable from below 10 MHz to 5 GHz by a control current. The performance of the autonomous Josephson mixer–local oscillator has been experimentally evaluated in terms of the current-voltage characteristics, intermediate frequency (IF)-tunable bandwidth, operation range, linearity, bias current, and temperature dependence of the IF output (or mixer conversion efficiency). We find the results are in good overall agreement with numerical simulation.

Journal of Applied Physics•Mar 1, 2012•10 citations
We report on the experimental realization of a sub-mm wavelength oscillator based on HTS Josephson junctions integrated on-chip with detector Josephson junction-mixer. Detector and oscillator are coupled via a microstripline. The oscillator is a 2-dimensional (2D) network (array) of 20 HTS step-edge junctions. The array is biased in parallel, i.e. all junctions of the network are oscillating with the same frequency. Effective pumping of the Josephson mixer was possible up to several hundred GHz. The best results, i.e. significant depression of the critical current and steep Shapiro steps up to the 4th order, were obtained between 150 GHz and 200 GHz. Power transfer was detectable up to frequencies around 1.15 THz.
All-refractory material superconducting millimeter-wave oscillators have been designed and investigated experimentally with different superconductor-insulator-superconductor (SIS) mixers integrated on the same chip. Tested structures include a flux-flow oscillator (FFO) based on a long Josephson junction, a coupling section, and an SIS detector with tuned out junction capacitance. Coupling sections were designed as multistep microstrip quarter-wave impedance transformers. All junctions have been fabricated on the basis of a high-quality trilayer Nb-AlO/sub x/-Nb process. Microwave oscillations in the frequency range 75-500 GHz have been detected experimentally. The level of delivered power was estimated from the pumped I-V curve of the strongly coupled single junction detector. Coupled power levels higher than 0.1 mu W at 256 GHz were achieved. A spectral linewidth of the FFO of less than 1 MHz has been estimated experimentally. The first attempt to create an integrated receiver based on an FFO and an SIS array mixer integrated on the same chip was made in the 2-mm wavelength band.>
The CSIRO Applied Superconductivity Group has a long-term effort in research and development of superconducting electronic devices and systems for various practical applications. In this paper, I will mainly describe our recent research progress in developing novel HTS Josephson devices for high frequency applications. Specifically, we have recently developed a novel HTS Josephson heterodyne gigahertz (GHz) microwave oscillator and on-chip down-converter (mixer). For even higher frequency application, we developed a HTS Josephson junction terahertz (THz) detector and applied it successfully to THz imaging. I will highlight some of the recent results and describe the on-going effort of developing an array of such detectors and associated electronics as well as system integration.
A high-temperature superconducting (HTS) terahertz (THz) frequency down-converter or mixer based on a thin-film ring-slot antenna coupled YBa 2 Cu 3 O 7– x (YBCO)/MgO step-edge Josephson junction is reported. The frequency down-conversion was achieved using higher order harmonics of an applied lower frequency (19–40 GHz) local oscillator signal in the Josephson junction mixing with a THz signal of over 600 GHz, producing a 1–3 GHz intermediate frequency signal. Up to 31st order of harmonic mixing was obtained and the mixer operated stably at temperatures up to 77 K. The design details of the antenna, HTS Josephson junction mixer, the matching and isolation circuits, and the DC and RF performance evaluation are described in this paper.
We report the experimental evaluation of a high-temperature superconducting (HTS) Josephson mixer. The mixer is fabricated from a HTS step-edge junction on MgO substrate. The mixer device operates as a lower side-band down-converter from a radio frequency between 6 and 10 GHz to a 1-2 GHz intermediate frequency under the action of a local oscillator. The experimental results of the current-voltage characteristics, optimal bias conditions, dynamic range, linearity, conversion gain, and the temperature dependence of the mixer are presented.
A high-temperature superconducting (HTS) terahertz (THz) heterodyne mixer based on a thin-film antenna-coupled YBa2Cu3O7-xstep-edge Josephson junction is presented. The frequency down-conversion from 0.6 THz to an intermediate frequency (IF) of 2 GHz was achieved using high-order harmonic mixing of a local oscillator (LO), thus removing the need to use a second THz source as the LO pumping source. The DC and RF characteristics of the harmonic mixer as well as the relationship of the IF output power versus the harmonic number were experimentally studied and compared with simulated results. Most of our measurements were made at 40 K, but we also observed stable harmonic mixing at 77 K which we believe has not been reported previously in HTS junction mixers.
We have recently developed a high-temperature superconducting (HTS) Josephson self-pumped mixer with an on-chip heterodyne local oscillator. The device is based on HTS step-edge junction technology and a “resistive-superconducting quantum interference device” (RSQUID) configuration. The heterodyne local oscillator and mixer output are frequency-tunable from below 10 MHz to 5 GHz by a control current. The performance of the autonomous Josephson mixer–local oscillator has been experimentally evaluated in terms of the current-voltage characteristics, intermediate frequency (IF)-tunable bandwidth, operation range, linearity, bias current, and temperature dependence of the IF output (or mixer conversion efficiency). We find the results are in good overall agreement with numerical simulation.