The first local oscillators based on moving magnetic flux quanta in long Josephson junctions are being developed for superconducting integrated quasi-optical SIS receivers. In order to further refine these oscillators one has to understand the complex dynamics of these devices. Since the local tunnel current is one of the most important internal junction parameters which together with the boundary conditions determine the dynamics, it is of vital importance to experimentally determine the current density throughout the entire junction with high spatial resolution. Here we report on measurements on different oscillator samples, performed with a novel Cryogenic Scanning Laser Microscope (CSLM) having a spatial resolution of less than /spl plusmn/2.5 /spl mu/m over a 500 /spl mu/m/spl times/50 /spl mu/m wide scanning area in the temperature range 2 K-300 K. Even though the dynamical states are extremely sensitive to external noise this microscope enables us to make stable in-situ measurements on operating Josephson junctions. Recent results are presented and discussed.>
The first local oscillators based on moving magnetic flux quanta in long Josephson junctions are being developed for superconducting integrated quasi-optical SIS receivers. In order to further refine these oscillators one has to understand the complex dynamics of these devices. Since the local tunnel current is one of the most important internal junction parameters which together with the boundary conditions determine the dynamics, it is of vital importance to experimentally determine the current density throughout the entire junction with high spatial resolution. Here we report on measurements on different oscillator samples, performed with a novel Cryogenic Scanning Laser Microscope (CSLM) having a spatial resolution of less than /spl plusmn/2.5 /spl mu/m over a 500 /spl mu/m/spl times/50 /spl mu/m wide scanning area in the temperature range 2 K-300 K. Even though the dynamical states are extremely sensitive to external noise this microscope enables us to make stable in-situ measurements on operating Josephson junctions. Recent results are presented and discussed.>
A novel cryogenic scanning laser microscope with a spatial resolution of less than 5 μm has been designed for on-chip in situ investigations of the working properties of normal and superconducting circuits and devices. The instrument relies on the detection of the electrical response of the circuit to a very localized heating induced by irradiation with 675 nm wavelength light from a semiconductor laser. The hot spot is moved by a specially designed piezoelectric scanner sweeping the tip of a single-mode optical fiber a few μm above the circuit. Depending on the scanner design the scanning area can be as large as 50×500 μm2 at 4.2 K. The microscope can be operated in the temperature range 2–300 K using a standard temperature controller. The central microscope body is mounted inside the vacuum can of a dip-stick-type cryoprobe. A damped spring system is used to reduce interference from extraneous mechanical vibrations. The microscope is integrated in a personal-computer-based data acquisition and control setup.
The low-current fluctuations at cryogenic temperatures together with the low dynamical resistance in the resonant states of Josephson tunnel junctions allow for the realization of superconducting oscillators up to the THz range with ultra-low spectral linewidth. By virtue of the Josephson frequency-voltage relationship, we show that the same properties can be exploited for the practical realization of magnetic flux-to-voltage transducers based on the flux–flow in long Josephson tunnel junctions whose intrinsic low-frequency voltage fluctuations at amount to few , that is, too small to be measured by any present semiconductor electronics. Nevertheless, by using a double transformer SQUID amplifier we demonstrate that the (amplitude) voltage spectral density, , of an all-niobium sensor does not exceed the level of and is not affected by excess noise at least down to few hertz. Such ultra-low white noise, corresponding to a magnetic field noise , together with a highly linear and broadband voltage responsivity over a wide magnetic flux range, makes the flux–flow magnetometers potentially competitive with SQUID-based devices.
The first object of this work is to theoretically study the effects of tunnel junction parameters on flux-flow Josephson oscillators (FFOs) by numerical simulation and to experimentally study the rf properties of FFOs by integrating them together with an SIS (superconductor-insulator-superconductor) mixer/detector on a chip. By using a CAD modeled integrated sub-mm wave receiver, the composite linewidth of two FFOs was measured to be less than 2.1 MHz in the band 280-330 GHz. The receiver consists of two identical FFOs and an SIS mixer. The linewidth was determined by mixing the two signals in the SIS mixer and analyzing the intermediate frequency. The output power coupled to a 10 .OMEGA. microstripline was about 0.5 µW, and could be adjusted by changing the current bias of the oscillator. The FFOs are connected to the SIS mixer via interdigital capacitors. The FFOs and the SIS element are made of Nb/NbOx/PbBi junctions by the "reactive ion beam oxidation" technique with the critical current density jc controlled by the oxidation time. Lift-off stencils for defining the junction sizes and the top-electrodes were made by using electron-beam writing on PMMA/Copolymer double layer resist. The jc of a long Josephson junction (LJJ) determines the fluxon motion. For LJJs which had jc > 1 kA/cm2, velocity-matching (VM, where the phase velocity of propagating fluxons equals that of the electromagnetic wave in the LJJ) steps could be tuned linearly from about 0.2 to 1.4 mV by an applied magnetic field. Coupled radiation at around 100 GHz (about 3 nW), 261 GHz (4.6 nW), and 330 GHz (0.43 µW), from flux-flow oscillations, was observed. From the step's steepness, the junction quality factor QJ is determined. QJ is between 4 to 7 in the voltage range of 0.4 to 1 mV. Coupled radiation (> 3 nW) at around 100 GHz corresponding to resonant soliton oscillation in low jc samples (250 to 1000 A/cm2) was detected. Simulations show that, for a uniform bias feed, the height of the VM step .gammam increases almost linearly with the external magnetic field .beta.e and the quasiparticle loss .alpha., but is less dependent on the surface loss .beta.. An approximate expression .gammam = a + .alpha(1+b).beta.e agrees with simulations. The maximum ac output voltage decreases with increasing dampings .alpha. and .beta.. It is important to include the .beta.-term in the mathematical model. The second part of this work is devoted to rf properties of long YBa2Cu3O7-.delta. (YBCO) grain boundary junctions made on 0- 32 °. [001]-tilt YSZ bicrystals. Josephson flux-flow resonances and Fiske resonances were observed. The first resonances could be tuned from about 0.5 to 2.0 mV in a 30 µm long junction at 16 K, and we determined the ratio between barrier thickness and relative dielectric constant td/.epsilon.r=2.9 Å and the loss .alpha.= 1.3 at 16 K. Simulations support the experimental observation that Josephson vortices can propagate unidirectionally in an overdamped, homogeneous junction up to .alpha.Ã? 2. From the Fiske resonances at 256-638 GHz, their Q-values, and the Steward-McCumber parameter, we find td/.epsilon.r=4 Å, the London penetration depth .gamma.L=145±5 nm and the surface resistance RS ~20 m.OMEGA. at 280 GHz. We conclude that the boundary is dielectric and the YBCO grains are well superconducting within 5-20 nm from the boundary. The dielectric between the grains could be part of a tunnel barrier and/or a matrix for filamentary conduction. Josephson flux-flow transitors based on long bicrystal junctions were made with an Au loop used as the control line. The line modulated the critical current Ic. Current gain larger than unity was obtained below 70 K. The gain increased with the junction length and varied roughly like the square root Ic when adjusting the temperature. A transresistance larger than 5 .OMEGA. was obtained at 15 K. Better performance is expected from junctions with high current densities.
Low temperature scanning electron microscopy (LTSEM) offers the possibility for spatially resolved investigations of microwave properties of single Josephson junctions, superconducting striplines, resonators, and complex cryoelectric circuits during their operation. The spatial resolution of about 1 μm is at least two orders of magnitude better than the typical wavelength (≳100 μm in the elements) in the frequency range of interest (50–500 GHz). We demonstrate that LTSEM is a well suited tool for the experimental investigation of superconducting microwave devices and cryoelectronic circuits.
We have designed and characterized a micro-SQUID with dispersive readout for use in low temperature scanning probe microscopy systems. The design features a capacitively shunted RF SQUID with a tunable resonance frequency from 5 to 12 GHz, micrometer spatial resolution, and integrated superconducting coils for local application of magnetic fields. The SQUID is operated as a nonlinear oscillator with a flux- and power-dependent resonance frequency. Measurements for device characterization and noise benchmarking were carried out at 4 K. The measured flux noise above 10 kHz at 4 K is 80 nΦ0 Hz−1∕2 at a bandwidth of 200 MHz. Estimations suggest that one can benefit from parametric gain based on inherent nonlinearity of the Josephson junction and reduce the flux noise to 30 nΦ0Hz–1∕2 at 100 mK, which corresponds to 10.6 μBHz–1∕2 for a magnetic moment located at the center of the pickup loop.
We discuss the dynamics of two-dimensional arrays of Josephson junctions in the overdamped regime. Our discussion is restricted to “classical” arrays, where the Josephson coupling energy is much larger than the charging energy. Such arrays represent a highly controllable system to study the dynamics of vortices. Furthermore, they are promising for applications like, e.g., a coherent microwave source. The experiments have been performed with arrays of Nb/AlOx/Nb-tunnel junctions allowing a high degree of junction uniformity across the array. The typical array size is 10×10 junctions. We show spatially resolved measurement results obtained by low-temperature scanning electron microscopy, and demonstrate the merit of these investigations for the clarification of complex regimes of vortex dynamics as well as for the optimization of coherent microwave sources. In the case of external microwave irradiation with increasing power, a continuous transition from a non-locked to a completely locked oscillation state is presented. In addition, we report on the quantitative measurement of the emitted microwave power from the arrays.