Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Quantum Electronics

Optical bistability in a nonlinear directional coupler

Carsten Thirstrup

Published Jan 1, 1995• 17 citations
Publisher

Abstract

In the nonlinear directional coupler, the optical field and the nonlinear material usually interact in a spatially and temporally local fashion and the device exhibits a nonlinear transmission characteristics, but it is not bistable. In this paper, it is shown theoretically that optical bistability in the input optical power is possible for the nonlinear directional coupler if the local phase change of the optical mode propagating through tile coupler is influenced by the excitation over the whole coupler. This condition can be satisfied in a coupler based on biased-pin-diodes comprising coupled asymmetric quantum wells in the i-region, Calculations show that in this configuration, the nonlinear directional coupler can exhibit sharp switching characteristics, low switching optical powers, optical bistability or bifurcation.

DOI
10.1109/3.477733

Related papers

Observation of Optical Bistability in Oppositely Directed Coupler

K. Nithyanandan

Nonlinear directional couplers (NDCs) find wide interest in optical communication system because of its potential application in signal processing including optical switching and logic operation. In couplers, if any one of the channel of NDCs is replaced with negative index material (NIM), then the coupler is called as oppositely directed coupler (ODC) because of the opposite direction of input and output fields. The electromagnetic wave entering in one channel of the coupler leave through other channel in opposite direction. Optical bistability (OB) is a nonlinear phenomenon observed in optical systems such that, the system possesses two output intensities for the same input intensity. The importance of optical bistability arises due to its potential application for the development of devices such as optical switches, memories, and amplifiers. The primary requirements of OB are the intensity dependent refractive index and optical feedback mechanism. A two core directional coupler with channels made of nonlinear and homogeneous materials is not bistable. However, ODC shows the phenomenon of OB and admit gap solitons due to effective feedback mechanism in NIM channel arising as a result of opposite directionality of phase velocity and energy flow.

JSAP-OSA Joint Symposia•Jan 1, 2017•0 citations

Optical Bistability and Switching in Oppositely Directed Coupler

Asghar Ali, K. Nithyanandan, Kuppusamy Porsezian +1 more

We report the optical bistability in two core oppositely directed coupler with negative index material channel. Using Langrangian variational method and Jacobi elliptic functions, we construct the solutions of the coupled nonlinear Schrödinger equations. The bistability arises due to the effective feedback mechanism as a result of opposite directionality of the phase velocity and energy flow in the negative index material channel. We report the various ways to control and manipulate the bistability threshold and hysteresis loop, which could be useful in the design and development of fast and low-threshold optical switches.

IEEE Journal of Quantum Electronics•Oct 10, 2016•10 citations

Bistability in oppositely directed coupler with negative index material channel

K. Nithyanandan, Asghar Ali, Patrice Tchofo Dinda +1 more

We observe that the oppositely directed coupler possesses optical bistable property. This property arises due to effective feedback mechanism as a result of opposite directionality of the phase velocity and energy flow in the negative index materials channel. We also report on the various means of tailoring the optical bistability power threshold and hysteresis loop for applications related to fast optical switches.

OSA Advanced Photonics Congress•Jan 1, 2018•0 citations

A Novel Observation of Optical Bistability in Oppositely Directed Coupler

K. Nithyanandan, Asghar Ali, Kuppuswamy Porsezian

We observe that the oppositely directed coupler possesses optical bistable property. This property arises due to effective feedback mechanism as a result of opposite directionality of the phase velocity and energy flow in the negative index materials channel. We also report on the various means of tailoring the optical bistability power threshold and hysteresis loop for applications related to fast optical switches.

Frontiers in Optics•Jan 1, 2016•0 citations

Bistability and switching in nonlinear prism coupling

G. I. Stegeman, G. Assanto, Raymond Zanoni +5 more

We demonstrate that when a nonlinear coupler is operated in the switching regime, small amounts of either nonlocality in the optically induced refractive index change or of longitudinal feedback can lead to optical bistability. Outside the switching regime, there is a threshold for the amount of nonlocality or feedback required for bistability. The diverse predictions of previous theoretical formulations are therefore reconciled.

Applied Physics Letters•Mar 14, 1988•71 citations

Nonlinear Prism Coupler with Diffusion

Guy Vitrant, R. Reinisch, Jean-Claude Paumier +2 more

The salient question which arises when light is coupled via a grating or a prism into a waveguide exhibiting an intensity-dependent refractive index is whether switching occurs with or without bistability under appropriate detuning conditions. There are two prevailing theories. In the first1, a plane wave input is assumed leading to a uniform optically induced index change in the coupling region. In the second2, a finite width incident beam is assumed and the growth of the guided field under the coupler leads to an index change proportional to the local guided wave intensity. The first approach leads to optical bistability under certain detuning conditions, whereas the second results in switching only. Although it is known that plane wave analyses are inadequate when dealing with linear-nonlinear interfaces, bistability has been observed experimentally with nonlinear prism couplers3. Fundamentally the finite beam theoretical approaches are unable to predict bistability because no longitudinal feedback is included. Recently we showed that when non-locality is introduced into the optically induced refractive index change, longitudinal feedback occurs and bistability is predicted for the growing mode case4. However, the model used for the non-locality was artificial and resulted only in qualitative predictions. In this paper the nonlocality is modelled by the same equation used to describe heat transfer and carrier diffusion, leading to a quantitative estimate of the minimum diffusion length required for bistability.

Nonlinear Guided Waves and Their Applications•Jan 1, 1989•0 citations
In the nonlinear directional coupler, the optical field and the nonlinear material usually interact in a spatially and temporally local fashion and the device exhibits a nonlinear transmission characteristics, but it is not bistable. In this paper, it is shown theoretically that optical bistability in the input optical power is possible for the nonlinear directional coupler if the local phase change of the optical mode propagating through tile coupler is influenced by the excitation over the whole coupler. This condition can be satisfied in a coupler based on biased-pin-diodes comprising coupled asymmetric quantum wells in the i-region, Calculations show that in this configuration, the nonlinear directional coupler can exhibit sharp switching characteristics, low switching optical powers, optical bistability or bifurcation.
Nonlinear directional couplers (NDCs) find wide interest in optical communication system because of its potential application in signal processing including optical switching and logic operation. In couplers, if any one of the channel of NDCs is replaced with negative index material (NIM), then the coupler is called as oppositely directed coupler (ODC) because of the opposite direction of input and output fields. The electromagnetic wave entering in one channel of the coupler leave through other channel in opposite direction. Optical bistability (OB) is a nonlinear phenomenon observed in optical systems such that, the system possesses two output intensities for the same input intensity. The importance of optical bistability arises due to its potential application for the development of devices such as optical switches, memories, and amplifiers. The primary requirements of OB are the intensity dependent refractive index and optical feedback mechanism. A two core directional coupler with channels made of nonlinear and homogeneous materials is not bistable. However, ODC shows the phenomenon of OB and admit gap solitons due to effective feedback mechanism in NIM channel arising as a result of opposite directionality of phase velocity and energy flow.
We report the optical bistability in two core oppositely directed coupler with negative index material channel. Using Langrangian variational method and Jacobi elliptic functions, we construct the solutions of the coupled nonlinear Schrödinger equations. The bistability arises due to the effective feedback mechanism as a result of opposite directionality of the phase velocity and energy flow in the negative index material channel. We report the various ways to control and manipulate the bistability threshold and hysteresis loop, which could be useful in the design and development of fast and low-threshold optical switches.
The salient question which arises when light is coupled via a grating or a prism into a waveguide exhibiting an intensity-dependent refractive index is whether switching occurs with or without bistability under appropriate detuning conditions. There are two prevailing theories. In the first1, a plane wave input is assumed leading to a uniform optically induced index change in the coupling region. In the second2, a finite width incident beam is assumed and the growth of the guided field under the coupler leads to an index change proportional to the local guided wave intensity. The first approach leads to optical bistability under certain detuning conditions, whereas the second results in switching only. Although it is known that plane wave analyses are inadequate when dealing with linear-nonlinear interfaces, bistability has been observed experimentally with nonlinear prism couplers3. Fundamentally the finite beam theoretical approaches are unable to predict bistability because no longitudinal feedback is included. Recently we showed that when non-locality is introduced into the optically induced refractive index change, longitudinal feedback occurs and bistability is predicted for the growing mode case4. However, the model used for the non-locality was artificial and resulted only in qualitative predictions. In this paper the nonlocality is modelled by the same equation used to describe heat transfer and carrier diffusion, leading to a quantitative estimate of the minimum diffusion length required for bistability.