Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Optics

Characteristics of ruby passive Q switching with a Dy^2+:CaF_2 solid-state saturable absorber

Yen‐Kuang Kuo, Milton Birnbaum

Published Oct 20, 1995• 10 citations
Publisher

Abstract

Characteristics of ruby passive Q switching with a Dy(2+):CaF(2) solid-state saturable absorber are investigated with output couplers of various reflectivities and saturable absorbers of different thicknesses. Numerical simulation is used to investigate the behavior of ruby passive Q switching with a Dy(2+):CaF(2) saturable absorber and to interpret the experimental results.

DOI
10.1364/ao.34.006829

Related papers

Dy^2+:CaF_2 saturable-absorber Q switch for the ruby laser

Yen‐Kuang Kuo, Wei Chen, Robert D. Stultz +1 more

Passive Q switching of a flash-lamp-pumped ruby laser has been demonstrated with a Dy(2+):CaF(2) saturable absorber at room temperature. Typically a single Q-switched pulse of 4.5 mJ and 94 ns was observed. At 694 nm, the ground-state absorption cross section and the excited-state absorption cross section of the Dy(2+):CaF(2) absorber were found to be 1.2 × 10(-18) cm(2) and 0.9 × 10(-18) cm(2) respectively, with a four-level slow-relaxing saturable-absorber model.

Applied Optics•Sep 20, 1994•13 citations

Saturation characteristics of Cr^4+:YAG crystals and dye films for passive Q switches

Young‐Soo Choi

Measurements of the saturated transmission and the undepleted ground-state population density of both Cr(4+):YAG crystals and dye films as saturable absorbers have been experimentally attempted to understand the additional unsaturated losses in a high Q state. The saturated transmission of a saturable absorber is less than its maximum at a high saturation fluence because of the undepleted ground-state population density. Higher saturated transmission and lower undepleted ground-state population density have been observed for Cr(4+):YAG crystals than have been observed for dye films at high optical densities.

Applied Optics•Oct 20, 2001•11 citations

Absorption saturation in Cr4+-activated silicate crystals and use of these crystals in passive laser switches

Nickolay Zhavoronkov, V. P. Mikhailov, Н. В. Кулешов +2 more

The absorption saturation in Cr 4+ -activated Mg 2 SiO 4 and Y 2 SiO 5 crystals was studied. The cross sections were calculated for the absorption of 694 nm light by the ground 3 A 2 ( 3 F ) and the excited 3 T 2 ( 3 F ) states. A ruby laser was passively Q-switched by Mg 2 SiO 4 : Cr 4+ and Y 2 SiO 5 : Cr 4+ crystals. The duration and energy of the output pulses were τ = 100 ns and E = 0.24 J.

Quantum Electronics•Jan 31, 1995•10 citations

Influence of Giant Pulse Irradiation on a Ruby Laser

Toshizo Nakaya, Hirobumi Okabe

In an optical system, consisting of two ruby lasers (one is Q-switching operation, the other normal operation), the following phenomena have been studied on the basis of the experimental results obtained on the fractional metastable state population; 1) quenching of normal laser oscillation, 2) amplification of incident giant pulse by maser mechanism, and 3) changes in giant pulse characteristics by giant pulse irradiation in a Q-switching laser with saturable absorber.

Japanese Journal of Applied Physics•Sep 1, 1967•1 citation

Experimental studies of non-radiative relaxation rates in solid state laser materials

M. Anson

Techniques for the measurement of non-radiative decay rates between the optically excited states in solid-state laser materials are described. Two crystals have been investigated, ruby (Cr3+:Al2O3) and Sm2+:CaF2. A review of the spectroscopy of these materials is presented with particular emphasis on aspects relevant to non-radiative decay. An experiment is described using a second harmonic Nd3+ Nd:glass Q-switched laser to pump ruby crystals. Limiting non-radiative relaxation times were derived from the rise of fluorescence. Rubies varying in concentration between 0.05% and 0.4% were studied over a range of temperatures, 77 -> 7000 K. 4T2 -> 2E(E + 2A), 4T2 -> 2T1 (Eb) and 4T2 -> 2T1 (2A + Ea) non-radiative relaxations were all found to be <4ns in good agreement with the experimental results of other workers. Two experiments employing a ruby laser to pump Sm2+ :CaF2 are described. The first used a Q-switched laser and, apart from some improvements was similar to the ruby experiment. An upper limit of 4f5 5d pump -> metastable non-radiative decay of 2ns was found for Sm2+:CaF2, The fluorescence decay constant at 295 K was also measured to be 63ns. The second experiment employed a mode-locked laser and the Sm2+:CaF2 non-radiative decay time was <0.5ns. A new effect - provisionally called 'surface emission' - discovered during the ruby measurements, has been examined in detail and the results of this investigation are presented. A phase-shift technique for the measurement of non-radiative decay times is examined in detail. A pilot experiment using a self-mode-locked He-Ne laser at 633 nm to pump Sm2+:CaF2 is described. The non-radiative relaxation time found by this method was <33ps. Suggestions for improved experiments, both pulsed and phase-shifts, are made and the application of the techniques to other materials is discussed.

•Jan 1, 1971•0 citations

Effect of soft saturation on nonlinear interface switching

Robert Cuykendall, Karlheinz Strobl

Numerical simulation of a nonlinear interface has shown that remarkable improvement in switching quality is theoretically possible by hard-limited saturation of the nonlinearity. We report the results of simulations investigating the effect of different types of soft saturation on nonlinear-interface switching behavior. The calculated predictions are consistent with recent experimental findings and show surprisingly little difference between hard and soft saturation. Significant softening leads to contrast reduction.

Physical Review A•Jan 1, 1990•8 citations
Characteristics of ruby passive Q switching with a Dy(2+):CaF(2) solid-state saturable absorber are investigated with output couplers of various reflectivities and saturable absorbers of different thicknesses. Numerical simulation is used to investigate the behavior of ruby passive Q switching with a Dy(2+):CaF(2) saturable absorber and to interpret the experimental results.
Measurements of the saturated transmission and the undepleted ground-state population density of both Cr(4+):YAG crystals and dye films as saturable absorbers have been experimentally attempted to understand the additional unsaturated losses in a high Q state. The saturated transmission of a saturable absorber is less than its maximum at a high saturation fluence because of the undepleted ground-state population density. Higher saturated transmission and lower undepleted ground-state population density have been observed for Cr(4+):YAG crystals than have been observed for dye films at high optical densities.
Techniques for the measurement of non-radiative decay rates between the optically excited states in solid-state laser materials are described. Two crystals have been investigated, ruby (Cr3+:Al2O3) and Sm2+:CaF2. A review of the spectroscopy of these materials is presented with particular emphasis on aspects relevant to non-radiative decay. An experiment is described using a second harmonic Nd3+ Nd:glass Q-switched laser to pump ruby crystals. Limiting non-radiative relaxation times were derived from the rise of fluorescence. Rubies varying in concentration between 0.05% and 0.4% were studied over a range of temperatures, 77 -> 7000 K. 4T2 -> 2E(E + 2A), 4T2 -> 2T1 (Eb) and 4T2 -> 2T1 (2A + Ea) non-radiative relaxations were all found to be <4ns in good agreement with the experimental results of other workers. Two experiments employing a ruby laser to pump Sm2+ :CaF2 are described. The first used a Q-switched laser and, apart from some improvements was similar to the ruby experiment. An upper limit of 4f5 5d pump -> metastable non-radiative decay of 2ns was found for Sm2+:CaF2, The fluorescence decay constant at 295 K was also measured to be 63ns. The second experiment employed a mode-locked laser and the Sm2+:CaF2 non-radiative decay time was <0.5ns. A new effect - provisionally called 'surface emission' - discovered during the ruby measurements, has been examined in detail and the results of this investigation are presented. A phase-shift technique for the measurement of non-radiative decay times is examined in detail. A pilot experiment using a self-mode-locked He-Ne laser at 633 nm to pump Sm2+:CaF2 is described. The non-radiative relaxation time found by this method was <33ps. Suggestions for improved experiments, both pulsed and phase-shifts, are made and the application of the techniques to other materials is discussed.
Numerical simulation of a nonlinear interface has shown that remarkable improvement in switching quality is theoretically possible by hard-limited saturation of the nonlinearity. We report the results of simulations investigating the effect of different types of soft saturation on nonlinear-interface switching behavior. The calculated predictions are consistent with recent experimental findings and show surprisingly little difference between hard and soft saturation. Significant softening leads to contrast reduction.