Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

ISRN Optics

A Method for the Measurement of Photons Number and Squeezing Parameter in a Quantum Cavity

Ghasem Naeimi, Siamak Khademi, Ozra Heibati

Published Dec 31, 2013• 4 citations
Publisher

Abstract

Measurement of photons number in a quantum cavity is very difficult and the photons number is changed after each measurement. Recently, many efforts have been done for the nondemolition measurement methods. Haroche et al. succeed in recognizing existence or nonexistence of one photon in a quantum cavity. In this paper, we employ their experimental setup for a quantum nondemolition measurement and pump a coherent state in their quantum cavity. In this case, we could detect more photons in the quantum cavity by a measurement of a displaced Wigner function. It is also shown that the measurement of more than one photon is possible by the Haroche method by measuring just one point of displaced Wigner function. Furthermore, if the cavity field is filled by a superposition of two number states, the average number of photons within the cavity would be measurable. We show that their setup is also suitable to apply for the measurement of the squeezing parameter for the squeezed state of photons number in the quantum cavity successfully.

DOI
10.1155/2013/271951

Related papers

Mode invisibility as a quantum nondemolition measurement of coherent light

Marvellous Onuma-Kalu, Robert B. Mann, Eduardo Martín-Martínez

We exploit geometric properties of quantum states of light in optical cavities to carry out quantum nondemolition measurements. We generalize the ``mode-invisibility'' method to obtain information about the Wigner function of a squeezed coherent state in a nondestructive way. We also simplify the application of this nondemolition technique to measure single-photon and few-photon states.

arXiv:1404.0726•Physical Review A•Sep 30, 2014•6 citations

Measuring photon numbers in a cavity by atomic interferometry: optimizing the convergence procedure

S. Haroche, M. Brune, J. M. Raimond

We describe the optimum detection procedure to follow in order to measure by atomic interferometry the number of photons present in a cavity by using a Quantum nondemolition scheme. The method we discuss is the one recently introduced by Brune et al. [1, 2], in which the field intensity is detected by recording atomic interferences in a Ramsey type set up. A succession of two-level atoms interacts with the cavity field which is the analog of a birefringent retarding plate for the atomic wave function. The information is acquired in the form of binary digits (atoms detected in one level or the other). We discuss an optimal strategy which yields the value of the photon number with a number of atoms of the order of the base 2 logarithm of the field photon number dispersion. The procedure described here is the one we intend to use in an experiment in preparation.

Journal de Physique II•Apr 1, 1992•23 citations

Generation and reconstruction of Schrodinger cat states of light in a cavity by quantum nondemolition measurements

I. Dotsenko, S. Deléglise, C. Sayrin +4 more

Application of the quantum nondemolition (QND) method to Schrodinger cat states is described. Phase cat states of trapped light is generated by QND measurement of the photon number parity of a coherent field initially injected into the cavity. The measured Wigner function of a cat state at four different delays between preparation and measurement is presented. The Wigner function exhibits two positive, ideally Gaussian, peaks corresponding to the two classical components of the state. Quantitative analysis of the decoherence process is also presented. Generalization of this experiment to the preparation of non-local cat states located at the same time between two different cavities is discussed.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 1, 2009•1 citation

QUANTUM FIELD STATE MEASUREMENT AND RECONSTRUCTION IN A CAVITY BY QUANTUM NONDEMOLITION PHOTON COUNTING

M. Brune, I. Dotsenko, S. Deléglise +7 more

Quantum nondemolition photon (QND) counting in a high Q cavity is performed by using circular Rydberg atoms. The atoms behave as clocks whose ticking rate is affected by light shifts induced by the cavity field. Measurning the atoms projects the field on non-classical states such as number states or Schrödinger cat states. We also use the QND measurement method for reconstructing the Wigner function of these states and to monitor their decoherence. These field manipulation methods can be applied to state preparation by quantum feedback and to demonstrate non locality with two fields located in separated cavities.

Laser Spectroscopy•Feb 1, 2010•0 citations

Squeezing in conditional measurement setup with coherent input

Devibala Esakkimuthu, Basherrudin Mahmud Ahmed A

Conditional Measurement scheme which employs linear optical elements and photon detection is the fertile ground for nonclassical state generation. We consider a simple setup that requires a coherent state and a number state as inputs of the beam splitter, and a photon detector. We show that by tuning the parameters involved in the setup, we can achieve optimal squeezing from the setup. This is facilitated by writing the output state of the conditional measurement as displaced qudits. Setting aside displacement which plays no role in squeezing, the finite-dimensional representation makes it possible to calculate the maximal amount of squeezing. By fixing the detection at one photon level irrespective of any number state input and carefully chosen coherent parameter and beam splitter reflectivity values, one can reach the maximal squeezing at least for lower number state inputs. This is in contrast to the earlier attempts in atom field interaction models etc., where the squeezing obtained was far from saturation. To accommodate the experimental imperfections, we consider the impure nature of the photon source and detector inefficiency.

arXiv:2412.19164•Dec 26, 2024•1 citation

Manipulation of photons in a cavity by dispersive atom-field coupling: Quantum-nondemolition measurements and generation of ‘‘Schrödinger cat’’ states

M. Brune, S. Haroche, J. M. Raimond +2 more

A quantum-nondemolition method to measure the number of photons stored in a high-Q cavity, introduced by Brune et al. [Phys. Rev. Lett. 65, 976 (1990)], is described in detail. It is based on the detection of the dispersive phase shift produced by the field on the wave function of nonresonant atoms crossing the cavity. This shift can be measured by atomic interferometry, using the Ramsey separated-oscillatory-field method. The information acquired by detecting a sequence of atoms modifies the field step by step, until it eventually collapses into a Fock state. At the same time, the field phase undergoes a diffusive process as a result of the back action of the measurement on the photon-number conjugate variable. Once a Fock state has been generated, its evolution under weak perturbation can be continuously monitored, revealing quantum jumps between various photon numbers. When applied to an initial coherent field, the intermediate steps of the measuring sequence produce quantum superpositions of classical fields, known as ``Schr\"odinger cat states.'' Ways to prepare and detect these states in a cavity subjected to a weak relaxation process are discussed. The effects analyzed in this article could realistically be observed by using circular Rydberg atoms and very high-Q superconducting microwave cavities. The possibility of photon ``manipulation'' through nonresonant atom-field interactions opens a domain in cavity QED studies.

Physical Review A•Apr 1, 1992•743 citations
Measurement of photons number in a quantum cavity is very difficult and the photons number is changed after each measurement. Recently, many efforts have been done for the nondemolition measurement methods. Haroche et al. succeed in recognizing existence or nonexistence of one photon in a quantum cavity. In this paper, we employ their experimental setup for a quantum nondemolition measurement and pump a coherent state in their quantum cavity. In this case, we could detect more photons in the quantum cavity by a measurement of a displaced Wigner function. It is also shown that the measurement of more than one photon is possible by the Haroche method by measuring just one point of displaced Wigner function. Furthermore, if the cavity field is filled by a superposition of two number states, the average number of photons within the cavity would be measurable. We show that their setup is also suitable to apply for the measurement of the squeezing parameter for the squeezed state of photons number in the quantum cavity successfully.
We describe the optimum detection procedure to follow in order to measure by atomic interferometry the number of photons present in a cavity by using a Quantum nondemolition scheme. The method we discuss is the one recently introduced by Brune et al. [1, 2], in which the field intensity is detected by recording atomic interferences in a Ramsey type set up. A succession of two-level atoms interacts with the cavity field which is the analog of a birefringent retarding plate for the atomic wave function. The information is acquired in the form of binary digits (atoms detected in one level or the other). We discuss an optimal strategy which yields the value of the photon number with a number of atoms of the order of the base 2 logarithm of the field photon number dispersion. The procedure described here is the one we intend to use in an experiment in preparation.
Application of the quantum nondemolition (QND) method to Schrodinger cat states is described. Phase cat states of trapped light is generated by QND measurement of the photon number parity of a coherent field initially injected into the cavity. The measured Wigner function of a cat state at four different delays between preparation and measurement is presented. The Wigner function exhibits two positive, ideally Gaussian, peaks corresponding to the two classical components of the state. Quantitative analysis of the decoherence process is also presented. Generalization of this experiment to the preparation of non-local cat states located at the same time between two different cavities is discussed.
Quantum nondemolition photon (QND) counting in a high Q cavity is performed by using circular Rydberg atoms. The atoms behave as clocks whose ticking rate is affected by light shifts induced by the cavity field. Measurning the atoms projects the field on non-classical states such as number states or Schrödinger cat states. We also use the QND measurement method for reconstructing the Wigner function of these states and to monitor their decoherence. These field manipulation methods can be applied to state preparation by quantum feedback and to demonstrate non locality with two fields located in separated cavities.
Conditional Measurement scheme which employs linear optical elements and photon detection is the fertile ground for nonclassical state generation. We consider a simple setup that requires a coherent state and a number state as inputs of the beam splitter, and a photon detector. We show that by tuning the parameters involved in the setup, we can achieve optimal squeezing from the setup. This is facilitated by writing the output state of the conditional measurement as displaced qudits. Setting aside displacement which plays no role in squeezing, the finite-dimensional representation makes it possible to calculate the maximal amount of squeezing. By fixing the detection at one photon level irrespective of any number state input and carefully chosen coherent parameter and beam splitter reflectivity values, one can reach the maximal squeezing at least for lower number state inputs. This is in contrast to the earlier attempts in atom field interaction models etc., where the squeezing obtained was far from saturation. To accommodate the experimental imperfections, we consider the impure nature of the photon source and detector inefficiency.
A quantum-nondemolition method to measure the number of photons stored in a high-Q cavity, introduced by Brune et al. [Phys. Rev. Lett. 65, 976 (1990)], is described in detail. It is based on the detection of the dispersive phase shift produced by the field on the wave function of nonresonant atoms crossing the cavity. This shift can be measured by atomic interferometry, using the Ramsey separated-oscillatory-field method. The information acquired by detecting a sequence of atoms modifies the field step by step, until it eventually collapses into a Fock state. At the same time, the field phase undergoes a diffusive process as a result of the back action of the measurement on the photon-number conjugate variable. Once a Fock state has been generated, its evolution under weak perturbation can be continuously monitored, revealing quantum jumps between various photon numbers. When applied to an initial coherent field, the intermediate steps of the measuring sequence produce quantum superpositions of classical fields, known as ``Schr\"odinger cat states.'' Ways to prepare and detect these states in a cavity subjected to a weak relaxation process are discussed. The effects analyzed in this article could realistically be observed by using circular Rydberg atoms and very high-Q superconducting microwave cavities. The possibility of photon ``manipulation'' through nonresonant atom-field interactions opens a domain in cavity QED studies.