Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Conference on Transparent Optical Networks

Experimental evaluation of high-speed optical fiber communication using nonbinary LDPC coded modulation with layered decoding

Murat Arabaci, Ivan B. Djordjević

Published Jun 1, 2011• 0 citations
Publisher

Abstract

In this paper, we present a reduced-latency nonbinary low-density parity-check (LDPC) coded modulation scheme suitable for high-speed optical fiber communication featuring the layered LDPC decoding algorithm. The use of the layered decoder in place of the conventional flooding decoder helps reduce by half the number of iterations taken in decoding. This in turn reduces the decoding latency, increases the decoding throughput, and significantly lowers the power consumption at the receiving ends of optical transport networks. We show by using the experimental data collected from a 4-ary rate-0.8 LDPC-coded NRZ-DQPSK modulation system that layered decoding indeed halves the required number of decoding iterations. We also show that, in the back-to-back configuration, even with a single iteration of layered decoding, one can attain a 7 dB gain in performance at the bit error ratio (BER) of 10-5when compared to using only the maximum a posteriori probability detector output based on the Bahl-Cocke-Jelinek-Raviv (BCJR) algorithm.

DOI
10.1109/icton.2011.5970877

Related papers

Performance analysis of LDPC code based on Watermark scheme in high-speed optical communication system

Wenxue He, Wenbo Zhang, Chao Li Chao Li +3 more

We study the decoding performance of low-density parity-check (LDPC) code based on Watermark scheme under different percentages of water-mark bits over 100 Gb/s differential quadrature phase shift keying (DQPSK) high-speed optical communication system. We also find the optimum percentage of water-mark bits according to the performance comparison. Simulation result shows an improvement of 0.5 dB net code gain by using the optimum Watermark scheme at a post-forward error correction bit error rate (BER) of 10-9, comparing with the traditional log-likelihood ratios belief propagation decoding algorithm. Also, for the same BER, there is a decrease in the number of iterations used in LDPC decoding.

Chinese Optics Letters•Jan 1, 2015•1 citation

Layered Decoding of Nonbinary LDPC Codes Suitable for High-Speed Optical Communications

Murat Arabaci, Ivan B. Djordjević

We propose using layered update rule in decoding nonbinary LDPC codes. Only 10-15 iterations suffice for good performance. Also, for the same BER performance, it increases throughput by twofold compared to conventional flooding update rule.

Optical Fiber Communication Conference•Jan 1, 2011•1 citation

Performance Analysis of NB-QC-LDPC Code for High-Speed Optical Communication Systems

Zhiqiang Lin, Jianyong Zhang

In the paper, we construct the non-binary quasi-cyclic low-density parity check (NB-QC-LDPC) code from the quasi-cyclic low-density parity check (QC-LDPC) code. The NB-QC-LDPC code over the Galois field GF(4) is suitable for 100Gb/s optical communication systems with QPSK or DQPSK modulation formats. We also study the bit error ratio (BER) performance of the NB-QC-LDPC code by using the Log-Fourier Sum and Product decoding algorithm (LFSPA). The numerical results show that the NB-QC-LDPC code with code length 500 can provide approximately 5.5dB coding gain at the BER of 910- and outperform QC-LDPC code by 0.7dB.

International Conference on Electronics, Communications and Control•Oct 16, 2012•0 citations

Hardware Efficient FPGA Implementation of a Layered QC-LDPC Decoder for Ultra-Reliable Low-Latency Communications

Bilal Mejmaa, Chakir Aqil, Abdelaziz Lberni +2 more

Low-Density Parity-Check (LDPC) codes have traditionally performed better at longer code lengths. This research develops and rigorously evaluates a layered Quasi-Cyclic Low-Density Parity-Check (QC-LDPC) decoder architecture intended for Ultra-Reliable Low-Latency Communication (URLLC) applications in 5G and subsequent technologies. The paper investigates LDPC codes in short-length contexts through architectural optimization based on a layered decoding approach, which provides improved convergence speed and reduced latency compared with traditional flooding techniques. The short block-length QC-LDPC code (280,176) addresses the dual challenge of achieving ultra-low latency while maintaining high performance relative to existing work. For a target BLER of 10−2, the decoder outperforms the shorter reference codes (60,40) and (96,64), with an Eb/N0 gain of up to 0.9 dB, part of which is attributable to the longer block length rather than to the decoder alone. The FPGA implementation results demonstrate that the design is hardware-efficient: it operates at a maximum frequency of 218.62 MHz, resulting in a throughput of 155.77 Mbps, while maintaining a decoding latency of only 1.129 µs and a power consumption of 0.201 W.

Chips•Aug 4, 2026•0 citations

Application of nonbinary LDPC codes about serial decoding algorithm in optical fiber communication

Mingyang Chen

This paper use serial BP decoding algorithm to decode nonbinary LDPC codes in order to reduce decoding latency in optical fiber communication system.Then we introduce the serial BP decoding algorithm for nonbinary LDPC codes and the simulation model of optical communication system in detail.After that we show the performance effect of the maximum iterations of serial BP decoding algorithm in LDPC decoder and compare the performance of the decoder with traditional BP decoding algorithm and serial BP decoding algorithm.The result indicates that serial BP decoding algorithm can really increase the convergence speed of LDPC decoder.

Optical Communication Technology•Jan 1, 2013•0 citations

Low-density parity-check code for high-speed fibre-optic communication and its experimental verification

Bo Xu, Jiandong Xie

Although low-density parity-check (LDPC) code has been proved as a powerful forward error correction code for fibre optic communication, its soft-decoding requires high quantisation resolution which is difficult to achieve for high-speed fibre-optic communication systems. A modification to LDPC decoding algorithms is proposed to effectively improve the performance at quantisation resolution as low as two-bit or one-bit. The good decoding performance of LDPC code for error correction is confirmed by experiment. Compared with the RS(255, 239) code commonly used in optical fibre communication, a Q-factor improvement of 2-dB is obtained in the experiment for an LDPC code with quasi-cyclic structure at the same redundancy as the RS code. Furthermore, the impacts of sampling phase and channel estimation using real data over the decoding performance are analysed.

IET Communications•Jun 24, 2010•5 citations
In this paper, we present a reduced-latency nonbinary low-density parity-check (LDPC) coded modulation scheme suitable for high-speed optical fiber communication featuring the layered LDPC decoding algorithm. The use of the layered decoder in place of the conventional flooding decoder helps reduce by half the number of iterations taken in decoding. This in turn reduces the decoding latency, increases the decoding throughput, and significantly lowers the power consumption at the receiving ends of optical transport networks. We show by using the experimental data collected from a 4-ary rate-0.8 LDPC-coded NRZ-DQPSK modulation system that layered decoding indeed halves the required number of decoding iterations. We also show that, in the back-to-back configuration, even with a single iteration of layered decoding, one can attain a 7 dB gain in performance at the bit error ratio (BER) of 10-5when compared to using only the maximum a posteriori probability detector output based on the Bahl-Cocke-Jelinek-Raviv (BCJR) algorithm.
We study the decoding performance of low-density parity-check (LDPC) code based on Watermark scheme under different percentages of water-mark bits over 100 Gb/s differential quadrature phase shift keying (DQPSK) high-speed optical communication system. We also find the optimum percentage of water-mark bits according to the performance comparison. Simulation result shows an improvement of 0.5 dB net code gain by using the optimum Watermark scheme at a post-forward error correction bit error rate (BER) of 10-9, comparing with the traditional log-likelihood ratios belief propagation decoding algorithm. Also, for the same BER, there is a decrease in the number of iterations used in LDPC decoding.
In the paper, we construct the non-binary quasi-cyclic low-density parity check (NB-QC-LDPC) code from the quasi-cyclic low-density parity check (QC-LDPC) code. The NB-QC-LDPC code over the Galois field GF(4) is suitable for 100Gb/s optical communication systems with QPSK or DQPSK modulation formats. We also study the bit error ratio (BER) performance of the NB-QC-LDPC code by using the Log-Fourier Sum and Product decoding algorithm (LFSPA). The numerical results show that the NB-QC-LDPC code with code length 500 can provide approximately 5.5dB coding gain at the BER of 910- and outperform QC-LDPC code by 0.7dB.
Low-Density Parity-Check (LDPC) codes have traditionally performed better at longer code lengths. This research develops and rigorously evaluates a layered Quasi-Cyclic Low-Density Parity-Check (QC-LDPC) decoder architecture intended for Ultra-Reliable Low-Latency Communication (URLLC) applications in 5G and subsequent technologies. The paper investigates LDPC codes in short-length contexts through architectural optimization based on a layered decoding approach, which provides improved convergence speed and reduced latency compared with traditional flooding techniques. The short block-length QC-LDPC code (280,176) addresses the dual challenge of achieving ultra-low latency while maintaining high performance relative to existing work. For a target BLER of 10−2, the decoder outperforms the shorter reference codes (60,40) and (96,64), with an Eb/N0 gain of up to 0.9 dB, part of which is attributable to the longer block length rather than to the decoder alone. The FPGA implementation results demonstrate that the design is hardware-efficient: it operates at a maximum frequency of 218.62 MHz, resulting in a throughput of 155.77 Mbps, while maintaining a decoding latency of only 1.129 µs and a power consumption of 0.201 W.
This paper use serial BP decoding algorithm to decode nonbinary LDPC codes in order to reduce decoding latency in optical fiber communication system.Then we introduce the serial BP decoding algorithm for nonbinary LDPC codes and the simulation model of optical communication system in detail.After that we show the performance effect of the maximum iterations of serial BP decoding algorithm in LDPC decoder and compare the performance of the decoder with traditional BP decoding algorithm and serial BP decoding algorithm.The result indicates that serial BP decoding algorithm can really increase the convergence speed of LDPC decoder.
Although low-density parity-check (LDPC) code has been proved as a powerful forward error correction code for fibre optic communication, its soft-decoding requires high quantisation resolution which is difficult to achieve for high-speed fibre-optic communication systems. A modification to LDPC decoding algorithms is proposed to effectively improve the performance at quantisation resolution as low as two-bit or one-bit. The good decoding performance of LDPC code for error correction is confirmed by experiment. Compared with the RS(255, 239) code commonly used in optical fibre communication, a Q-factor improvement of 2-dB is obtained in the experiment for an LDPC code with quasi-cyclic structure at the same redundancy as the RS code. Furthermore, the impacts of sampling phase and channel estimation using real data over the decoding performance are analysed.