We numerically investigate the transient interaction between optical Kerr bistability and stimulated Brillouin scattering (SBS) when an intense optical pulse is incident in a short fiber ring resonator. An initial phase detuning of the ring resonator and the difference in the phase shift between the pump wave and the created Stokes wave are taken into account in the three-wave SBS model. The ratio of the Brillouin gain coefficient to the nonlinear refractive index of the fiber, which is termed the relative Brillouin gain coefficient, is used as a key parameter for examining the conditions for obtaining optical Kerr bistability in a fiber ring resonator. The numerical results show that optical Kerr bistability cannot be obtained in a ring resonator made from a conventional fused-silica fiber because of the generation of SBS. However, if other fibers with relative Brillouin gain coefficients at least 1 order smaller than that of fused-silica fibers are used, we can suppress SBS and hence obtain optical Kerr bistability. Moreover, we investigate theoretically and experimentally the dynamics of SBS in a fused-silica fiber ring resonator irradiated by a Gaussian pulse. The relaxation and pulsation in the Stokes signal depend strongly on the initial phase detuning of the ring resonator. The experimental results obtained with a single-frequency pulsed YAG laser agree qualitatively with theoretical predictions.
We numerically investigate the transient interaction between optical Kerr bistability and stimulated Brillouin scattering (SBS) when an intense optical pulse is incident in a short fiber ring resonator. An initial phase detuning of the ring resonator and the difference in the phase shift between the pump wave and the created Stokes wave are taken into account in the three-wave SBS model. The ratio of the Brillouin gain coefficient to the nonlinear refractive index of the fiber, which is termed the relative Brillouin gain coefficient, is used as a key parameter for examining the conditions for obtaining optical Kerr bistability in a fiber ring resonator. The numerical results show that optical Kerr bistability cannot be obtained in a ring resonator made from a conventional fused-silica fiber because of the generation of SBS. However, if other fibers with relative Brillouin gain coefficients at least 1 order smaller than that of fused-silica fibers are used, we can suppress SBS and hence obtain optical Kerr bistability. Moreover, we investigate theoretically and experimentally the dynamics of SBS in a fused-silica fiber ring resonator irradiated by a Gaussian pulse. The relaxation and pulsation in the Stokes signal depend strongly on the initial phase detuning of the ring resonator. The experimental results obtained with a single-frequency pulsed YAG laser agree qualitatively with theoretical predictions.
We demonstrate the generation of optical bistability in a Fabry–Perot resonator made of a fused-silica single-mode polarization-maintaining fiber. To suppress the undesirable generation of stimulated Brillouin scattering, a pulse train from a mode-locked and Q-switched picosecond laser was used as an incident pulse and the fiber resonator was synchronized with it. We observed first-order bistability, higher order bistability, and power limiting depending on the initial cavity detuning and mirror reflectivity. The obtained results could be well explained by our previous transient analysis based on an iterative method.
We report the superluminal phenomenon of both Stokes and pump light in stimulated Brillouin scattering (SBS) via an optical-fiber ring lasing resonator. In our experiment, the superluminal generation of Stokes light firstly delayed with 33.79 ns and then propagated with the advancement of 93.34 ns within an 8-m single mode fiber (SMF), when the pump power increased from the SBS threshold to a higher power. This proves the first evidence that the optical interaction is determined by the group velocity even at the negative group velocity superluminal propagation. It is important that, this implies the possibility of superluminal information interchange because the results also indicate that the signal conversion between different wavelengths can be realized at the negative group velocity propagation.
Based on the mechanism of Kerr effect in Brillouin Fiber-optic Ring Resonator(BFRR),the resonant cavity characteristic is researched theoretically when considering the Kerr effect,in order to get the possibility of occurrence of first-order Stokes light optical bistability. Experiments show that the optical bistability in 30 meters short cavity happens while input light intensity is about 440 μW,and the bistability is related with coupling coefficient and the insertion loss of the cavity coupler. Secondly,the Kerr effect in BFRR of Brillouin Fiber-optic Gyroscope (BFOG) is analyzed,focusing on the influence of resonant deviation on gyroscope nonlinear output and dynamic working range. Furthermore,the double-loop BFOG program is proposed,which provides a potential solution of Kerr effect error in Brillouin fiber-optic gyroscope.
The characteristics of the gain of Stokes pulses in single-mode optical fibres by stimulated Brillouin scattering (SBS) of monochromatic and nonmonochromatic pump signals have been investigated by numerical simulation using a spectral approach. Conditions under which ‘slow light’ (caused by a group delay) can be implemented are found (it is reasonable to apply this term to a process in which a pulse is delayed with conservation of its shape). The plane-wave interaction model is shown to describe adequately the dynamics of this process in single-mode fibres. A number of gain modes are investigated for Stokes pulses with different time structures upon monochromatic and nonmonochromatic excitation. A new data transfer technique is proposed, which is based on the conversion of stepwise phase modulation of the input Stokes signal into amplitude modulation of the output signal.
The polarization-related properties of stimulated Brillouin scattering (SBS) processes in long, randomly birefringent, standard optical fibers are examined. Evolution equations for the pump and signal waves, in the presence of both birefringence and SBS, are provided in Jones and Stokes spaces. It is shown that in the undepleted pump regime, the amplification of the SBS signal wave is equivalent to that of a linear medium with polarization-dependent gain. The process is associated with a pair of orthogonal states of polarizations (SOPs) of the signal wave, which undergo maximum and minimum amplification. In long, standard fibers, the Jones vector of the probe SOP which corresponds to maximum amplification is aligned with the complex conjugate of the pump wave Jones vector. The maximum and minimum SBS gain coefficients in such fibers equal two-thirds and one-third of the gain coefficient that is predicted by scalar theory, respectively. The large differential gain of the SBS process gives rise to an effective pulling of the amplified Stokes probe wave SOP, towards that of maximum amplification. Lastly, Stokes wave pulses that are aligned for maximum and minimum amplification experience different group delays, which manifest as polarization-related distortions in SBS slow light setups.
Frontiers in Guided Wave Optics and Optoelectronics 84 absorption is much too high to render the group effect useful.An exciting breakthrough happened in the early nineties when it was shown that group velocities of few tens of meters per second were possible with nonlinear resonance interactions (Hau et al., 1999).Two important features of nonlinear resonances make this possible: substantially reduced absorption, or even amplification, of radiation at a resonance, and sharpness of such resonances; the sharper a resonance, the higher dn/dω and so the stronger the enhancement of group index, and hence the greater the pulse is delayed.Widely ranging applications for slow light have been proposed, of which those for telecommunication systems and devices (optical delay lines, optical buffers, optical equalizers and signal processors) are currently of most interest (Gauthier, 2005).The essential demand of such devices is compatibility with existing telecommunication systems, that is they must be of wide enough bandwidth (≥10 GHz) and able to be integrated seamlessly into such systems.Of the various nonlinear resonance mechanisms and media, which allow sufficiently long induced delays, stimulated Brillouin and Raman scattering (SBS and SRS) in optical fiber are deemed to be among the best candidates.Currently SBS is the most actively investigated and many experimental and theoretical papers on pulse delaying via SBS in optical fiber have been published in the last few years, see the review paper (Thevenaz, 2008) and references therein.In this process the pulse to be delayed is a frequency down-shifted (Stokes) pulse.This is transmitted through an optical fiber through which continuous wave (CW) pump radiation is sent in the opposite direction to prime the delay process.It is supposed that the Stokes pulse is amplified by parametric coupling with the pump wave and a material (acoustic) wave in the medium (Kroll, 1965), and the amplification is characterised by a resonant-type gain profile.The dispersion of refractive index associated with this profile (which is similar to that in Fig. 1) can then be used to increase the group index for optical pulses at the Stokes frequency (Zeldovich, 1972).Along with obvious device compatibility, there are several other advantages of the SL via SBS approach for optical communications systems: slow-light resonance can be created at any wavelength by changing the pump wavelength; use of optical fibre allows for long interaction lengths and thus low powers for the pump radiation, the process runs at room temperature, it uses off the shelf telecom equipment, and SBS works in the entire transparency range of fibers and in all types of fiber.Currently a main obstacle to applications of this approach is the narrow SBS gain spectral bandwidth, (Thevenaz, 2008), which is typically ≈ 120-200 MHz in silica fiber in the spectral range of telecom optical radiation (~1.3-1.6 μm) (Agrawal, 2006).This chapter reviews our ongoing work on the physical mechanisms that give rise to pulse delay in SBS.In section 2 the theoretical background of the SBS phenomenon is given and the main working equations describing this nonlinear interaction are presented.In section 3 ways by which the SBS spectral bandwidth may be increased are addressed.Waveguide induced spectral broadening of SBS in optical fibre is considered as a means of increasing the bandwidth to the multi-GHz range.An alternative way widely discussed in the literature, (Thevenaz, 2008), is based on spectral broadening of the pump radiation.However it is shown through analytic analysis of the SBS equations converted to the frequency domain that pump radiation broadening by any reasonable amount has only a negligible effect on increasing the SBS bandwidth.Importantly in this section we show that, irrespective of the nature of the broadening considered, the SBS gain bandwidth remains www.intechopen.