Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Bulletin of the American Physical Society

Stabilized 1762 nm Laser for Barium Ion Qubit Readout via Adiabatic Passage

J.S. Salacka

Published May 29, 2008• 0 citations
OpenAlex

Related papers

An injection-locked 1762 nm laser for trapped barium ion qubits

Tarun Dutta

Applied Physics B•Jun 30, 2022•4 citations

High-power 1762 nm single-frequency fiber laser system for trapped barium ion qubits

Andrei Fedotov, Iuliia Zalesskaia, Petteri Uusimaa

Quantum Computing, Communication, and Simulation•Mar 19, 2025•0 citations

Implementation of single-qubit quantum gates by adiabatic passage and static laser phases

X. Lacour, S. Guérin, Nikolay V. Vitanov +2 more

Optics Communications•Jun 16, 2006•28 citations

Experiments with remote entanglement using single barium ions

Nathan Kurz

Barium ions are trapped and Doppler cooled in a linear Paul trap with the goal of demonstrating state initialization, single-qubit operations and detection. Rabi rotations are demonstrated on the 6S1/2 ↔ 6P3/2 transition using single pulses from a mode-locked Ti:Sapphire laser, and some evidence for the same on the more useful 6S1/2] ↔ 6P1/2 transition is shown. With the goal of entangling the polarization mode of emitted photons with the spin state of the ion in the trap in mind, single photon generation and detection ability is demonstrated. A stabilized 1.762 µm laser is used on the 6S1/2 → 5D5/2 transition to demonstrate the ability to state selectively shelve the ion from the ground state to be used as readout. Using the techniques that will enable qubit operations and readout, several quantities of interest in 137Ba+ are measured either for the first time or to higher accuracy than previously achieved.

•Jan 1, 2010•0 citations

Adiabatic passage in the presence of noise

T. Noel, Matthew Dietrich, Nathan Kurz +3 more

We report on an experimental investigation of rapid adiabatic passage (RAP) in a trapped barium ion system. RAP is implemented on the transition from the $6{S}_{1/2}$ ground state to the metastable $5{D}_{5/2}$ level by applying a laser at 1.76 $\ensuremath{\mu}$m. We focus on the interplay of laser frequency noise and laser power in shaping the effectiveness of RAP, which is commonly assumed to be a robust tool for high-efficiency population transfer. However, we note that reaching high state transfer fidelity requires a combination of small laser linewidth and large Rabi frequency.

arXiv:1108.2671•Physical Review A•Feb 1, 2012•23 citations

High Power Single-Frequency 1762 nm Laser for Barium Ion Optical Qubits

Saïd Hamdi, Kentin Poncelet, Coline Lavit +4 more

Quantum processors based on ion traps (171Yb+,88Sr+,43Ca+or133Ba+) are one of the key components in the emergence of quantum technologies and have seen their interest explode in the last decade [1]. Although171Yb+ions are commonly used as qubits, a new alternative is based on133Ba+offering several key advantages in terms of lifetime, speed, fidelity and performance. The readout of the qubit is made by shelving the133Ba+ion directly to the metastable 5D5/2 state using a 1762 nm single-frequency laser radiation [2]. For quantum computing and optical qubit manipulation low noise and high-power laser at this wavelength is highly recommended. Thulium doped fiber amplifiers (TDFAs) with broad emission between 1600–2100 nm and high-power capabilities are one of the best candidates for this application. Walasik et al demonstrated a 3W-1762 nm single-frequency TDFA but phase and intensity noise weren't investigated [3].

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jun 23, 2025•0 citations
Barium ions are trapped and Doppler cooled in a linear Paul trap with the goal of demonstrating state initialization, single-qubit operations and detection. Rabi rotations are demonstrated on the 6S1/2 ↔ 6P3/2 transition using single pulses from a mode-locked Ti:Sapphire laser, and some evidence for the same on the more useful 6S1/2] ↔ 6P1/2 transition is shown. With the goal of entangling the polarization mode of emitted photons with the spin state of the ion in the trap in mind, single photon generation and detection ability is demonstrated. A stabilized 1.762 µm laser is used on the 6S1/2 → 5D5/2 transition to demonstrate the ability to state selectively shelve the ion from the ground state to be used as readout. Using the techniques that will enable qubit operations and readout, several quantities of interest in 137Ba+ are measured either for the first time or to higher accuracy than previously achieved.
We report on an experimental investigation of rapid adiabatic passage (RAP) in a trapped barium ion system. RAP is implemented on the transition from the 6S1/26{S}_{1/2}6S1/2​ ground state to the metastable 5D5/25{D}_{5/2}5D5/2​ level by applying a laser at 1.76 $\ensuremath{\mu}$m. We focus on the interplay of laser frequency noise and laser power in shaping the effectiveness of RAP, which is commonly assumed to be a robust tool for high-efficiency population transfer. However, we note that reaching high state transfer fidelity requires a combination of small laser linewidth and large Rabi frequency.
Quantum processors based on ion traps (171Yb+,88Sr+,43Ca+or133Ba+) are one of the key components in the emergence of quantum technologies and have seen their interest explode in the last decade [1]. Although171Yb+ions are commonly used as qubits, a new alternative is based on133Ba+offering several key advantages in terms of lifetime, speed, fidelity and performance. The readout of the qubit is made by shelving the133Ba+ion directly to the metastable 5D5/2 state using a 1762 nm single-frequency laser radiation [2]. For quantum computing and optical qubit manipulation low noise and high-power laser at this wavelength is highly recommended. Thulium doped fiber amplifiers (TDFAs) with broad emission between 1600–2100 nm and high-power capabilities are one of the best candidates for this application. Walasik et al demonstrated a 3W-1762 nm single-frequency TDFA but phase and intensity noise weren't investigated [3].