Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Communications

Characteristic lifetimes derived from steady state photophysical hole burning measurements on crystal violet in water at room temperature

Ralf Menzel, Peter Witte

Published Dec 1, 1989• 1 citation
Publisher
DOI
10.1016/0030-4018(89)90502-6

Related papers

Photophysical hole burning in the excited state absorption bands of dissolved organic molecules at room temperature

Ralf Menzel, Peter Witte

Chemical Physics Letters•Dec 1, 1987•12 citations

Modelling excited state absorption (ESA) measurements including the photophysical hole burning effect with rate equations

Ralf Menzel

Excited state absorption measurements have usually to be modelled for the determination of the population densities in the different occupied excited states. Rate equations can be used for this purpose if the described experimental conditions are fulfilled. The photophysical hole burning (PPHB) effect may then be considered in an elementary way. Finally the decay rates of the different states and the holes can be determined. Fast routines for solving the system of differential equations are given allowing for an easy interactive analysis of the measurements on personal computers. The behaviour of the solutions for the two simplest models is discussed. The experimental results of PPHB measurements on crystal violet in 2-propanol were modelled using this formalism.

Molecular Physics•Sep 1, 1989•5 citations

Microparticle-based persistent spectral hole-burning memory at room temperature

Lingbing Chen, Yan Wang, Yong‐Le Pan +5 more

Persistent spectral hole burning with multiplicity was realized at room temperature for Nile blue molecules-doped polymeric dielectric spherical microparticles based on morphology-dependent resonances. Hole parameters depending on burning conditions were studied. Dynamical characteristic behavior of hole formation was measured and analyzed with a model based on rate equations. The effective hole formation rate was obtained by simulation. Photophysical and photochemical mechanisms of the room temperature hole burning for this system was discussed.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Sep 3, 1996•0 citations

Theory of lifetime effects and resonant emission processes in solid state spectroscopies

Carl-Olof Almbladh

•Jan 1, 1984•0 citations

Persistent Spectral Hole-Burning in Inorganic Materials

R. M. Macfarlane, Robert M. Shelby

Topics in current physics•Jan 1, 1988•9 citations

Photophysical and photochemical molecular hole burning theory

Harmen de Vries, Douwe A. Wiersma

In this paper theories are given, describing photophysical and photochemical hole burning experiments on molecular mixed crystals at low temperature. Population saturation hole burning is treated for a two-level system where the lower level is the ground state. Hole burning due to a triplet state acting as a population bottle neck is also described by a steady-state density matrix theory. Connection is made with optical free induction decay. To obtain T2 (the decay time of the off-diagonal elements of the density matrix), which is the main goal of these hole burning experiments, a linear extrapolation method is discussed. For photochemical hole burning a time-dependent density matrix treatment is given. Using this theory numerical simulations were performed of the experimental results obtained by Völker and co-workers for porphin in n-octane at low temperature. Good agreement with experiment is obtained. For this case extrapolation methods are discussed in order to obtain reliable T2 values. A time-dependent kinetic theory is used to simulate the photochemical hole burning experiments on dimethyl-s-tetrazine in durene and s-tetrazine in benzene. This theory accounts for the recently revealed two-photon character of these photodissociations. It is shown that despite this complication the hole full width at half-maximum may still equal twice the homogeneous width of the So-S1 transition.

The Journal of Chemical Physics•Feb 1, 1980•135 citations
Excited state absorption measurements have usually to be modelled for the determination of the population densities in the different occupied excited states. Rate equations can be used for this purpose if the described experimental conditions are fulfilled. The photophysical hole burning (PPHB) effect may then be considered in an elementary way. Finally the decay rates of the different states and the holes can be determined. Fast routines for solving the system of differential equations are given allowing for an easy interactive analysis of the measurements on personal computers. The behaviour of the solutions for the two simplest models is discussed. The experimental results of PPHB measurements on crystal violet in 2-propanol were modelled using this formalism.
Persistent spectral hole burning with multiplicity was realized at room temperature for Nile blue molecules-doped polymeric dielectric spherical microparticles based on morphology-dependent resonances. Hole parameters depending on burning conditions were studied. Dynamical characteristic behavior of hole formation was measured and analyzed with a model based on rate equations. The effective hole formation rate was obtained by simulation. Photophysical and photochemical mechanisms of the room temperature hole burning for this system was discussed.
In this paper theories are given, describing photophysical and photochemical hole burning experiments on molecular mixed crystals at low temperature. Population saturation hole burning is treated for a two-level system where the lower level is the ground state. Hole burning due to a triplet state acting as a population bottle neck is also described by a steady-state density matrix theory. Connection is made with optical free induction decay. To obtain T2 (the decay time of the off-diagonal elements of the density matrix), which is the main goal of these hole burning experiments, a linear extrapolation method is discussed. For photochemical hole burning a time-dependent density matrix treatment is given. Using this theory numerical simulations were performed of the experimental results obtained by Völker and co-workers for porphin in n-octane at low temperature. Good agreement with experiment is obtained. For this case extrapolation methods are discussed in order to obtain reliable T2 values. A time-dependent kinetic theory is used to simulate the photochemical hole burning experiments on dimethyl-s-tetrazine in durene and s-tetrazine in benzene. This theory accounts for the recently revealed two-photon character of these photodissociations. It is shown that despite this complication the hole full width at half-maximum may still equal twice the homogeneous width of the So-S1 transition.