Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Shapiro steps observed in annular intrinsic Josephson junctions at low microwave frequencies

Huabing Wang, Sunmi Kim, Shinya Urayama, Masanori Nagao, Toshihisa Hatano, Shunichi Arisawa, Takashi Yamashita, Peiheng Wu

Published Feb 6, 2006• 15 citations
Publisher

Abstract

With annular intrinsic Josephson junctions structured from a slice of Bi2Sr2CaCu2O8+δ single crystal 200nm thick, we have devised a way to inject fluxons into the junctions only by sweeping the bias current. The stacks have shown typical properties concerning Josephson fluxon conservation. These annular junctions are sensitive to microwave irradiation, and quite sharp Shapiro steps have been observed at ∼20GHz which is much lower than the plasma frequency of the junctions, indicating many applications can be possible with practically accessible microwave sources.

DOI
10.1063/1.2172010

Related papers

Individual Shapiro steps observed in resistively shunted intrinsic Josephson junctions on Bi2Sr2CaCu2O8+x single crystals

H. B. Wang, Yuta Aruga, J. Chen +3 more

With a thin gold layer, we fabricated mesa-like shunted intrinsic Josephson junction stacks on Bi2Sr2CaCu2O8+x single crystals. Instead of the multibranch structure and large voltage jumps often observed in conventional intrinsic junctions, current–voltage characteristics typical of resistively shunted junctions were obtained. Individual Shapiro steps were clearly visible with irradiation at frequencies from a few to 20 GHz. The experiments demonstrated not only the ac Josephson effects directly but also the possibility of employing intrinsic Josephson junctions in high-frequency applications.

Applied Physics Letters•Aug 14, 2000•25 citations

Microwave-induced current steps in intrinsic Josephson junctions patterned on Bi2Sr2CaCu2O8 single crystal

H.B. Wang, Yuta Aruga, Takashi Tachiki +5 more

With a 10 μm×10 μm mesa patterned on Bi2Sr2CaCu2O8 single crystals, we measure the current–voltage (I–V) curves of a stack of intrinsic Josephson junctions. Current steps are observed at an equal voltage spacing of 4 mV when the sample is subjected to microwave radiation at around 7 GHz. With increase of the microwave power, more steps occur while the spacing between neighboring steps does not seem to change. The magnitude of each step depends on the microwave power in an oscillating way. Tuning the microwave frequency causes such steps to occur over separate frequency ranges, and each range is quite narrow. A temperature rise from 4.2 to 14.3 K completely quenches the step structures. Possible explanations for the step structures, based on resonances excited by microwave or geometric resonances in the junction cavity, are discussed.

Applied Physics Letters•Jun 14, 1999•19 citations

BSCCO intrinsic Josephson junctions for microwave detection

Takashi Tachiki, Takashi Uchida, Yoshizumi Yasuoka

Microwave-induced steps were observed in I-V characteristics of intrinsic Josephson junctions fabricated on an overdoped BSCCO single crystal with a weak magnetic field parallel to the c-axis. Voltage intervals between the steps under the irradiation of 12.2, 13.2 and 13.9 GHz microwaves were independent of the microwave power and proportional to the frequency. From the measurement of voltage intervals, it was found that all the junctions in the fabricated junction stack simultaneously produced Shapiro steps, assuming that the steps are Shapiro steps.

IEEE Transactions on Applied Superconductivity•Jun 1, 2003•5 citations

Zero-crossing steps in intrinsic Josephson junctions of Bi2Sr2CaCu2O8+δ

H. L. Johnson, Gerd Hechtfischer, Gabriel Götz +2 more

We have investigated the response to microwave irradiation of small mesas fabricated on single crystals of Bi2Sr2CaCu2O8+δ. We observe zero-crossing steps in the current-voltage characteristic which are consistent with the intrinsic Josephson junctions in the mesa stack phase-locking to the external microwave field.

Journal of Applied Physics•Jul 15, 1997•17 citations

Three-dimensional arrays of BiSrCaCuO-2212 intrinsic Josephson junctions and zero-crossing Shapiro steps at 760 GHz

H. B. Wang, Peiheng Wu, J. Chen +2 more

On a slice of 200–300-nm-thick Bi2Sr2CaCu2O8+x, stacks of intrinsic Josephson junctions are patterned, connected to each other, and integrated with a bow-tie antenna and some chokes. Over an area of 150 μm by 170 μm, we have been able to fabricate up to 256 stacks with over 11 000 junctions. Such three-dimensional arrays of intrinsic Josephson junctions respond sensitively to irradiation at 760 GHz from a far-infrared laser, showing clear zero-crossing Shapiro steps up to 0.75 V. In addition, possible applications in quantum voltage standards are discussed here. The high density of integration of the Josephson junctions is also promising for many other applications.

arXiv:cond-mat/0110234•Applied Physics Letters•Mar 4, 2002•33 citations

Intrinsic Josephson Junctions in BiSrCaCuO-2212: Recent Progress

Huabing Wang, Jian Chen, Lixing You +2 more

SUMMARY In this paper, we review the progress in BiSrCaCuO-2212 Intrinsic Josephson junctions (IJJs) bysummarizing our recent results in fabrication and high frequencyexperiments. Using a double-side fabrication process, a well defined number of intrinsic Josephson junctions in a well defined geometrycan be fabricated. The junctions in the stack are quite homogeneous, and the power distribution of external irradiation among the junctions is even. Shapiro steps are clearlyobserved up to 2.5 THz, and the general condition for the occurrence of Shapiro steps at frequency f is that it should be much greater than the plasma frequency fpl. Under certain conditions the Shapiro steps are zero-crossing, making some applications possible, such as quantum voltage standard etc.

IEICE Transactions on Electronics•Mar 1, 2002•1 citation
With annular intrinsic Josephson junctions structured from a slice of Bi2Sr2CaCu2O8+δ single crystal 200nm thick, we have devised a way to inject fluxons into the junctions only by sweeping the bias current. The stacks have shown typical properties concerning Josephson fluxon conservation. These annular junctions are sensitive to microwave irradiation, and quite sharp Shapiro steps have been observed at ∼20GHz which is much lower than the plasma frequency of the junctions, indicating many applications can be possible with practically accessible microwave sources.
With a thin gold layer, we fabricated mesa-like shunted intrinsic Josephson junction stacks on Bi2Sr2CaCu2O8+x single crystals. Instead of the multibranch structure and large voltage jumps often observed in conventional intrinsic junctions, current–voltage characteristics typical of resistively shunted junctions were obtained. Individual Shapiro steps were clearly visible with irradiation at frequencies from a few to 20 GHz. The experiments demonstrated not only the ac Josephson effects directly but also the possibility of employing intrinsic Josephson junctions in high-frequency applications.
With a 10 μm×10 μm mesa patterned on Bi2Sr2CaCu2O8 single crystals, we measure the current–voltage (I–V) curves of a stack of intrinsic Josephson junctions. Current steps are observed at an equal voltage spacing of 4 mV when the sample is subjected to microwave radiation at around 7 GHz. With increase of the microwave power, more steps occur while the spacing between neighboring steps does not seem to change. The magnitude of each step depends on the microwave power in an oscillating way. Tuning the microwave frequency causes such steps to occur over separate frequency ranges, and each range is quite narrow. A temperature rise from 4.2 to 14.3 K completely quenches the step structures. Possible explanations for the step structures, based on resonances excited by microwave or geometric resonances in the junction cavity, are discussed.
Microwave-induced steps were observed in I-V characteristics of intrinsic Josephson junctions fabricated on an overdoped BSCCO single crystal with a weak magnetic field parallel to the c-axis. Voltage intervals between the steps under the irradiation of 12.2, 13.2 and 13.9 GHz microwaves were independent of the microwave power and proportional to the frequency. From the measurement of voltage intervals, it was found that all the junctions in the fabricated junction stack simultaneously produced Shapiro steps, assuming that the steps are Shapiro steps.
On a slice of 200–300-nm-thick Bi2Sr2CaCu2O8+x, stacks of intrinsic Josephson junctions are patterned, connected to each other, and integrated with a bow-tie antenna and some chokes. Over an area of 150 μm by 170 μm, we have been able to fabricate up to 256 stacks with over 11 000 junctions. Such three-dimensional arrays of intrinsic Josephson junctions respond sensitively to irradiation at 760 GHz from a far-infrared laser, showing clear zero-crossing Shapiro steps up to 0.75 V. In addition, possible applications in quantum voltage standards are discussed here. The high density of integration of the Josephson junctions is also promising for many other applications.
SUMMARY In this paper, we review the progress in BiSrCaCuO-2212 Intrinsic Josephson junctions (IJJs) bysummarizing our recent results in fabrication and high frequencyexperiments. Using a double-side fabrication process, a well defined number of intrinsic Josephson junctions in a well defined geometrycan be fabricated. The junctions in the stack are quite homogeneous, and the power distribution of external irradiation among the junctions is even. Shapiro steps are clearlyobserved up to 2.5 THz, and the general condition for the occurrence of Shapiro steps at frequency f is that it should be much greater than the plasma frequency fpl. Under certain conditions the Shapiro steps are zero-crossing, making some applications possible, such as quantum voltage standard etc.