Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Electron temperature fluctuation noise in hot-electron superconducting mixers

Hans Erik Ekström, Boris S. Karasik

Published Jun 5, 1995• 31 citations
Publisher

Abstract

An experimental study is presented of the output noise in hot-electron superconducting NbN bolometer mixers. Fluctuations of the electron temperature have been shown to be the main source of electrical noise. The rolloff frequency of the spectral noise density corresponds well to the inverse electron temperature relaxation time (≊230 ps). Equivalent noise data have been obtained for the device at a physical temperature within superconducting transition region, and at a somewhat lower physical temperature with the device pumped by 350 GHz radiation to reach the same operating point. The single sideband (SSB) mixer noise temperature due to intrinsic noise mechanisms for the NbN device is estimated to 360 K independent of radiation frequency. A larger critical current density may promote a further reduction of the intrinsic conversion loss of the mixer device.

DOI
10.1063/1.113726

Related papers

Analysis of the Noise Performance of a Hot-Electron Superconducting Bolometer Mixer

Boris S. Karasik, A. I. Elant’ev

A theoretical analysis for the noise temperature of hot—electron superconducting mixer has been presented. The contributions of both Johnson noise and electron temperature fluctuations have been evaluated. A set of criteria ensuring low noise performance of the mixer has been stated and a simple analytic expression for the noise temperature of the mixer device has been suggested. It has been shown that an improvement of the mixer sensitivity does not necessarily follow by a decrease of the bandwidth. An SSB noise temperature limit due to the intrinsic noise mechanisms has been estimated to be as low as 40-90 K for a mixer device made from Nb or NbN thin film. Furthermore, the conversion gain bandwidth can be as wide as is allowed by the intrinsic electron temperature relaxation time if an appropriate choice of the mixer resistance has been made. The intrinsic mixer noise bandwidth is of 3 GHz for Nb device and of 5 GHz for NbN device. An additional improvement of the theory has been made when a distinction between the impedance measured at high intermediate frequency (larger than the mixer bandwidth) and the mixer ohmic resistance has been taken into account. Recently obtained experimental data on Nb and NbN bolometer mixer devices are viewed in connection with the theoretical predictions. The noise temperature limit has also been specified for the mixer device where an outdiffusion cooling mechanism rather than the electron—phonon energy relaxation determines the mixer bandwidth. A consideration of the noise performance of a bolometer mixer made from YBaCuO film utilizing a hot—electron effect has been done.

•Mar 1, 1995•29 citations

Noise temperature limit of a superconducting hot-electron bolometer mixer

Boris S. Karasik, A. I. Elant’ev

A theoretical analysis for the noise temperature of a low-temperature hot-electron superconducting mixer has been presented. The contribution of both Johnson noise and electron temperature fluctuations has been evaluated. The theoretical limit of the single-side band noise temperature of the device due to the intrinsic noise mechanisms has been estimated to be as low as 20–40 K, depending on the film material. The corresponding noise bandwidth can be as large as 2–3 GHz, for a device with the electron-phonon cooling mechanism. An improvement of the sensitivity is not necessarily followed by a decrease of the mixer conversion gain bandwidth.

Applied Physics Letters•Feb 5, 1996•103 citations

Rigorous Analysis of a Superconducting Hot-Electron Bolometer Mixer: Theory and Comparison with Experiment

Rainer S. Nebosis, Alexei D. Semenov, Yu. P. Gousev +1 more

We present theoretical analysis of the performance of a superconducting hot-electron bolometer mixer with electron cooling due to electron phonon interaction. The analysis is based on a complete set of thermal balance equations for phonons and electrons. A non-thermal action of a dc current has been considered phenomenologically using an analytical fit of isothermal current-voltage characteristics of the mixer. The operation point of the mixer has been determined as a result of the heating by both the power of a local oscillator and the power dissipated by the current. Electron temperature fluctuations, Nyquist noise, and shot noise have been supposed to only contribute to the mixer noise. The conversion gain and the noise temperature of the mixer have been evaluated taking into account an electro-thermal feedback between the mixer and an intermediate frequency circuit with an arbitrary impedance. We have obtained general expressions for the conversion gain, noise temperature and impedance which enabled us to estimate ultimate performance of a superconducting hot-electron bolometer mixer. Theoretical predictions are in good agreement with experimental results obtained for a NbN hot-electron bolometer mixer at a radiation frequency of 2.5 THz.

Softwaretechnik-Trends•Mar 1, 1996•22 citations

Noise Behaviour of a THz Superconducting Hot-Electron Bolometer Mixer

Wen Zhang, Ning Li, Ling Jiang +11 more

A quasi-optical superconducting NbN hot-electron bolometer (HEB) mixer is measured in the frequency range of 0.5–2.5 THz for understanding of the frequency dependence of noise temperature of THz coherent detectors. It has been found that noise temperature increasing with frequency is mainly due to the coupling loss between the quasi-optical planar antenna and the superconducting HEB bridge when taking account of non-uniform distribution of high-frequency current. With the coupling loss corrected, the superconducting HEB mixer demonstrates a noise temperature nearly independent of frequency.

Chinese Physics Letters•Jun 1, 2007•8 citations

Linear and nonlinear characteristics of NbN hot electron bolometer devices

Yan Zhuang

The superconducting HEB device is so far the most promising low noise mixer in the THz frequency range. It out-performs other existing receiver systems because it has low noise temperature and sufficient bandwidth for applications in the FIR range such as astronomy, remote sensing and plasma diagnostics. This work investigates the linear and nonlinear characteristics of NbN Hot Electron Bolometer (HEB) devices. First of all, a thorough expression of the Johnson noise and the thermal fluctuation noise has been re-derived. Our circuit model is more preferable for the HEB devices than the traditional one being used for the semiconductor bolometer. Secondly, the equivalent noise temperature of our receiver system has been significantly improved: the noise temperature went from the original 5800K to a record of 500K for silicon substrate devices. We are also getting improved noise performance for the new MgO substrate devices. The simulation results agree with the measured data very well around the optimum operating point. Finally, the device in the unstable region can be stabilized by connecting a series resistor with higher resistance than the negative resistance of the device. Two frequencies are related to the oscillation waveforms of the voltage and the current of the device. The first one is the repetition frequency that is actually related to the external circuit. The second one is the relaxation frequency that is related to the intrinsic phenomena of the device itself. The domain wall velocity and the relaxation oscillation frequency have been calculated both theoretically and experimentally. The calculated results are within a satisfactory range compared with the measured data. Also, a thorough explanation of the device oscillation process has been presented.

Journal of Bioresource Management•Jan 1, 2002•4 citations

Direct Measurement of the Input RF Noise of Superconducting Hot Electron Bolometer Receivers

W. Miao, Wen Zhang, Kangmin Zhou +4 more

A good understanding of input radio-frequency (RF) noise contribution is of particular importance to the development of high-sensitivity superconducting hot electron bolometer (HEB) receivers. In terms of simulation results based on the hot spot model, we found that the output noise of HEB mixers is nearly linearly decreased with the mixer's bath temperature when the HEB mixer is operated at its optimum DC-bias regime under appropriate local-oscillator signal pumping, and the effect of this decrease on the receiver output power can be well corrected. Thus, we used an intersecting lines technique to measure the input RF noise temperature of a quasi-optical superconducting NbN HEB receiver, and the measured input RF noise temperature of the HEB receiver is around 300 K at 850 GHz. For comparison, we also evaluated the losses and equivalent noise temperatures of the quasi-optical components in the RF signal path. The evaluated input RF noise temperature is found to be smaller than the measured one.

IEEE Transactions on Applied Superconductivity•Nov 27, 2012•2 citations
An experimental study is presented of the output noise in hot-electron superconducting NbN bolometer mixers. Fluctuations of the electron temperature have been shown to be the main source of electrical noise. The rolloff frequency of the spectral noise density corresponds well to the inverse electron temperature relaxation time (≊230 ps). Equivalent noise data have been obtained for the device at a physical temperature within superconducting transition region, and at a somewhat lower physical temperature with the device pumped by 350 GHz radiation to reach the same operating point. The single sideband (SSB) mixer noise temperature due to intrinsic noise mechanisms for the NbN device is estimated to 360 K independent of radiation frequency. A larger critical current density may promote a further reduction of the intrinsic conversion loss of the mixer device.
A theoretical analysis for the noise temperature of hot—electron superconducting mixer has been presented. The contributions of both Johnson noise and electron temperature fluctuations have been evaluated. A set of criteria ensuring low noise performance of the mixer has been stated and a simple analytic expression for the noise temperature of the mixer device has been suggested. It has been shown that an improvement of the mixer sensitivity does not necessarily follow by a decrease of the bandwidth. An SSB noise temperature limit due to the intrinsic noise mechanisms has been estimated to be as low as 40-90 K for a mixer device made from Nb or NbN thin film. Furthermore, the conversion gain bandwidth can be as wide as is allowed by the intrinsic electron temperature relaxation time if an appropriate choice of the mixer resistance has been made. The intrinsic mixer noise bandwidth is of 3 GHz for Nb device and of 5 GHz for NbN device. An additional improvement of the theory has been made when a distinction between the impedance measured at high intermediate frequency (larger than the mixer bandwidth) and the mixer ohmic resistance has been taken into account. Recently obtained experimental data on Nb and NbN bolometer mixer devices are viewed in connection with the theoretical predictions. The noise temperature limit has also been specified for the mixer device where an outdiffusion cooling mechanism rather than the electron—phonon energy relaxation determines the mixer bandwidth. A consideration of the noise performance of a bolometer mixer made from YBaCuO film utilizing a hot—electron effect has been done.
A theoretical analysis for the noise temperature of a low-temperature hot-electron superconducting mixer has been presented. The contribution of both Johnson noise and electron temperature fluctuations has been evaluated. The theoretical limit of the single-side band noise temperature of the device due to the intrinsic noise mechanisms has been estimated to be as low as 20–40 K, depending on the film material. The corresponding noise bandwidth can be as large as 2–3 GHz, for a device with the electron-phonon cooling mechanism. An improvement of the sensitivity is not necessarily followed by a decrease of the mixer conversion gain bandwidth.
We present theoretical analysis of the performance of a superconducting hot-electron bolometer mixer with electron cooling due to electron phonon interaction. The analysis is based on a complete set of thermal balance equations for phonons and electrons. A non-thermal action of a dc current has been considered phenomenologically using an analytical fit of isothermal current-voltage characteristics of the mixer. The operation point of the mixer has been determined as a result of the heating by both the power of a local oscillator and the power dissipated by the current. Electron temperature fluctuations, Nyquist noise, and shot noise have been supposed to only contribute to the mixer noise. The conversion gain and the noise temperature of the mixer have been evaluated taking into account an electro-thermal feedback between the mixer and an intermediate frequency circuit with an arbitrary impedance. We have obtained general expressions for the conversion gain, noise temperature and impedance which enabled us to estimate ultimate performance of a superconducting hot-electron bolometer mixer. Theoretical predictions are in good agreement with experimental results obtained for a NbN hot-electron bolometer mixer at a radiation frequency of 2.5 THz.
A quasi-optical superconducting NbN hot-electron bolometer (HEB) mixer is measured in the frequency range of 0.5–2.5 THz for understanding of the frequency dependence of noise temperature of THz coherent detectors. It has been found that noise temperature increasing with frequency is mainly due to the coupling loss between the quasi-optical planar antenna and the superconducting HEB bridge when taking account of non-uniform distribution of high-frequency current. With the coupling loss corrected, the superconducting HEB mixer demonstrates a noise temperature nearly independent of frequency.
The superconducting HEB device is so far the most promising low noise mixer in the THz frequency range. It out-performs other existing receiver systems because it has low noise temperature and sufficient bandwidth for applications in the FIR range such as astronomy, remote sensing and plasma diagnostics. This work investigates the linear and nonlinear characteristics of NbN Hot Electron Bolometer (HEB) devices. First of all, a thorough expression of the Johnson noise and the thermal fluctuation noise has been re-derived. Our circuit model is more preferable for the HEB devices than the traditional one being used for the semiconductor bolometer. Secondly, the equivalent noise temperature of our receiver system has been significantly improved: the noise temperature went from the original 5800K to a record of 500K for silicon substrate devices. We are also getting improved noise performance for the new MgO substrate devices. The simulation results agree with the measured data very well around the optimum operating point. Finally, the device in the unstable region can be stabilized by connecting a series resistor with higher resistance than the negative resistance of the device. Two frequencies are related to the oscillation waveforms of the voltage and the current of the device. The first one is the repetition frequency that is actually related to the external circuit. The second one is the relaxation frequency that is related to the intrinsic phenomena of the device itself. The domain wall velocity and the relaxation oscillation frequency have been calculated both theoretically and experimentally. The calculated results are within a satisfactory range compared with the measured data. Also, a thorough explanation of the device oscillation process has been presented.
A good understanding of input radio-frequency (RF) noise contribution is of particular importance to the development of high-sensitivity superconducting hot electron bolometer (HEB) receivers. In terms of simulation results based on the hot spot model, we found that the output noise of HEB mixers is nearly linearly decreased with the mixer's bath temperature when the HEB mixer is operated at its optimum DC-bias regime under appropriate local-oscillator signal pumping, and the effect of this decrease on the receiver output power can be well corrected. Thus, we used an intersecting lines technique to measure the input RF noise temperature of a quasi-optical superconducting NbN HEB receiver, and the measured input RF noise temperature of the HEB receiver is around 300 K at 850 GHz. For comparison, we also evaluated the losses and equivalent noise temperatures of the quasi-optical components in the RF signal path. The evaluated input RF noise temperature is found to be smaller than the measured one.