Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Letters

Optical bistability with surface plasmons

Gary Mathew Wysin, Henry J. Simon, Robert T. Deck

Published Jan 1, 1981• 83 citations
Publisher

Abstract

We theoretically examine bistable operation in reflection with simultaneous excitation of the surface-plasmon mode at the interface with a nonlinear Kerr medium. Bistability may occur for an incident power an order of magnitude below that reported previously for a grazing-incidence geometry.
DOI
10.1364/ol.6.000030

Related papers

Optical bistability from surface plasmon excitation through a nonlinear medium

P. Martinot, S. Laval, A. Köster

The excitation of surface plasmon by attenuated total reflection can be used to get a bistable optical device. As the incident light beam propagates through a nonlinear medium, any intensity variation tunes the plasmon excitation through resonance. Furthermore, the superposition of the incident and reflected beams induces a feedback and allows bistable operation.

Journal de physique•Jan 1, 1984•33 citations

Optical Bistability with Surface Plasmons beyond Plane Waves in Nonlinear Dielectric

G. S. Agarwal, Subhasish Dutta Gupta

Wysin et al1 suggested that the local field enhancement near a metal surface which occurs if surface plasmons are excited in a metal film, can be useful for observing optical bistability arising from the nonlinearity of the Kerr medium. Other geometrical arrangements2 have also been suggested. These studies assume plane waves in the nonlinear medium and use the Fresnel formulae for reflection and refraction from a layered medium but with linear refractive index replaced by the nonlinear refractive index. This assumes that the fields in the medium are homogeneous. However if surface plasmons are excited, then the fields are inhomogeneous and one has the problem of reflection and refraction from an inhomogeneous layered medium. The inhomogeneity is to be determined self consistently. Thus a proper treatment of optical bistability with surface plasmons should use the nonlinear solutions of the wave equation in Kerr medium. This is what we do in this paper.

Topical Meeting on Optical Bistability (OB)•Jan 1, 1985•0 citations

Optical Bistability Associated with Surface Plasmon Polariton Excitation

Toshihiro Okamoto, Masanobu Haraguchi, Masuo Fukui

We have theoretically analysed the optical bistability due to the excitation of surface plasmon polaritons (SP's) in samples, prism/metal film/nonlinear optic medium and prism/gap material/metal film/non-linear optic medium, where the non-linear optic medium has an intensity-dependent refractive index. We considered two cases, i.e. non-linearity along the propagation direction of SP's and along the normal to the interface. In the former case, the critical input power for the optical bistability was too high to allow experimental observation, while it was reasonably low for the latter case.

Journal of the Physical Society of Japan•May 15, 1992•2 citations

Optical bistability with surface plasmons beyond plane waves in a nonlinear dielectric

Subhasish Dutta Gupta, G. S. Agarwal

Optical bistability with surface plasmons is studied assuming nonlinear polaritons in a Kerr medium. Significant departures from the plane-wave results for the switching intensities and hysteresis curves are predicted.

Journal of the Optical Society of America B•Feb 1, 1986•30 citations

Exact results on optical bistability with surface plasmons in layered media

G. S. Agarwal, Subhasish Dutta Gupta

Optical bistability with surface plasmons in layered structures on a nonlinear substrate is studied using Leung's exact results for the nonlinear p-polarized surface waves. Explicit results for the bistable behavior of the reflected field are given for two different geometries involving excitation of short-range and long-range surface plasmons. The excitation of long-range plasmons results in a much lower bistability threshold.

Physical review. B, Condensed matter•Oct 15, 1986•36 citations

Phase optical bistability in structures with surface plasmons

V. F. Nazvanov, D. I. Kovalenko

A theoretical analysis is made of the phenomenon of phase optical bistability in structures with surface plasmons. It is shown that in an optical waveguide with a nonlinear layer, not only amplitude but also phase bistability may occur when p -polarized radiation is reflected from the nonlinear waveguide.

Technical Physics Letters•Aug 1, 1998•4 citations
Wysin et al1 suggested that the local field enhancement near a metal surface which occurs if surface plasmons are excited in a metal film, can be useful for observing optical bistability arising from the nonlinearity of the Kerr medium. Other geometrical arrangements2 have also been suggested. These studies assume plane waves in the nonlinear medium and use the Fresnel formulae for reflection and refraction from a layered medium but with linear refractive index replaced by the nonlinear refractive index. This assumes that the fields in the medium are homogeneous. However if surface plasmons are excited, then the fields are inhomogeneous and one has the problem of reflection and refraction from an inhomogeneous layered medium. The inhomogeneity is to be determined self consistently. Thus a proper treatment of optical bistability with surface plasmons should use the nonlinear solutions of the wave equation in Kerr medium. This is what we do in this paper.
We have theoretically analysed the optical bistability due to the excitation of surface plasmon polaritons (SP's) in samples, prism/metal film/nonlinear optic medium and prism/gap material/metal film/non-linear optic medium, where the non-linear optic medium has an intensity-dependent refractive index. We considered two cases, i.e. non-linearity along the propagation direction of SP's and along the normal to the interface. In the former case, the critical input power for the optical bistability was too high to allow experimental observation, while it was reasonably low for the latter case.