Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review B

Cross correlations between charge noise and critical-current fluctuations in a four-level tunable Josephson system

Lara Faoro, F. W. J. Hekking

Published Feb 23, 2010• 7 citations
Publisher

Abstract

A protocol to test cross correlations between charge and critical-current noise in the small superconducting contacts of an asymmetric Cooper-pair transistor coupled to a phase qubit is presented. The superconducting circuit behaves as a tunable four-level quantum system that can be prepared in two different configurations where cross-correlation terms are, respectively, absent or present and therefore, in principle, detectable. The measurements of the cross correlations are performed either through the escape probability of the dc superconducting quantum interference device or a quantum-state tomography of a few elements of the reduced density matrix of the four-level quantum system.

DOI
10.1103/physrevb.81.052505

Related papers

Strong Tunable Coupling between a Superconducting Charge and Phase Qubit

Aurélien Fay, Emile Hoskinson, Florent Lecocq +4 more

We have realized a tunable coupling over a large frequency range between an asymmetric Cooper pair transistor (charge qubit) and a dc SQUID (phase qubit). Our circuit enables the independent manipulation of the quantum states of each qubit as well as their entanglement. The measurement of the charge qubit's quantum states is performed by an adiabatic quantum transfer from the charge to the phase qubit. The measured coupling strength is in agreement with an analytic theory including a capacitive and a tunable Josephson coupling between the two qubits.

arXiv:0712.3970•Physical Review Letters•May 6, 2008•41 citations

Cooper-pair tunneling in small junctions with tunable Josephson coupling

Y. Harada, Hideaki Takayanagi, A. A. Odintsov

We investigate Cooper-pair tunneling in a circuit consisting of two dc-superconducting quantum interference devices in series, with a gate capacitively coupled to the central island. Measurements cover a wide range of values of the ratio between Josephson coupling energy ${E}_{J}$ and charging energy ${E}_{C}$. The $\frac{{E}_{J}}{{E}_{C}}$ ratio dependence of the supercurrent is well described by the orthodox theory provided that strong fluctuations of the Josephson phase due to the electromagnetic environment are taken into account. Our data can be interpreted in terms of squeezing of the charge fluctuations with decreasing $\frac{{E}_{J}}{{E}_{C}}$ ratio.

Physical review. B, Condensed matter•Sep 1, 1996•15 citations

Asymmetric Cooper pair transistor in parallel to a dc SQUID: Two coupled quantum systems

Aurélien Fay, Wiebke Guichard, O. Buisson +1 more

We present a theoretical analysis of a superconducting quantum circuit based on a highly asymmetric Cooper pair transistor (ACPT) in parallel to a dc superconduction quantum intereference device (SQUID). Starting from the full Hamiltonian we show that the circuit can be modeled as a charge qubit (ACPT) coupled to an anharmonic oscillator (dc SQUID). Depending on the anharmonicity of the SQUID, the Hamiltonian can be reduced either to one that describes two coupled qubits or to the Jaynes-Cummings Hamiltonian. Here the dc SQUID can be viewed as a tunable micrometer-sized resonator. The coupling term, which is a combination of a capacitive and a Josephson coupling between the two qubits, can be tuned from the very strong- to the zero-coupling regime. It describes very precisely the tunable coupling strength measured in this circuit [A. Fay et al., Phys. Rev. Lett. 100, 187003 (2008)] and explains the ``quantronium'' as well as the adiabatic quantum transfer readout.

arXiv:1011.6148•Physical Review B•May 17, 2011•11 citations

Quantum coherent dynamics of two coupled superconducting charge qubits

Yu. A. Pashkin, O. V. Astafiev, Tsuyoshi Yamamoto +5 more

We have analyzed and measured the quantum coherent dynamics of a circuit containing two coupled superconducting charge qubits. Each qubit is based on a Cooper pair box connected to a reservoir electrode through a Josephson junction. Two qubits are coupled electrostatically by a small island overlapping both Cooper pair boxes. Quantum state manipulation ofthe qubit circuit is done by applying non-adiabatic voltage pulses to the common gate. We read out each qubit by means of probe electrodes connected to Cooper pair boxes through high-Ohmic tunnel junctions. With such a setup the measured pulse-induced probe currents are proportional to the probability for each qubit to have an extra Cooper pai1r after the manipulation. As expected from theory and observed experimentally the measured pulse-induced current in each probe has two frequency components whose position on the frequency axis can be externally controlled. This is a result ofthe inter-qubit coupling which is also responsible for the avoided level crossing that we observed in the qubits' spectra. Our simulations show that in the absence of decoherence and with a rectangular pulse shape the system remains entangled most ofthe time reaching maximally entangled states at certain instances.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jun 1, 2005•0 citations

Josephson-Junction Qubits

Yuriy Makhlin, Gerd Schön, Alexander Shnirman

Among the potential physical implementations of quantum bits (qubits) solid state devices appear most promising for large scale applications and integration in electronic circuits. Devices based on low-capacitance Josephson junctions exploit the coherence of the superconducting state, combined with the possibility to control individual charges by Coulomb blockade effects. The logical states in these systems differ by one Cooper-pair charge. Single- and two-bit operations can be performed by applying a sequence of gate voltages. The phase coherence time is sufficiently long to allow a series of these steps. If, in addition, the strength of the Josephson coupling is controlled (e.g. by currents in SQUID loops) the system is ideal for quantum computation. Recent experiments by Nakamura et al. show the feasibility of this approach. In addition to the manipulations of qubits the resulting quantum state has to be read out. This quantum measurement process can be accomplished by coupling a single-electron transistor (SET) capacitively to the qubit. We investigate the process by analyzing the time-evolution of the density matrix of the coupled system. The measurement process is characterized by three time scales: the dephasing time, which is fast when a dissipative current flows in the SET, a longer ‘measurement time’ needed to read out the signal, and a third, even longer ‘mixing time’, characterizing measurement induced transitions which destroy the information about the initial quantum state. The noise spectrum of the current in the SET displays these time scales and allows their direct observation.

Fortschritte der Physik•Sep 1, 2000•11 citations

Measurements of 1∕f noise in Josephson junctions at zero voltage: Implications for decoherence in superconducting quantum bits

Michael Mück, Matthias Korn, Chas Mugford +2 more

Critical current fluctuations with a 1∕f spectral density (f is frequency) are potentially a limiting source of intrinsic decoherence in superconducting quantum bits (qubits) based on Josephson tunnel junctions. Prior measurements of this noise were made at nonzero voltages whereas qubits are operated in the zero voltage state. We report measurements of 1∕f noise in a dc superconducting quantum interference device first, coupled to a resonant tank circuit and operated in a dispersive mode at zero voltage, and, second, operated conventionally with a current bias in the voltage regime. Both measurements yield essentially the same magnitude of critical current 1∕f noise.

arXiv:cond-mat/0501153•Applied Physics Letters•Dec 27, 2004•19 citations
A protocol to test cross correlations between charge and critical-current noise in the small superconducting contacts of an asymmetric Cooper-pair transistor coupled to a phase qubit is presented. The superconducting circuit behaves as a tunable four-level quantum system that can be prepared in two different configurations where cross-correlation terms are, respectively, absent or present and therefore, in principle, detectable. The measurements of the cross correlations are performed either through the escape probability of the dc superconducting quantum interference device or a quantum-state tomography of a few elements of the reduced density matrix of the four-level quantum system.
We have realized a tunable coupling over a large frequency range between an asymmetric Cooper pair transistor (charge qubit) and a dc SQUID (phase qubit). Our circuit enables the independent manipulation of the quantum states of each qubit as well as their entanglement. The measurement of the charge qubit's quantum states is performed by an adiabatic quantum transfer from the charge to the phase qubit. The measured coupling strength is in agreement with an analytic theory including a capacitive and a tunable Josephson coupling between the two qubits.
We investigate Cooper-pair tunneling in a circuit consisting of two dc-superconducting quantum interference devices in series, with a gate capacitively coupled to the central island. Measurements cover a wide range of values of the ratio between Josephson coupling energy EJ{E}_{J}EJ​ and charging energy EC{E}_{C}EC​. The EJEC\frac{{E}_{J}}{{E}_{C}}EC​EJ​​ ratio dependence of the supercurrent is well described by the orthodox theory provided that strong fluctuations of the Josephson phase due to the electromagnetic environment are taken into account. Our data can be interpreted in terms of squeezing of the charge fluctuations with decreasing EJEC\frac{{E}_{J}}{{E}_{C}}EC​EJ​​ ratio.
We present a theoretical analysis of a superconducting quantum circuit based on a highly asymmetric Cooper pair transistor (ACPT) in parallel to a dc superconduction quantum intereference device (SQUID). Starting from the full Hamiltonian we show that the circuit can be modeled as a charge qubit (ACPT) coupled to an anharmonic oscillator (dc SQUID). Depending on the anharmonicity of the SQUID, the Hamiltonian can be reduced either to one that describes two coupled qubits or to the Jaynes-Cummings Hamiltonian. Here the dc SQUID can be viewed as a tunable micrometer-sized resonator. The coupling term, which is a combination of a capacitive and a Josephson coupling between the two qubits, can be tuned from the very strong- to the zero-coupling regime. It describes very precisely the tunable coupling strength measured in this circuit [A. Fay et al., Phys. Rev. Lett. 100, 187003 (2008)] and explains the ``quantronium'' as well as the adiabatic quantum transfer readout.
We have analyzed and measured the quantum coherent dynamics of a circuit containing two coupled superconducting charge qubits. Each qubit is based on a Cooper pair box connected to a reservoir electrode through a Josephson junction. Two qubits are coupled electrostatically by a small island overlapping both Cooper pair boxes. Quantum state manipulation ofthe qubit circuit is done by applying non-adiabatic voltage pulses to the common gate. We read out each qubit by means of probe electrodes connected to Cooper pair boxes through high-Ohmic tunnel junctions. With such a setup the measured pulse-induced probe currents are proportional to the probability for each qubit to have an extra Cooper pai1r after the manipulation. As expected from theory and observed experimentally the measured pulse-induced current in each probe has two frequency components whose position on the frequency axis can be externally controlled. This is a result ofthe inter-qubit coupling which is also responsible for the avoided level crossing that we observed in the qubits' spectra. Our simulations show that in the absence of decoherence and with a rectangular pulse shape the system remains entangled most ofthe time reaching maximally entangled states at certain instances.
Among the potential physical implementations of quantum bits (qubits) solid state devices appear most promising for large scale applications and integration in electronic circuits. Devices based on low-capacitance Josephson junctions exploit the coherence of the superconducting state, combined with the possibility to control individual charges by Coulomb blockade effects. The logical states in these systems differ by one Cooper-pair charge. Single- and two-bit operations can be performed by applying a sequence of gate voltages. The phase coherence time is sufficiently long to allow a series of these steps. If, in addition, the strength of the Josephson coupling is controlled (e.g. by currents in SQUID loops) the system is ideal for quantum computation. Recent experiments by Nakamura et al. show the feasibility of this approach. In addition to the manipulations of qubits the resulting quantum state has to be read out. This quantum measurement process can be accomplished by coupling a single-electron transistor (SET) capacitively to the qubit. We investigate the process by analyzing the time-evolution of the density matrix of the coupled system. The measurement process is characterized by three time scales: the dephasing time, which is fast when a dissipative current flows in the SET, a longer ‘measurement time’ needed to read out the signal, and a third, even longer ‘mixing time’, characterizing measurement induced transitions which destroy the information about the initial quantum state. The noise spectrum of the current in the SET displays these time scales and allows their direct observation.
Critical current fluctuations with a 1∕f spectral density (f is frequency) are potentially a limiting source of intrinsic decoherence in superconducting quantum bits (qubits) based on Josephson tunnel junctions. Prior measurements of this noise were made at nonzero voltages whereas qubits are operated in the zero voltage state. We report measurements of 1∕f noise in a dc superconducting quantum interference device first, coupled to a resonant tank circuit and operated in a dispersive mode at zero voltage, and, second, operated conventionally with a current bias in the voltage regime. Both measurements yield essentially the same magnitude of critical current 1∕f noise.