Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Japanese Journal of Applied Physics

Numerical Evaluation for the High-Frequency Response of Josephson Junctions Having Finite Capacitance

Yoshinao Mizugaki, Jian Chen, Kensuke Nakajima Kensuke Nakajima, Tsutomu Yamashita

Published Nov 1, 1998• 6 citations
Publisher

Abstract

The high-frequency response of a Josephson junction is numerically investigated. The resistively shunted junction (RSJ) model and the resistively and capacitively shunted junction (RCSJ) model are employed. Simulation results for the Shapiro steps are different between the two models. The difference with respect to the RF current is explained by employing a simple resistor and capacitor model.

DOI
10.1143/jjap.37.5971

Related papers

I-Vcharacteristics of microwave-driven Josephson junctions in the low-frequency and high-damping regime

C. Vanneste, C. C., Karen H. Brown +10 more

Experimental I-V curves of microwave-driven Josephson tunnel junctions with resistive shunts are reported. The results are in very good agreement with numerical calculations using the resistively shunted junction model. In the low-frequency regime there are three distinct regions in the I-V curves and two different types of Shapiro steps. It is demonstrated that the overall shape of the I-V curves can be explained by using an adiabatic interpretation of the junction response. The two different types of Shapiro steps are related to a compensation effect between dc and rf bias currents.

Physical review. B, Condensed matter•Apr 1, 1985•22 citations

RCLSJ model correction and verification by a proposed test method for DFF’s high-frequency performance

Shuangmu Wang, Xi Gao, Jie Ren

Abstract The pursuit of high-speed response and precise reconstruction of phase reversal within Josephson junction constitutes the principal research objectives for the device model in the superconducting single flux quantum (SFQ) circuits. The proposing of the resistive-capacitive-inductive-shunted junction (RCLSJ) model by incorporating a shunted inductance on the classical resistive-capacitive-shunted junction (RCSJ) model, indeed achieves a more accurate description of the Current–Voltage ( I – V ) characteristics of Josephson junctions. However, the effectiveness of the RCLSJ model in dynamic simulations of SFQ circuits has not yet been verified. We proposed a simple and convenient test structure for D flip-flop (DFF) circuits to obtain the variation of its bias margin over a wide frequency sweep range. Post-simulations using the RCLSJ model were performed for DFF circuits. It was found that there are still matching problems between the simulations and tests, especially in the higher frequency region. Based on the junction area structure and layout application under the SIMIT-Nb03 process, a corrected RCLSJ model, designated as the RCLSJv model, was developed. This model mainly reassigns the parasitic inductance of the junction area and introduces correction coefficients by fitting the test data. The validity of the model has been verified through the comprehensive fitting of multiple sets of DFFs’ test data. In comparation with the RCSJ model, the deviation between the test and simulation results was successfully confined within 3%. Notably, in the frequency range above 60 GHz, the matching degree exhibits a remarkable enhancement, with an improvement factor ranging from 2 to 5 times.

Superconductor Science and Technology•Apr 14, 2025•1 citation

Model analysis for a current-step-like structure in a high Tc Josephson device coupled to a microwave signal

Yoshinao Mizugaki, Jian Chen

High Tc Josephson junctions have IcRn products as large as a few mV at liquid helium temperature, and hence, the frequency normalized by IcRn∕Φ0 becomes on the order of 10−3 for a gigahertz (GHz) microwave signal. (Here, Ic, Rn, and Φ0 are the critical current, the normal resistance, and a flux quantum, respectively.) It is well known that a microwave-current-driven Josephson junction does not exhibit clear Shapiro steps under such low frequency conditions. Instead of Shapiro steps, however, we often observe a current-step-like structure in the current–voltage curve of YBa2Cu3O7−δ grain boundary Josephson junctions coupled to a GHz signal. In this article, we present a model analysis for such current-step-like structures. Two types of device models are employed: a simple resistively and capacitively shunted junction model and a rf-field-driven two-junction superconducting quantum interference device model. Numerical results of the latter model agree with the experimental results, which indicates that the envelope of small Shapiro steps, including the effects of microwave-induced motion of flux quanta, appears as a current-step-like structure in a high Tc Josephson device coupled to a GHz microwave.

Journal of Applied Physics•Mar 8, 2005•3 citations

A new behavioral-level model of superconducting Josephson junctions with Simulink

Yalin Zhong, Peng Chen

Abstract Josephson junctions based on superconducting materials are fundamental components for quantum detection, quantum communication and quantum computers. An accurate behavioral model of Josephson junctions is the prerequisite for predicting various superconducting circuits. In this study, We present a resistively and capacitively shunted junction (RCSJ) model-based behavioral-level model for the current-voltage characteristics of Josephson junctions. This model accurately predicts the current-voltage characteristics and their temperature dependencies of Josephson junctions made of different materials under three typical working modes: underdamped voltage-driven, overdamped current-driven, and underdamped current-driven. Additionally, it forecasts the critical current and superconducting energy gap characteristics with respect to temperature, as well as the constraint relationship between the shunt resistance, superconducting energy gap, and critical current. Comparing the measured data with the simulation predictions, the model has an average accuracy of 85.9%, which illustrates the reliability of the model.

Journal of Computational Electronics•Aug 3, 2024•1 citation

Dynamics of underdamped Josephson junctions with nonsinusoidal current-phase relation

Victor K. Kornev, T. Yu. Karminskaya, Yu. V. Kislinskiĭ +3 more

Results on analytical and computational investigations of high frequency dynamics of Josephson junctions, characterized by nonzero capacitance and the second harmonic in the current-phase relation are presented. These attributes each influence on behaviour of integer Shapiro steps and lead to formation of non-integer Shapiro steps. Analytic theory of the integer and non-integer Shapiro steps has been developed for so-called high frequency limit. The analytical and numerical results are compared with experimental data for hybrid heterostructures YBCO/Au/Nb. Detector response for the case of high fluctuation level has been considered as well.

Journal of Physics Conference Series•Jun 1, 2006•10 citations

The plasma resonance in the response and in the rf impedance of a capacitively shunted Josephson junction in the presence of thermal noise

Tim Poorter, Harm Tolner

The rf impedance and the wide-band response to radiation of a resistively shunted junction (RSJ) model Josephson junction have been measured in the presence of thermal noise, using a phase-locked-loop analog of the RSJ model. In the conditions for which analytical calculations are valid there is good agreement between the theory and the analog. When the RSJ model is shunted with a capacitance, a plasma type resonance can occur in the rf impedance when the junction is biased in the supercurrent (in-lock). When thermal noise is present, this plasma resonance can also occur when a nonzero average voltage is generated across the junction. We found that in this case a resonance also occurs in the wide-band response to radiation. This resonance takes place at a frequency that can be identified as the attempt frequency, with which the junction attempts to escape the phase locked condition in which it exists for a fraction of the time even though the average voltage across the junction is nonzero. The average lifetimes of the junction in lock τin (?=0) and out of lock τout (?=?out) were also measured in the presence of thermal noise. τin is in good agreement with existing theory and τout is derived from the measurements.

Journal of Applied Physics•Dec 1, 1980•1 citation
The high-frequency response of a Josephson junction is numerically investigated. The resistively shunted junction (RSJ) model and the resistively and capacitively shunted junction (RCSJ) model are employed. Simulation results for the Shapiro steps are different between the two models. The difference with respect to the RF current is explained by employing a simple resistor and capacitor model.
Experimental I-V curves of microwave-driven Josephson tunnel junctions with resistive shunts are reported. The results are in very good agreement with numerical calculations using the resistively shunted junction model. In the low-frequency regime there are three distinct regions in the I-V curves and two different types of Shapiro steps. It is demonstrated that the overall shape of the I-V curves can be explained by using an adiabatic interpretation of the junction response. The two different types of Shapiro steps are related to a compensation effect between dc and rf bias currents.
Abstract The pursuit of high-speed response and precise reconstruction of phase reversal within Josephson junction constitutes the principal research objectives for the device model in the superconducting single flux quantum (SFQ) circuits. The proposing of the resistive-capacitive-inductive-shunted junction (RCLSJ) model by incorporating a shunted inductance on the classical resistive-capacitive-shunted junction (RCSJ) model, indeed achieves a more accurate description of the Current–Voltage ( I – V ) characteristics of Josephson junctions. However, the effectiveness of the RCLSJ model in dynamic simulations of SFQ circuits has not yet been verified. We proposed a simple and convenient test structure for D flip-flop (DFF) circuits to obtain the variation of its bias margin over a wide frequency sweep range. Post-simulations using the RCLSJ model were performed for DFF circuits. It was found that there are still matching problems between the simulations and tests, especially in the higher frequency region. Based on the junction area structure and layout application under the SIMIT-Nb03 process, a corrected RCLSJ model, designated as the RCLSJv model, was developed. This model mainly reassigns the parasitic inductance of the junction area and introduces correction coefficients by fitting the test data. The validity of the model has been verified through the comprehensive fitting of multiple sets of DFFs’ test data. In comparation with the RCSJ model, the deviation between the test and simulation results was successfully confined within 3%. Notably, in the frequency range above 60 GHz, the matching degree exhibits a remarkable enhancement, with an improvement factor ranging from 2 to 5 times.
High Tc Josephson junctions have IcRn products as large as a few mV at liquid helium temperature, and hence, the frequency normalized by IcRn∕Φ0 becomes on the order of 10−3 for a gigahertz (GHz) microwave signal. (Here, Ic, Rn, and Φ0 are the critical current, the normal resistance, and a flux quantum, respectively.) It is well known that a microwave-current-driven Josephson junction does not exhibit clear Shapiro steps under such low frequency conditions. Instead of Shapiro steps, however, we often observe a current-step-like structure in the current–voltage curve of YBa2Cu3O7−δ grain boundary Josephson junctions coupled to a GHz signal. In this article, we present a model analysis for such current-step-like structures. Two types of device models are employed: a simple resistively and capacitively shunted junction model and a rf-field-driven two-junction superconducting quantum interference device model. Numerical results of the latter model agree with the experimental results, which indicates that the envelope of small Shapiro steps, including the effects of microwave-induced motion of flux quanta, appears as a current-step-like structure in a high Tc Josephson device coupled to a GHz microwave.
Abstract Josephson junctions based on superconducting materials are fundamental components for quantum detection, quantum communication and quantum computers. An accurate behavioral model of Josephson junctions is the prerequisite for predicting various superconducting circuits. In this study, We present a resistively and capacitively shunted junction (RCSJ) model-based behavioral-level model for the current-voltage characteristics of Josephson junctions. This model accurately predicts the current-voltage characteristics and their temperature dependencies of Josephson junctions made of different materials under three typical working modes: underdamped voltage-driven, overdamped current-driven, and underdamped current-driven. Additionally, it forecasts the critical current and superconducting energy gap characteristics with respect to temperature, as well as the constraint relationship between the shunt resistance, superconducting energy gap, and critical current. Comparing the measured data with the simulation predictions, the model has an average accuracy of 85.9%, which illustrates the reliability of the model.
Results on analytical and computational investigations of high frequency dynamics of Josephson junctions, characterized by nonzero capacitance and the second harmonic in the current-phase relation are presented. These attributes each influence on behaviour of integer Shapiro steps and lead to formation of non-integer Shapiro steps. Analytic theory of the integer and non-integer Shapiro steps has been developed for so-called high frequency limit. The analytical and numerical results are compared with experimental data for hybrid heterostructures YBCO/Au/Nb. Detector response for the case of high fluctuation level has been considered as well.
The rf impedance and the wide-band response to radiation of a resistively shunted junction (RSJ) model Josephson junction have been measured in the presence of thermal noise, using a phase-locked-loop analog of the RSJ model. In the conditions for which analytical calculations are valid there is good agreement between the theory and the analog. When the RSJ model is shunted with a capacitance, a plasma type resonance can occur in the rf impedance when the junction is biased in the supercurrent (in-lock). When thermal noise is present, this plasma resonance can also occur when a nonzero average voltage is generated across the junction. We found that in this case a resonance also occurs in the wide-band response to radiation. This resonance takes place at a frequency that can be identified as the attempt frequency, with which the junction attempts to escape the phase locked condition in which it exists for a fraction of the time even though the average voltage across the junction is nonzero. The average lifetimes of the junction in lock τin (?=0) and out of lock τout (?=?out) were also measured in the presence of thermal noise. τin is in good agreement with existing theory and τout is derived from the measurements.