Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Optics

Two-step selective photoionization of rubidium by using a Ti:sapphire laser

Koji Tamura, Masaki Oba, Takashi Arisawa

Published Feb 20, 1993• 4 citations
Publisher

Abstract

A pulsed Ti:sapphire laser (TSL) is applied for what is, to our knowledge, the first time to laser isotope separation. A collimated beam of a rubidium atom with a natural isotope composition ((85)Rb, 72%; (87)Rb, 28%) is excited selectively from the ground state to the 5(2)P(3/2) state by irradiation of the single-longitudinalmode TSL, and is photoionized by successive UV radiation. Ion spectra of each isotope indicate that each isotope is selectively photoionized.

DOI
10.1364/ao.32.000987

Related papers

Selective excitation and chemical reactions in alkali metal vapor

V. O. Chaltykyan, G. G. Grigoryan, Yu. P. Malakyan

We consider a gas of two-level atoms of two species (for example, natural Rb vapor consisting of two isotopes) in the field of laser radiation tuned close to resonance with the certain transition of a specific iostope. This radiation may turn to be rather close to a near lying transition of other isotope (within the linewidth of laser radiation), so it is necessary to take into account the possibility of excitation of other isotope in order to evaluate the enrichment degree if it is aimed at the isotope separation by means of selective excitation with subsequent chemcial reaction (in our example the rubidium hydride formation) of the excited isotope which is believed to take place at a rate much higher than that in the ground state of the atom.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 11, 2003•0 citations

Resonance ionization of rubidium using sequential diode laser-driven transitions

Robert W. Shaw, Jack Phillip Young, J. Michael Ramsey

Diode laser excitation of rubidium atoms at the D2 line followed by (1 + 1) ionization using a pulsed dye laser was examined. Mass-resolved D2 spectra were recorded for both natural isotopes. Excitation using two sequential diode laser photons was accomplished by counterpropagating the beam from the 780 nm laser and one from a 775.8 laser; the latter excites Rb from the {sup 5}P{sub 3/2} level to the {sup 5}D{sub 5/2} level at 25704 cm{sup {minus}1}. A photon from the R6G laser then ionized the atom. Spectra resulting from scanning the second diode laser -- with the first an an off-resonance fixed frequency revealed both two-photon and sequential (1 + 1) processes.

•Jan 1, 1992•3 citations

Isotope-selective photoionization spectroscopy of barium

Darrell J. Armstrong, J. Cooper

We demonstrate an experimental technique that selects the nuclear spin I=0 isotope $^{138}\mathrm{Ba}$ for spectroscopic measurements from a beam of natural barium containing seven stable isotopes. A cw dye laser is used to optically pump the I=3/2 isotopes $^{135}\mathrm{Ba}$ and $^{137}\mathrm{Ba}$ into the metastable 6s5d $^{1}$${\mathit{D}}_{2}$ and $^{3}$${\mathit{D}}_{1,2}$ levels via the 6s6p $^{1}$${\mathit{P}}_{1}$ excited state, leaving nearly pure $^{138}\mathrm{Ba}$ in the ground state. Photoionization spectra of the excited 5d6p $^{3}$${\mathit{D}}_{1}$ even isotope state recorded with optical pumping of $^{135}\mathrm{Ba}$ and $^{137}\mathrm{Ba}$ to the metastable levels are essentially devoid of forbidden features associated with the hyperfine interaction in the odd isotopes.

Physical Review A•Apr 1, 1993•11 citations

Selective photoionization of the ytterbium atom by coherent two-photon excitation

Hyunmin Park, Jongmin Lee, Jai-Hyung Lee +1 more

Highly selective photoionization of the ytterbium atom by coherent two-photon excitation was demonstrated experimentally. The Yb atom was excited by two single-mode lasers and ionized by a time-delayed broadband laser. The isotope ratio of the ions was analyzed by a time-of-flight mass spectrometer. The ion yield and the selectivity were recorded as a function of detuning of the first exciting laser. The maximum of ion yield was observed when the laser was detuned from resonance. The selectivity of $^{168}\mathrm{Yb}$ was increased higher than 20 000 when the laser was blue-detuned to the most efficient position. Also, numerical analysis was performed to explain the experimental results. \textcopyright{} 1996 The American Physical Society.

Physical Review A•Mar 1, 1996•10 citations

Isotope-selective laser excitation and field ionization of thenF5/2Rydberg states in a thallium beam

Petr A. Bokhan, Nikolai V. Fateev, V A Kim +1 more

The effective isotope-selective excitation and field ionization of the 16F5/2 thallium Rydberg states have been studied experimentally. The 16F5/2 states were excited by the two-step scheme 6P1/2→6D3/2→nF5/2 in a dense collimated atomic beam by means of monochromatic radiation from two frequency tunable lasers (λ1 = 276.9 nm, λ2 = 773–808 nm) with a mean power density of more than 1 W.The largest selectivity of excitation in this scheme takes place in the first step 6P1/2→6D3/2. The experiments showed that the main reason for the limiting selectivity excitation of the Rydberg states is the field broadening of the absorption resonances at the first and second steps of the excitation scheme. The excitation efficiency of this scheme is considerably governed by the parameters of the laser radiation at the second step and an electric field pulse.

Laser Physics•Apr 16, 2013•1 citation

Towards Selective Two-step Photoionization of Ba Isotopes for Ba+ Ion Trap

Tamura Koji, Ogura Koichi, Shimada Hiroyuki +5 more

Cooling and trapping ion system is considered as a promising candidate for quantum information processor. Especially, by manipulating 133Ba+ ion, improved fidelity of qubit operation is expected, where selective 133Ba isotope introduction to the ion trap is required. Development of isotope selective loading system of Ba ion for the ion trap using the two-step laser photoionization is shown. For the excitation step (791 nm), the target isotope atom is photo-excited among other Ba isotopes based on their isotope shift. A tunable laser with a narrow spectral linewidth compared to the Ba isotope shift, was developed using an external cavity diode laser (ECDL). Mode-hop-free (MHF) scanning was achieved. For the second ionization step, a pulsed N2 laser was used. Both laser beams were combined using a mirror, focused with a lens, and introduced into a vacuum chamber. An atomic source was made by resistive heating, which can heat the source and generate atomic beam with sufficient vapor pressure and atomic density for the measurements. The system is under development and is prepared for the Ba atomic beam generation and laser photoionization experiments.

•Jul 4, 2024•0 citations
A pulsed Ti:sapphire laser (TSL) is applied for what is, to our knowledge, the first time to laser isotope separation. A collimated beam of a rubidium atom with a natural isotope composition ((85)Rb, 72%; (87)Rb, 28%) is excited selectively from the ground state to the 5(2)P(3/2) state by irradiation of the single-longitudinalmode TSL, and is photoionized by successive UV radiation. Ion spectra of each isotope indicate that each isotope is selectively photoionized.
We consider a gas of two-level atoms of two species (for example, natural Rb vapor consisting of two isotopes) in the field of laser radiation tuned close to resonance with the certain transition of a specific iostope. This radiation may turn to be rather close to a near lying transition of other isotope (within the linewidth of laser radiation), so it is necessary to take into account the possibility of excitation of other isotope in order to evaluate the enrichment degree if it is aimed at the isotope separation by means of selective excitation with subsequent chemcial reaction (in our example the rubidium hydride formation) of the excited isotope which is believed to take place at a rate much higher than that in the ground state of the atom.
Diode laser excitation of rubidium atoms at the D2 line followed by (1 + 1) ionization using a pulsed dye laser was examined. Mass-resolved D2 spectra were recorded for both natural isotopes. Excitation using two sequential diode laser photons was accomplished by counterpropagating the beam from the 780 nm laser and one from a 775.8 laser; the latter excites Rb from the {sup 5}P{sub 3/2} level to the {sup 5}D{sub 5/2} level at 25704 cm{sup {minus}1}. A photon from the R6G laser then ionized the atom. Spectra resulting from scanning the second diode laser -- with the first an an off-resonance fixed frequency revealed both two-photon and sequential (1 + 1) processes.
We demonstrate an experimental technique that selects the nuclear spin I=0 isotope 138Ba^{138}\mathrm{Ba}138Ba for spectroscopic measurements from a beam of natural barium containing seven stable isotopes. A cw dye laser is used to optically pump the I=3/2 isotopes 135Ba^{135}\mathrm{Ba}135Ba and 137Ba^{137}\mathrm{Ba}137Ba into the metastable 6s5d 1^{1}1D2{\mathit{D}}_{2}D2​ and 3^{3}3D1,2{\mathit{D}}_{1,2}D1,2​ levels via the 6s6p 1^{1}1P1{\mathit{P}}_{1}P1​ excited state, leaving nearly pure 138Ba^{138}\mathrm{Ba}138Ba in the ground state. Photoionization spectra of the excited 5d6p 3^{3}3D1{\mathit{D}}_{1}D1​ even isotope state recorded with optical pumping of 135Ba^{135}\mathrm{Ba}135Ba and 137Ba^{137}\mathrm{Ba}137Ba to the metastable levels are essentially devoid of forbidden features associated with the hyperfine interaction in the odd isotopes.
Highly selective photoionization of the ytterbium atom by coherent two-photon excitation was demonstrated experimentally. The Yb atom was excited by two single-mode lasers and ionized by a time-delayed broadband laser. The isotope ratio of the ions was analyzed by a time-of-flight mass spectrometer. The ion yield and the selectivity were recorded as a function of detuning of the first exciting laser. The maximum of ion yield was observed when the laser was detuned from resonance. The selectivity of 168Yb^{168}\mathrm{Yb}168Yb was increased higher than 20 000 when the laser was blue-detuned to the most efficient position. Also, numerical analysis was performed to explain the experimental results. \textcopyright{} 1996 The American Physical Society.
The effective isotope-selective excitation and field ionization of the 16F5/2 thallium Rydberg states have been studied experimentally. The 16F5/2 states were excited by the two-step scheme 6P1/2→6D3/2→nF5/2 in a dense collimated atomic beam by means of monochromatic radiation from two frequency tunable lasers (λ1 = 276.9 nm, λ2 = 773–808 nm) with a mean power density of more than 1 W.The largest selectivity of excitation in this scheme takes place in the first step 6P1/2→6D3/2. The experiments showed that the main reason for the limiting selectivity excitation of the Rydberg states is the field broadening of the absorption resonances at the first and second steps of the excitation scheme. The excitation efficiency of this scheme is considerably governed by the parameters of the laser radiation at the second step and an electric field pulse.
Cooling and trapping ion system is considered as a promising candidate for quantum information processor. Especially, by manipulating 133Ba+ ion, improved fidelity of qubit operation is expected, where selective 133Ba isotope introduction to the ion trap is required. Development of isotope selective loading system of Ba ion for the ion trap using the two-step laser photoionization is shown. For the excitation step (791 nm), the target isotope atom is photo-excited among other Ba isotopes based on their isotope shift. A tunable laser with a narrow spectral linewidth compared to the Ba isotope shift, was developed using an external cavity diode laser (ECDL). Mode-hop-free (MHF) scanning was achieved. For the second ionization step, a pulsed N2 laser was used. Both laser beams were combined using a mirror, focused with a lens, and introduced into a vacuum chamber. An atomic source was made by resistive heating, which can heat the source and generate atomic beam with sufficient vapor pressure and atomic density for the measurements. The system is under development and is prepared for the Ba atomic beam generation and laser photoionization experiments.